Search OEDI Data

Showing results 301 - 325 of 411.
Show results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
"Submerged mid-column pressure differential"×

Utah FORGE Core Material Friction Experiments

The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...
Marone, C. et al The Pennsylvania State University
Mar 15, 2023
7 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence B Raw Data

**Overview** Sequences B, C, and D: Downwind Baseline (F), Downwind Low Pitch (F), Downwind High Pitch (F) This test sequence used a downwind, teetered turbine with a 3.4° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of ±180° were achieved at low wind sp...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 14, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence C Raw Data

**Overview** Sequences B, C, and D: Downwind Baseline (F), Downwind Low Pitch (F), Downwind High Pitch (F) This test sequence used a downwind, teetered turbine with a 3.4° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of ±180° were achieved at low wind sp...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 14, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence D Raw Data

**Overview** Sequences B, C, and D: Downwind Baseline (F), Downwind Low Pitch (F), Downwind High Pitch (F) This test sequence used a downwind, teetered turbine with a 3.4° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of ±180° were achieved at low wind sp...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 14, 2018
1 Resources
0 Stars
Publicly accessible

Raw Data from National Wind Technology Center M2 Tower (1996 2001)

This raw data reflects readings from instruments mounted on or near a 82 meter meteorological tower located at the [National Wind Technology Center (NWTC)](http://www.nrel.gov/wind/ "NWTC website"), approximately 5 miles south of Boulder, CO (specifically: 39.9107 N, 105.2348 W, d...
Hallett, K. and Laboratory, N. National Renewable Energy Laboratory
Nov 25, 2014
2 Resources
0 Stars
In curation

Analysis of downhole data from USU-1 well Leidos Technical Report

USU Camas-1 is a geothermal test well drilled in Camas Prairie, Idaho, in the Summer and Fall of 2018. The purpose of this test well was to validate Play Fairway methodologies of the Snake River Plain Play Fairway Analysis project. In this report, test data are analyzed to infer...
Garg, S. and Goranson, C. Utah State University
Dec 04, 2018
1 Resources
0 Stars
Publicly accessible

Material Properties for Brady Hot Springs Nevada USA from PoroTomo Project

The PoroTomo team has completed inverse modeling of the three data sets (seismology, geodesy, and hydrology) individually, as described previously. The estimated values of the material properties are registered on a three-dimensional grid with a spacing of 25 meters between nodes....
Feigl, K. and PoroTomo Team, . University of Wisconsin
Mar 06, 2019
10 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: 4850L Downhole Camera Surveys During Injection

This package includes data and footage from two rounds of downhole camera surveys performed at the Sanford Underground Research Facility (SURF) on the 4850 level. The exercise was performed once on 25 May 2018 and once on 21 December 2018. On May 25th, the first round was done dur...
Schwering, P. et al Sandia National Laboratories
May 25, 2018
9 Resources
0 Stars
Publicly accessible

Caldwell Ranch Exploration and Confirmation Project, Northwest Geysers, CA: 2011 Geothermal Technologies Peer Review Project Summary

Caldwell Ranch Exploration and Confirmation Project, Northwest Geysers, CA: 2011 Geothermal Technologies Peer Review Project Summary The Caldwell Ranch Exploration and Confirmation Project was to drill, test, and confirm the present economic viability of the undeveloped geothermal...
Walters, M. Geysers Power Company, LLC
Jan 01, 2011
1 Resources
0 Stars
Publicly accessible

Fully Coupled Geomechanics and Discrete Flow Network Modeling of Hydraulic Fracturing for Geothermal Applications

The primary objective of our current research is to develop a computational test bed for evaluating borehole techniques to enhance fluid flow and heat transfer in enhanced geothermal systems (EGS). Simulating processes resulting in hydraulic fracturing and/or the remobilization of...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 01, 2011
2 Resources
0 Stars
Publicly accessible

Turbine Depth Optimization Study, Admiralty Inlet, WA

The zipped file contains a directory of data and routines used in the NNMREC turbine depth optimization study (Kawase et al., 2011), and calculation results thereof. For further info, please contact Mitsuhiro Kawase at kawase@uw.edu.
Kawase, M. et al University of Washington
Nov 22, 2009
2 Resources
0 Stars
Publicly accessible

EGS Collab: Modeling and Simulation Working Group Teleconference Series (1-98)

This submission contains the presentation slides and recordings from the first 98 EGS Collab Modeling and Simulation Working Group teleconferences. These teleconferences served three objectives for the project: 1) share simulation results, 2) communicate field activities and resul...
White, M. et al Pacific Northwest National Laboratory
Feb 04, 2020
100 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence 6 Raw Data

**Overview** Sequence 6: Shroud Wake Measure (P) This test sequence used a downwind, rigid turbine with a 3.4° cone angle. The wind speeds for this sequence corresponded to subcritical [7 m/s], transitional [15 m/s], and supercritical [20 m/s] Reynolds number regimes for the ci...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence F Raw Data

**Overview** Sequence F: Downwind High Cone (F) This test sequence used a downwind, rigid turbine with an 18° cone angle. The wind speed ranged from 10 m/s to 20 m/s. Excessive inertial loading due to the high cone angle prevented operation at lower wind speeds. Yaw angles of Â...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 27, 2018
1 Resources
0 Stars
Publicly accessible

Lidar HilFlowS LLNL ZephIR300 MOP Processed Data

**Overview** The ZephIR300 is a continuous wave LIDAR with a range of 10 m to 300 m. During HilFlowS the ZephIR300 was programmed to measure from 10 m to 150 m. In addition, the ZephIR300 provided a measurement at 1 m height using an onboard meteorological sensor. The ZephIR300 ...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible

Lidar HilFlowS LLNL ZephIR300 WOP Processed Data

**Overview** The ZephIR300 is a continuous wave LIDAR with a range of 10 m to 300 m. During HilFlowS the ZephIR300 was programmed to measure from 10 m to 150 m. In addition, the ZephIR300 provided a measurement at 1 m height using an onboard meteorological sensor. The ZephIR300 ...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 58-32 Core Analyses

This dataset contains final reports regarding stress measurements, permeability measurements, and mechanical properties from the core testing of well 58-32, in PDF format, and spreadsheets containing tables from the reports as part of Utah FORGE Phase 2B. Please refer to the repor...
McLennan, J. Energy and Geoscience Institute at the University of Utah
May 30, 2018
1 Resources
0 Stars
Publicly accessible

AeroDyn V15.04: Design Tool for Wind and MHK Turbines

AeroDyn is a time-domain wind and MHK turbine aerodynamics module that can be coupled into the FAST version 8 multi-physics engineering tool to enable aero-elastic simulation of horizontal-axis wind turbines. AeroDyn V15.04 has been updated to include a cavitation check for MHK tu...
Murray, R. et al National Renewable Energy Laboratory
Apr 28, 2017
1 Resources
0 Stars
Publicly accessible

Super-Resolution for Renewable Energy Resource Data with Climate Change Impacts (Sup3rCC)

The Super-Resolution for Renewable Energy Resource Data with Climate Change Impacts (Sup3rCC) data is a collection of 4km hourly wind, solar, temperature, humidity, and pressure fields for the contiguous United States under various climate change scenarios. Sup3rCC is downscaled ...
Buster, G. et al The National Renewable Energy Lab (NREL)
Apr 19, 2023
7 Resources
1 Stars
Curated

ARPA-E Grid Optimization (GO) Competition Challenge 3 update

adding data for Events 1-3 that were deleted.
Elbert, S. Pacific Northwest National Laboratory
May 29, 2024
19 Resources
0 Stars
In progress

SGW paper Rheological Properties of Drilling Fluids Containing Special Additives for Geothermal Drilling Applications

The paper was presented at the 46th Workshop on Geothermal Reservoir Engineering, Stanford University, Stanford, California, February 15-17, 2021. In this study, the effectiveness of different additives was evaluated in maintaining drilling fluid rheology at HPHT(high pressure and...
Mohamed, A. et al University of Oklahoma
Jan 04, 2023
1 Resources
0 Stars
Publicly accessible

Additional Data Focused on Phase 1 Geared Toward Computational Fluid Dynamics (CFD) validation

**Overview** A new validation campaign was developed within the Offshore Code Comparison Collaboration, Continued, with Correlation and unCertainty (OC6) to better understand the complex interactions between components of a floating wind system (e.g., columns, pontoons, etc.) in ...
Robertson, A. Wind Energy Technologies Office (WETO)
Apr 08, 2021
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence X Raw Data

**Overview** Sequence X: Elevated RPM (F) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 12 m/s, and yaw angles of ±30° were obtained. The blade pitch angle was 3°. The rotor rotated at 90 RPM. Blade pressure measur...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 29, 2018
1 Resources
0 Stars
Publicly accessible

Fallon FORGE: Distinct Element Reservoir Modeling

Archive containing input/output data for distinct element reservoir modeling for Fallon FORGE. Models created using 3DEC, InSite, and in-house Python algorithms (ITASCA). List of archived files follows; please see 'Modeling Metadata.pdf' (included as a resource below) for addition...
Blankenship, D. et al Sandia National Laboratories
Mar 12, 2018
2 Resources
0 Stars
Publicly accessible

Harsh Environment Sensors for Geothermal Applications

Technical papers detailing the development of harsh environment sensors for geothermal applications. Principle Investigator is Prof. Albert P. Pisano (University of California, Berkeley). Submission includes a paper about geothermal environmental exposure testing on encapsulant a...
Senesky, D. et al Regents of the University University of California
Jan 01, 2012
2 Resources
0 Stars
Publicly accessible
<< Previous891011121314151617Next >>