Search OEDI Data

Showing results 1 - 25 of 125.
Show results per page.
Order by:
Available Now:
Clear All Filters ×
Research Areas
Accessibility
Data Type
Organization
Source
"fracture prediction"×
Document×

Development of a Neutron Diffraction Based Experimental Capability for Investigating Hydraulic Fractures for EGS-like Conditions

Understanding the relationship between stress state, strain state and fracture initiation and propagation is critical to the improvement of fracture simulation capability if it is to be used as a tool for guiding hydraulic fracturing operations. The development of fracture predict...
Polsky, Y. et al Oak Ridge National Laboratory
Feb 01, 2013
1 Resources
0 Stars
Publicly accessible

Subsurface Characterization and Machine Learning Predictions at Brady Hot Springs

Subsurface data analysis, reservoir modeling, and machine learning (ML) techniques have been applied to the Brady Hot Springs (BHS) geothermal field in Nevada, USA to further characterize the subsurface and assist with optimizing reservoir management. Hundreds of reservoir simulat...
Beckers, K. et al National Renewable Energy Laboratory
Feb 18, 2021
1 Resources
0 Stars
Publicly accessible

CO2 Push-Pull Dual (Conjugate) Faults Injection Simulations

This submission contains datasets and a final manuscript associated with a project simulating carbon dioxide push-pull into a conjugate fault system modeled after Dixie Valley- sensitivity analysis of significant parameters and uncertainty prediction by data-worth analysis. Datas...
Oldenburg, C. et al Lawrence Berkeley National Laboratory
Jul 20, 2017
2 Resources
0 Stars
Publicly accessible

WEC Controls Optimization Final Report

The over-arching project objective is to fully develop and validate optimal controls frameworks that can subsequently be applied widely to different WEC devices and concepts. Optimal controls of WEC devices represent a fundamental building block for WEC designers that must be cons...
Previsic, M. and Karthikeyan, A. Re Vision Consulting
Aug 26, 2020
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2439v2: Report on Predicting Far-Field Stresses Using Finite Element Modeling and Near-Wellbore Machine Learning for Well 16A(78)-32

This report presents the far-field stress predictions at two locations along the vertical section of Utah FORGE Well 16A (78)-32 using a physics-based thermo-poro-mechanical model. Three principal stresses in far-field were obtained by solving an inverse problem based on the near-...
Lu, G. et al University of Pittsburgh
Aug 30, 2024
2 Resources
0 Stars
Publicly accessible

Utah FORGE 2439: Machine Learning for Well 16A(78)-32 Stress Predictions September 2023 Report

This task completion report documents the development and implementation of machine learning (ML) models for the prediction of in-situ vertical (Sv), minimum horizontal (SHmin) and maximum horizontal (SHmax) stresses in well 16A(78)-32. The detailed description of the experimental...
Mustafa, A. et al Battelle Memorial Institute
Sep 28, 2023
3 Resources
0 Stars
Publicly accessible

M3 Wave DMP/APEX WEC Numerical Survivability Report Baseline Geometry

Summary of numerical survivability modeling method for the baseline geometry of the Delos-Reyes Morrow Pressure Device (DMP), commercialized by M3 Wave LLC as "APEX."
Roberts, J. et al M3 Wave
Aug 16, 2016
2 Resources
0 Stars
Publicly accessible

Mt. Simon Sandstone Brine Chemistry for DDU Technology at the U of IL Campus

A review of brine chemistry data for the Mt. Simon Sandstone in the Illinois Basin is provided for calculations to predict the potential for mineral scaling and precipitation. The assessment includes expected changes in temperature, pressure, and/or exposure to air or other materi...
Lu, Y. and McKaskle, R. University of Illinois
Mar 31, 2019
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2446: Connecting In Situ Stress and Wellbore Deviation to Near-Well Fracture Complexity using Phase-Field Simulations

This report presents a series of numerical experiments investigating the relationships among near-well fracture complexity, in situ stress conditions, and wellbore deviation. Using a phase-field modeling approach, the study explores how factors such as stress regimes, wellbore ori...
Cusini, M. and Fei, F. Lawrence Livermore National Laboratory
Jan 30, 2025
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Hydraulic Fracture Width Determination Using Stoneley Wave Pressure Testing and Electrical Borehole Scans

This report provides insights into Utah FORGE well 58-32's hydraulic fractures. It utilizes both electrical borehole scans from Schlumberger's Formation Micro-scanner Image tool (FMI) and Stoneley waves from a borehole sonic tool. These methods are combined in a comprehensive work...
Hornby, B. Hornby Geophysical Services, LLC
Oct 06, 2023
1 Resources
0 Stars
Publicly accessible

Applications of Fractured Continuum Model to Enhanced Geothermal System Heat Extraction Problems

This paper describes the applications of the fractured continuum model to the different enhanced geothermal systems reservoir conditions. The capability of the fractured continuum model to generate fracture characteristics expected in enhanced geothermal systems reservoir environm...
Kalinina, E. et al Sandia National Laboratories
May 06, 2014
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Common Discrete Fracture Network

This package includes data and models that support hydraulic fracture stimulation and fluid circulation experiments in the Sanford Underground Research Facility (SURF). A paper by Schwering et al. (2020) describes the deterministic basis for developing a "common" discrete fracture...
Schwering, P. et al Sandia National Laboratories
Sep 18, 2019
4 Resources
0 Stars
Publicly accessible

Mapping Fracture Network Creation with Microseismicity During EGS Demonstrations

This a report for the project "Mapping Fracture Network Creation with Microseismicity During EGS Demonstrations". Effective enhanced geothermal systems (EGS) require optimal fracture networks for efficient heat transfer between hot rock and fluid. Microseismic mapping is a key too...
Templeton, D. et al Lawrence Livermore National Laboratory
Apr 18, 2014
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2446: Report on Phase Field Modelling of Near-Wellbore Hydraulic Fracture Nucleation and Propagation

This is a report that describes the modelling of fracture nucleation and propagation in the near-wellbore region to understand the relationship between in situ stress and fracture patterns. A novel phase field formulation is described here, which represents fractures as a diffuse ...
Cusini, M. and Fei, F. Lawrence Livermore National Laboratory
Dec 31, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 58-32 (MU-ESW1) FMI Log Fracture Results

A Schlumberger Fullbore Formation Micro-Imager (FMI) log was run from 7390 feet to 7527 feet depth in well 58-32, originally known as well MU-ESW1. Well 58-32 was completed in 2017 as part of Utah FORGE Phase 2. It reached a depth of 7536 feet and recorded a bottom hole temperatur...
BLOCHOWICZ, A. Energy and Geoscience Institute at the University of Utah
Mar 06, 2021
1 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2615: Shear Enhanced Permeability In a Granitoid Fracture Presentation Slides

Provided here is a set of presentation slides detailing stress-dependent permeability in FORGE granitoid fractures and how fracture slip affects permeability. It outlines empirical correlations between permeability, stress, and fracture aperture, emphasizing that mechanically clos...
Ghassemi, A. and Ye, Z. University of Oklahoma
Feb 28, 2024
1 Resources
0 Stars
Publicly accessible

State Estimation for advanced control of wave energy converters

A report on state estimation for advanced control of wave energy converters (WECs), with supporting data models and slides from the overview presentation. The methods discussed are intended for use to enable real-time closed loop control of WECs.
Coe, R. and Bacelli, G. Sandia National Laboratories
Apr 25, 2017
6 Resources
0 Stars
Publicly accessible

Thermal Drawdown-Induced Flow Channeling in a Single Fracture in EGS

The evolution of flow pattern along a single fracture and its effects on heat production is a fundamental problem in the assessments of engineered geothermal systems (EGS). The channelized flow pattern associated with ubiquitous heterogeneity in fracture aperture distribution caus...
Guo, B. et al Lawrence Livermore National Laboratory
Nov 15, 2015
1 Resources
0 Stars
Publicly accessible

Data of High-Temperature Dynamic LCM Testing Setup

Data from high temperature dynamic sealing tests for various fracture widths, at various temperatures (degrees F), with 5 wt.% bentonite-based mud containing various material fiber contents, at 100 to 400 psi differential pressure. Data from pressure test and evaluation of the dy...
Magzoub, M. et al University of Oklahoma
May 31, 2021
11 Resources
0 Stars
Publicly accessible

Utah FORGE: 2024 Discrete Fracture Network Model Data

The Utah FORGE 2024 Discrete Fracture Network (DFN) Model dataset provides a set of files representing discrete fracture network modeling for the FORGE site near Milford, Utah. The dataset includes four distinct DFN model file sets, each corresponding to different time frames and ...
Finnila, A. and Jones, C. Energy and Geoscience Institute at the University of Utah
Sep 08, 2024
5 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Simplified Discrete Fracture Network Data

The FORGE team is making these fracture models available to researchers wanting a set of natural fractures in the FORGE reservoir for use in their own modeling work. They have been used to predict stimulation distances during hydraulic stimulation at the open toe section of well 1...
Finnila, A. Golder Associates Inc.
Jun 01, 2021
3 Resources
0 Stars
Publicly accessible

Generalized Displacement Correlation Method for Estimating Stress Intensity Factors

This paper presents a generalized form of the displacement correlation method (the GDC method), which can use any linear or quadratic finite element type with homogeneous meshing without local refinement. These two features are critical for modeling dynamic fracture propagation pr...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Report on Geodetic Observations of Fracture Development During April 2024 Stimulations

This report presents geodetic observations from the April 2024 stimulations at the Utah FORGE site, as part of LBNL FORGE Project 3-2535. It focuses on Distributed Strain Sensing (DSS) data from an optical fiber in well 16B, capturing localized strain linked to fracture propagatio...
Vasco, D. et al Lawrence Berkeley National Laboratory
Apr 28, 2025
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: SIMFIP Notch-164 GRL Paper

Characterizing the stimulation mode of a fracture is critical to assess the hydraulic efficiency and the seismic risk related to deep fluid manipulations. We have monitored the three-dimensional displacements of a fluid-driven fracture during water injections in a borehole at ~1.5...
Guglielmi, Y. Lawrence Berkeley National Laboratory
Sep 24, 2020
9 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2446: Characterizing Stress Roughness Through Simulation of Hydraulic Fracture Growth

This dataset covers work that investigated the apparent toughness anisotropy at Utah FORGE by comparing microseismic data with stress profiles from field measurements. The study analyzes the hydraulic fracture growth of Stage 3 at Well 16A(78)-32 using MEQ data, calibrating a nume...
Cusini, M. and Fei, F. Lawrence Livermore National Laboratory
Jan 30, 2025
3 Resources
0 Stars
Publicly accessible
12345Next >>