Search OEDI Data

Showing results 376 - 400 of 647.
Show results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
"ocean test"×

Gearbox Reliability Collaborative Phase 3 Gearbox 2 Test

The National Renewable Energy Laboratory (NREL) Gearbox Reliability Collaborative (GRC) was established by the U.S. Department of Energy in 2006; its key goal is to understand the root causes of premature gearbox failures and improve their reliability. The GRC uses a combined gear...
Keller and RobbNational Renewable Energy Laboratory
May 02, 2016
17 Resources
0 Stars
Publicly accessible

New York State Energy Research and Development Authority Exterior Building Solutions To Insulation

TO4 8.2.2: Space Cond. for Deep Energy Retrofits The purpose of this project for the New York State Energy Research and Development Authority (NYSERDA) is to find new or improved strategies for exterior building solutions in regard to insulation that will provide extensive energy...
Beach, R. et al Ibacos Innovation
Apr 27, 2016
14 Resources
0 Stars
Publicly accessible

ORNL Air Handling Fault Test Data FRP#1

ORNL test data for air handling faults. Data contains electrical measurements and power consumption measurements.
Fugate, D. and Laboratory, O. Oak Ridge National Laboratory
Mar 22, 2017
5 Resources
0 Stars
In curation

UAE6 Wind Tunnel Tests Data UAE6 Sequence G Raw Data

**Overview** Sequence G: Upwind Teetered (F) Test sequence G used an upwind, teetered turbine with a 0° cone angle. The wind speeds ranged from 5 m/s to 25 m/s. Yaw angles of ±180° were achieved at low wind speeds and angles of ±10° were achieved at the high wind speeds. Th...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

ALFA Discrete Element Method (DEM) Simulations using PFC3D

Contains input scripts, background information, reduced data, and results associated with the discrete element method (DEM) simulations of interface shear tests, plate anchor pullout tests, and torpedo anchor installation and pullout tests, using the software PFC3D (v4.0).
Evans, M. Northwest National Marine Renewable Energy Center
Jan 05, 2016
3 Resources
0 Stars
Publicly accessible

Comparative Performance of Four Prototype Mechanical Building Cooling Systems in a Desert Climate

Data and result of approximately fifteen months of monitoring of four houses located in the desert climate of Borrego Springs, California. Four houses were constructed using identical floor plans but differing wall materials, and different cooling systems that were designed to red...
Springer, D. et al Davis Energy
Jul 20, 2016
9 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence P Raw Data

**Overview** Sequence P: Wake Flow Visualization, Upwind (P) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 15 m/s. Yaw angles of 0° to –60° were achieved. The blade tip pitch was 3°. The rotor rotated at 72 RPM. ...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Neubrex Well 16B(78)-32 Cementing and Circulation Fiber Optics Monitoring Reports July, 2023

Included here are two fiber optics monitoring reports on Utah FORGE well 16B(78)-32 from Neubrex Energy Services. These reports review the fiber optics monitoring during both the cementing and circulation test periods of the well. Cementing as well as post-cementing monitoring a...
Jurick, D. et al Neubrex Energy Services (US), LLC
Oct 21, 2023
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Triaxial Direct Shear Results February 2025

This dataset contains results from nine triaxial direct shear tests conducted by Los Alamos National Laboratory on samples from FORGE Well 16A(78)-32. The primary objectives of this work were to determine the shear strength in both intact and residual states, evaluate dilation aga...
Frash, L. et al Los Alamos National Laboratory
Feb 28, 2025
1 Resources
0 Stars
Publicly accessible

Devices Suitable for Sectional Isolation Along Both Cased and Open-hole Wellbores Pipe Preparation Report

The main goal of this project is to develop an annular isolation system capable to withstand geothermal downhole conditions and mitigate the problems experienced by conventional packers in FORGE wells. This pipe preparation report is based on the test pipe that was procured and pr...
Teodoriu, C. et al Welltec
Mar 31, 2023
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 2C Seismic Observation and Ground Water Well Data and Well Locations

This submission contains the following data associated with Utah FORGE Phase 2C within the Roosevelt Hot Springs geothermal area: An ArcGIS shapefile with well locations for wells 58-32, 78-32, 68-32, OH-3, OH-4, WOW-2, and WOW-3. Well 58-32 is the deep test well, wells 68-32 an...
Abraham, S. et al Energy and Geoscience Institute at the University of Utah
Mar 26, 2019
6 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence D Raw Data

**Overview** Sequences B, C, and D: Downwind Baseline (F), Downwind Low Pitch (F), Downwind High Pitch (F) This test sequence used a downwind, teetered turbine with a 3.4° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of ±180° were achieved at low wind sp...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 14, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence B Raw Data

**Overview** Sequences B, C, and D: Downwind Baseline (F), Downwind Low Pitch (F), Downwind High Pitch (F) This test sequence used a downwind, teetered turbine with a 3.4° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of ±180° were achieved at low wind sp...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 14, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence C Raw Data

**Overview** Sequences B, C, and D: Downwind Baseline (F), Downwind Low Pitch (F), Downwind High Pitch (F) This test sequence used a downwind, teetered turbine with a 3.4° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of ±180° were achieved at low wind sp...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 14, 2018
1 Resources
0 Stars
Publicly accessible

Matlab Scripts and Sample Data Associated with Water Resources Research Article

Scripts and data acquired at the Mirror Lake Research Site, cited by the article submitted to Water Resources Research: Distributed Acoustic Sensing (DAS) as a Distributed Hydraulic Sensor in Fractured Bedrock M. W. Becker(1), T. I. Coleman(2), and C. C. Ciervo(1) 1 California St...
Becker, M. and Coleman, T. California State University
Jul 18, 2015
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Stress Logging Data

This spreadsheet consist of data and graphs from deep well 58-32 stress testing from 6900 7500 ft depth. Measured stress data were used to correct logging predictions of in situ stress. Stress plots shows pore pressure (measured during the injection testing), the total vertical in...
McLennan, J. Energy and Geoscience Institute at the University of Utah
Mar 14, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence 8 Raw Data

**Overview** Sequences 8 and 9: Downwind Sonics (F,P) and Downwind Sonics Parked (P) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of 0° to 60° were achieved. The blade tip pitch was 3°. The roto...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence 9 Raw Data

**Overview** Sequences 8 and 9: Downwind Sonics (F,P) and Downwind Sonics Parked (P) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of 0° to 60° were achieved. The blade tip pitch was 3°. The roto...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

Newberry EGS Demonstration: Initial Project Report and Induced Seismicity Mitigation Plan, 2011

This is the first project report and induced seismicity mitigation plan for the Newberry Enhanced Geothermal Systems (EGS) Demonstration project. The primary objectives of this first phase were to obtain necessary permits and comply with all regulations, including NEPA, communica...
Cladouhos, T. et al AltaRock Energy Inc
May 05, 2024
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Stage 1 Pressure Falloff Analysis

This is an analysis of the pressure falloff in stage 1 fracture stimulation of FORGE well 16A(78)-32. The objective of this research is to understand the information content of the well stimulation data of FORGE Well 16A(78)-32. The Stage 1 step-rate test, a variant of the classic...
Kazemi, H. et al Colorado School of Mines
Aug 04, 2022
1 Resources
0 Stars
Publicly accessible

Admiralty Inlet Advanced Turbulence Measurements: May 2015

This data is from measurements at Admiralty Head, in Admiralty Inlet (Puget Sound) in May of 2015. The measurements were made using Inertial Motion Unit (IMU) equipped ADVs mounted on a 'StableMoor' (Manufacturer: DeepWater Buoyancy) buoy and a Tidal Turbulence Mooring (TTM). Thes...
Kilcher, L. National Renewable Energy Laboratory
May 18, 2015
18 Resources
0 Stars
Publicly accessible

Evaluation of the U.S. Department of Energy Challenge Home Program Certification of Production Builders Chicago, IL and Devens, MA

TO4 Task 3.1 K Hovnanian Chicago, IL DOE Challenge Home Program Certified Home Constructed and Verified Specifications DOE Challenge Home Building envelope Ceiling R-49 blown fiberglass, Grade I Walls 2x4 framing @ 16 o.c. with R-13 fiberglass batts, Grade I and 1"" R-5 extrude...
Loomis, H. and Kerrigan, P. Building Science Corporation
Apr 27, 2016
6 Resources
0 Stars
Publicly accessible

HERO WEC V1 Upgrade 2023 Laboratory Testing (processed data)

The following submission includes processed laboratory data from NREL's Hydraulic and Electric Reverse Osmosis Wave Energy Converter (HERO WEC), in the form of MATLAB workspaces. This dataset was created using NREL's Large Amplitude Motion Platform (LAMP) and collected between Aug...
Panzarella, J. et al National Renewable Energy Laboratory
Jan 01, 2024
12 Resources
0 Stars
Publicly accessible

HydroAir Power Take Off Combined Design Report

The submission is the combined design report for the HydroAir Power Take Off (PTO). CAD drawings, circuit diagrams, design report, test plan, technical specifications and data sheets are included for the Main and auxiliary control cabinets and three-phase-synchronous-motor with a ...
Pearson, G. et al Dresser-Rand Company
Jun 26, 2015
15 Resources
0 Stars
Publicly accessible

Using Fully Coupled Hydro-Geomechanical Numerical Test Bed to Study Reservoir Stimulation with Low Hydraulic Pressure

This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimu...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 31, 2012
2 Resources
0 Stars
Publicly accessible
<< Previous11121314151617181920Next >>