Search OEDI Data

Utah FORGE Project 3-2535: Building a 3D Resistivity Model for Simulation and Survey Design of EM Measurements

The included report outlines the creation of three 3D resistivity models that will be used to determine the sensitivity of EM measurements for the hypothetical stimulated reservoir at FORGE as well as for EM survey design. FORGE project 3-2535 is planning on using a casing source ...

Alumbaugh, D. et al Lawrence Berkeley National Laboratory

Dec 01, 2022
5 Resources
0 Stars
Publicly accessible

AeroDyn V15.04: Design Tool for Wind and MHK Turbines

AeroDyn is a time-domain wind and MHK turbine aerodynamics module that can be coupled into the FAST version 8 multi-physics engineering tool to enable aero-elastic simulation of horizontal-axis wind turbines. AeroDyn V15.04 has been updated to include a cavitation check for MHK tu...

Murray, R. et al National Renewable Energy Laboratory

Apr 28, 2017
1 Resources
0 Stars
Publicly accessible

University of Illinois Campus Deep Direct-Use Feasibility Study Design of Injection Well #1 (CCS1)

Includes specification sheet, wellbore geometry, and drilling fluids at section target depth associated with the design of Injection Well #1 (CCS1) for the Illinois Basin Decatur Project (IBDP).

Greenberg, S. University of Illinois

Mar 30, 2018
1 Resources
0 Stars
Publicly accessible

M3 Wave DMP/APEX WEC Device Configuration Drawings

Configurations as tested and modeled in final phase of project for the Delos-Reyes Morrow Pressure Device (DMP), commercialized by M3 Wave LLC as "APEX."

Morrow, M. and Delos-Reyes, M. M3 Wave

Aug 08, 2017
1 Resources
0 Stars
Publicly accessible

Ground Source Heat Pump Computational Results

This data submission includes simulation results for ground loop heat pump systems located in 6 different cities across the United States. The cities are Boston, MA, Dayton, OH, Omaha, NE, Orlando, FL, Sacramento, CA, and St. Paul, MN. These results were obtained from the two-dime...

Menart, J. Wright State University

Jul 31, 2013
6 Resources
0 Stars
Publicly accessible

Measured Performance of a Varied Airflow Small-Diameter Duct System

In this study, researchers with the U.S. Department of Energy's Building America team IBACOS built on research previously done in two new-construction unoccupied test houses-one in Pittsburgh, Pennsylvania (Poerschke and Stecher 2014) and one in Fresno, California (Stecher and Poe...

Poerschke, A. Ibacos Innovation

Apr 27, 2016
5 Resources
0 Stars
Publicly accessible

Reference Model 6 Full Scale Geometry (RM6: Oscillating Water Column)

Contains the Reference Model 6 (RM6) full scale geometry files of the Oscillating Water Column, developed by the Reference Model Project (RMP). These full scale geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. This data was g...

Neary, V. et al Sandia National Laboratories

Sep 30, 2014
4 Resources
0 Stars
Publicly accessible

Advanced TidGen Power System LCOE Calculations and System Overview

The TidGen Power System generates emission-free electricity from tidal currents and connects directly into existing grids using smart grid technology. The power system consists of three major subsystems: shore-side power electronics, mooring system, and turbine generator unit (TGU...

Marnagh, C. and McEntee, J. Ocean Renewable Power Company

Jun 14, 2018
4 Resources
0 Stars
Publicly accessible

HERO WEC V1.0 SolidWorks Model

The attached zip file includes a SolidWorks pack-and-go assembly of NREL's HERO WEC (hydraulic and electric reverse osmosis wave energy converter) V1.0. This model does not include all aspects of the design (i.e. RO (reverse osmosis) system, electrical enclosure, hose, cable) it o...

Jenne, S. National Renewable Energy Laboratory

Aug 12, 2022
2 Resources
0 Stars
Publicly accessible

Seismic Survey 2016 Metadata at San Emidio, Nevada

1301 Vertical Component seismic instruments were deployed at San Emidio Geothermal field in Nevada in December 2016. The first record starts at 2016-12-05T02:00:00.000000Z (UTC) and the last record ends at 2016-12-11T14:00:59.998000Z (UTC). Data are stored in individual files in o...

Lord, N. et al University of Wisconsin

Dec 05, 2016
10 Resources
0 Stars
Publicly accessible

Advanced TidGen Power System Summary Presentation

Marnagh, C. and McEntee, J. Ocean Renewable Power Company

May 10, 2018
1 Resources
0 Stars
Publicly accessible

FOSWEC v2: System identification and control testing at Hinsdale Wave Research Laboratory

This report summarizes the design and execution of a wave tank test of the floating oscillating surge wave energy converter (FOSWEC) in the O.H. Hinsdale Wave Research Laboratory Directional Wave Basin at Oregon State University. This device, which uses two "flaps" that pivot abou...

Coe, R. et al Sandia National Laboratories

Feb 01, 2020
2 Resources
0 Stars
Publicly accessible

Brookfield Homes Passive House Performance Evaluation

TO4 3.1.3: Brookfield Homes Short-Term Results TO5 3.1.3: Brookfield Passive House Monitoring To further define its market position on high performance homebuilding, Brookfield worked with IBACOS and the Building America program to design and construct a Passive House (PH) certif...

Beach, R. et al Ibacos Innovation

Apr 27, 2016
4 Resources
0 Stars
Publicly accessible

Spooling control design for flight optimization of tethered tidal kites

This submission includes three peer-reviewed (under review) papers from the researchers at North Carolina State University presenting different control-based techniques to maximize the efficiency and robustness of a tethered energy-harvesting kite. Below are the abstracts of each ...

Daniels, J. et al North Carolina State University

Sep 16, 2019
3 Resources
0 Stars
Publicly accessible

Conway St Apartments Olive Street Development

In Greenfield, Massachusetts, Olive Street Development transformed an old elementary school building into 12 high-end rental apartments. The developer aimed to get as close to net-zero performance as practical, installing: (1) R-30 high-density spray foam against the brick walls (...

Aldrich, R. and Williamson, J. Steven Winter Associates of the Consortium for Advanced Residential Buildings

Apr 27, 2016
2 Resources
0 Stars
In curation

LandRAY PTO Test Plans with NREL NWTC 5 MW Dynamometer

The overarching project objective is to demonstrate the feasibility of using an innovative PowerTake-Off (PTO) Module in Columbia Power's utility-scale wave energy converter (WEC). The PTO Module uniquely combines a large-diameter, direct-drive, rotary permanent magnet generator; ...

Prudell, J. et al Columbia Power Technologies, Inc.

Feb 29, 2016
5 Resources
0 Stars
Publicly accessible

LandRAY PTO Testing Utilizing the NREL NWTC 5MW Dynamometer

Lenee-Bluhm, P. and Rhinefrank, K. Columbia Power Technologies, Inc.

Jun 13, 2016
3 Resources
0 Stars
Publicly accessible

Desert Peak Geodatabase for Geothermal Exploration Artificial Intelligence

These files contain the geodatabases related to the Desert Peak Geothermal Field. It includes all input and output files used in the project. The files include data categories of raw data, pre-processed data, and analysis (post-processed data). In each of these categories there ar...

Moraga, J. et al Colorado School of Mines

Apr 27, 2021
3 Resources
0 Stars
Publicly accessible

Deep Sedimentary Basin EGS Development

Stratigraphic reservoirs with high permeability and temperature at economically accessible depths are attractive for power generation because of their large areal extent (> 100 km2) compared to the fault controlled hydrothermal reservoirs (< 10 km2) found throughout much of the we...

Allis, R. and Moore, J. University of Utah

Jan 24, 2013
1 Resources
0 Stars
Publicly accessible

Utah FORGE Project 3-2535: Modeling Studies of Energized Steel-Casing Source EM Method for Detecting Stimulated Zone

Numerical modeling Studies for electromagnetic (EM) Data Acquisition Survey Design this milestone report describes the 3D modeling studies of energized steel-casing source electromagnetic method for detecting stimulated zone at the Utah FORGE Site. FORGE project 3-2535 is planning...

Um, E. et al Lawrence Berkeley National Laboratory

Feb 06, 2023
4 Resources
0 Stars
Publicly accessible

REopt Lite Geothermal Heat Pump Design Requirements

This document describes the design requirements for the geothermal heat pump (GHP) module being added to the existing REopt Lite web tool. This document describes the purpose, users, and functional requirements to which the modified web tool shall conform. This document will be re...

Olis, D. National Renewable Energy Laboratory

Mar 08, 2021
6 Resources
0 Stars
Publicly accessible

Control of an AUV with deployable energy-harvesting kite

This paper examines the control of an autonomous underwater vehicle (AUV) with a deployable energy-harvesting kite for oceanographic observation and surveillance. The proposed design and control strategies specifically address objectives of achieving high-payload, long-endurance A...

Reed, J. et al North Carolina State University

Sep 02, 2019
1 Resources
0 Stars
Publicly accessible

National Renewable Energy Laboratory/Habitat for Humanity Zero Energy Home: A Cold Climate Case Study for Affordable Zero Energy Homes

The design of this 1,280-square-foot, three-bedroom Habitat for Humanity of Metro Denver zero energy home carefully combines envelope efficiency, efficient equipment, appliances and lighting, and passive and active solar features to reach the zero energy goal. The home was designe...

Norton, P. et al National Renewable Energy Laboratory

Jul 21, 2016
4 Resources
0 Stars
Publicly accessible

The Foundational Industry Energy Dataset: Unit-level Characterization and Derived Energy Estimates for Industrial Facilities in 2017

The Foundational Industry Energy Dataset (FIED) addresses several of the areas of growing disconnect between the demands of industrial energy analysis and the state of industrial energy data by providing unit-level characterization by facility. Each facility is identified by a uni...

McMillan, C. et al National Renewable Energy Laboratory (NREL)

Jul 01, 2024
4 Resources
0 Stars
Curated

Global Value Chain and Manufacturing Analysis on Geothermal Power Plant Turbines

In this study, we have undertaken a robust analysis of the global supply chain and manufacturing costs for components of Organic Rankine Cycle (ORC) Turboexpander and steam turbines used in geothermal power plants. We collected a range of market data influencing manufacturing from...

Akar, S. et al National Renewable Energy Laboratory

Mar 30, 2018
6 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 6 7 Next >>