Search OEDI Data

Showing results 1 - 25 of 43.
Show results per page.
Order by:
Available Now:
Clear All Filters ×
Research Areas
Accessibility
Data Type
Organization
Source
"dynamic test rig"×
Sandia National Laboratories×

McGinness Hills Well 27A-10 Daily Drilling Report Data

This data should be used with the daily drilling record and other data which can be obtained from the contact listed below.
Knudsen, S. Sandia National Laboratories
Mar 25, 2014
2 Resources
0 Stars
Publicly accessible

West Flank Coso FORGE: Well 74-2TCH Temperature, Pressure, Well History, Well Bore Schematic

Temperature logs, pressure logs, directional survey, well history, well bore schematic, and other reports for well 74-2TCH at West Flank FORGE
Blankenship, D. Sandia National Laboratories
May 13, 2016
1 Resources
0 Stars
Publicly accessible

Advanced WEC Dynamics and Controls, Test 1

Numerous studies have shown that advanced control of a wave energy converter's (WEC's) power take off (PTO) can provide significant increases (on the order of 200-300%) in WEC energy absorption. Transitioning these control approaches from simplified paper studies to application in...
Coe, R. Sandia National Laboratories
Feb 26, 2016
3 Resources
0 Stars
Publicly accessible

FOSWEC v2: System identification and control testing at Hinsdale Wave Research Laboratory

This report summarizes the design and execution of a wave tank test of the floating oscillating surge wave energy converter (FOSWEC) in the O.H. Hinsdale Wave Research Laboratory Directional Wave Basin at Oregon State University. This device, which uses two "flaps" that pivot abou...
Coe, R. et al Sandia National Laboratories
Feb 01, 2020
2 Resources
0 Stars
Publicly accessible

Fallon FORGE 3D Geologic Model

An x,y,z scattered data file for the 3D geologic model of the Fallon FORGE site. Model created in Earthvision by Dynamic Graphic Inc. The model was constructed with a grid spacing of 100 m. Geologic surfaces were extrapolated from the input data using a minimum tension gridding al...
Blankenship, D. Sandia National Laboratories
Mar 01, 2016
1 Resources
0 Stars
Publicly accessible

West Flank Coso FORGE: 3D Geologic Model

This is an x,y,z file of the West Flank FORGE 3D geologic model. Model created in Earthvision by Dynamic Graphic Inc. The model was constructed with a grid spacing of 100 m. Geologic surfaces were extrapolated from the input data using a minimum tension gridding algorithm. The da...
Blankenship, D. Sandia National Laboratories
Mar 01, 2016
1 Resources
0 Stars
Publicly accessible

Hydroshear Simulation Lab Test 2, Additional Data Sheets

This file contains additional data for this test (hydroshear test 3.2). In this test a sample of granite with a pre-cut (man made fracture) is confined, heated and differential stress is applied. The max temperature in this this system development test is 95C. More test details ca...
Bauer, S. Sandia National Laboratories
Aug 01, 2014
2 Resources
0 Stars
Publicly accessible

Hydroshear Simulation Lab Test 2

This data file is for test 2. In this test a sample of granite with a pre-cut (man made fracture) is confined, heated and differential stress is applied. The max temperature in this this system development test is 95C. More test details can be found on the spreadsheets--note that ...
Bauer, S. Sandia National Laboratories
Aug 01, 2014
3 Resources
0 Stars
Publicly accessible

MASK3 for Advanced WEC Dynamics and Controls

This report outlines the "MASK3" wave tank test within the Advanced WEC Dynamics and Controls (AWDC) project. This test represents the final test in the AWDC project. The focus of the MASK3 test was to consider coordinated 3-degree-of-freedom (3DOF) control of a WEC in a realistic...
Coe, R. et al Sandia National Laboratories
May 01, 2019
4 Resources
0 Stars
Publicly accessible

Laboratory Evaluation of EGS Shear Stimulation-Test 001

This is the results of an initial setup-shakedon test in order to develop the plumbing system for this test design. a cylinder of granite with offset holes was jacketed and subjected to confining pressure and low temperature (85C) and pore water pressure. Flow through the sample w...
Bauer, S. Sandia National Laboratories
Jul 29, 2014
1 Resources
0 Stars
Publicly accessible

High Temperature Chemical Sensing Tool: Preliminary pH and reference electrode test results

Project: High Temperature Chemical Sensing Tool for Distributed Mapping of Fracture Flow in EGS. Preliminary pH and reference electrode test results.
Cieslewski, G. Sandia National Laboratories
Sep 30, 2014
6 Resources
0 Stars
Publicly accessible

SiC Diode Test Data

Fabricated SiC diodes are tested in the temperature range of 300 degrees C to 600 degrees C.
Gilbert, G. Sandia National Laboratories
Aug 01, 2014
1 Resources
0 Stars
Publicly accessible

Microhole Test Data

Drilling results from the microhole project at the Sandia High Operating Temperature test facility. The project is seeking to help reduce the cost of exploration and monitoring of geothermal wells and formations by drilling smaller holes. The tests were part of a control algorith...
Su, J. Sandia National Laboratories
May 23, 2016
5 Resources
0 Stars
Publicly accessible

West Flank Coso, CA FORGE Test Area

A map with the Coso West Flank FORGE test area outlined, along with regional seismicity, the aeromagnetic data set and the area currently being utilized for the creation of the 3D model.
Blankenship, D. Sandia National Laboratories
Nov 15, 2015
1 Resources
0 Stars
Publicly accessible

Test Report for Detonation Velocity Measurements

Test report for detonation velocity measurements. A series of tests were conducted to determine reaction rate and general behavior of aluminum (AL) and magnesium (MG) powder mixtures (metalized explosives) with Bullseye double-base smokeless propellant. Given the indeterminate sen...
Grubelich, M. Sandia National Laboratories
Jan 13, 2014
1 Resources
0 Stars
Publicly accessible

MASK2B Initial Results from Wave Tank Test of Closed-Loop WEC Control

This dataset covers the MASK2B wave tank experiment focused on a more complete study of one degree of freedom (1DOF) control of the WEC was considered, including maximization of electrical power, multi-objective performance mapping, and implementation of a novel predictionless con...
Coe, R. et al Sandia National Laboratories
May 25, 2018
3 Resources
0 Stars
Publicly accessible

Microhole drilling technology utilizing a golden section search algorithm

A fundamental issue in microhole drilling is that delivering high weight-on-bit (WOB), high torque rotational horsepower to a conventional drill bit does not scale down to the hole sizes necessary to realize the envisioned cost savings An optimization algorithm called a golden sec...
Su, J. et al Sandia National Laboratories
Jun 23, 2021
7 Resources
0 Stars
Publicly accessible

Castlegate Sandstone True Triaxial Test Data

Data set containing results from constant mean stress constant Lode angle true triaxial compression tests performed on Castlegate Sandstone. From the test preformed, the bedding plane and the strain type inside the band of sedimentary rocks can be related to stress histories. The ...
Ingraham, M. et al Sandia National Laboratories
May 06, 2012
8 Resources
0 Stars
Curated

Testing for Controlled Rapid Pressurization

Borehole W1 is a NQ core hole drilled at our test site in Socorro. The rock is rhyolite. Borehole W1 which was used to test gas-gas explosive mixtures is 55 feet deep with casing (pinkish in the drawing) set to 35 feet. The model is a representation of the borehole and the hol...
Knudsen, S. Sandia National Laboratories
Sep 03, 2014
1 Resources
0 Stars
Publicly accessible

Reference Model 3 Scaled Geometry (RM3: Wave Point Absorber)

Contains the Reference Model 3 (RM3) scaled scale geometry files of the Wave Point Absorber, developed by the Reference Model Project (RMP). These scaled geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. The scaled RM3 device ...
Neary, V. et al Sandia National Laboratories
Sep 30, 2014
7 Resources
0 Stars
Publicly accessible

Fallon, NV FORGE well 21-31 Lithology, Mineral, Image Log, and Injection Test data

Attached is 5 datasets collected from Fallon FORGE well 21-31 located in Churchill County, Nevada collected and interpreted between Feburary 2018-January 2020. This submission includes 1) new lithology interpretation derived from petrographic thin sections of sidewall cores taken ...
Kraal, K. and Ayling, B. Sandia National Laboratories
May 30, 2020
5 Resources
0 Stars
Publicly accessible

Auto Indexer Auto-Indexer for Percussive Hammers: Vane Motor Dynamometer Testing

Objectives Options associated with geothermal drilling operations are generally limited by factors such as formation temperature and rock strength. The objective of the research is to expand the "tool box" available to the geothermal driller by furthering the development of a hig...
Su, J. Sandia National Laboratories
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible

Experimental Testing of a Floating Oscillating Surge Wave Energy Converter at Hinsdale Wave Research Laboratory

In order to generate a public data set that can be used to validate Wave Energy Converter (WEC) numerical codes, such as WEC-Sim, Sandia National Laboratories led an experimental testing campaign of a 1:33 scale Floating Oscillating Surge Wave Energy Converter (FOSWEC) in the Dire...
Ruehl, K. et al Sandia National Laboratories
Jun 15, 2016
3 Resources
0 Stars
Publicly accessible

Reference Model 1 Scaled Geometry (RM1: Tidal Current Turbine)

Contains the Reference Model 1 (RM1) scaled scale geometry files of the Tidal Current Turbine, developed by the Reference Model Project (RMP). These scaled geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. The scaled RM1 devic...
Neary, V. and Hill, C. Sandia National Laboratories
Sep 30, 2014
8 Resources
0 Stars
Publicly accessible

EGS Collab: Hydraulic Fracturing Test Measurements on the 4100L of SURF

This package includes data from two days of testing at the Sanford Underground Research Facility (SURF) on the 4100 level. The tests were performed in borehole TV4100 in the battery charging alcove south of the Yates shaft. TV4100 is a vertical borehole ~50 meters deep. A series o...
Ingraham, M. et al Sandia National Laboratories
Aug 15, 2019
3 Resources
0 Stars
Publicly accessible
12Next >>