Search OEDI Data

Showing results 76 - 100 of 136.
Show results per page.
Order by:
Available Now:
Clear All Filters ×
Research Areas
Accessibility
Data Type
Organization
Source
"Utah seismic"×
Website×

Utah FORGE 3-2535: Modeling Studies of Energized Steel-Casing Source EM Method for Detecting Stimulated Zone

Numerical modeling Studies for electromagnetic (EM) Data Acquisition Survey Design this milestone report describes the 3D modeling studies of energized steel-casing source electromagnetic method for detecting stimulated zone at the Utah FORGE Site. FORGE project 3-2535 is planning...
Um, E. et al Lawrence Berkeley National Laboratory
Feb 06, 2023
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Triaxial Direct Shear Results

This submission contains a report and associated data from triaxial direct shear tests conducted by Los Alamos National Laboratory. The samples used were sourced from 16A(78)-32 well core. The primary objectives of this test were to determine the shear strength in both intact an...
Frash, L. et al Los Alamos National Laboratory
Aug 14, 2023
2 Resources
0 Stars
Publicly accessible

STRESSINVERSE Software for Stress Inversion

The STRESSINVERSE code uses an iterative method to find the nodal planes most consistent with the stress field given fault frictional properties. STRESINVERSE inverts the strike, rake and dip from moment tensor solutions for the in-situ state of stress. The code iteratively solves...
Gritto, R. Array Information Technology
Oct 31, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Building a 3D Resistivity Model for Simulation and Survey Design of EM Measurements

The included report outlines the creation of three 3D resistivity models that will be used to determine the sensitivity of EM measurements for the hypothetical stimulated reservoir at FORGE as well as for EM survey design. FORGE project 3-2535 is planning on using a casing source ...
Alumbaugh, D. et al Lawrence Berkeley National Laboratory
Dec 01, 2022
5 Resources
0 Stars
Publicly accessible

Appalachian Basin Play Fairway Analysis: Revised 2016 Combined Risk Factor Analysis

This submission contains information used to compute the combined risk factors for deep geothermal energy opportunities in the Appalachian Basin, in the context of a the Play Fairway Analysis project. The risk factors are sedimentary rock reservoir quality, thermal resource qualit...
E., T. Cornell University
Nov 15, 2016
2 Resources
0 Stars
Publicly accessible

Fallon FORGE: Geophysics and Geochemistry

The data is associated to the Fallon FORGE project and includes mudlogs for all wells used to characterize the subsurface, as wells as gravity, magnetotelluric, earthquake seismicity, and temperature data from the Navy GPO and Ormat. Also included are geologic maps from the USGS a...
Blankenship, D. Sandia National Laboratories
May 23, 2016
5 Resources
0 Stars
Publicly accessible

Imperial Valley Dark Fiber Project Continuous DAS Data

The Imperial Valley Dark Fiber Project acquired Distributed Acoustic Sensing (DAS) seismic data on a ~28 km segment of dark fiber between the cities of Calipatria and Imperial in the Imperial Valley, Southern California. Dark fiber refers to unused optical fiber cables in telecomm...
Ajo-Franklin, J. et al Lawrence Berkeley National Laboratory
Nov 10, 2020
4 Resources
0 Stars
Publicly accessible

Solar Resource and Meteorological Assessment Project (SOLRMAP): Rotating Shadowband Radiometer (RSR) Data for Cedar City, Utah

The U.S. Department of Energy's National Renewable Energy Laboratory collaborates with the solar industry to establish high quality solar and meteorological measurements. This Solar Resource and Meteorological Assessment Project (SOLRMAP) provides high quality measurements to supp...
Wilcox and AndreasNational Renewable Energy Laboratory
Dec 17, 2014
2 Resources
0 Stars
Publicly accessible

Utah FORGE: InSAR Data from 2022

Interferometric Synthetic Aperture Radar data from the TerraSAR-X and the TanDEM-X satellite missions operated by the German Space Agency (DLR). Interferometric pairs (interferograms) were created using generic mapping tool GMT-SAR processing software (see link in Resources). Data...
Batzli, S. and Feigl, K. University of Wisconsin
Nov 30, 2022
9 Resources
0 Stars
Publicly accessible

Utah FORGE 2439: Machine Learning for Well 16A(78)-32 Stress Predictions September 2023 Report

This task completion report documents the development and implementation of machine learning (ML) models for the prediction of in-situ vertical (Sv), minimum horizontal (SHmin) and maximum horizontal (SHmax) stresses in well 16A(78)-32. The detailed description of the experimental...
Mustafa, A. et al Battelle Memorial Institute
Sep 28, 2023
3 Resources
0 Stars
Publicly accessible

Utah FORGE: InSAR Data from 2021

Interferometric Synthetic Aperture Radar data from the TerraSAR-X and the TanDEM-X satellite missions operated by the German Space Agency (DLR). Interferometric pairs (interferograms) were created using generic mapping tool GMT-SAR processing software (see link in Resources). Data...
Batzli, S. and Feigl, K. University of Wisconsin
Nov 30, 2021
9 Resources
0 Stars
Publicly accessible

Utah FORGE: InSAR Data from 2020

Interferometric Synthetic Aperture Radar data from the TerraSAR-X and the TanDEM-X satellite missions operated by the German Space Agency (DLR). Interferometric pairs (interferograms) were created using generic mapping tool GMT-SAR processing software (see link in Resources). Data...
Batzli, S. and Feigl, K. University of Wisconsin
Dec 24, 2020
9 Resources
0 Stars
Publicly accessible

Solar Resource and Meteorological Assessment Project (SOLRMAP): Rotating Shadowband Radiometer (RSR) Data for Milford, Utah

The U.S. Department of Energy's National Renewable Energy Laboratory collaborates with the solar industry to establish high quality solar and meteorological measurements. This Solar Resource and Meteorological Assessment Project (SOLRMAP) provides high quality measurements to supp...
Wilcox and AndreasNational Renewable Energy Laboratory
Dec 17, 2014
2 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2439v2: Report on Predicting Far-Field Stresses Using Finite Element Modeling and Near-Wellbore Machine Learning for Well 16A(78)-32

This report presents the far-field stress predictions at two locations along the vertical section of Utah FORGE Well 16A (78)-32 using a physics-based thermo-poro-mechanical model. Three principal stresses in far-field were obtained by solving an inverse problem based on the near-...
Lu, G. et al University of Pittsburgh
Aug 30, 2024
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Sanvean Technologies Drilling Data from Well 16B(78)-32

Included here is Sanvean Technologies bit sensor data amalgamated with data from National Oilwell Varco's (NOV) BlackBox tool for Reed Hycalog bits used during drilling of Well 16B(78)-32. The dataset contains information collected at the bit while drilling including rate of penet...
Barker, C. Energy and Geoscience Institute at the University of Utah
Oct 26, 2023
5 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Continuous Broadband Seismic Waveform Data

Two broadband seismometers were installed on the 4100 level and recorded for the duration of EGS Collab Experiment #2. Inspired by published data from similar instruments installed in the Aspo Hard Rock Lab, these long-period instruments aimed to measure the tilting of the drift i...
Rodriguez Tribaldos, V. Lawrence Berkeley National Laboratory
Sep 12, 2022
6 Resources
0 Stars
Publicly accessible

Sedimentary Geothermal Feasibility in Eastern Nevada and Millard County, Utah Well Databases

In order to gather data to assess sedimentary geothermal feasibility in Nevada and Utah, state oil and gas and geothermal databases were serached for well files and well logs. Well data from the Nevada Bureau of Mines and Geology oil and gas and geothermal databases was mined for ...
Taverna, N. National Renewable Energy Laboratory
Nov 30, 2019
12 Resources
0 Stars
Publicly accessible

Utah FORGE 2439: Well 16B(78)-32 Field-Test Data from Mini-Frac Tests

This submittal includes the field-test data collected during stress tests conducted in the Utah FORGE 16B(78)-32 wellbore to measure/characterize the stresses in the geothermal reservoir. The type of stress test performed is referred to as a mini-frac test or a micro-frac test. Th...
Kelley, M. et al Battelle Memorial Institute
Jul 02, 2023
4 Resources
0 Stars
Publicly accessible

Project Hotspot Petrology, Geochemistry and Stratigraphy of the Kimama core hole, Snake River Plain, Idaho

This submission contains links to two open source published papers on the Kimama core hole, Project Hotspot. "Volcanic stratigraphy and age model of the Kimama deep borehole (Project Hotspot)" Basalts erupted in the Snake River Plain of central Idaho and sampled in the Kimama dri...
Shervais, J. et al Utah State University
Mar 19, 2019
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Pump and Probe Test on an Intact Westerly Granite Sample

This dataset contains results from a pump and probe experiment conducted on an intact Westerly Granite sample with a diameter of 1 inch and a height of 1 3/8 inches. The experiment was performed within an aluminum triaxial pressure vessel (TEMCO) to investigate the non-linear acou...
Klinghammer, H. et al Pennsylvania State University
May 21, 2024
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Pump and Probe Test on a Mated Fracture Westerly Granite Sample

This dataset contains results from a pump and probe experiment conducted on a mated fracture Westerly Granite sample with a diameter of 1 inch and a height of 2 7/8 inches. The experiment was performed within an aluminum triaxial pressure vessel (TEMCO) to investigate the non-line...
Klinghammer, H. et al Pennsylvania State University
May 19, 2024
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 1a Tensor Strainmeter Data for the April, 2022 Stimulation of Well 16A(78)-32

Data from two Tensor Optical Fiber Strainmeters that were operational during Stages 1, 2, and 3 of the April, 2022 stimulation of well 16A(78)-32. Each csv file contains data from each stimulation stage (stage1, stage2, stage3) for both Phase 1a strainmeter installations (FS01, f...
DeWolf, S. and Murdoch, L. Clemson University
Sep 15, 2022
8 Resources
0 Stars
Publicly accessible

Irradiation Data from NREL'S MDIC Stations

The Measurement and Instrumentation Data Center (MIDC) provides Irradiance and Meteorological Data from these stations: NREL Solar Radiation Research Lab, BSRN Prototype Station, Atmospheric Optical Calibration System, TSR-1, RSR Version 2, RSR Version 1, National Wind Technology...
Afshin, A. and Laboratory, N. National Renewable Energy Laboratory
Nov 25, 2014
1 Resources
0 Stars
In curation

Utah FORGE: Reports on Northwestern Nevada Well Doublet Drilling and Testing by Fervo Energy

These reports review Fervo Energy's construction of a commercial enhanced geothermal system (EGS). Fervo has qualified full functionality of the system through production testing at commercially relevant operating conditions. The project site is located in a nearfield setting ad...
Dadi, S. et al Fervo Energy
Sep 05, 2023
2 Resources
0 Stars
Publicly accessible

Conducting a 3D Converted Shear Wave Project to Reduce Exploration Risk at Wister, CA

2010 Peer Review of the 'Conducting a 3D Converted Shear Wave' Project to reduce exploration risk at Wister, CA. The presentation includes a timeline, budget, barriers, and partners. The objective of the project is also explained in the presentation.
Matlick, S. Ormat Nevada Inc
May 18, 2010
2 Resources
0 Stars
Publicly accessible
<< Previous123456Next >>