Search OEDI Data

Showing results 201 - 225 of 710.
Show results per page.
Order by:
Available Now:
Clear All Filters ×
Research Areas
Accessibility
Data Type
Organization
Source
"Reference Model 1"×
Geothermal Energy×

3D Model of the Tuscarora Geothermal Area

The Tuscarora geothermal system sits within a ~15 km wide left-step in a major west-dipping range-bounding normal fault system. The step over is defined by the Independence Mountains fault zone and the Bull Runs Mountains fault zone which overlap along strike. Strain is transferre...
E., J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

3D Model of the Neal Hot Springs Geothermal Area

The Neal Hot Springs geothermal system lies in a left-step in a north-striking, west-dipping normal fault system, consisting of the Neal Fault to the south and the Sugarloaf Butte Fault to the north (Edwards, 2013). The Neal Hot Springs 3D geologic model consists of 104 faults and...
E., J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Feasibility of a Deep Direct-Use Geothermal System at the University of Illinois Urbana-Champaign

Paper authored by Stumpf et al. for the 2018 Geothermal Resources Council Annual Meeting held in Reno, NV USA. Included with the paper is the Microsoft PowerPoint presentation made at the GRC meeting and data tables associated with some of the figures.
Stumpf, A. et al University of Illinois
Dec 31, 2018
6 Resources
0 Stars
Publicly accessible

PoroTomo: Horizontal Distributed Acoustic Sensing (DAS) Measurements During an M 2.3 Explosion

Included here are Distributed Acoustic Sensing (DAS) data collected by the horizontal DAS array at Brady's Hot Springs Geothermal Field. The system recorded this data during an M 2.3 explosion at the Nevada Test Site (NTS), which is located approximately 400km southeast of the fie...
Kratt, C. et al Center for Transformative Environmental Monitoring Programs (CTEMPs)
Dec 18, 2018
5 Resources
0 Stars
Publicly accessible

Utah FORGE: Roosevelt Hot Springs Analytical Well-Based Temperature Model Data

This submission contains a cumulative record of one-dimensional temperature modeling based off of well data in the vicinity of the Utah FORGE site. Temperature log data from wells used, and in some cases were extrapolated below the bottom of a number of wells. The data were corre...
Podgorney, R. and Allis, R. Idaho National Laboratory
Dec 07, 2018
2 Resources
0 Stars
Publicly accessible

EPRI Report: Enhancing Geothermal Representation in EPRI's US-REGEN Model

This report examines improvements to the representation of geothermal resources and technologies, including hydrothermal, near-field, and deep enhanced geothermal systems (EGS), in EPRI's US-REGEN capacity expansion model. Using updated datasets from the National Renewable Energy ...
Molar-Cruz, A. and Johnson, N. National Renewable Energy Laboratory
Dec 13, 2024
1 Resources
0 Stars
Publicly accessible

Brady Geothermal Field Well Lithologies

Well lithologies and corresponding descriptions exported from the 3D Leapfrog geologic model.
Lopeman, J. University of Wisconsin
Jul 22, 2015
2 Resources
0 Stars
Publicly accessible

Renewable Energy Potential Model: Geothermal Supply Curves

The Renewable Energy Potential (reV) model is a geospatial platform for estimating technical potential and developing renewable energy supply curves, initially developed for wind and solar technologies. The model evaluates deployment constraints, considering land use, environmenta...
Trainor-Guitton, W. et al National Renewable Energy Laboratory
Aug 21, 2023
3 Resources
0 Stars
Publicly accessible

Applications of Fractured Continuum Model to Enhanced Geothermal System Heat Extraction Problems

This paper describes the applications of the fractured continuum model to the different enhanced geothermal systems reservoir conditions. The capability of the fractured continuum model to generate fracture characteristics expected in enhanced geothermal systems reservoir environm...
Kalinina, E. et al Sandia National Laboratories
May 06, 2014
1 Resources
0 Stars
Publicly accessible

Newberry FORGE: 3D Gravity Density Model for Newberry Volcano

These data are Pacific Northwest National Lab inversions of an amalgamation of two surface gravity datasets: Davenport-Newberry gravity collected prior to 2012 stimulations and Zonge International gravity collected for the project "Novel use of 4D Monitoring Techniques to Improve...
Bonneville, A. Pacific Northwest National Laboratory
Mar 11, 2016
1 Resources
0 Stars
Publicly accessible

Fallon FORGE: Distinct Element Reservoir Modeling

Archive containing input/output data for distinct element reservoir modeling for Fallon FORGE. Models created using 3DEC, InSite, and in-house Python algorithms (ITASCA). List of archived files follows; please see 'Modeling Metadata.pdf' (included as a resource below) for addition...
Blankenship, D. et al Sandia National Laboratories
Mar 12, 2018
2 Resources
0 Stars
Publicly accessible

Hawaii Play Fairway Analysis Model

Custom MATLAB and custom GMT scripts for Hawaii Play Fairway Analysis modeling.
Lautze, N. University of Hawaii
Jan 01, 2015
2 Resources
0 Stars
Publicly accessible

REopt Lite Geothermal Heat Pump Design Requirements

This document describes the design requirements for the geothermal heat pump (GHP) module being added to the existing REopt Lite web tool. This document describes the purpose, users, and functional requirements to which the modified web tool shall conform. This document will be re...
Olis, D. National Renewable Energy Laboratory
Mar 08, 2021
4 Resources
0 Stars
Publicly accessible

West Flank Coso, CA FORGE Test Area

A map with the Coso West Flank FORGE test area outlined, along with regional seismicity, the aeromagnetic data set and the area currently being utilized for the creation of the 3D model.
Blankenship, D. Sandia National Laboratories
Nov 15, 2015
1 Resources
0 Stars
Publicly accessible

Hawaii Play Fairway Analysis: Recharge Data for the Islands of Kauai, Lanai and Molokai, Hawaii

Recharge data for the islands of Kauai, Lanai and Molokai in shapefile format. These data are from the following sources: Whittier, R.B and A.I. El-Kadi. 2014. Human Health and Environmental Risk Ranking of On-Site Sewage Disposal systems for the Hawaiian Islands of Kauai, Molo...
Lautze, N. University of Hawaii
Jan 01, 2015
12 Resources
0 Stars
Publicly accessible

A Hydrogeochemical Analysis of Geothermal Resources in the State of Hawaii

The University of Hawaii at Manoa conducted a Play Fairway Analysis of the state of geothermal potential for the islands. Phase I included the aggregation of all existing geologic, geophysical and geochemical data available. A probability model incorporating heat, fluid, and perme...
Tachera, D. University of Hawaii
May 01, 2018
2 Resources
0 Stars
Publicly accessible

CAES 2014 Chemical Analyses of Thermal Wells and Springs in Southeastern Idaho

This dataset contains chemical analyses for thermal wells and springs in Southeastern Idaho. Data includes all major cations, major anions, pH, collection temperature, and some trace metals. These samples were collected in 2014 by the Center for Advanced Energy Studies (CAES), an...
Mattson, E. Idaho National Laboratory
Mar 10, 2014
7 Resources
0 Stars
Publicly accessible

Utah FORGE: 3D Gravity Data

These resources describe the 3D geophysical inversion modeling of gravity data at the FORGE site near Milford, Utah. FORGE is the Frontier Observatory for Research in Geothermal Energy and the site in Utah has been selected by the U.S. Dept. of Energy for a 5-year R&D program to t...
Hardwick, C. and Witter, J. Energy and Geoscience Institute at the University of Utah
Jun 24, 2019
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase Native State FALCON Model Files

The submission includes FALCON input file and mesh for the an initial pressure-temperature simulation, and a second set for pressure-temperature-displacement simulation. All simulations are steady state. Data and input for the FORGE Phase 2 native state model were compiled from hi...
Podgorney, R. Idaho National Laboratory
Jun 06, 2019
2 Resources
0 Stars
Publicly accessible

Nevada Play Fairway Steptoe Valley Geodatabase and Modeling Data

This package contains data and metadata for the 3d thermal model, well lithology logs, gravity grids and depth to basement inversions, play fairway modelling, and ArcGIS geodatabase resources. This project focused on defining geothermal play fairways and development of a detailed...
Faulds, J. Nevada Bureau of Mines and Geology
Aug 25, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Building a 3D Resistivity Model for Simulation and Survey Design of EM Measurements

The included report outlines the creation of three 3D resistivity models that will be used to determine the sensitivity of EM measurements for the hypothetical stimulated reservoir at FORGE as well as for EM survey design. FORGE project 3-2535 is planning on using a casing source ...
Alumbaugh, D. et al Lawrence Berkeley National Laboratory
Dec 01, 2022
5 Resources
0 Stars
Publicly accessible

Rare Earth Element Concentrations in Submarine Hydrothermal Fluids

Rare earth element concentrations in submarine hydrothermal fluids from Alarcon Rise, East Pacific Rise, REE concentrations in submarine hydrothermal fluids from Pescadero Basin, Gulf of California, and the Cleft vent field, southern Juan de Fuca Ridge. Data are not corrected to z...
Fowler, A. and Zierenberg, R. University of California
Oct 27, 2017
3 Resources
0 Stars
Publicly accessible

3D Model of the McGinness Hills Geothermal Area

The McGinness Hills geothermal system lies in a ~8.5 km wide, north-northeast trending accommodation zone defined by east-dipping normal faults bounding the Toiyabe Range to the west and west-dipping normal faults bounding the Simpson Park Mountains to the east. Within this broad ...
E. Faulds, J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Earth Model Datasets

The EGS Collab Project performed a series of tests to increase the understanding the response of crystalline rock mass to stimulations and fluid circulation to efficiently implement enhanced geothermal systems (EGS) technologies. The EGS Collab team created two underground testbed...
Neupane, G. et al Idaho National Laboratory
May 29, 2022
6 Resources
0 Stars
Publicly accessible

Oilwell Conversion (Well API 121913310501) to Geothermal Heat Storage Well for Flexible Electricity Storage

Geothermal growth is limited by a lack of geographically dispersed high-temperature thermal resources and high initial upfront investment in characterization and well construction. This project intended to address the challenges of energy supply intermittency and enhance grid resi...
Malkewicz, N. et al University of Illinois
May 05, 2021
8 Resources
0 Stars
Publicly accessible
<< Previous45678910111213Next >>