Search OEDI Data

Showing results 1 - 25 of 226.
Show results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
"Shaft Speed"×

Accelerated Lifetime Testing of Main Shaft Seals for Tidal Turbine Rotors

The lifetime assessment experimental platform described in this report is specifically designed for testing the low-speed main shaft seal for Verdant Power's (Verdant Power Inc., New York, New York) fifth-generation (Gen5) underwater power generation turbine. This project is joint...
Murray, R. et al National Renewable Energy Laboratory
Jul 01, 2024
1 Resources
0 Stars
Publicly accessible

Auto Indexer Auto-Indexer for Percussive Hammers: Vane Motor Dynamometer Testing

Objectives Options associated with geothermal drilling operations are generally limited by factors such as formation temperature and rock strength. The objective of the research is to expand the "tool box" available to the geothermal driller by furthering the development of a hig...
Su, J. Sandia National Laboratories
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible

HydroAir Power Take Off Combined Design Report

The submission is the combined design report for the HydroAir Power Take Off (PTO). CAD drawings, circuit diagrams, design report, test plan, technical specifications and data sheets are included for the Main and auxiliary control cabinets and three-phase-synchronous-motor with a ...
Pearson, G. et al Dresser-Rand Company
Jun 26, 2015
15 Resources
0 Stars
Publicly accessible

Gearbox Reliability Collaborative Phase 3 Gearbox 2 Test

The National Renewable Energy Laboratory (NREL) Gearbox Reliability Collaborative (GRC) was established by the U.S. Department of Energy in 2006; its key goal is to understand the root causes of premature gearbox failures and improve their reliability. The GRC uses a combined gear...
Keller and RobbNational Renewable Energy Laboratory
May 02, 2016
17 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence Q Raw Data

**Overview** Sequence Q: Dynamic Inflow (P) This sequence was designed to characterize the dynamic inflow variation using the five-hole probes that extend upwind of the leading edge of the blade. This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind sp...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 11, 2018
1 Resources
0 Stars
Publicly accessible

UNH TDP Voltsys Raw Data and Processing Scripts Fall 2021

This submission contains raw Voltsys rectifier data and processing scripts associated with MHKDR submission 394 (UNH TDP Concurrent Measurements of Inflow, Power Performance, and Loads for a Grid-Synchronized Vertical Axis Cross-Flow Turbine Operating in a Tidal Estuary, DOI: 10.1...
Bharath, A. et al National Renewable Energy Laboratory
Dec 21, 2021
4 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Laser Scanned 4100 L Drift Map

The EGS Collab project is evaluating a site for Experiment 2 (hydraulic fracturing/shearing) at a depth of 1.25 km in the Sanford Underground Research Facility (SURF) on the 4100 Level. Two early test holes were drilled in an alcove (formerly known as Battery Charging Station) nea...
Neupane, G. et al Idaho National Laboratory
Dec 19, 2019
4 Resources
0 Stars
Publicly accessible

TEAMER: Vertical Axies Hydrokinetic Turbine Data, Emrgy Inc. 2022, Post Access Submission

The data herein contains all data collected and used for the Performance Characterization Testing and Model Calibration of a Vertical Axis Hydrokinetic Turbine. The data includes performance data and durability data for the Hydrokinetic Turbine. The device performance data contain...
Cuthbert, T. Emrgy, Inc.
Apr 06, 2022
4 Resources
0 Stars
Publicly accessible

Wind Turbine Gearbox Condition Monitoring Vibration Analysis Benchmarking Datasets

Wind turbine condition monitoring (CM) can potentially help the wind industry reduce turbine downtime and operation and maintenance (O&M) cost. NREL CM research has investigated various condition-monitoring techniques such as acoustic emission (AE specifically stress wave), vibrat...
Sheng, S. National Renewable Energy Laboratory
Mar 28, 2014
5 Resources
2 Stars
Publicly accessible

EGS Collab Experiment 2: Preliminary Test Wells Locations and Orientations

The EGS Collab project is evaluating a site for Experiment 2 (hydraulic fracturing/shearing) at a depth of 1.25 km in the Sanford Underground Research Facility (SURF) on the 4100 Level. Two early test holes were drilled in an alcove (formerly known as Battery Charging Station) nea...
Neupane, G. et al Idaho National Laboratory
Dec 19, 2019
4 Resources
0 Stars
Publicly accessible

MBARI-WEC September and October 2022 Field Data

This data is needed to simulate a model of the MBARI-WEC (Monterey Bay Aquarium Research Institute, Wave Energy Converter device) in a simulation environment (e.g. Gazebo) for 56 observation dates in the time between September and October 2022, and to compare the simulation output...
Dizon, C. et al Oregon State University
Sep 07, 2022
5 Resources
0 Stars
Publicly accessible

Current Energy Harnessing using Synergistic Kinematics of Schools of Fish-Shaped Bodies: Marine Hydrodynamics Laboratory Tank Testing Data

The objectives of the proposed work pertain to building a high power-density and high efficiency device to harness MHK energy by mimicking fish-school kinematics. Vortex Hydro Energy is collaborating with a concept formed and undergone preliminary testing at the University of Mich...
Bernitsas, M. Vortex Hydro Energy
Apr 11, 2017
20 Resources
0 Stars
Publicly accessible

Lidar HilFlowS LLNL ZephIR300 WOP Processed Data

**Overview** The ZephIR300 is a continuous wave LIDAR with a range of 10 m to 300 m. During HilFlowS the ZephIR300 was programmed to measure from 10 m to 150 m. In addition, the ZephIR300 provided a measurement at 1 m height using an onboard meteorological sensor. The ZephIR300 ...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible

Lidar HilFlowS LLNL ZephIR300 MOP Processed Data

**Overview** The ZephIR300 is a continuous wave LIDAR with a range of 10 m to 300 m. During HilFlowS the ZephIR300 was programmed to measure from 10 m to 150 m. In addition, the ZephIR300 provided a measurement at 1 m height using an onboard meteorological sensor. The ZephIR300 ...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible

Preliminary performance of HT Datalink

Preliminary performance of high-temperature (HT) high-speed (HS) data link at room temperature over 5000 ft of wireline. The data shows ability of the data link to adapt by decreasing speed.
Cieslewski, G. Sandia National Laboratories
Feb 11, 2014
1 Resources
0 Stars
Publicly accessible

Surface Meteorological Station HilFlowS LLNL 52m tall tower EOP Processed Data

**Overview** The WindCube v2 was co-located with Site 300’s 52-m-tall meteorological tower so that measurements below 40 m could also be observed. The meteorological tower has three measurement levels: 10 m, 23 m, and 52 m. Wind speed was measured with a cup anemometer; wind di...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible

UNH TDP Concurrent Measurements of Inflow, Power Performance, and Loads for a Grid-Synchronized Vertical Axis Cross-Flow Turbine Operating in a Tidal Estuary

This data was collected between October 12 and December 15 of 2021 at the University of New Hampshire (UNH) and Atlantic Marine Energy Center (AMEC) turbine deployment platform (TDP). This data set includes over 29 days of grid connected turbine operation during this 65 day time f...
Wosnik, M. et al National Renewable Energy Laboratory
Dec 21, 2021
30 Resources
0 Stars
Publicly accessible

Lidar HilFlowS LLNL WindCube v2 EOP Processed Data

**Overview** The WindCube v2 is a pulsed LIDAR and uses four beams sent in succession in the four cardinal directions along a 28°scanning cone angle to measure horizontal velocity and wind direction. A fifth beam is sent in the vertical direction to measure vertical velocity. Me...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible

Design of high deflection foils for MHK applications CFD files

The Ocean Renewable Power Company's (ORPC's) goal is to design, develop, and test hydrofoils with large deflections. The effects of the deflections on cross-flow turbine performance would be evaluated in order to inform design considerations for full-scale water turbines and other...
Barrington, M. and McEntee, J. Ocean Renewable Power Company
Jun 01, 2021
5 Resources
0 Stars
Publicly accessible

Advanced Direct-Drive Generator for Improved Availability of Oscillating Wave Surge Converter Power Generation Systems: 10hp 30rpm Radial-Flux Magnetically Geared Generator Test Data

Static torque, no load, constant speed, and sinusoidal oscillation test data for a 10hp, 300rpm magnetically-geared generator prototype using either an adjustable load bank for a fixed resistance or an output power converter.
Ouyang, W. and Tchida, C. ABB Inc.
May 02, 2017
1 Resources
0 Stars
Publicly accessible

Simulated wind speed and initial conditions over the WFIP2 region: Cold-front (D01)

**Overview** The purpose of this work is to assess the sensitivity of the forecast for turbine height wind speed to initial condition (IC) uncertainties over the Columbia River Gorge and Columbia River Basin for two typical weather phenomena: a local thermal gradient induced by a...
Liu, Y. Wind Energy Technologies Office (WETO)
Aug 19, 2016
1 Resources
0 Stars
Publicly accessible

Simulated wind speed and initial conditions over the WFIP2 region: Cold-front (D02)

**Overview** The purpose of this work is to assess the sensitivity of the forecast for turbine height wind speed to initial condition (IC) uncertainties over the Columbia River Gorge and Columbia River Basin for two typical weather phenomena: a local thermal gradient induced by a...
Liu, Y. Wind Energy Technologies Office (WETO)
Aug 19, 2016
1 Resources
0 Stars
Publicly accessible

Simulated wind speed and initial conditions over the WFIP2 region: Sea-breeze (D01)

**Overview** The purpose of this work is to assess the sensitivity of the forecast for turbine height wind speed to initial condition (IC) uncertainties over the Columbia River Gorge and Columbia River Basin for two typical weather phenomena: a local thermal gradient induced by a...
Liu, Y. Wind Energy Technologies Office (WETO)
Aug 15, 2016
1 Resources
0 Stars
Publicly accessible

Simulated wind speed and initial conditions over the WFIP2 region: Sea-breeze (D02)

**Overview** The purpose of this work is to assess the sensitivity of the forecast for turbine height wind speed to initial condition (IC) uncertainties over the Columbia River Gorge and Columbia River Basin for two typical weather phenomena: a local thermal gradient induced by a...
Liu, Y. Wind Energy Technologies Office (WETO)
Aug 15, 2016
1 Resources
0 Stars
Publicly accessible

Wind Resources in Alaska

Wind resource data for Alaska and southeast Alaska, both high resolution wind resource maps and gridded wind parameters. The two high resolution wind maps are comprised of a grid of cells each containing a single value of average wind speed (m/s) at a hub height of 30, 50, 70, and...
AEDI, A. National Renewable Energy Laboratory
Dec 31, 2006
3 Resources
0 Stars
In curation
12345Next >>