Search OEDI Data

Showing results 26 - 50 of 510.
Show results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
"material study"×

NREL 25-cm2 High-Pressure Low-Temperature Electrolysis Cell Hardware (Open Source)

This data resource describes an open-source cell hardware that enables low temperature electrolysis (LTE) testing at elevated pressures. Existing commercial options have several downsides when it comes to R&D testing. They are often not designed for repeated reassembly, may no...
Wrubel. . et al National Renewable Energy Laboratory
Nov 14, 2023
2 Resources
0 Stars
Publicly accessible

Evaluating an Exterior Insulation and Finish System for Deep Energy Retrofits

This report provides a case study of a deep energy retrofit using a site-applied exterior insulation and finish system (EIFS). Prefabricated EIFS panels are also discussed as a potential wall insulation retrofit solution. EIFSs are common in new and retrofit commercial constructio...
Dentz, J. and Podorson, D. The Levy Partnership, Inc Systems Building Research Alliance
Apr 27, 2016
2 Resources
0 Stars
Publicly accessible

Life Cycle Analysis Data and Results for Geothermal and Other Electricity Generation Technologies

Life cycle analysis (LCA) is an environmental assessment method that quantifies the environmental performance of a product system over its entire lifetime, from cradle to grave. Based on a set of relevant metrics, the method is aptly suited for comparing the environmental performa...
Sullivan, J. Argonne National Laboratory
Jun 04, 2013
1 Resources
0 Stars
Publicly accessible

TEAMER: Electrically Engaged Undulation System for Unmanned Underwater Vehicles

This TEAMER RFTS 1 (Request for Technical Support) project supported the flume tank testing of a long range, high endurance unmanned underwater vehicle (UUV) to monitor maritime space. Today, battery-powered remotely operated vehicles (ROVs) lack the duration to make persistent, w...
Lu, K. and Datla, R. Pyro-E
Oct 01, 2021
4 Resources
0 Stars
Publicly accessible

Test Report for Detonation Velocity Measurements

Test report for detonation velocity measurements. A series of tests were conducted to determine reaction rate and general behavior of aluminum (AL) and magnesium (MG) powder mixtures (metalized explosives) with Bullseye double-base smokeless propellant. Given the indeterminate sen...
Grubelich, M. Sandia National Laboratories
Jan 13, 2014
1 Resources
0 Stars
Publicly accessible

Model and experimental validation of ocean kite dynamics and controls

This submission includes two peer-reviewed papers from researchers at North Carolina State University presenting the modeling and lab-scale experimentation of the dynamics and control of a tethered tidal ocean kite. Below are the abstracts of each file included in the submission. ...
Vermillion, C. et al North Carolina State University
Mar 01, 2020
2 Resources
0 Stars
Publicly accessible

Contribution of Renewables to World Energy Supply (1971 2008)

OECD Factbook 2010: Economic, Environmental and Social Statistics ISBN 92-64-08356-1 © OECD 2010. [Available directly from the OECD Statistics website (beta version)](http://www.oecd.org/document/0,3746,en_2649_201185_46462759_1_1_1_1,00.html "Statistics from A to Z") Presents ...
Hallett, K. and (OECD), O. National Renewable Energy Laboratory
Dec 31, 2009
2 Resources
0 Stars
In curation

Omics Standard Operating Procedures

This living document will illustrate Standard Operating Procedures (SOPs) for sampling biofilm material from reverse osmosis (RO) membrane modules. The SOPs will empower the NAWI research community to apply omics tools (e.g., time-series metagenomic, meta-transcriptomic, metaprote...
May, A. et al Oak Ridge National Laboratory
Jan 18, 2021
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 56-32 Sludge XRF

This is an Excel spreadsheet containing the results of X-ray fluorescence from well 56-32 sludge samples. The instrumentation used was a Olympus Vanta M series handheld XRF analyzer. A glass (SiO2) "blank" was analyzed at the beginning and end of each sample batch to detect contam...
Smith, K. Utah Geological Survey
Jul 15, 2022
1 Resources
0 Stars
Publicly accessible

TidGen MHK Generator Composite Fatigue Analysis Procedure

A procedure was described for performing a fatigue analysis of composite foils for an MHK generator. The steps included generating load data, S-N (Stress versus Number of cycles to failure) diagrams through fatigue testing, cycle counts, damage versus load, and cumulative damage. ...
Krumpe, A. ORPC Inc.
Apr 14, 2020
2 Resources
0 Stars
Publicly accessible

TriFrame Mount Structural Performance Period A

Long-Term TriFrame Monitoring System (LTTFMS) data collected during Period A (13 days 10/22/20 11/4/20). The central component of the Verdant Power Free Flow System is a three-bladed horizontal-axis turbine. The turbine is equipped with a composite rotor with three fixed-pitch bl...
Colby, J. et al Verdant Power Inc.
Nov 12, 2021
1 Resources
0 Stars
Publicly accessible

U.S. Nuclear Regulation Data (Information Digest, 2010 2011)

The US Nuclear Regulatory Commission (NRC) publishes an Information Digest containing summary information about the NRC and its industry. The report's appendices include demographic data on U.S. nuclear power reactors, both commercial and test facilities. Details include licensee ...
Hallett, K. and (USNRC), U. National Renewable Energy Laboratory
Aug 30, 2010
10 Resources
0 Stars
In curation

Testing for Controlled Rapid Pressurization

Borehole W1 is a NQ core hole drilled at our test site in Socorro. The rock is rhyolite. Borehole W1 which was used to test gas-gas explosive mixtures is 55 feet deep with casing (pinkish in the drawing) set to 35 feet. The model is a representation of the borehole and the hol...
Knudsen, S. Sandia National Laboratories
Sep 03, 2014
1 Resources
0 Stars
Publicly accessible

Geomechanical Modeling for Thermal Spallation Drilling

Wells for Engineered Geothermal Systems (EGS) typically occur in conditions presenting significant challenges for conventional rotary and percussive drilling technologies: granitic rocks that reduce drilling speeds and cause substantial equipment wear. Thermal spallation drilling,...
Walsh, S. et al Lawrence Livermore National Laboratory
Aug 24, 2011
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 3 Native State Model 2022 Update

This is the Phase 3 native state model update. The Phase 3 numerical model represents a significant subsurface volume below the FORGE site footprint. The model domain of 4.0 km x 4.0 km x 4.2 km is located approximately between depths of 4000 to 4200 meters below land surface. Thi...
Podgorney, R. and Liu, R. Idaho National Laboratory
Jul 29, 2022
1 Resources
0 Stars
Publicly accessible

Comparative Performance of Four Prototype Mechanical Building Cooling Systems in a Desert Climate

Data and result of approximately fifteen months of monitoring of four houses located in the desert climate of Borrego Springs, California. Four houses were constructed using identical floor plans but differing wall materials, and different cooling systems that were designed to red...
Springer, D. et al Davis Energy
Jul 20, 2016
9 Resources
0 Stars
Publicly accessible

Castlegate Sandstone True Triaxial Test Data

Data set containing results from constant mean stress constant Lode angle true triaxial compression tests performed on Castlegate Sandstone. From the test preformed, the bedding plane and the strain type inside the band of sedimentary rocks can be related to stress histories. The ...
Ingraham, M. et al Sandia National Laboratories
May 06, 2012
8 Resources
0 Stars
Publicly accessible

Newberry EGS Demonstration: Stimulating the Existing Fracture Network Report

The Newberry Volcano EGS Demonstration in central Oregon, a 3 year project started in 2010, tests recent technological advances designed to reduce the cost of power generated by EGS in a hot, dry well (NWG 55-29) drilled in 2008. First, the stimulation pumps used were designed to ...
Cladouhos, T. et al AltaRock Energy Inc
Mar 10, 2014
1 Resources
0 Stars
Publicly accessible

Statistics Canada Energy Data: 2005 2009

Statistics Canada collects and produces annual energy-related data for the country. These official statistics are published on the Statistics Canada website. The data includes: annual energy fuel consumption in the manufacturing sector, by fuel type and by subsectors (2005 2009); ...
Hallett, K. and Canada, S. National Renewable Energy Laboratory
Jul 29, 2014
2 Resources
0 Stars
In curation

Techno-Economic Assessment for Integrating Biosorption into Rare Earth Recovery Process

The current uncertainty in the global supply of rare earth elements (REEs) necessitates the development of novel extraction technologies that utilize a variety of REE source materials. Herein, we examined the techno-economic performance of integrating a biosorption approach into ...
Jiao, Y. et al Lawrence Livermore National Laboratory
Jul 01, 2017
1 Resources
0 Stars
Publicly accessible

Techno-Economic Assessment for Integrating Biosorption into Rare Earth Recovery Process

The current uncertainty in the global supply of rare earth elements (REEs) necessitates the development of novel extraction technologies that utilize a variety of REE source materials. Herein, we examined the techno-economic performance of integrating a biosorption approach into a...
Jiao, Y. et al Lawrence Livermore National Laboratory
Oct 09, 2017
1 Resources
0 Stars
Publicly accessible

StingRAY Structural Optimization Final Technical Report

The overall project objective is to materially decrease the leveled cost of energy (LCOE) of the Columbia Power (CPower) StingRAY utility-scale wave energy converter (WEC). This will be achieved by reducing structural material and manufacturing costs and increasing energy output. ...
Lenee-Bluhm, P. Columbia Power Technologies, Inc.
Aug 05, 2020
2 Resources
0 Stars
Publicly accessible

Solar-to-Grid Public Data File for Utility-scale (UPV) and Distributed Photovoltaics (DPV) Generation, Capacity Credit, and Value for 2012-2020

Lawrence Berkeley National Laboratory (Berkeley Lab) estimates hourly project-level generation data for utility-scale solar projects and hourly county-level generation data for residential and non-residential distributed photovoltaic (PV) systems in the seven organized wholesale m...
Seel, J. et al Lawrence Berkeley National Lab
Oct 01, 2021
4 Resources
1 Stars
Publicly accessible

Auto Indexer Auto-Indexer for Percussive Hammers: Vane Motor Dynamometer Testing

Objectives Options associated with geothermal drilling operations are generally limited by factors such as formation temperature and rock strength. The objective of the research is to expand the "tool box" available to the geothermal driller by furthering the development of a hig...
Su, J. Sandia National Laboratories
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible

Regional Slip Tendency Analysis of the Great Basin Region

Slip and dilation tendency on the Great Basin fault surfaces (from the USGS Quaternary Fault Database) were calculated using 3DStress (software produced by Southwest Research Institute). Slip and dilation tendency are both unitless ratios of the resolved stresses applied to the f...
E., J. University of Nevada
Sep 30, 2013
1 Resources
0 Stars
Publicly accessible
<< Previous123456Next >>