Search OEDI Data

Admiralty Inlet Hub-Height Turbulence Measurements from June 2012

This data is from measurements at Admiralty Head, in Admiralty Inlet. The measurements were made using an IMU equipped ADV mounted on a mooring, the 'Tidal Turbulence Mooring' or 'TTM'. The inertial measurements from the IMU allows for removal of mooring motion in post processing....

Kilcher, L. National Renewable Energy Laboratory

Jun 18, 2012
7 Resources
0 Stars
Publicly accessible

WEC Controls Optimization Final Report

The over-arching project objective is to fully develop and validate optimal controls frameworks that can subsequently be applied widely to different WEC devices and concepts. Optimal controls of WEC devices represent a fundamental building block for WEC designers that must be cons...

Previsic, M. and Karthikeyan, A. Re Vision Consulting

Aug 26, 2020
1 Resources
0 Stars
Publicly accessible

Spooling control design for flight optimization of tethered tidal kites

This submission includes three peer-reviewed (under review) papers from the researchers at North Carolina State University presenting different control-based techniques to maximize the efficiency and robustness of a tethered energy-harvesting kite. Below are the abstracts of each ...

Daniels, J. et al North Carolina State University

Sep 16, 2019
3 Resources
0 Stars
Publicly accessible

Northwest National Marine Renewable Energy Center, OR Project Plans

Plans for Northwest National Marine Renewable Energy Center (NNMREC) Project. Mobile Ocean Test Berth (MOTB) plans PMEC-SETS Plans

Hellin, D. Northwest National Marine Renewable Energy Center

Jun 29, 2016
20 Resources
0 Stars
Publicly accessible

StingRAY Updated WEC Risk Registers

Updated Risk Registers for major subsystems of the StingRAY WEC completed according to the methodology described in compliance with the DOE Risk Management Framework developed by NREL.

Rhinefrank, K. and Ondusko, M. Columbia Power Technologies, Inc.

Jun 27, 2018
17 Resources
0 Stars
Publicly accessible

StingRAY Failure Mode, Effects and Criticality Analysis: WEC Risk Registers

Analysis method to systematically identify all potential failure modes and their effects on the Stingray WEC system. This analysis is incorporated early in the development cycle such that the mitigation of the identified failure modes can be achieved cost effectively and efficient...

Rhinefrank, K. Columbia Power Technologies, Inc.

Jul 25, 2016
18 Resources
0 Stars
Publicly accessible

Ocean Thermal Energy Conversion (OTEC) Grid points with annual averages (HYCOM+NCODA)

This point shapefile contains the HYCOM+NCODA point locations used in the report. These grid points contain the annual average attribute values for ocean thermal energy conversion used in the report and analysis. Please see the full report for details on the data (chapter 2) and ...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Ocean Thermal Energy Conversion (OTEC) Plant Spacing Estimates

This shapefile represents estimated plant spacing distances. The estimates shown here were obtained considering the availability of cold water at a particular location based on two criteria, the deep-water velocities from HYCOM and a layer-depth constraint estimated from the gl...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Ocean Thermal Energy Conversion (OTEC) Sea Surface Temperature (Annual Average)

This shapefile represents annual average sea surface temperature recordings. The sea surface temperature is the temperature of the warm water source used by an OTEC plant. This is defined to be near the sea surface at a depth of 20 m, the approximate depth of a warm water intak...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Ocean Thermal Energy Conversion (OTEC) Sea Surface Temperature (Summer Average)

This shapefile represents seasonal summer average sea surface temperature recordings. The sea surface temperature is the temperature of the warm water source used by an OTEC plant. This is defined to be near the sea surface at a depth of 20 m, the approximate depth of a warm wa...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Ocean Thermal Energy Conversion (OTEC) Sea Surface Temperature (Winter Average)

This shapefile represents seasonal winter average sea surface temperature recordings. The sea surface temperature is the temperature of the warm water source used by an OTEC plant. This is defined to be near the sea surface at a depth of 20 m, the approximate depth of a warm wa...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Ocean Thermal Energy Conversion (OTEC) Cold Water Depth (Annual Average)

This shapefile represents annual average cold water depth recordings. The cold water is defined by locating the depth that leads to the greatest average annual net power at each location when depth and its corresponding ?T are input into the power equation. This optimization ba...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Ocean Thermal Energy Conversion (OTEC) Cold Water Depth (Summer Average)

This shapefile represents seasonal summer average cold water depth recordings. The cold water is defined by locating the depth that leads to the greatest average annual net power at each location when depth and its corresponding ΔT are input into the power equation. This optim...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Ocean Thermal Energy Conversion (OTEC) Cold Water Depth (Winter Average)

This shapefile represents seasonal winter average cold water depth recordings. The cold water is defined by locating the depth that leads to the greatest average annual net power at each location when depth and its corresponding ΔT are input into the power equation. This optim...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Ocean Thermal Energy Conversion (OTEC) delta T (Annual Average)

This shapefile represents annual average delta T estimates. ΔT represents the difference in temperature (°C) between the warm and cold water sources used by an OTEC plant at a specific location. Warm water is defined uniformly as water at a depth of 20 m, while cold water is ...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Ocean Thermal Energy Conversion (OTEC) delta T (Summer Average)

This shapefile represents seasonal summer average delta T estimates. ΔT represents the difference in temperature (°C) between the warm and cold water sources used by an OTEC plant at a specific location. Warm water is defined uniformly as water at a depth of 20 m, while cold ...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Triton Field Trials (TFiT) underwater noise University of New Hampshire Living Bridge turbine Processed Data

In July 2021, a commercial-off-the-shelf hydrophone was deployed in a free-drifting configuration to measure underwater acoustic emissions and characterize a 25 kW-rated tidal turbine at the University of New Hampshire's Living Bridge Project in Portsmouth, New Hampshire. Sampling...

Haxel, J. et al Pacific Northwest National Laboratory

Jul 21, 2021
6 Resources
0 Stars
Publicly accessible

Reference Model 1 Scaled Geometry (RM1: Tidal Current Turbine)

Contains the Reference Model 1 (RM1) scaled scale geometry files of the Tidal Current Turbine, developed by the Reference Model Project (RMP). These scaled geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. The scaled RM1 devic...

Neary, V. and Hill, C. Sandia National Laboratories

Sep 30, 2014
8 Resources
0 Stars
Publicly accessible

Reference Model 1 Full Scale Geometry (RM1: Tidal Current Turbine)

Contains the Reference Model 1 (RM1) full scale geometry files of the Tidal Current Turbine, developed by the Reference Model Project (RMP). These full scale geometry files are saved as SolidWorks assembly, X_T, IGS, and STEP files, and require a CAD program to view. This data was...

Neary, V. et al Sandia National Laboratories

Sep 30, 2014
7 Resources
0 Stars
Publicly accessible

UNH TDP Concurrent Measurements of Inflow, Power Performance, and Loads for a Grid-Synchronized Vertical Axis Cross-Flow Turbine Operating in a Tidal Estuary

This data was collected between October 12 and December 15 of 2021 at the University of New Hampshire (UNH) and Atlantic Marine Energy Center (AMEC) turbine deployment platform (TDP). This data set includes over 29 days of grid connected turbine operation during this 65 day time f...

Wosnik, M. et al National Renewable Energy Laboratory

Dec 21, 2021
30 Resources
0 Stars
Publicly accessible

Admiralty Inlet Advanced Turbulence Measurements: May 2015

This data is from measurements at Admiralty Head, in Admiralty Inlet (Puget Sound) in May of 2015. The measurements were made using Inertial Motion Unit (IMU) equipped ADVs mounted on a 'StableMoor' (Manufacturer: DeepWater Buoyancy) buoy and a Tidal Turbulence Mooring (TTM). Thes...

Kilcher, L. National Renewable Energy Laboratory

May 18, 2015
18 Resources
0 Stars
Publicly accessible

BOBr Processed Breaking Wave Data, Agate Beach, OR

This data was recorded by the BOBr (Buoy to Observe Breaking) off the coast of Newport, OR at Agate Beach in the surf zone. The data was recorded by a 9dof inertial measurement unit and consists of a timestamp, quaternion orientation, acceleration vector, rotation vector, and mag...

C, A. Oregon State University

Oct 31, 2013
17 Resources
0 Stars
Publicly accessible

Admiralty Inlet Advanced Turbulence Measurements: June 2014

This data is from measurements at Admiralty Head, in Admiralty Inlet (Puget Sound) in June of 2014. The measurements were made using Inertial Motion Unit (IMU) equipped ADVs mounted on Tidal Turbulence Mooring's (TTMs). The TTM positions the ADV head above the seafloor to make mid...

Kilcher, L. National Renewable Energy Laboratory

Jun 30, 2014
26 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5