Search OEDI Data

Showing results 51 - 75 of 139.
Show results per page.
Order by:
Available Now:
Clear All Filters ×
Research Areas
Accessibility
Data Type
Organization
Source
"shear failure"×
Downloadable×

Fallon FORGE: Analogue Outcrop Samples

Compilation of results for mechanical and fluid flow properties of analogue outcrop samples experimental data for compressional and shear wave velocities, tensile strengths, and compressive strengths. Outcrop location and sample orientation data are documented in a separate csv file.
Blankenship, D. et al Sandia National Laboratories
Mar 12, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Core Material Friction Experiments

The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...
Marone, C. et al Pennsylvania State University
Mar 15, 2023
7 Resources
0 Stars
Publicly accessible

Utah FORGE 2439: Well 16B(78)-32 Field-Test Data from Mini-Frac Tests

This submittal includes the field-test data collected during stress tests conducted in the Utah FORGE 16B(78)-32 wellbore to measure/characterize the stresses in the geothermal reservoir. The type of stress test performed is referred to as a mini-frac test or a micro-frac test. Th...
Kelley, M. et al Battelle Memorial Institute
Jul 02, 2023
4 Resources
0 Stars
Publicly accessible

Water chemistry data and calculations for Fracture Sustainability Tests

Measured cation, anion, and silica are presented as well as calculations evaluating mass balance performed for 4 fracture sustainability tests under EGS conditions: Stripa granite, Metamudstone, Rhyolitic Ashflow Tuff, and Silicified Rhyolitic Tuff. Calculations of charge balance ...
Kneafsey, T. et al Lawrence Berkeley National Laboratory
Sep 30, 2020
2 Resources
0 Stars
Publicly accessible

TEAMER: Technical Support for Aquantis (Materials): CRD-21-17762-0

The Aquantis Tidal Power Tug is a unique synthesis of best-available technologies and materials configured as a novel spar vessel to create an optimal platform for tidal stream energy conversion. The Power Tug utilizes an upstream-facing horizontal, 2-bladed rotor. To drive down c...
Swales, H. et al Aquantis, Inc.
Oct 17, 2024
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: In-situ observation of pre-, co and post-seismic shear slip preceding hydraulic fracturing

Understanding the initiation and arrest of earthquakes is one of the long-standing challenges of seismology. Here we report on direct observations of borehole displacement by a meter-sized shear rupture induced by pressurization of metamorphic rock at 1.5 km depth. We observed the...
Guglielmi, Y. et al Lawrence Berkeley National Laboratory
May 22, 2018
2 Resources
0 Stars
Publicly accessible

Washington Play Fairway Analysis Analysis of High Precision GPS Time Series and Strain Rates for the Cascade Range

Global Positioning System (GPS) time series from the National Science Foundation (NSF) Earthscope's Plate Boundary Observatory (PBO) and Central Washington University's Pacific Northwest Geodetic Array (PANGA). GPS station velocities were used to infer strain rates using the "spli...
Swyer, M. AltaRock Energy Inc
Feb 22, 2015
2 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2419: Seismicity-Permeability Relationships Probed via Nonlinear Acoustic Imaging Workshop Presentation

This is a presentation on the Seismicity-Permeability Relationships Probed via Nonlinear Acoustic Imaging project by Pennsylvania State University, presented by Derek Elsworth. The project's objectives were to explore controls and acoustic signatures of aseismic through seismic e...
Elsworth, D. et al Pennsylvania State University
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Baseline Cross-well Seismic

As part of the geophysical characterization suite for the first EGS Collab tesbed, here are the baseline cross-well seismic data and resultant models. The campaign seismic data have been organized, concatenated with geometry and compressional (P-) & and shear (S-) wave picks, and ...
Schwering, P. et al Sandia National Laboratories
Apr 30, 2018
9 Resources
0 Stars
Publicly accessible

Fallon FORGE: Distinct Element Reservoir Modeling

Archive containing input/output data for distinct element reservoir modeling for Fallon FORGE. Models created using 3DEC, InSite, and in-house Python algorithms (ITASCA). List of archived files follows; please see 'Modeling Metadata.pdf' (included as a resource below) for addition...
Blankenship, D. et al Sandia National Laboratories
Mar 12, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE: 2019 ARMA Overview Slide Presentation

This is an overview presentation of the Utah FORGE project given by Joseph Moore, Ph.D., at the 2019 American Rock Mechanics Associate meeting. It details the state of the Utah FORGE project at on 8/17/2019.
Moore, J. Energy and Geoscience Institute at the University of Utah
Aug 17, 2019
1 Resources
0 Stars
Publicly accessible

Field Testing of an Unvented Roof with Fibrous Insulation, Tiles, and Vapor Diffusion Venting

BSC TO5 Task 2.5 Field Testing of an Un-vented Roof with Fibrous Insulation and Tiles Winter Park, FL 32789 Field test data available for wood moisture contents, temperature, and relative humidity. Un-vented roofs (aka cathedral-ized attics) are an established presence in Florida...
Ueno, K. and Lstiburek, J. Building Science Corporation
Apr 27, 2016
2 Resources
0 Stars
Publicly accessible

Advanced TidGen Power System Material Characterization Program

The TidGen Power System generates emission-free electricity from tidal currents and connects directly into existing grids using smart grid technology. The power system consists of three major subsystems: shore-side power electronics, mooring system, and turbine generator unit (TGU...
Marnagh, C. and McEntee, J. Ocean Renewable Power Company
Jun 14, 2018
2 Resources
0 Stars
Publicly accessible

Fallon FORGE: Lithology Logs and Well 21-31 Drilling Data

This submission includes lithology logs for all Fallon FORGE area wells; determined from core, cuttings, and thin section. Wells included are 84-31, 21-31, 82-36, FOH-3D, 62-36, 18-5, 88-24, 86-25, FOH-2, 14-36, 17-16, 34-33, 35A-11, 51A-20, 62-15, 72-7, 86-15, Carson_Strat_1_36-3...
Blankenship, D. et al Sandia National Laboratories
Mar 11, 2018
2 Resources
0 Stars
Publicly accessible

Laboratory Evaluation of EGS Shear Stimulation-Test 001

This is the results of an initial setup-shakedon test in order to develop the plumbing system for this test design. a cylinder of granite with offset holes was jacketed and subjected to confining pressure and low temperature (85C) and pore water pressure. Flow through the sample w...
Bauer, S. Sandia National Laboratories
Jul 29, 2014
1 Resources
0 Stars
Publicly accessible

SMP and Fracture Modeling

The problem of loss circulation in geothermal wells is inherently challenging due to high temperatures, brittle rocks, and presence of abundant fractures. Because of the inherent challenges in geothermal environments, there are limitations in selecting proper lost circulation mate...
Salehi, S. et al University of Oklahoma
Oct 01, 2021
4 Resources
0 Stars
Publicly accessible

SMP Preparation, Programming, and Characterization

The problem of loss circulation in geothermal wells is inherently challenging due to high temperatures, brittle rocks, and presence of abundant fractures. Because of the inherent challenges in geothermal environments, there are limitations in selecting proper lost circulation mate...
Salehi, S. et al University of Oklahoma
Oct 01, 2021
4 Resources
0 Stars
Publicly accessible

Triton-C Point Absorber Preliminary System Design Package

Preliminary System Design Package for the Triton-C WEC, including a report and CAD drawings pertaining to the overall preliminary design, system arrangement, surface float hull, and surface float arrangement.
Mundon, T. Oscilla Power, Inc.
Dec 01, 2017
4 Resources
0 Stars
Publicly accessible

Grain-Scale Failure in Thermal Spallation Drilling

Geothermal power promises clean, renewable, reliable and potentially widely-available energy, but is limited by high initial capital costs. New drilling technologies are required to make geothermal power financially competitive with other energy sources. One potential solution is ...
Walsh, S. et al Lawrence Livermore National Laboratory
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2557: Role of Fluid and Temperature in Fracture Mechanics and Couples THMC Processes for Enhanced Geothermal Systems 2024 Annual Workshop Presentation

This is a presentation on the Role of Fluid and Temperature in Fracture Mechanics and Couples THMC Processes for Enhanced Geothermal Systems by Purdue University, presented by Laura Pyrak-Nolte. This video slide presentation describes the development and validation of a macroscopi...
Pyrak-Nolte, L. Energy and Geoscience Institute at the University of Utah
Aug 13, 2024
1 Resources
0 Stars
Publicly accessible

M3 Wave DMP/APEX WEC Survival Test Report

This survival test report for the Delos-Reyes Morrow Pressure Device (DMP), commercialized by M3 Wave LLC as "APEX," summarizes the key tank test data, numerical model results, input test conditions (both numerical and tank testing), and crosses these items with three designs of t...
Morrow, M. and Delos-Reyes, M. M3 Wave
Aug 31, 2017
1 Resources
0 Stars
Publicly accessible

Illite Dissolution Rates and Equation (100 to 280 deg C)

The objective of this suite of experiments was to develop a useful kinetic dissolution expression for illite applicable over an expanded range of solution pH and temperature conditions representative of subsurface conditions in natural and/or engineered geothermal reservoirs. Usi...
Carroll, S. Lawrence Livermore National Laboratory
Oct 17, 2014
1 Resources
0 Stars
Publicly accessible

Fracture Sustainability Test, Pre and Post-Test Photomicrographs

The primary objective of this research is to understand how different rock types, mineral and fluid compositions, and fracture surface textures determine the longevity of fracture apertures, so that selection of reservoir rock can be economically optimized to reduce future refract...
Dobson, P. et al Lawrence Berkeley National Laboratory
Sep 26, 2016
9 Resources
0 Stars
Publicly accessible

Utah FORGE: Laboratory Experiments Examining the Effect of Thermal and Mechanical Processes on Hydraulic Transmissivity Evolution

Using laboratory slide-hold-slide experiments, at temperatures from 22 to 200 degrees C, to examine effects of fracture reactivation and quasi-static loading on the evolution of fluid transport properties of simulated fractures in Westerly granite. At all temperatures, the in-plan...
Lockner, D. et al United States Geological Survey
Apr 03, 2023
2 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2557: Fluid and Temperature in Fracture Mechanics and Coupled THMC Processes Workshop Presentation

This is a presentation on the Role of Fluid and Temperature in Fracture Mechanics and Coupled Thermo-Hydro-Mechanical-Chemical (THMC) Processes for Enhanced Geothermal Systems project by Purdue University, presented by Distinguished Professor of Physics & Astronomy, Laura J. Pyrak...
Pyrak-Nolte, L. Purdue University
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible
<< Previous123456Next >>