Search OEDI Data

Utah FORGE 2-2439v2: Report on Predicting Far-Field Stresses Using Finite Element Modeling and Near-Wellbore Machine Learning for Well 16A(78)-32

This report presents the far-field stress predictions at two locations along the vertical section of Utah FORGE Well 16A (78)-32 using a physics-based thermo-poro-mechanical model. Three principal stresses in far-field were obtained by solving an inverse problem based on the near-...

Lu, G. et al University of Pittsburgh

Aug 30, 2024
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Sanvean Technologies Drilling Data from Well 16B(78)-32

Included here is Sanvean Technologies bit sensor data amalgamated with data from National Oilwell Varco's (NOV) BlackBox tool for Reed Hycalog bits used during drilling of Well 16B(78)-32. The dataset contains information collected at the bit while drilling including rate of penet...

Barker, C. Energy and Geoscience Institute at the University of Utah

Oct 26, 2023
5 Resources
0 Stars
Publicly accessible

2020 Annual Technology Baseline (ATB) Cost and Performance Data for Transportation Technologies

The 2020 Transportation Annual Technology Baseline (ATB) provides detailed cost and performance data, estimates, and assumptions for vehicle and fuel technologies in the United States. The Transportation ATB includes current and projected estimates through 2050 for light-duty vehi...

Jadun. . et al National Renewable Energy Laboratory

Aug 22, 2020
5 Resources
0 Stars
Publicly accessible

Model and experimental validation of ocean kite dynamics and controls

This submission includes two peer-reviewed papers from researchers at North Carolina State University presenting the modeling and lab-scale experimentation of the dynamics and control of a tethered tidal ocean kite. Below are the abstracts of each file included in the submission. ...

Vermillion, C. et al North Carolina State University

Mar 01, 2020
2 Resources
0 Stars
Publicly accessible

WEC Controls Optimization Final Report

The over-arching project objective is to fully develop and validate optimal controls frameworks that can subsequently be applied widely to different WEC devices and concepts. Optimal controls of WEC devices represent a fundamental building block for WEC designers that must be cons...

Previsic, M. and Karthikeyan, A. Re Vision Consulting

Aug 26, 2020
1 Resources
0 Stars
Publicly accessible

TidGen MHK Generator Composite Fatigue Analysis Procedure

A procedure was described for performing a fatigue analysis of composite foils for an MHK generator. The steps included generating load data, S-N (Stress versus Number of cycles to failure) diagrams through fatigue testing, cycle counts, damage versus load, and cumulative damage. ...

Krumpe, A. ORPC Inc.

Apr 14, 2020
2 Resources
0 Stars
Publicly accessible

Comparative Performance of Four Prototype Mechanical Building Cooling Systems in a Desert Climate

Data and result of approximately fifteen months of monitoring of four houses located in the desert climate of Borrego Springs, California. Four houses were constructed using identical floor plans but differing wall materials, and different cooling systems that were designed to red...

Springer, D. et al Davis Energy

Jul 20, 2016
9 Resources
0 Stars
Publicly accessible

Control-based optimization for tethered tidal kite

This submission includes three peer-reviewed (under review) papers from the researchers at North Carolina State University presenting control-based techniques to maximize effectiveness of a tethered tidal kite. Below are the abstracts of each file included in the submission. Cobb...

Vermillion, C. et al North Carolina State University

Mar 02, 2020
3 Resources
0 Stars
Publicly accessible

Greenbuilt Construction Energy Efficiency Retrofit House Demonstration Sacramento

One of the homes that was part of Sacramento Municipal Utility District's (SMUD) Energy Efficiency Retrofit Demonstration (EERD) project was a 1980's era home in Fair Oaks, California, referred to as the Greenbuilt house, as Greenbuilt Construction completed the retrofit of the h...

Sparn, B. et al Mountain Energy Partnership

Aug 27, 2018
8 Resources
0 Stars
Publicly accessible

Advanced TidGen Power System Composites Structural Testing

Seawater aging response was investigated in marine-grade glass/epoxy, glass/vinyl ester, carbon/epoxy and carbon/vinyl ester composites with respect to water uptake, interlaminar shear strength, flexural strength, tensile strength, and tensile fracture surface observations. The re...

Krumpe, A. ORPC Inc.

Jan 06, 2020
2 Resources
0 Stars
Publicly accessible

MASK4 Test Campaign for Sandia WaveBot Device Dataset

This data and report details the findings from a wave tank test focused on production of useful work of a wave energy converter (WEC) device. The experimental system and test were specifically designed to validate models for power transmission throughout the WEC system. Additional...

Forbush, D. et al Sandia National Laboratories

Dec 25, 2023
5 Resources
0 Stars
Publicly accessible

LandRAY PTO Test Plans with NREL NWTC 5 MW Dynamometer

The overarching project objective is to demonstrate the feasibility of using an innovative PowerTake-Off (PTO) Module in Columbia Power's utility-scale wave energy converter (WEC). The PTO Module uniquely combines a large-diameter, direct-drive, rotary permanent magnet generator; ...

Prudell, J. et al Columbia Power Technologies, Inc.

Feb 29, 2016
5 Resources
0 Stars
Publicly accessible

ALFA Shared Autonomy Manipulation Data with a Seabotix vLBV300

This report outlines marine field demonstrations for manipulation tasks with a semi-Autonomous Underwater Vehicle (sAUV). The vehicle is built off a Seabotix vLBV300 platform with custom software interfacing it with the Robot Operating System (ROS). The vehicle utilizes an inertia...

Hollinger, G. and Lawrance, N. Oregon State University

Jun 19, 2017
2 Resources
0 Stars
Publicly accessible

TEAMER: AquaHarmonics High Fidelity WEC Sim PTO and Control Model Validation, Sim Model

Collaborative effort between AquaHarmonics, Sandia National Laboratories (SNL), and the National Renewable Energy Laboratory (NREL) to revise and validate Aquaharmonics' full wave to wire model, allowing for reduced uncertainty and increased understanding of design requirements of...

Tom, N. and Leon, J. AquaHarmonics, Inc.

Dec 31, 2021
6 Resources
0 Stars
Publicly accessible

Inputs and Outputs for "A Resource Adequacy Assessment of Correlated Wide-Area Outages in the Power Grid”

This readme describes the input and output files associated with the study “A Resource Adequacy Assessment of Correlated Wide-Area Outages in the Power Grid” (DOI: 10.1088/2753-3751/add465). Specifically, it contains both the inputs and outputs of Probabilistic Resource Adequa...

Dhulipala. . et al National Renewable Energy Laboratory

May 19, 2025
3 Resources
0 Stars
Publicly accessible

Silver Peak Innovative Exploration Project (Ram Power Inc.)

Data generated from the Silver Peak Innovative Exploration Project, in Esmeralda County, Nevada, encompasses a deep-circulation (amagmatic) meteoric-geothermal system circulating beneath basin-fill sediments locally blanketed with travertine in western Clayton Valley (lithium-rich...

Miller, C. Ram Power, Inc.

Jan 01, 2010
27 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Stage 1 Pressure Falloff Analysis

This is an analysis of the pressure falloff in stage 1 fracture stimulation of FORGE well 16A(78)-32. The objective of this research is to understand the information content of the well stimulation data of FORGE Well 16A(78)-32. The Stage 1 step-rate test, a variant of the classic...

Kazemi, H. et al Colorado School of Mines

Aug 04, 2022
1 Resources
0 Stars
Publicly accessible

TEAMER: OSU X Hinsdale & Sandia LUPA Uncertainty Testing

This processed data is from TEAMER testing through RFTS 7 at the O.H. Hinsdale Wave Research Laboratory in Corvallis, Oregon. This testing was conducted by Oregon State University (OSU) and Sandia National Laboratories in October and November 2023. The Laboratory Upgrade Point Abs...

Robertson, B. et al Oregon State University

Oct 19, 2023
6 Resources
0 Stars
Publicly accessible

MOIS LabVIEW Software

Software developed in LabVIEW for the Modular Ocean Instrumentation System (MOIS) is provided. Two documents: MOIS User's Guide and MOIS Software Developer's Guide are included in the submission.

Nelson, E. National Renewable Energy Laboratory

Dec 03, 2015
3 Resources
0 Stars
Publicly accessible

LCOE Baseline for RME Surge WEC Device

This submission includes all the data to support an LCOE baseline assessment for the Resolute Marine Energy (RME) Surge WEC device.

Previsic, M. et al Re Vision Consulting

Jul 19, 2017
4 Resources
0 Stars
Publicly accessible

Alum Innovative Exploration Project (Ram Power Inc.)

Data generated from the Alum Innovative Exploration Project, one of several promising geothermal properties located in the middle to upper Miocene (~11-5 Ma, or million years BP) Silver Peak-Lone Mountain metamorphic core complex (SPCC) of the Walker Lane structural belt in Esmera...

Miller, C. Ram Power, Inc.

Jan 01, 2010
14 Resources
0 Stars
Publicly accessible

Multi-Sensor Object Detection Data from Infrastructure Sensors Deployed at Traffic Intersections in the City of Colorado Springs, Colorado, USA

The dataset provided here was collected as a part of the US Department of Transportation (USDOT) Strengthening Mobility and Revolutionizing Transportation (SMART) project, where the City of Colorado Springs (Colorado, USA) and National Renewable Energy Laboratory (NREL) collaborat...

Sandhu. . et al National Renewable Energy Laboratory

Mar 11, 2025
6 Resources
0 Stars
Publicly accessible

Next Generation RivGen Power System: Feasibility Assessment of Hydroacoutics Data for Development of a Probability of Encounter Model of Salmon Smolts

This document contains a feasibility assessment for salmon smolt characterization and analysis based on existing hydroacoustics data and probability of encounter model.

Daroux, A. and Zydlewski, G. Igiugig Village Council

Oct 04, 2017
1 Resources
0 Stars
Publicly accessible

Mass Customization of Prefabricated Panel Blocks for Deep Wall Insulation Retrofits

The project this data comes from looks to make building wall retrofits less expensive and easier to install by using exterior insulating panels. This is done to make buildings more energy efficient without expensive wall retrofits or reconstruction. The "Measurement and Verificati...

Sharon, A. et al Fraunhofer Center for Manufacturing Innovation CMI

Dec 14, 2021
2 Resources
0 Stars
Publicly accessible

Deep Direct-Use Feasibility Study Numerical Modeling and Uncertainty Analysis using iTOUGH2 for West Virginia University

To reduce the geothermal exploration risk, a feasibility study is performed for a deep direct-use system proposed at the West Virginia University (WVU) Morgantown campus. This study applies numerical simulations to investigate reservoir impedance and thermal production. Because of...

Garapati, N. et al West Virginia University

Dec 20, 2019
13 Resources
0 Stars
Publicly accessible

<< Previous 6 7 8 9 10 11 12 13 14 15 Next >>