Search OEDI Data

Showing results 26 - 50 of 67.
Show results per page.
Order by:
Available Now:
Clear All Filters ×
Research Areas
Accessibility
Data Type
Organization
Source
"peak load"×
Geothermal Data Repository (GDR)×

Community Geothermal: Energy, Cost, and Carbon Modeling for District Design Ann Arbor, MI

This data includes results on an analysis of existing and projected energy, cost, and carbon for the City of Ann Arbor District Geothermal Design and Deployment to Equitably Decarbonize Low Income Neighborhoods in Ann Arbor project. The scope of the project includes designing and ...
Lee, J. and McMillen, A. IMEG Corp
Jan 01, 2024
31 Resources
0 Stars
Publicly accessible

Deep Direct-Use Feasibility Study Energy Demand Characterization and Surface Plant Modeling for West Virginia University

This dataset provides information gathered to determine end use load and assessment of existing district heating systems (DHS). It also provides Aspen simulation files used to model hybrid natural gas geothermal district heating and cooling (GDHC) system along with Exchange Design...
Garapati, N. West Virginia University
Jan 09, 2020
4 Resources
0 Stars
Publicly accessible

Dynamic Earth Energy Storage: Terawatt-Year, Grid-Scale Energy Storage using Planet Earth as a Thermal Battery (GeoTES): Seedling Project Final Report

Grid-scale energy storage has been identified as a needed technology to support the continued build-out of intermittent renewable energy resources. As of April 2017, the U.S. had approximately 24.2 GW of energy storage on line, compared to 1,081 GW of installed generation capacity...
McLing, T. et al Idaho National Laboratory
May 31, 2019
11 Resources
0 Stars
Publicly accessible

End Use Load Profile (EULP) of US Building Sector resulting from mass GHP retrofits

This collection of datasets describes the change (difference) in hourly energy consumption of the U.S. residential and commercial building stock while replacing existing HVAC systems with ground source heat pumps for all the balancing areas in the US, for all buildings eligible fo...
Liu, X. et al Oak Ridge National Laboratory
Apr 15, 2023
2 Resources
0 Stars
Publicly accessible

Laboratory Evaluation of EGS Shear Stimulation-Test 001

This is the results of an initial setup-shakedon test in order to develop the plumbing system for this test design. a cylinder of granite with offset holes was jacketed and subjected to confining pressure and low temperature (85C) and pore water pressure. Flow through the sample w...
Bauer, S. Sandia National Laboratories
Jul 29, 2014
1 Resources
0 Stars
Publicly accessible

University of Illinois Campus Deep Direct-Use Feasibility Study Long-Term Meteorological Data

This submission includes meteorological data recorded by National Weather Service at University of Illinois Willard Airport, Savoy IL for period 1972 to 2018. This data is for use in parameterizing the demand and life-cycle assessments associated with the project, and provides inf...
Lin, Y. University of Illinois
Mar 30, 2018
3 Resources
0 Stars
Publicly accessible

Utah FORGE: Fault Shear Reactivation Experimental Data for Fluid Injection-Rate Controls on Seismic Moment

Included are experimental data recorded from shear experiments that specifically explore the link between fluid-injection rate and seismic moment resulting from shear reactivation of laboratory faults. Raw mechanical data from three experiments are included alongside corresponding...
Roseboom, M. et al Pennsylvania State University
Nov 07, 2023
6 Resources
0 Stars
Publicly accessible

PoroTomo Distributed Temperature Sensing (DTS) Measurements made in Brady Observation Well 56-1

This submission is a follow-up to Distributed Temperature Sensing (DTS) measurements made in Brady observation well 56-1 during the PoroTomo field experiment conducted in March, 2016. The measurements in this data set were made on August 24, 2018 over an approximately 20 hour per...
Kratt, C. et al Oregon State University
Jan 09, 2019
6 Resources
0 Stars
Publicly accessible

CO2 Push-Pull Single Fault Injection Simulations

ASCII text files containing grid-block name, X-Y-Z location, and multiple parameters from TOUGH2 simulation output of CO2 injection into an idealized single fault representing a dipping normal fault at the Desert Peak geothermal field (readable by GMS). The fault is composed of a ...
Borgia, A. et al Lawrence Berkeley National Laboratory
Sep 21, 2017
5 Resources
0 Stars
Publicly accessible

Utah FORGE 6-3712: Report on a Data Foundation for Real-Time Identification of Microseismic Events

This submission is a technical report for the Probabilistic Estimation of Seismic Response Using Physics Informed Recurrent Neural Networks project. The report describes the process of extracting events from the borehole seismic sensors. To be effective once deployed, the process ...
Williams, J. et al Global Technology Connection, Inc.
Jan 21, 2025
3 Resources
0 Stars
Publicly accessible

U.S. Geothermal District Heating Systems and Funding Data

This dataset contains detailed information on geothermal district heating (GDH) systems across the United States, including technical specifications, costs, energy usage, and funding sources. Data includes system details such as state, site, location, operational years, temperatu...
Kolker, A. et al National Renewable Energy Laboratory
Nov 02, 2020
1 Resources
0 Stars
Publicly accessible

Oilwell Conversion (Well API 121913310501) to Geothermal Heat Storage Well for Flexible Electricity Storage

Geothermal growth is limited by a lack of geographically dispersed high-temperature thermal resources and high initial upfront investment in characterization and well construction. This project intended to address the challenges of energy supply intermittency and enhance grid resi...
Malkewicz, N. et al University of Illinois
May 05, 2021
8 Resources
0 Stars
Publicly accessible

EGS Collab: Hydraulic Fracturing Test Measurements on the 4100L of SURF

This package includes data from two days of testing at the Sanford Underground Research Facility (SURF) on the 4100 level. The tests were performed in borehole TV4100 in the battery charging alcove south of the Yates shaft. TV4100 is a vertical borehole ~50 meters deep. A series o...
Ingraham, M. et al Sandia National Laboratories
Aug 15, 2019
3 Resources
0 Stars
Publicly accessible

Utah FORGE: Fault Reactivation Through Fluid Injection Induced Seismicity Laboratory Experiments

Included are results from shear reactivation experiments on laboratory faults pre-loaded close to failure and reactivated by the injection of fluid into the fault. The sample comprises a single-inclined-fracture (SIF) transecting a cylindrical sample of Westerly granite. All expe...
Yu, J. et al Pennsylvania State University
Jul 01, 2023
27 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Stimulation Data (April, 2022)

This is a set of data related to the stimulation program at Utah FORGE well 16A(78)-32 during April, 2022. This includes daily reports, 1 second Pason data, tracer data, and shear stimulation data and information including a report of an evolving prognosis for the stimulation oper...
McLennan, J. Energy and Geoscience Institute at the University of Utah
May 18, 2022
11 Resources
0 Stars
Publicly accessible

Cornell Ithaca Campus heat use data for a model year

Hourly steam use data for all significant buildings from the fiscal year (FY) 2017 (1 July 2016 30 June 2017) are provided. The total annual campus heating load in FY 2017 was about 0.81 trillion Btu (283,000 MWth-hrs). The data are presented as a spreadsheet, detailing on an ho...
Beyers, S. and Gustafson, J. Cornell University
Nov 13, 2019
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Second Set Tracer Test Results

The EGS Collab project is developing ~10-20 m-scale field sites where fracture stimulation and flow models can be validated against controlled, small-scale, in-situ experiments. The first multi-well experimental site was established at the 4850 level in the Homestake Mine in Lead,...
Neupane, G. et al Idaho National Laboratory
Dec 19, 2019
4 Resources
0 Stars
Publicly accessible

Community Geothermal: Thermal Conductivity Test and Data Analysis Report Wallingford, CT

Report on a formation thermal conductivity test that was performed on the geothermal test bore at Ulbrich Heights at 38 Louis Circle Lane in Wallingford, Connecticut. Data are applicable only within the Wallingford region and should not be extrapolated for other climatic and geogr...
Martin, C. Connecticut Department of Energy and Environmental Protection (CT DEEP)
Feb 20, 2024
1 Resources
0 Stars
Publicly accessible

Structural Inventory of Great Basin Geothermal Systems and Definition of Favorable Structural Settings

Structural controls of 426 geothermal systems in the Great Basin region including western Nevada, central Nevada, northwestern Nevada, northeastern Nevada, east-central Nevada, eastern California, southern Oregon, and western Utah were analyzed with literature research, air photos...
Faulds, J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Auto Indexer Auto-Indexer for Percussive Hammers: Vane Motor Dynamometer Testing

Objectives Options associated with geothermal drilling operations are generally limited by factors such as formation temperature and rock strength. The objective of the research is to expand the "tool box" available to the geothermal driller by furthering the development of a hig...
Su, J. Sandia National Laboratories
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible

Slip and Dilation Tendency Analysis of the Salt Wells Geothermal Area

Critically stressed fault segments have a relatively high likelihood of acting as fluid flow conduits (Sibson, 1994). As such, the tendency of a fault segment to slip (slip tendency; Ts; Morris et al., 1996) or to dilate (dilation tendency; Td; Ferrill et al., 1999) provides an in...
E., J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Slip and Dilation Tendency Analysis of the San Emidio Geothermal Area

Critically stressed fault segments have a relatively high likelihood of acting as fluid flow conduits (Sibson, 1994). As such, the tendency of a fault segment to slip (slip tendency; Ts; Morris et al., 1996) or to dilate (dilation tendency; Td; Ferrill et al., 1999) provides an in...
E., J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Repetitive Regeneration of Media #1 in a Dynamic Column Extraction using Brine #1

This data is from a regeneration study from a dynamic column extraction experiment where we ran a solution of REE's through a column of media #1 then stripped the REE's off the media using 2M HNO3 solution. We then re-equilibrated the media and repeated the process of running a RE...
Garland, G. Tusaar Corp.
Oct 14, 2015
4 Resources
0 Stars
Publicly accessible

Snake River Plain FORGE: Well Data for WO-2

Well data for the WO-2 well located in eastern Snake River Plain, Idaho. This data collection includes lithology reports, borehole logs, temperature at depth data, neutron density and gamma data, and rock strength parameters for the WO-2 well. This collection of data has been ass...
Podgorney, R. Idaho National Laboratory
Jul 29, 1991
9 Resources
0 Stars
Publicly accessible

Ground Source Heat Pump Computational Results

This data submission includes simulation results for ground loop heat pump systems located in 6 different cities across the United States. The cities are Boston, MA, Dayton, OH, Omaha, NE, Orlando, FL, Sacramento, CA, and St. Paul, MN. These results were obtained from the two-dime...
Menart, J. Wright State University
Jul 31, 2013
6 Resources
0 Stars
Publicly accessible
<< Previous123Next >>