Search OEDI Data

Utah FORGE: Well 16A(78)-32 Stage 1 Pressure Falloff Analysis

This is an analysis of the pressure falloff in stage 1 fracture stimulation of FORGE well 16A(78)-32. The objective of this research is to understand the information content of the well stimulation data of FORGE Well 16A(78)-32. The Stage 1 step-rate test, a variant of the classic...

Kazemi, H. et al Colorado School of Mines

Aug 04, 2022
1 Resources
0 Stars
Publicly accessible

Active Management of Integrated Geothermal-CO2 Storage Reservoirs in Sedimentary Formations

Active Management of Integrated Geothermal-CO2 Storage Reservoirs in Sedimentary Formations: An Approach to Improve Energy Recovery and Mitigate Risk: FY1 Final Report The purpose of phase 1 is to determine the feasibility of integrating geologic CO2 storage (GCS) with geothermal...

A., T. Lawrence Livermore National Laboratory

Jan 01, 2000
6 Resources
0 Stars
Publicly accessible

Exploration for Blind Geothermal Resources in the State of Hawaii Utilizing Dissolved Noble Gasses in Well Waters

This study is an extension of the Hawaii Play Fairway Analysis (PFA), a statewide geothermal exploration project funded by the United States Department of Energy. Based on results from prior phases of the PFA, this project targeted 66 wells on the islands of Hawaii, Maui, Lanai, O...

Ferguson, C. University of Hawaii

Nov 01, 2020
4 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2439v2: Report on Predicting Far-Field Stresses Using Finite Element Modeling and Near-Wellbore Machine Learning for Well 16A(78)-32

This report presents the far-field stress predictions at two locations along the vertical section of Utah FORGE Well 16A (78)-32 using a physics-based thermo-poro-mechanical model. Three principal stresses in far-field were obtained by solving an inverse problem based on the near-...

Lu, G. et al University of Pittsburgh

Aug 30, 2024
2 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Building a 3D Resistivity Model for Simulation and Survey Design of EM Measurements

The included report outlines the creation of three 3D resistivity models that will be used to determine the sensitivity of EM measurements for the hypothetical stimulated reservoir at FORGE as well as for EM survey design. FORGE project 3-2535 is planning on using a casing source ...

Alumbaugh, D. et al Lawrence Berkeley National Laboratory

Dec 01, 2022
5 Resources
0 Stars
Publicly accessible

WHOLESCALE: Seismic Waveform Data from San Emidio, Nevada 2022

Included here is a link to seismic waveform data collected at San Emidio, Nevada in 2022. The seismic instruments used were provided by EarthScope Consortium through the EarthScope Primary Instrument Center at New Mexico Tech. Data collected are available here through EarthScope ...

Lord, N. et al University of Wisconsin Madison

Apr 05, 2022
3 Resources
0 Stars
Publicly accessible

Appalachian Basin Play Fairway Analysis: Thermal Quality Analysis in Low-Temperature Geothermal Play Fairway Analysis (GPFA-AB)

This collection of files are part of a larger dataset uploaded in support of Low Temperature Geothermal Play Fairway Analysis for the Appalachian Basin (GPFA-AB). Phase 1 of the GPFA-AB project identified potential Geothermal Play Fairways within the Appalachian basin of Pennsylva...

E., T. Cornell University

Nov 15, 2015
50 Resources
0 Stars
Publicly accessible

Final Report: Low Temperature Geothermal Play Fairway Analysis for the Appalachian Basin

This is a final report summarizing a two-year (2014-16) DOE funded Geothermal Play Fairway Analysis of the Low-Temperature resources of the Appalachian Basin of New York, Pennsylvania and West Virginia. Collaborators included Cornell University, Southern Methodist University, and ...

E. Jordan, T. Cornell University

Nov 18, 2015
12 Resources
0 Stars
Publicly accessible

SOLTHERM Thermodynamic Database for Geochemical Modeling

This data submission is a link to a thermodynamic database maintained by the University of Oregon. The data at this link are not 'data results' from sampling. The data at this link comprise a thermodynamic database for aqueous species, minerals, and gases, including data for stoic...

Palandri, J. University of Oregon

Oct 07, 2015
2 Resources
0 Stars
Publicly accessible

Testing for Controlled Rapid Pressurization

Borehole W1 is a NQ core hole drilled at our test site in Socorro. The rock is rhyolite. Borehole W1 which was used to test gas-gas explosive mixtures is 55 feet deep with casing (pinkish in the drawing) set to 35 feet. The model is a representation of the borehole and the hol...

Knudsen, S. Sandia National Laboratories

Sep 03, 2014
1 Resources
0 Stars
Publicly accessible

Extraction/Injection Well Design for Deep Direct Use at University of Illinois at Urban-Champaign

The large scale Deep Direct Use (DDU) geothermal project in the low temperature environment of the Illinois Basin requires drilling and completing two wells. One well would be the extraction (producing) well and would be built to deliver a flow rate of approximately 6000 barrels ...

Kirksey, J. and Lu, Y. University of Illinois

Mar 31, 2019
1 Resources
0 Stars
Publicly accessible

Utah FORGE: UGS Interactive Geoscience Map

This is a link to the Utah Geological Survey's Utah FORGE Interactive Geoscience Map. The map layers include information on geology, geography, subsurface temperatures, seismicity, gravity and groundwater. Instructions for using the interactive map and a legend for the interactive...

Hill, J. Utah Geological Survey

Jan 01, 2021
1 Resources
0 Stars
Publicly accessible

Using Fully Coupled Hydro-Geomechanical Numerical Test Bed to Study Reservoir Stimulation with Low Hydraulic Pressure

This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimu...

Fu, P. et al Lawrence Livermore National Laboratory

Jan 31, 2012
2 Resources
0 Stars
Publicly accessible

Development of a Neutron Diffraction Based Experimental Capability for Investigating Hydraulic Fractures for EGS-like Conditions

Understanding the relationship between stress state, strain state and fracture initiation and propagation is critical to the improvement of fracture simulation capability if it is to be used as a tool for guiding hydraulic fracturing operations. The development of fracture predict...

Polsky, Y. et al Oak Ridge National Laboratory

Feb 01, 2013
1 Resources
0 Stars
Publicly accessible

3D Model of the McGinness Hills Geothermal Area

The McGinness Hills geothermal system lies in a ~8.5 km wide, north-northeast trending accommodation zone defined by east-dipping normal faults bounding the Toiyabe Range to the west and west-dipping normal faults bounding the Simpson Park Mountains to the east. Within this broad ...

E. Faulds, J. University of Nevada

Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Milford Gravity Data Shapefile

This is a zipped GIS compatible shapefile of gravity data points used in the Milford, Utah FORGE project as of March 21st, 2016. The shapefile is native to ArcGIS, but can be used with many GIS software packages. Additionally, there is a .dbf (dBase) file that contains the dataset...

Moore, J. Energy and Geoscience Institute at the University of Utah

Mar 13, 2016
1 Resources
0 Stars
Publicly accessible

GeoThermalCloud framework for fusion of big data and multi-physics models in Nevada and Southwest New Mexico

Our GeoThermalCloud framework is designed to process geothermal datasets using a novel toolbox for unsupervised and physics-informed machine learning called SmartTensors. More information about GeoThermalCloud can be found at the GeoThermalCloud GitHub Repository. More information...

Vesselinov, V. Los Alamos National Laboratory

Mar 29, 2021
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Simplified Discrete Fracture Network Data

The FORGE team is making these fracture models available to researchers wanting a set of natural fractures in the FORGE reservoir for use in their own modeling work. They have been used to predict stimulation distances during hydraulic stimulation at the open toe section of well 1...

Finnila, A. Golder Associates Inc.

Jun 01, 2021
3 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2446: Characterizing Stress Roughness Through Simulation of Hydraulic Fracture Growth

This dataset covers work that investigated the apparent toughness anisotropy at Utah FORGE by comparing microseismic data with stress profiles from field measurements. The study analyzes the hydraulic fracture growth of Stage 3 at Well 16A(78)-32 using MEQ data, calibrating a nume...

Cusini, M. and Fei, F. Lawrence Livermore National Laboratory

Jan 30, 2025
3 Resources
0 Stars
Publicly accessible

Poroelastic References

This file contains a list of relevant references on the Biot theory (forward and inverse approaches), the double-porosity and dual-permeability theory, and seismic wave propagation in fracture porous media, in RIS format, to approach seismic monitoring in a complex fractured porou...

Morency, C. Lawrence Livermore National Laboratory

Dec 12, 2014
1 Resources
0 Stars
Publicly accessible

West Flank Coso FORGE Digital Elevation Model and Geology Shapefiles

Geologic ArcGIS data of West Flank Coso, Ca FORGE site from a unpublished map by Rich Whitmarsh. The zip file includes a DEM, hillshade and four shapefiles of the general outlines of FORGE area.

Blankenship, D. Sandia National Laboratories

Dec 21, 2015
1 Resources
0 Stars
Publicly accessible

West Flank Coso FORGE: 3D Temperature Model

x,y,z data of the 3D temperature model for the West Flank Coso FORGE site. Model grid spacing is 250m. The temperature model for the Coso geothermal field used over 100 geothermal production sized wells and intermediate-depth temperature holes. At the near surface of this model,...

Blankenship, D. Sandia National Laboratories

Mar 01, 2016
1 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Modeling Studies of Energized Steel-Casing Source EM Method for Detecting Stimulated Zone

Numerical modeling Studies for electromagnetic (EM) Data Acquisition Survey Design this milestone report describes the 3D modeling studies of energized steel-casing source electromagnetic method for detecting stimulated zone at the Utah FORGE Site. FORGE project 3-2535 is planning...

Um, E. et al Lawrence Berkeley National Laboratory

Feb 06, 2023
4 Resources
0 Stars
Publicly accessible

Hawthorne Nevada Deep Direct-Use Feasibility Study 3D Seismic

The objective of this project is to use a multi-disciplinary, three-tiered approach to assess the geothermal resource and determine the feasibility of implementing a large-scale, direct-use facility for the Hawthorne Army Depot (HAD) and the various town and county facilities in H...

Lowry, T. et al Nevada Bureau of Mines and Geology

Mar 29, 2018
6 Resources
0 Stars
Publicly accessible

Snake River Plain Play Fairway Analysis: Phase 1 Report

This presents the results of Phase 1 of the Snake River Plain Play Fairway Analysis project, along with a proposed work for Phase 2. No new data were collected, but we list data sources for our compilation. The Snake River volcanic province (SRP) overlies a thermal anomaly that e...

Shervais, J. et al Utah State University

Jan 25, 2016
1 Resources
0 Stars
Publicly accessible

<< Previous 7 8 9 10 11 12 13 14 15 16 Next >>