Search OEDI Data

Life Cycle Water Consumption and Water Resource Assessment for Utility-Scale Geothermal Systems: An In-Depth Analysis of Historical and Forthcoming EGS Projects

This report is the third in a series of reports sponsored by the U.S. Department of Energy Geothermal Technologies Program in which a range of water-related issues surrounding geothermal power production are evaluated. The first report made an initial attempt at quantifying the li...

Schroeder, J. et al Argonne National Laboratory

Aug 31, 2013
11 Resources
0 Stars
Publicly accessible

Fallon FORGE: Analogue Outcrop Samples

Compilation of results for mechanical and fluid flow properties of analogue outcrop samples experimental data for compressional and shear wave velocities, tensile strengths, and compressive strengths. Outcrop location and sample orientation data are documented in a separate csv file.

Blankenship, D. et al Sandia National Laboratories

Mar 12, 2018
2 Resources
0 Stars
Publicly accessible

Active Source Seismic (Ultrasonic) Data from Double-Direct Shear Lab Experiments

Active source ultrasonic data from lab experiments p5270 and p5271 including raw waveforms (WF) and mechanical data (mat). From the PSU team working on the "Machine Learning Approaches to Predicting Induced Seismicity and Imaging Geothermal Reservoir Properties" project. The fric...

Marone, C. Pennsylvania State University

May 05, 2021
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Core Material Friction Experiments

The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...

Marone, C. et al Pennsylvania State University

Mar 15, 2023
7 Resources
0 Stars
Publicly accessible

Utah FORGE 2439: Well 16B(78)-32 Field-Test Data from Mini-Frac Tests

This submittal includes the field-test data collected during stress tests conducted in the Utah FORGE 16B(78)-32 wellbore to measure/characterize the stresses in the geothermal reservoir. The type of stress test performed is referred to as a mini-frac test or a micro-frac test. Th...

Kelley, M. et al Battelle Memorial Institute

Jul 02, 2023
3 Resources
0 Stars
Publicly accessible

Water chemistry data and calculations for Fracture Sustainability Tests

Measured cation, anion, and silica are presented as well as calculations evaluating mass balance performed for 4 fracture sustainability tests under EGS conditions: Stripa granite, Metamudstone, Rhyolitic Ashflow Tuff, and Silicified Rhyolitic Tuff. Calculations of charge balance ...

Kneafsey, T. et al Lawrence Berkeley National Laboratory

Sep 30, 2020
2 Resources
0 Stars
Publicly accessible

Washington Play Fairway Analysis Analysis of High Precision GPS Time Series and Strain Rates for the Cascade Range

Global Positioning System (GPS) time series from the National Science Foundation (NSF) Earthscope's Plate Boundary Observatory (PBO) and Central Washington University's Pacific Northwest Geodetic Array (PANGA). GPS station velocities were used to infer strain rates using the "spli...

Swyer, M. AltaRock Energy Inc

Feb 22, 2015
2 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2419: Seismicity-Permeability Relationships Probed via Nonlinear Acoustic Imaging Workshop Presentation

This is a presentation on the Seismicity-Permeability Relationships Probed via Nonlinear Acoustic Imaging project by Pennsylvania State University, presented by Derek Elsworth. The project's objectives were to explore controls and acoustic signatures of aseismic through seismic e...

Elsworth, D. et al Pennsylvania State University

Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: In-situ observation of pre-, co and post-seismic shear slip preceding hydraulic fracturing

Understanding the initiation and arrest of earthquakes is one of the long-standing challenges of seismology. Here we report on direct observations of borehole displacement by a meter-sized shear rupture induced by pressurization of metamorphic rock at 1.5 km depth. We observed the...

Guglielmi, Y. et al Lawrence Berkeley National Laboratory

May 22, 2018
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Baseline Cross-well Seismic

As part of the geophysical characterization suite for the first EGS Collab tesbed, here are the baseline cross-well seismic data and resultant models. The campaign seismic data have been organized, concatenated with geometry and compressional (P-) & and shear (S-) wave picks, and ...

Schwering, P. et al Sandia National Laboratories

Apr 30, 2018
9 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Stage 1 Pressure Falloff Analysis

This is an analysis of the pressure falloff in stage 1 fracture stimulation of FORGE well 16A(78)-32. The objective of this research is to understand the information content of the well stimulation data of FORGE Well 16A(78)-32. The Stage 1 step-rate test, a variant of the classic...

Kazemi, H. et al Colorado School of Mines

Aug 04, 2022
1 Resources
0 Stars
Publicly accessible

Newberry EGS Demonstration: Repairing and Re-Stimulating Well 55-29 Report

The Newberry Volcano EGS Demonstration in central Oregon, a 5 year project begun in 2010, tests recent technological advances designed to reduce the cost of power generated by EGS in a hot, dry well (NWG 55-29) drilled in 2008. First, the stimulation pumps used were designed to ru...

Cladouhos, T. et al AltaRock Energy Inc

Jul 03, 2015
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Common Discrete Fracture Network

This package includes data and models that support hydraulic fracture stimulation and fluid circulation experiments in the Sanford Underground Research Facility (SURF). A paper by Schwering et al. (2020) describes the deterministic basis for developing a "common" discrete fracture...

Schwering, P. et al Sandia National Laboratories

Sep 18, 2019
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 2C Topical Report

This is the topical report that wraps up the work and results achieved during Utah FORGE Phase 2C. The zip file includes several folders containing (1) an overview; (2) the results; (3) the lessons learned; and (4) the conclusions. It also contains a folder containing appendices i...

Moore, J. et al Energy and Geoscience Institute at the University of Utah

Dec 11, 2019
2 Resources
0 Stars
Publicly accessible

Laboratory Evaluation of EGS Shear Stimulation-Test 001

This is the results of an initial setup-shakedon test in order to develop the plumbing system for this test design. a cylinder of granite with offset holes was jacketed and subjected to confining pressure and low temperature (85C) and pore water pressure. Flow through the sample w...

Bauer, S. Sandia National Laboratories

Jul 29, 2014
1 Resources
0 Stars
Publicly accessible

Fallon FORGE: Lithology Logs and Well 21-31 Drilling Data

This submission includes lithology logs for all Fallon FORGE area wells; determined from core, cuttings, and thin section. Wells included are 84-31, 21-31, 82-36, FOH-3D, 62-36, 18-5, 88-24, 86-25, FOH-2, 14-36, 17-16, 34-33, 35A-11, 51A-20, 62-15, 72-7, 86-15, Carson_Strat_1_36-3...

Blankenship, D. et al Sandia National Laboratories

Mar 11, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Optimization of a Plug-and-Perf Stimulation (Fervo Energy)

Information around the plug-and-perf treatment design at Utah FORGE by Fervo Energy. Objective and Purpose: Develop a multistage hydraulic stimulation approach designed specifically to target the top three factors that control the technical and commercial viability of an EGS sys...

Norbeck, J. et al Fervo Energy

Feb 08, 2023
3 Resources
0 Stars
Publicly accessible

Illite Dissolution Rates and Equation (100 to 280 deg C)

The objective of this suite of experiments was to develop a useful kinetic dissolution expression for illite applicable over an expanded range of solution pH and temperature conditions representative of subsurface conditions in natural and/or engineered geothermal reservoirs. Usi...

Carroll, S. Lawrence Livermore National Laboratory

Oct 17, 2014
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Laboratory Experiments Examining the Effect of Thermal and Mechanical Processes on Hydraulic Transmissivity Evolution

Using laboratory slide-hold-slide experiments, at temperatures from 22 to 200 degrees C, to examine effects of fracture reactivation and quasi-static loading on the evolution of fluid transport properties of simulated fractures in Westerly granite. At all temperatures, the in-plan...

Lockner, D. et al United States Geological Survey

Apr 03, 2023
2 Resources
0 Stars
Publicly accessible

Fracture Sustainability Test, Pre and Post-Test Photomicrographs

The primary objective of this research is to understand how different rock types, mineral and fluid compositions, and fracture surface textures determine the longevity of fracture apertures, so that selection of reservoir rock can be economically optimized to reduce future refract...

Dobson, P. et al Lawrence Berkeley National Laboratory

Sep 26, 2016
9 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16B(78)-32 Logs from Schlumberger Technologies

This dataset is a collection of well logs provided by Schlumberger Technologies from the Utah FORGE well 16B(78)-32 drilling project. Information here includes critical borehole information collected by an ultrasonic borehole imager (UBI) and a fullbore formation microimager (FMI)...

May, D. and Jones, D. Energy and Geoscience Institute at the University of Utah

Sep 14, 2023
7 Resources
0 Stars
Publicly accessible

Using Fully Coupled Hydro-Geomechanical Numerical Test Bed to Study Reservoir Stimulation with Low Hydraulic Pressure

This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimu...

Fu, P. et al Lawrence Livermore National Laboratory

Jan 31, 2012
2 Resources
0 Stars
Publicly accessible

Direct-Drive Electrical Generator and PTO System for Flap-type Wave Energy Converters

Project and generator specifications and initial prototype test data for flap-type wave energy converters (WEC)

Englebretson, S. ABB Inc.

Mar 20, 2015
2 Resources
0 Stars
Publicly accessible

Chlorite, Biotite, Illite, Muscovite and Feldspar Dissolution Kinetics at Variable pH and Temperatures up to 280 deg C

Chemical reactions pose an important but poorly understood threat to EGS long-term success because of their impact on fracture permeability. This report summarizes the dissolution rate equations for layered silicates where data were lacking for geothermal systems. Here we report ...

Carroll, S. et al Lawrence Livermore National Laboratory

Feb 24, 2017
2 Resources
0 Stars
Publicly accessible

Summary of Cement Formulations Tested by BNL for Self-Healing Ability Tests Conditions and Data

A table of cement formulations tested by Brookhaven National Laboratory in 2016-2017 in the frame of the "Self-healing and Re-Adhering Cements with Improved Toughness at Casing and Formation Interfaces for Geothermal Wells" project.

Sugama, T. Brookhaven National Laboratory

Sep 27, 2017
2 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 Next >>