Search OEDI Data

Performance estimation of resonance-enhanced dual-buoy wave energy converter using coupled time-domain simulation

This paper presents the modeling methodology and performance evaluation of the resonance-enhanced dual-buoy WEC (Wave Energy Converter) by HEM (hydrodynamic & electro-magnetic) fully-coupled-dynamics time-domain-simulation program. The numerical results are systematically compared...

Kang, H. et al Texas A&M University

Aug 31, 2020
3 Resources
0 Stars
Publicly accessible

Planning for the Evolution of the Electric Grid with a Long-Run Marginal Emission Rate Data and Code

Data and code generated for the paper "Planning for the evolution of the electric grid with a long-run marginal emission rate," Pieter Gagnon and Wesley Cole, 2022.

Gagnon and ColeNational Renewable Energy Laboratory

Feb 02, 2022
5 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2439v2: Reports on Stress Prediction and Modeling for Well 16B(78)-32 May 2025

These two reports from the University of Pittsburgh document related efforts under Utah FORGE Project 2-2439v2 to estimate in-situ stresses in well 16B(78)-32 using laboratory data, machine learning models, and physics-based simulations. One report focuses on developing and valida...

Lu, G. et al University of Pittsburgh

Jun 05, 2025
2 Resources
0 Stars
Publicly accessible

Comparative Performance of Four Prototype Mechanical Building Cooling Systems in a Desert Climate

Data and result of approximately fifteen months of monitoring of four houses located in the desert climate of Borrego Springs, California. Four houses were constructed using identical floor plans but differing wall materials, and different cooling systems that were designed to red...

Springer, D. et al Davis Energy

Jul 20, 2016
9 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2439v2: Report on Predicting Far-Field Stresses Using Finite Element Modeling and Near-Wellbore Machine Learning for Well 16A(78)-32

This report presents the far-field stress predictions at two locations along the vertical section of Utah FORGE Well 16A (78)-32 using a physics-based thermo-poro-mechanical model. Three principal stresses in far-field were obtained by solving an inverse problem based on the near-...

Lu, G. et al University of Pittsburgh

Aug 30, 2024
2 Resources
0 Stars
Publicly accessible

Direct-Drive Electrical Generator and PTO System for Flap-type Wave Energy Converters

Project and generator specifications and initial prototype test data for flap-type wave energy converters (WEC)

Englebretson, S. ABB Inc.

Mar 20, 2015
2 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2565: Evolution of Permeability and Strength Recovery of Shear Fractures Under Hydrothermal Conditions 2024 Annual Workshop Presentation

This is a presentation on the Evolution of Permeability and Strength Recovery of Shear Fractures Under Hydrothermal Conditions by United States Geological Survey, presented by Tamara Jeppson. This video slide presentation, by the USGS, discusses the determination of how thermal, ...

Jeppson, T. et al Energy and Geoscience Institute at the University of Utah

Sep 15, 2024
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Evaluation of Potential Geochemical Responses to Injection in the FORGE Geothermal Reservoir

Plugging of fracture porosity from mineral precipitation due to injecting cold water into a a geothermal reservoir can impact the overall permeability of the fracture network in the reservoir. This can have serious ramifications on the efficiency of the geothermal resource. Geoche...

Patil, V. and Simmons, S. Energy and Geoscience Institute at the University of Utah

Apr 03, 2019
1 Resources
0 Stars
Publicly accessible

Alternative Geothermal Power Production Scenarios

The information given in this file pertains to Argonne life-cycle analyses (LCAs) of the plant cycle stage for a set of ten new geothermal scenario pairs, each comprised of a reference and improved case. These analyses were conducted to compare environmental performances among the...

Sullivan, J. Argonne National Laboratory

Mar 14, 2014
1 Resources
0 Stars
Publicly accessible

Thermal-Hydrological-Mechanical Modelling of Stockton University Reservoir Cooling System, Fine Scale Stress Test Modelling

Mesh, properties, initial conditions, injection/withdrawal rates for modelling thermal, hydrological, and mechanical effects of fluid injection to and withdrawal from ground for Stockton University reservoir cooling system (aquifer storage cooling system), Galloway, New Jersey, fo...

Smith, J. et al Lawrence Berkeley National Laboratory

Feb 22, 2021
14 Resources
0 Stars
Publicly accessible

ARPA-E Grid Optimization (GO) Competition Challenge 2

The ARPA-E Grid Optimization (GO) Competition Challenge 2, from 2020 to 2021, expanded upon the problem posed in Challenge 1 by adding adjustable transformer tap ratios, phase shifting transformers, switchable shunts, price-responsive demand, ramp rate constrained generators and l...

Elbert, S. et al Pacific Northwest National Laboratory

Sep 20, 2024
29 Resources
0 Stars
Publicly accessible

Mini-Split Heat Pump Evaluation and Zero Energy Ready Home Support

This project was created from a partnership between the U.S. Department of Energy's (DOE's) Building America research team, IBACOS, Inc., and a production builder of high-performance homes called Imagine Homes, which is located in San Antonio, Texas-a hot-humid climate. The primar...

Rapport, A. and Herk, A. Ibacos Innovation

Apr 27, 2016
5 Resources
0 Stars
Publicly accessible

McGee Mountain Geoprobe Study, Humboldt County, Nevada

Geoprobes were developed by the environmental industry to collect water, gas and soil samples from contaminated sites at shallow depths (10-40 meters), with a minimum of environmental disturbance. A modified Geoprobe was used to collect bottom hole temperatures, and attempt to col...

Tullar, K. Geothermal Technical Partners, Inc.

Jun 19, 2010
3 Resources
0 Stars
Publicly accessible

Thermal-Hydrological-Mechanical Modelling of Stockton University Reservoir Cooling System, Large Scale Grid

Mesh, properties, initial conditions, injection/withdrawal rates for modeling thermal, hydrological, and mechanical effects of fluid injection to and withdrawal from ground for Stockton University reservoir cooling system (aquifer storage cooling system), Galloway, New Jersey, on ...

Smith, J. et al Lawrence Berkeley National Laboratory

Feb 26, 2021
15 Resources
0 Stars
Publicly accessible

Geocellular model of St. Peter Sandstone for University of Illinois at Urbana-Champaign DDU Feasibility Study

The geocellular model of the St. Peter Sandstone was constructed for the University of Illinois at Urbana-Champaign DDU feasibility study. Starting with the initial area of review (18.0 km by 18.1 km [11.2 miles by 11.3 miles]) the boundaries of the model were trimmed down to 9.7 ...

Damico, J. University of Illinois

Dec 31, 2018
5 Resources
0 Stars
Publicly accessible

Geocellular Model of Mt. Simon Sandstone for University of Illinois at Urbana-Champaign DDU feasibility study

The geocellular model of the Mt. Simon Sandstone was constructed for the University of Illinois at Urbana-Champaign DDU feasibility study. Starting with the initial area of review (18.0 km by 18.1 km [11.2 miles by 11.3 miles]) the boundaries of the model were trimmed down to 9.7 ...

Damico, J. University of Illinois

Dec 31, 2018
4 Resources
0 Stars
Publicly accessible

Stability of Elastomers Subjected to Geothermal Well-Like Conditions

The aim of this study is to understand how commercially available elastomers perform under geothermal well-like conditions and make recommendations to the community based on these results. This poster highlights the mechanical performance of several elastomers (including EPDM, Vit...

Redline, E. et al Sandia National Laboratories

Aug 10, 2014
1 Resources
0 Stars
Publicly accessible

Practices Maintain Straight Hole in Crooked Hole Conditions, While Also Enabling Significant Gains in Drill Rate

Bottom hole assembly (BHA) designs were assessed in field trials for their ability to achieve critical low inclination requirements, while simultaneously enabling high drill rates. Because angle has historically been controlled by reducing weight on bit (WOB), these are often com...

Knudsen, S. et al Sandia National Laboratories

Apr 30, 2014
2 Resources
0 Stars
Publicly accessible

Metering Best Practices Applied in the National Renewable Energy Laboratory's Research Support Facility: A Primer to the 2011 Measured and Modeled Energy Consumption Datasets

Modern buildings are complex energy systems that must be controlled for energy efficiency. The Research Support Facility (RSF) at the National Renewable Energy Laboratory (NREL) has hundreds of controllers computers that communicate with the building's various control systems to...

Sheppy. . et al National Renewable Energy Laboratory

Mar 25, 2016
4 Resources
0 Stars
Publicly accessible

Laboratory Evaluation of EGS Shear Stimulation-Test 001

This is the results of an initial setup-shakedon test in order to develop the plumbing system for this test design. a cylinder of granite with offset holes was jacketed and subjected to confining pressure and low temperature (85C) and pore water pressure. Flow through the sample w...

Bauer, S. Sandia National Laboratories

Jul 29, 2014
1 Resources
0 Stars
Publicly accessible

BuildingsBench: A Large-Scale Dataset of 900K Buildings and Benchmark for Short-Term Load Forecasting

The BuildingsBench datasets consist of: Buildings-900K: A large-scale dataset of 900K buildings for pretraining models on the task of short-term load forecasting (STLF). Buildings-900K is statistically representative of the entire U.S. building stock. 7 real residential and com...

Emami, P. and Graf, P. National Renewable Energy Laboratory

Dec 31, 2018
6 Resources
1 Stars
Publicly accessible

Evaluation of a Wave Powered Water Pump Performance by Ocean Field Testing and WEC-Sim Modeling

This submission from AMEC (the Atlantic Marine Energy Center) includes data from an ocean field deployment of a wave powered water pump in March 2023. The wave pump is an upweller device, designed to enhance macroalgal aquaculture. The wave pump device was deployed off the coast ...

Kimball, C. et al University of New Hampshire, Atlantic Marine Energy Center (AMEC)

Mar 21, 2023
3 Resources
0 Stars
Publicly accessible

NWEI Azura RTI 1/20th Model Validation Wave Tank Test Data

Data from the 1/20th wave tank test of the RTI model. Northwest Energy Innovations (NWEI) has licensed intellectual property from RTI, and modified the PTO and retested the 1/20th RTI model that was tested as part of the Wave Energy Prize. The goal of the test was to validate NWEI...

Ling, B. and Lettenmaier, T. Northwest Energy Innovations

May 08, 2017
7 Resources
0 Stars
Publicly accessible

Utah FORGE: Laboratory Experiments Examining the Effect of Thermal and Mechanical Processes on Hydraulic Transmissivity Evolution

Using laboratory slide-hold-slide experiments, at temperatures from 22 to 200 degrees C, to examine effects of fracture reactivation and quasi-static loading on the evolution of fluid transport properties of simulated fractures in Westerly granite. At all temperatures, the in-plan...

Lockner, D. et al United States Geological Survey

Apr 03, 2023
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Stimulation DFN Fracture Plane Evaluation and Data

This dataset includes files used to fit planar fractures through the preliminary earthquake catalogs of the three stages of the April 2022 well 16A(78)-32 stimulation which is linked bellow. These planar features have been used to update the FORGE reference Discrete Fracture Netwo...

Finnila, A. WSP Golder

Oct 27, 2022
3 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 6 7 Next >>