Search OEDI Data

Showing results 101 - 125 of 901.
Show results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
"Numerical Analysis"×

Utah FORGE: Evaluation of Potential Geochemical Responses to Injection in the FORGE Geothermal Reservoir

Plugging of fracture porosity from mineral precipitation due to injecting cold water into a a geothermal reservoir can impact the overall permeability of the fracture network in the reservoir. This can have serious ramifications on the efficiency of the geothermal resource. Geoche...
Patil, V. and Simmons, S. Energy and Geoscience Institute at the University of Utah
Apr 03, 2019
1 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2565: Hydrothermal Evolution of Fracture Properties Workshop Presentation

This is a presentation on the Evolution of Permeability and Strength Recovery of Shear Fractures Under Hydrothermal Conditions project by the U.S. Geological Survey, presented by Dr. David Lockner. The project's objective was to determine how thermal, hydraulic, mechanical, and ch...
Lockner, D. et al United States Geological Survey
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

UMass 2-Body WEC Techno-Economic Assessment

The University of Massachusetts (UMass) is developing a 2-body wave energy converter (WEC) device that is converting mechanical power into electricity using a mechanical motion rectifier that allows the system to couple to a flywheel. UMass has completed numerical modeling, wave t...
Previsic, M. Re Vision Consulting
Nov 19, 2024
2 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2514: A Strain Sensing Array to Characterize Deformation at the FORGE Site Workshop Presentation

This is a presentation on the Strain Sensing Array to Characterize Deformation at the FORGE Site project by Clemson University, presented by Lawrence Murdoch. The project's objective was to evaluate the feasibility of measuring and interpreting tensor strain data to improve the pe...
Murdoch, L. et al Clemson University
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 3 Native State Model 2022 Update

This is the Phase 3 native state model update. The Phase 3 numerical model represents a significant subsurface volume below the FORGE site footprint. The model domain of 4.0 km x 4.0 km x 4.2 km is located approximately between depths of 4000 to 4200 meters below land surface. Thi...
Podgorney, R. and Liu, R. Idaho National Laboratory
Jul 29, 2022
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2446: Closing the Loop Between In-situ Stress Complexity and EGS Fracture Complexity Workshop Presentation

This is a presentation on the Closing the Loop Between In-situ Stress Complexity and EGS Fracture Complexity project by Lawrence Livermore National Laboratory, presented by Dr. Matteo Cusini. The project's objective was to employ a combination of high-fidelity simulations and true...
Cusini, M. and Bunger, A. Lawrence Livermore National Laboratory
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Data for 3-D Model Development Lithology, Temperature, Pressure, and Stress

This submission comprises two downloadable .zip archives. Each archive contains spreadsheets with 3-D data and a .txt document describing the data. The Mesh Files .zip download contains data regarding the lithologic contacts of the granitoid and overlying sedimentary basin fill. T...
Podgorney, R. Idaho National Laboratory
Mar 17, 2020
2 Resources
0 Stars
Publicly accessible

Generalized Displacement Correlation Method for Estimating Stress Intensity Factors

This paper presents a generalized form of the displacement correlation method (the GDC method), which can use any linear or quadratic finite element type with homogeneous meshing without local refinement. These two features are critical for modeling dynamic fracture propagation pr...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible

Experimental Testing of a Floating Oscillating Surge Wave Energy Converter at Hinsdale Wave Research Laboratory

In order to generate a public data set that can be used to validate Wave Energy Converter (WEC) numerical codes, such as WEC-Sim, Sandia National Laboratories led an experimental testing campaign of a 1:33 scale Floating Oscillating Surge Wave Energy Converter (FOSWEC) in the Dire...
Ruehl, K. et al Sandia National Laboratories
Jun 15, 2016
3 Resources
0 Stars
Publicly accessible

Reference Model 3 Scaled Geometry (RM3: Wave Point Absorber)

Contains the Reference Model 3 (RM3) scaled scale geometry files of the Wave Point Absorber, developed by the Reference Model Project (RMP). These scaled geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. The scaled RM3 device ...
Neary, V. et al Sandia National Laboratories
Sep 30, 2014
7 Resources
0 Stars
Publicly accessible

Investigation of Stimulation-Response Relationships for Complex Fracture Systems in Enhanced Geothermal Reservoirs

Hydraulic fracturing is currently the primary method for stimulating low-permeability geothermal reservoirs and creating Enhanced (or Engineered) Geothermal Systems (EGS) with improved permeability and heat production efficiency. Complex natural fracture systems usually exist in ...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 01, 2011
2 Resources
0 Stars
Publicly accessible

CalWave WEC Open Water Demonstration Public Final Test Report

The objective of this project is to advance the Technology Readiness Level of the x1 Wave Energy Converter (WEC) developed by CalWave Power Technologies Inc. through advanced numerical simulations, dynamic hardware tests, and ultimately a scaled open water demonstration deployment...
Boerner, T. et al CalWave Power Technologies Inc.
Nov 30, 2022
2 Resources
0 Stars
Publicly accessible

Wind Integration National Dataset (WIND) Toolkit

Wind resource data for North America was produced using the Weather Research and Forecasting Model (WRF). The WRF model was initialized with the European Centre for Medium Range Weather Forecasts Interim Reanalysis (ERA-Interm) data set with an initial grid spacing of 54 km. Thre...
Maclaurin, G. et al National Renewable Energy Laboratory
Sep 26, 2014
6 Resources
1 Stars
Publicly accessible

Seedling Project Report: A Novel Heat Pump Integrated Underground Thermal Energy Storage for Shaping Electric Demand of Buildings

This report presents a preliminary assessment of the technical feasibility of utilizing underground thermal energy storage (UTES) and electric-driven heat pumps (EDHPs) to enable flexible behind-the-meter electric demand of buildings while meeting their thermal demands in an energ...
Liu, X. et al Oak Ridge National Laboratory
May 31, 2019
1 Resources
0 Stars
Publicly accessible

WEC Controls Optimization Final Report

The over-arching project objective is to fully develop and validate optimal controls frameworks that can subsequently be applied widely to different WEC devices and concepts. Optimal controls of WEC devices represent a fundamental building block for WEC designers that must be cons...
Previsic, M. and Karthikeyan, A. Re Vision Consulting
Aug 26, 2020
1 Resources
0 Stars
Publicly accessible

TEAMER: Numerical Modeling and Optimization of the iProTech Pitching Inertial Pump (PIP) Wave Energy Converter (WEC)

This project focused on developing an automated workflow to evaluate and optimize the iProTech Pitching Inertial Pump (PIP) wave energy converter (WEC) using open-source Python packages and the MATLAB/Simulink tool, WEC-Sim. The process involved parameterizing key design variables...
Wynn, N. et al National Renewable Energy Laboratory
Apr 11, 2024
1 Resources
0 Stars
Publicly accessible

OC6 Phase Ia Nonlinear hydrodynamic loading validation dataset

**Overview** Two validation campaigns were examined within the Offshore Code Comparison Collaboration, Continued, with Correlation and unCertainty (OC6) Phase 1 project to examine the modeling tools' underprediction of loads and motion of a floating wind semisubmersible (semi) at...
Robertson, A. Wind Energy Technologies Office (WETO)
Aug 08, 2021
1 Resources
0 Stars
Publicly accessible

Chemical Impact of Elevated CO2 on Geothermal Energy Production

Numerical simulations have shown that the use of supercritical CO2 instead of water as a heat transfer fluid yields significantly greater heat extraction rates for geothermal energy. If this technology is implemented successfully, it could increase geothermal energy production and...
Carroll, S. et al Lawrence Livermore National Laboratory
Jan 01, 2013
3 Resources
0 Stars
Publicly accessible

Thermal Drawdown-Induced Flow Channeling in a Single Fracture in EGS

The evolution of flow pattern along a single fracture and its effects on heat production is a fundamental problem in the assessments of engineered geothermal systems (EGS). The channelized flow pattern associated with ubiquitous heterogeneity in fracture aperture distribution caus...
Guo, B. et al Lawrence Livermore National Laboratory
Nov 15, 2015
1 Resources
0 Stars
Publicly accessible

Fracture Sustainability Test, Pre and Post-Test Photomicrographs

The primary objective of this research is to understand how different rock types, mineral and fluid compositions, and fracture surface textures determine the longevity of fracture apertures, so that selection of reservoir rock can be economically optimized to reduce future refract...
Dobson, P. et al Lawrence Berkeley National Laboratory
Sep 26, 2016
9 Resources
0 Stars
Publicly accessible

CO2 Push-Pull Single Fault Injection Simulations

ASCII text files containing grid-block name, X-Y-Z location, and multiple parameters from TOUGH2 simulation output of CO2 injection into an idealized single fault representing a dipping normal fault at the Desert Peak geothermal field (readable by GMS). The fault is composed of a ...
Borgia, A. et al Lawrence Berkeley National Laboratory
Sep 21, 2017
5 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Temperature profile

This submission includes an input file, plot file, Fortran conversion file, and 3D data file from the simulation of the temperature profile within the Test Bed #1 of the EGS Collab project. The simulation was executed with PNNL's STOMP-GT simulator, which reads the input file, and...
White, M. Pacific Northwest National Laboratory
Apr 01, 2019
6 Resources
0 Stars
Publicly accessible

Wave and Offshore Wind Resource in the U.S. Pacific Ocean Minor Outlying Islands

Coastal environments such as islands have unique opportunities for renewable energy resources. This work explores the wave and offshore wind energy potential for the U.S. Pacific Ocean Minor Outlying Islands, including Baker Island, Howland Island, Jarvis Island, Johnston Atoll, K...
Yang, Z. et al Pacific Northwest National Laboratory
Dec 31, 2020
30 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 2C Topical Report

This is the topical report that wraps up the work and results achieved during Utah FORGE Phase 2C. The zip file includes several folders containing (1) an overview; (2) the results; (3) the lessons learned; and (4) the conclusions. It also contains a folder containing appendices i...
Moore, J. et al Energy and Geoscience Institute at the University of Utah
Dec 11, 2019
2 Resources
0 Stars
Publicly accessible

Bench Testing Data and Report for an Early Prototype Pitch Resonator WEC

This dataset encompasses data and documentation from bench tests conducted on an early prototype of a "pitch resonator" wave energy converter (WEC). The testing aimed to validate numerical models and reduce risks associated with the pitch resonator concept, which is designed to co...
Coe, R. et al Sandia National Laboratories
Aug 09, 2024
4 Resources
0 Stars
Publicly accessible
<< Previous123456789Next >>