Search OEDI Data
Showing results 151 - 175 of 821.
Show
results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
Competing Use Analysis for Offshore Renewables and Subsea Cables
Demand for abundant and diverse resources in the oceans is growing, necessitating marine spatial planning. To inform development of Marine Hydrokinetic (MHK) and Offshore Wind (OSW) resources, the Department of Energy (DOE) has asked NREL to identify the competing uses areas betwe...
Best, B. and Kilcher, L. National Renewable Energy Laboratory
Aug 29, 2019
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Portland DDU Feasibility Study: The Spatial and Temporal Evolution of the Portland and Tualatin Basins, Oregon, USA
The Portland and Tualatin basins are part of the Puget-Willamette Lowland in the Cascadia forearc of Oregon and Washington. The Coast Range to the west has undergone Paleogene transtension and Neogene transpression, which is reflected in basin stratigraphy. To better understand th...
Scanlon, D. Portland State University
Jul 29, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Surface Meteorological Station HilFlowS LLNL 52m tall tower EOP Processed Data
**Overview**
The WindCube v2 was co-located with Site 300’s 52-m-tall meteorological tower so that measurements below 40 m could also be observed. The meteorological tower has three measurement levels: 10 m, 23 m, and 52 m. Wind speed was measured with a cup anemometer; wind di...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Lidar HilFlowS LLNL WindCube v2 EOP Processed Data
**Overview**
The WindCube v2 is a pulsed LIDAR and uses four beams sent in succession in the four cardinal directions along a 28°scanning cone angle to measure horizontal velocity and wind direction. A fifth beam is sent in the vertical direction to measure vertical velocity. Me...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Lidar HilFlowS LLNL ZephIR300 MOP Processed Data
**Overview**
The ZephIR300 is a continuous wave LIDAR with a range of 10 m to 300 m. During HilFlowS the ZephIR300 was programmed to measure from 10 m to 150 m. In addition, the ZephIR300 provided a measurement at 1 m height using an onboard meteorological sensor. The ZephIR300 ...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Lidar HilFlowS LLNL ZephIR300 WOP Processed Data
**Overview**
The ZephIR300 is a continuous wave LIDAR with a range of 10 m to 300 m. During HilFlowS the ZephIR300 was programmed to measure from 10 m to 150 m. In addition, the ZephIR300 provided a measurement at 1 m height using an onboard meteorological sensor. The ZephIR300 ...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Envisat Track 349 and Sentinel-1A Track 64 Interferometric Synthetic Aperture Radar Data of Coso Geothermal Field, California, USA, 2004-2016
This submission contains tarred pair directories for interferometric synthetic aperture radar (InSAR) data covering Coso Geothermal Field in California, USA.
Explanation of pair subdirectories:
Pairs are formed using the InSAR processing software GMT5SAR (Sandwell et al., 2011).
...
Reinisch, E. and Feigl, K. University of Wisconsin
Jun 25, 2019
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Utah FORGE: Wells Wow2 and Wow3 Groundwater Monitoring Data
This dataset includes ground water level data for Utah FORGE Phase 2c ground water monitoring wells Wow2 and Wow3. The readme file explains the fields contained in the included Excel spreadsheet and contains the coordinates for the wells. The Excel spreadsheet contains raw data ta...
Kirby, S. Energy and Geoscience Institute at the University of Utah
Jun 20, 2019
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: North Milford Groundwater Geochemistry
This dataset contains groundwater geochemistry from several wells in North Milford Valley, Utah, in the region of the Utah FORGE project (Phase 2c). Readme file that discusses the data contained in the Excel spreadsheet. Data include GPS coordinates (UTM, Lat-Long), sampling tempe...
Simmons, S. and Kirby, S. Energy and Geoscience Institute at the University of Utah
Jun 20, 2019
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Crude Oil Analysis (COA) database
The Crude Oil Analysis (COA) database contains the digital data compilation of 9,076 crude oil analyses from samples collected from 1920 through 1983 from the United States and around the world and analyzed by the United States Bureau of Mines (National Institute for Petroleum and...
Lillis, P. and DOE, N. National Renewable Energy Laboratory
May 29, 2019
2 Resources
0 Stars
In curation
2 Resources
0 Stars
In curation
Utah FORGE: Seismic Activity from April, 2019
This dataset contains seismic event detections acquired using the 151 Nodal geophones deployed at the Utah FORGE site in April 2019. Details regarding the publishing are available in the paper linked below (Mesimeri, M. and K. L. Pankow et al. 2020). A frequency-domain-based algor...
Pankow, K. University of Utah Seismograph Stations
May 01, 2019
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 58-32 Stimulation Conference Paper and Data
The U.S. Department of Energy's (U.S. DOE) Frontier Observatory for Research in Geothermal Energy (FORGE) is a field laboratory that provides a unique opportunity to develop and test new technologies for characterizing, creating and sustaining Enhanced Geothermal Systems (EGS) in ...
Best, S. Energy and Geoscience Institute at the University of Utah
Apr 24, 2019
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 58-32 Stimulation Data
Pressure, temperature, and flow data from open-hole, upper perforation, and lower perforation well stimulations gathered from various tools collected at well 58-32 during phase 2C.
Best, S. Geothermal Resource Group
Apr 20, 2019
16 Resources
0 Stars
Publicly accessible
16 Resources
0 Stars
Publicly accessible
Utah FORGE: Evaluation of Potential Geochemical Responses to Injection in the FORGE Geothermal Reservoir
Plugging of fracture porosity from mineral precipitation due to injecting cold water into a a geothermal reservoir can impact the overall permeability of the fracture network in the reservoir. This can have serious ramifications on the efficiency of the geothermal resource. Geoche...
Patil, V. and Simmons, S. Energy and Geoscience Institute at the University of Utah
Apr 03, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
EGS Collab Experiment 1: Circulation Testing
These data and test descriptions comprise a chilled circulation test conducted at the 164' fracture in the EGS Collab Experiment 1 testbed on the 4850 ft level of the Sanford Underground Research Facility. Descriptions of the meta data, design drawings for the flow testing system,...
Knox, H. et al Lawrence Berkeley National Laboratory
Apr 01, 2019
11 Resources
0 Stars
Publicly accessible
11 Resources
0 Stars
Publicly accessible
Utah FORGE: Phase 2C Seismic Observation and Ground Water Well Data and Well Locations
This submission contains the following data associated with Utah FORGE Phase 2C within the Roosevelt Hot Springs geothermal area:
An ArcGIS shapefile with well locations for wells 58-32, 78-32, 68-32, OH-3, OH-4, WOW-2, and WOW-3. Well 58-32 is the deep test well, wells 68-32 an...
Abraham, S. et al Energy and Geoscience Institute at the University of Utah
Mar 26, 2019
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Assessing REE Concentrations in Geothermal and Oil and Gas Produced Waters: A Potential Domestic Source of Strategic Mineral Commodities
The project team collected and analyzed 224 water samples and 101 matching rock samples. INL's improved method of measuring aqueous REEs allows study of samples previously thought too volume limited to measure.
The study found that aqueous REEs occur at trace levels in all analyz...
Quillinan, S. et al University of Wyoming
Mar 08, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Resource Analysis for Deep Direct-Use Feasibility Study in East Texas, Part 2
The National Renewable Energy Laboratory, Southern Methodist University Geothermal Laboratory, Eastman Chemical, Turbine Air Systems, and the Electric Power Research Institute are evaluating the feasibility of using geothermal heat to improve the efficiency of natural gas power pl...
Richards, M. et al Southern Methodist University
Mar 01, 2019
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
PoroTomo Distributed Temperature Sensing (DTS) Measurements made in Brady Observation Well 56-1
This submission is a follow-up to Distributed Temperature Sensing (DTS) measurements made in Brady observation well 56-1 during the PoroTomo field experiment conducted in March, 2016. The measurements in this data set were made on August 24, 2018 over an approximately 20 hour per...
Kratt, C. et al Oregon State University
Jan 09, 2019
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Geocellular model of St. Peter Sandstone for University of Illinois at Urbana-Champaign DDU Feasibility Study
The geocellular model of the St. Peter Sandstone was constructed for the University of Illinois at Urbana-Champaign DDU feasibility study. Starting with the initial area of review (18.0 km by 18.1 km [11.2 miles by 11.3 miles]) the boundaries of the model were trimmed down to 9.7 ...
Damico, J. University of Illinois
Dec 31, 2018
5 Resources
0 Stars
Publicly accessible
5 Resources
0 Stars
Publicly accessible
Geocellular Model of Mt. Simon Sandstone for University of Illinois at Urbana-Champaign DDU feasibility study
The geocellular model of the Mt. Simon Sandstone was constructed for the University of Illinois at Urbana-Champaign DDU feasibility study. Starting with the initial area of review (18.0 km by 18.1 km [11.2 miles by 11.3 miles]) the boundaries of the model were trimmed down to 9.7 ...
Damico, J. University of Illinois
Dec 31, 2018
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
BuildingsBench: A Large-Scale Dataset of 900K Buildings and Benchmark for Short-Term Load Forecasting
The BuildingsBench datasets consist of:
Buildings-900K: A large-scale dataset of 900K buildings for pretraining models on the task of short-term load forecasting (STLF). Buildings-900K is statistically representative of the entire U.S. building stock.
7 real residential and com...
Emami, P. and Graf, P. National Renewable Energy Laboratory
Dec 31, 2018
6 Resources
0 Stars
Curated
6 Resources
0 Stars
Curated
Utah FORGE: Earth Model Mesh Data for Selected Surfaces
This submission contains a number of data files with vertices of meshed/interpolated surfaces used in the Phase 2B earth model. Examples include land surface (based on 10-meter DEM), the granitoid-basin fill contact, several faults, and also interpolated temperature isosurfaces f...
Podgorney, R. Idaho National Laboratory
Dec 07, 2018
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Utah FORGE: Roosevelt Hot Springs Analytical Well-Based Temperature Model Data
This submission contains a cumulative record of one-dimensional temperature modeling based off of well data in the vicinity of the Utah FORGE site. Temperature log data from wells used, and in some cases were extrapolated below the bottom of a number of wells. The data were corre...
Podgorney, R. and Allis, R. Idaho National Laboratory
Dec 07, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Well Data for Student Competition
Well 58-32 (previously labeled MU-ESW1) was drilled near Milford Utah during Phase 2B of the FORGE Project to confirm geothermal reservoir characteristics met requirements for the final FORGE site.
Well Accord-1 was drilled decades ago for geothermal exploration purposes. While ...
Podgorney, R. et al Idaho National Laboratory
Dec 07, 2018
12 Resources
0 Stars
Publicly accessible
12 Resources
0 Stars
Publicly accessible