Search OEDI Data

Showing results 1 - 25 of 363.
Show results per page.
Order by:
Available Now:
Clear All Filters ×
Research Areas
Accessibility
Data Type
Organization
Source
"numerical weather model"×
Geothermal Data Repository (GDR)×

Snake River Plain Play Fairway Analysis: Mountain Home Geothermal Area Natural State Model

The Mountain Home area is characterized by high heat flow and temperature gradient. Temperature data are available from 18 boreholes with depths equal to or greater than 200 m, 5 of which have depths ranging from ~1340 m to ~3390 m (MH-1, MH-2, Bostic1, Lawrence D No.1, and Anschu...
Garg, S. et al Utah State University
Jul 28, 2015
4 Resources
0 Stars
Publicly accessible

Simulating Complex Fracture Systems in Geothermal Reservoirs Using an Explicitly Coupled Hydro-Geomechanical Model

Low permeability geothermal reservoirs can be stimulated by hydraulic fracturing to create Enhanced (or Engineered) Geothermal Systems (EGS) with higher permeability and improved heat transfer to increase heat production. In this paper, we document our effort to develop a numerica...
Carrigan, C. et al Lawrence Livermore National Laboratory
Jan 01, 2011
2 Resources
0 Stars
Publicly accessible

Using Fully Coupled Hydro-Geomechanical Numerical Test Bed to Study Reservoir Stimulation with Low Hydraulic Pressure

This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimu...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 31, 2012
2 Resources
0 Stars
Publicly accessible

Modeling Responses of Naturally Fractured Geothermal Reservoir to Low-Pressure Stimulation

Hydraulic shearing is an appealing reservoir stimulation strategy for Enhanced Geothermal Systems. It is believed that hydro-shearing is likely to simulate a fracture network that covers a relatively large volume of the reservoir whereas hydro-fracturing tends to create a small nu...
Fu, P. and Carrigan, C. Lawrence Livermore National Laboratory
Jan 01, 2012
2 Resources
0 Stars
Publicly accessible

Deep Direct-Use Feasibility Study Numerical Modeling and Uncertainty Analysis using iTOUGH2 for West Virginia University

To reduce the geothermal exploration risk, a feasibility study is performed for a deep direct-use system proposed at the West Virginia University (WVU) Morgantown campus. This study applies numerical simulations to investigate reservoir impedance and thermal production. Because of...
Garapati, N. et al West Virginia University
Dec 20, 2019
13 Resources
0 Stars
Publicly accessible

University of Illinois Campus Deep Direct-Use Feasibility Study Long-Term Meteorological Data

This submission includes meteorological data recorded by National Weather Service at University of Illinois Willard Airport, Savoy IL for period 1972 to 2018. This data is for use in parameterizing the demand and life-cycle assessments associated with the project, and provides inf...
Lin, Y. University of Illinois
Mar 30, 2018
3 Resources
0 Stars
Publicly accessible

Machine Learning-Assisted High-Temperature Reservoir Thermal Energy Storage Optimization: Numerical Modeling and Machine Learning Input and Output Files

This data set includes the numerical modeling input files and output files used to synthesize data, and the reduced-order machine learning models trained from the synthesized data for reservoir thermal energy storage site identification. In this study, a machine-learning-assiste...
Jin, W. et al Idaho National Laboratory
Apr 15, 2022
4 Resources
0 Stars
Publicly accessible

Simulation Tools for Modeling Thermal Spallation Drilling on Multiple Scales

Widespread adoption of geothermal energy will require access to deeply buried resources in granitic basement rocks at high temperatures and pressures. Exploiting these resources necessitates novel methods for drilling, stimulation, and maintenance, under operating conditions that ...
Walsh, S. et al Lawrence Livermore National Laboratory
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible

WISE-CASING: DC Simulation at Containment and Monitoring Institute (CaMI), Calgary, Canada

For the model calculation we applied EM3D using completion diagram of CaMI site and a background resistivity consistent with the borehole logs. It was also important to use the accurate position of the return electrode. We note that for the data fit the code also incorporated we...
Wang, J. and Wilt, M. Lawrence Berkeley National Laboratory
Apr 30, 2019
7 Resources
0 Stars
Publicly accessible

Utah FORGE Project 3-2535: Building a 3D Resistivity Model for Simulation and Survey Design of EM Measurements

The included report outlines the creation of three 3D resistivity models that will be used to determine the sensitivity of EM measurements for the hypothetical stimulated reservoir at FORGE as well as for EM survey design. FORGE project 3-2535 is planning on using a casing source ...
Alumbaugh, D. et al Lawrence Berkeley National Laboratory
Dec 01, 2022
5 Resources
0 Stars
Publicly accessible

SMP and Fracture Modeling

The problem of loss circulation in geothermal wells is inherently challenging due to high temperatures, brittle rocks, and presence of abundant fractures. Because of the inherent challenges in geothermal environments, there are limitations in selecting proper lost circulation mate...
Salehi, S. et al University of Oklahoma
Oct 01, 2021
4 Resources
0 Stars
Publicly accessible

Geomechanical Modeling for Thermal Spallation Drilling

Wells for Engineered Geothermal Systems (EGS) typically occur in conditions presenting significant challenges for conventional rotary and percussive drilling technologies: granitic rocks that reduce drilling speeds and cause substantial equipment wear. Thermal spallation drilling,...
Walsh, S. et al Lawrence Livermore National Laboratory
Aug 24, 2011
1 Resources
0 Stars
Publicly accessible

Utah FORGE Phase 3 Native State Model: 2022 Update

This is the Phase 3 native state model update. The Phase 3 numerical model represents a significant subsurface volume below the FORGE site footprint. The model domain of 4.0 km x 4.0 km x 4.2 km is located approximately between depths of 4000 to 4200 meters below land surface. Thi...
Podgorney, R. and Liu, R. Idaho National Laboratory
Jul 29, 2022
1 Resources
0 Stars
Publicly accessible

Hawaii Play Fairway Analysis: Oahu Groundwater Flow Model

Groundwater flow model for the island of Oahu. Data is from the following sources: Rotzoll, K., A.I. El-Kadi. 2007. Numerical Ground-Water Flow Simulation for Red Hill Fuel Storage Facilities, NAVFAC Pacific, Oahu, Hawaii Prepared TEC, Inc. Water Resources Research Center, Univer...
Lautze, N. University of Hawaii
Jan 01, 2015
1 Resources
0 Stars
Publicly accessible

Utah FORGE Project 3-2535: Numerical Modeling of Energized Steel-Casing Source for Imaging Stimulated Zone

This short report details and tests the workflow that will be used to simulate steel well casings in deviated production/extraction boreholes at at the Utah FORGE site. Boreholes will be electrically energized and will serve as data sources for future proposed electromagnetic bore...
Um, E. et al Lawrence Berkeley National Laboratory
Nov 15, 2022
4 Resources
0 Stars
Publicly accessible

Utah FORGE Project 3-2535: Modeling Studies of Energized Steel-Casing Source EM Method for Detecting Stimulated Zone

Numerical modeling Studies for electromagnetic (EM) Data Acquisition Survey Design this milestone report describes the 3D modeling studies of energized steel-casing source electromagnetic method for detecting stimulated zone at the Utah FORGE Site. FORGE project 3-2535 is planning...
Um, E. et al Lawrence Berkeley National Laboratory
Feb 06, 2023
4 Resources
0 Stars
Publicly accessible

WISE-CASING: Frequency Domain EM Data from Cymric Oil Field, CA

Cymric oil field frequency domain electromagnetic (FEM) data with two parts of data labeled Part 1 and Part 2. Part 1 utilizes an electrical source line parallel to the receiver line, while Part 2 utilizes an electrical source line at a 75 deg angle to the receiver line. Data are ...
Wang, J. et al Lawrence Berkeley National Laboratory
Apr 30, 2019
11 Resources
0 Stars
Publicly accessible

Utah FORGE Project 3-2535: Compilation of Geodetic Data and Estimation of Associated Deformation

Report on possible geodetic signature of the 3 stimulations in April 2022 as well as a comparison with existing InSAR data gathered over the site before, during, and after the stimulation. In geothermal production it is important to understand the existing stress field and the cha...
Vasco, D. et al Lawrence Berkeley National Laboratory
Apr 29, 2022
4 Resources
0 Stars
Publicly accessible

Hawaii Play Fairway Analysis: Recharge Data for the Islands of Kauai, Lanai and Molokai, Hawaii

Recharge data for the islands of Kauai, Lanai and Molokai in shapefile format. These data are from the following sources: Whittier, R.B and A.I. El-Kadi. 2014. Human Health and Environmental Risk Ranking of On-Site Sewage Disposal systems for the Hawaiian Islands of Kauai, Molo...
Lautze, N. University of Hawaii
Jan 01, 2015
12 Resources
0 Stars
Publicly accessible

Numerical Modeling for Hydraulic Fracture Prediction

Numerical modeling on fused silica cylindrical materials for predicting overpressures required to fracture an homogeneous pure (surrogate) material with known mechanical properties similar to igneous rock materials and later compare these values to experimental overpressures obtai...
Gupta, V. Pacific Northwest National Laboratory
Apr 26, 2016
1 Resources
0 Stars
Publicly accessible

Stimulation at Desert Peak Modeling with the Coupled THM Code FEHM

Numerical modeling of the 2011 shear stimulation at the Desert Peak Well 27-15 using a coupled thermal-hydrological-mechanical simulator. This submission contains the finite element heat and mass transfer (FEHM) executable code for a 64-bit PC Windows-7 machine, and the input and ...
Kelkar, S. et al Los Alamos National Laboratory
Apr 30, 2013
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Data for 3-D Model Development Lithology, Temperature, Pressure, and Stress

This submission comprises two downloadable .zip archives. Each archive contains spreadsheets with 3-D data and a .txt document describing the data. The Mesh Files .zip download contains data regarding the lithologic contacts of the granitoid and overlying sedimentary basin fill. T...
Podgorney, R. Idaho National Laboratory
Mar 17, 2020
2 Resources
0 Stars
Publicly accessible

Investigation of Stimulation-Response Relationships for Complex Fracture Systems in Enhanced Geothermal Reservoirs

Hydraulic fracturing is currently the primary method for stimulating low-permeability geothermal reservoirs and creating Enhanced (or Engineered) Geothermal Systems (EGS) with improved permeability and heat production efficiency. Complex natural fracture systems usually exist in ...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 01, 2011
2 Resources
0 Stars
Publicly accessible

Understanding Constraints on Geothermal Sustainability Through Reservoir Characterization at Brady Geothermal Field, Nevada

The vast supply of geothermal energy stored throughout the Earth and the exceedingly long time required to dissipate that energy makes the world's geothermal energy supply nearly limitless. As such, this resource holds the potential to provide a large supply of the world's energy ...
Patterson, J. University of Wisconsin
Jul 11, 2018
1 Resources
0 Stars
Publicly accessible

STRESSINVERSE Software for Stress Inversion

The STRESSINVERSE code uses an iterative method to find the nodal planes most consistent with the stress field given fault frictional properties. STRESINVERSE inverts the strike, rake and dip from moment tensor solutions for the in-situ state of stress. The code iteratively solves...
Gritto, R. Array Information Technology
Oct 31, 2018
1 Resources
0 Stars
Publicly accessible
12345Next >>