Search OEDI Data

State Estimation for advanced control of wave energy converters

A report on state estimation for advanced control of wave energy converters (WECs), with supporting data models and slides from the overview presentation. The methods discussed are intended for use to enable real-time closed loop control of WECs.

Coe, R. and Bacelli, G. Sandia National Laboratories

Apr 25, 2017
6 Resources
0 Stars
Publicly accessible

Feasibility of a Deep Direct-Use Geothermal System at the University of Illinois Urbana-Champaign

Paper authored by Stumpf et al. for the 2018 Geothermal Resources Council Annual Meeting held in Reno, NV USA. Included with the paper is the Microsoft PowerPoint presentation made at the GRC meeting and data tables associated with some of the figures.

Stumpf, A. et al University of Illinois

Dec 31, 2018
6 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 3 Magnetotelluric (MT) Data

New high-quality tensor MT data at 122 sites, including the vertical magnetic field and utilizing ultra-remote referencing, have been acquired over the Utah FORGE project area. The results will be used to delineate the densities of faults and fractures in crystalline basement rock...

Wannamaker, P. and Maris, V. Energy and Geoscience Institute at the University of Utah

Oct 01, 2020
5 Resources
0 Stars
Publicly accessible

Deep Direct-Use Feasibility Study Numerical Modeling and Uncertainty Analysis using iTOUGH2 for West Virginia University

To reduce the geothermal exploration risk, a feasibility study is performed for a deep direct-use system proposed at the West Virginia University (WVU) Morgantown campus. This study applies numerical simulations to investigate reservoir impedance and thermal production. Because of...

Garapati, N. et al West Virginia University

Dec 20, 2019
13 Resources
0 Stars
Publicly accessible

RANS Simulation RRF of Single Full Scale DOE RM1 MHK Turbine

Attached are the .cas and .dat files for the Reynolds Averaged Navier-Stokes (RANS) simulation of a single full scale DOE RM1 turbine implemented in ANSYS FLUENT CFD-package. In this case study taking advantage of the symmetry of the DOE RM1 geometry, only half of the geometry i...

Javaherchi, T. et al University of Washington

Apr 10, 2013
2 Resources
0 Stars
Publicly accessible

Applications of Fractured Continuum Model to Enhanced Geothermal System Heat Extraction Problems

This paper describes the applications of the fractured continuum model to the different enhanced geothermal systems reservoir conditions. The capability of the fractured continuum model to generate fracture characteristics expected in enhanced geothermal systems reservoir environm...

Kalinina, E. et al Sandia National Laboratories

May 06, 2014
1 Resources
0 Stars
Publicly accessible

Fallon FORGE: Distinct Element Reservoir Modeling

Archive containing input/output data for distinct element reservoir modeling for Fallon FORGE. Models created using 3DEC, InSite, and in-house Python algorithms (ITASCA). List of archived files follows; please see 'Modeling Metadata.pdf' (included as a resource below) for addition...

Blankenship, D. et al Sandia National Laboratories

Mar 12, 2018
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Common Discrete Fracture Network

This package includes data and models that support hydraulic fracture stimulation and fluid circulation experiments in the Sanford Underground Research Facility (SURF). A paper by Schwering et al. (2020) describes the deterministic basis for developing a "common" discrete fracture...

Schwering, P. et al Sandia National Laboratories

Sep 18, 2019
4 Resources
0 Stars
Publicly accessible

RANS Simulation ADM of the NREL Phase VI wind turbine modeled as MHK Turbine

Attached are the .cas and .dat files for the Reynolds Averaged Navier-Stokes (RANS) simulation of a single lab-scaled DOE RM1 turbine implemented in ANSYS FLUENT CFD-package. In this case study the flow field around and in the wake of the NREL Phase VI wind turbine, modeled is MH...

Javaherchi, T. University of Washington

Jun 08, 2016
3 Resources
0 Stars
Publicly accessible

Modeling and Performance Data for Heaving Buoy Wave Energy Converter with a Compressible Degree of Freedom (CDOF)

Modeling and performance data in Matlab data file (.mat) containing 3 structures (WEC model, simRes_sr and simRes_fix), and a pdf document describing the model, the simulations, and the analysis that has been carried out.

Bacelli, G. Sandia National Laboratories

Sep 28, 2016
2 Resources
0 Stars
Publicly accessible

Approaches to 30% Energy Savings at the Community Scale in the Hot-Humid Climate

The Building America Partnership for Improved Residential Construction, formerly the Building America Industrialized Housing Partnership, has worked with several community-scale builders within the hot-humid climate zone to improve performance of production-, or community-scale, h...

Beal, D. et al University of Central Florida Florida Solar Energy Center

Apr 27, 2016
9 Resources
0 Stars
Publicly accessible

Utah FORGE: 3D Gravity Data

These resources describe the 3D geophysical inversion modeling of gravity data at the FORGE site near Milford, Utah. FORGE is the Frontier Observatory for Research in Geothermal Energy and the site in Utah has been selected by the U.S. Dept. of Energy for a 5-year R&D program to t...

Hardwick, C. and Witter, J. Energy and Geoscience Institute at the University of Utah

Jun 24, 2019
2 Resources
0 Stars
Publicly accessible

Utah FORGE Project 3-2535: Building a 3D Resistivity Model for Simulation and Survey Design of EM Measurements

The included report outlines the creation of three 3D resistivity models that will be used to determine the sensitivity of EM measurements for the hypothetical stimulated reservoir at FORGE as well as for EM survey design. FORGE project 3-2535 is planning on using a casing source ...

Alumbaugh, D. et al Lawrence Berkeley National Laboratory

Dec 01, 2022
5 Resources
0 Stars
Publicly accessible

Geothermal Technologies Program GETEM and LCOE Improvements Review (March 21, 2013)

This file was a report submitted to GTO by Mark Paster, a consultant to the GETEM project, to outline the improvements that were made between summer 2011 and spring 2013. The report focuses on six areas of model improvement: (1) Site Specific Cost Variability; (2) Consistency wi...

Paster, M. Idaho National Laboratory

Mar 21, 2013
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Earth Model Datasets

The EGS Collab Project performed a series of tests to increase the understanding the response of crystalline rock mass to stimulations and fluid circulation to efficiently implement enhanced geothermal systems (EGS) technologies. The EGS Collab team created two underground testbed...

Neupane, G. et al Idaho National Laboratory

May 29, 2022
6 Resources
0 Stars
Publicly accessible

Advanced WEC Dynamics and Controls, Test 1

Numerous studies have shown that advanced control of a wave energy converter's (WEC's) power take off (PTO) can provide significant increases (on the order of 200-300%) in WEC energy absorption. Transitioning these control approaches from simplified paper studies to application in...

Coe, R. Sandia National Laboratories

Feb 26, 2016
3 Resources
0 Stars
Publicly accessible

Dynamically Downscaled Hourly Future Weather Data with 12-km Resolution Covering Most of North America

This is an hourly future weather dataset for energy modeling applications. The dataset is primarily based on the output of a regional climate model (RCM), i.e., the Weather Research and Forecasting (WRF) model version 3.3.1. The WRF simulations are driven by the output of a genera...

Zeng, Z. et al Argonne National Laboratory

Oct 03, 2023
4 Resources
0 Stars
Curated

Coupling Subsurface and Above-Surface Models for Optimizing the Design of Borefields and District Heating and Cooling Systems

Accurate dynamic energy simulation is important for the design and sizing of district heating and cooling systems with geothermal heat exchange for seasonal energy storage. Current modeling approaches in building and district energy simulation tools typically consider heat conduct...

Hu, J. et al Lawrence Berkeley National Laboratory

Jan 31, 2022
10 Resources
0 Stars
Publicly accessible

Microhole Tubing Bending Report

A downhole tubing bending study was made and is reported herein. It contains a report and 2 excel spreadsheets to calculate tubing bending and to estimate contact points of the tubing to the drilled hole wall (creating a new support point).

Ruan, C. Impact Technologies LLC

Jan 01, 2012
3 Resources
0 Stars
Publicly accessible

Aquantis 2.5 MW Ocean Current Generation Device Scaled Tank Test Design and Results

Aquantis 2.5 MW Ocean Current Generation Device, Tow Tank Dynamic Rig Structural Analysis Results. This is the detailed documentation for scaled device testing in a tow tank, including models, drawings, presentations, cost of energy analysis, and structural analysis. This datase...

Swales, H. et al Dehlsen Associates, LLC

Jun 03, 2015
46 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Baseline Cross-well Seismic

As part of the geophysical characterization suite for the first EGS Collab tesbed, here are the baseline cross-well seismic data and resultant models. The campaign seismic data have been organized, concatenated with geometry and compressional (P-) & and shear (S-) wave picks, and ...

Schwering, P. et al Sandia National Laboratories

Apr 30, 2018
9 Resources
0 Stars
Publicly accessible

REopt Lite Geothermal Heat Pump Design Requirements

This document describes the design requirements for the geothermal heat pump (GHP) module being added to the existing REopt Lite web tool. This document describes the purpose, users, and functional requirements to which the modified web tool shall conform. This document will be re...

Olis, D. National Renewable Energy Laboratory

Mar 08, 2021
6 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: 3D Seismic Velocity Model and Updated Microseismic Catalog Using Transfer-Learning Aided Double-Difference Tomography

This package contains a 3D Seismic velocity model and an updated microseismic catalog associated with a proceedings paper (Chai et al., 2020) published in the 45th Workshop on Geothermal Reservoir Engineering. The 3D_seismic_velocity_model text file contains x (m), y(m), z(m), P-w...

Chai, C. et al Oak Ridge National Laboratory

Apr 20, 2020
7 Resources
0 Stars
Publicly accessible

Simulating Complex Fracture Systems in Geothermal Reservoirs Using an Explicitly Coupled Hydro-Geomechanical Model

Low permeability geothermal reservoirs can be stimulated by hydraulic fracturing to create Enhanced (or Engineered) Geothermal Systems (EGS) with higher permeability and improved heat transfer to increase heat production. In this paper, we document our effort to develop a numerica...

Carrigan, C. et al Lawrence Livermore National Laboratory

Jan 01, 2011
2 Resources
0 Stars
Publicly accessible

Deep Direct-Use Feasibility Study Development of 3-D Structural Surface Model for the Tuscarora Sandstone, Morgantown, WV

This dataset contains grid files for subsurface maps created in GES interpretation software and exported as Zmap formated grid files. Depth values in SSTVD (subsea true vertical depth). The methods used for analysis and a detailed discussion of the results are presented in a paper...

McCleery, R. et al West Virginia University

Dec 19, 2019
3 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 6 7 8 Next >>