Search OEDI Data
Showing results 1 - 25 of 54.
Show
results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
Data Associated with "Mock Ink Development and Coating Processes Design for Proton Exchange Membrane Water Electrolyzer Anodes"
Data for "Mock Ink Development and Coating Processes Design for Proton Exchange Membrane Water Electrolyzer Anodes.” This work addresses the development of surrogate inks to reduce the cost of coating process development for more expensive iridium oxide inks. Rheological propert...
Iyer, R. et al National Laboratory of the Rockies
Oct 02, 2026
22 Resources
0 Stars
Publicly accessible
22 Resources
0 Stars
Publicly accessible
Microhole Test Data
Drilling results from the microhole project at the Sandia High Operating Temperature test facility. The project is seeking to help reduce the cost of exploration and monitoring of geothermal wells and formations by drilling smaller holes. The tests were part of a control algorith...
Su, J. Sandia National Laboratories
May 23, 2016
5 Resources
0 Stars
Publicly accessible
5 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 16B(78)-32 Cuttings X-Ray Diffraction Data
X-ray diffraction (XRD) results from cuttings samples collected during drilling of Utah FORGE well 16B(78)-32. The dataset includes XRD data for 77 samples taken between 3,120 and 10,977 feet measured depth (from the Kelly Bushing, 31 feet above ground level), with sampling interv...
Jones, C. Energy and Geoscience Institute at the University of Utah
Apr 20, 2025
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
WISE-CASING: Surface Seismic Survey at Cymric Field, California Central Valley
This test was conducted at the Chevron Cymric oilfield in the California central valley near Bakersfield. A reflected seismic signal was observed in all three components (x, y, z) of the 3-component Episensor geophone, as well as all phones on the single component array. The arriv...
Wu, Y. et al Lawrence Berkeley National Laboratory
Apr 02, 2018
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Specified System Requirements for the HydroAir Power Take Off System
Includes Annual Energy Production of the system, Target Availability of the system, the system's PWR (power to weight ratio), Critical Dimensions and Weights (e.g. center of gravity and center of buoyancy, capture length) of the system, the system's Noise Levels, and All Grid Requ...
Natanzi, S. and Hall, R. Siemens Government Technologies, Inc.
Oct 02, 2020
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Snake River Plain Geothermal Play Fairway Analysis Project Active Source Seismic Data
This archive contains seismic shot field records for 10 profiles located in Camas Prairie, Idaho. The eight numbered .sgy files were acquired using a seismic land streamer system with an accelerated weight drop source and 72 geophones. These 10-Hz geophones were mounted on base pl...
Liberty, L. and Shervais, J. Boise State University
Sep 30, 2018
21 Resources
0 Stars
Publicly accessible
21 Resources
0 Stars
Publicly accessible
StingRAY Structural Optimization Final Technical Report
The overall project objective is to materially decrease the leveled cost of energy (LCOE) of the Columbia Power (CPower) StingRAY utility-scale wave energy converter (WEC). This will be achieved by reducing structural material and manufacturing costs and increasing energy output. ...
Lenee-Bluhm, P. Columbia Power Technologies, Inc.
Aug 05, 2020
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
REE Adsorption Performance with Immobilized Caulobacter Biofilms
This submission includes data collected from experiments on the performance of rare earth adsorption by immobilized bacteria that accompany the FY18 Q2 and Q3 quarter reports. Relevant information from these reports is included in a resource below. The spreadsheet below includes d...
Jiao, Y. and Park, D. Lawrence Livermore National Laboratory
Apr 01, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Unified Field Study 5 (UFS-5)
The Unified Field Studies (UFS), established by the Algae Testbed Public-Private Partnership (ATP3), produced data on the effect of environmental and process conditions on algal growth rates and algal composition. The goal of the fifth Unified Field Study (UFS-5), performed Decemb...
Wolfrum, E. et al National Renewable Energy Laboratory
Sep 27, 2016
24 Resources
0 Stars
Publicly accessible
24 Resources
0 Stars
Publicly accessible
Unified Field Study 3 (UFS-3)
The Unified Field Studies (UFS), established by the Algae Testbed Public-Private Partnership (ATP3), produced data on the effect of environmental and process conditions on algal growth rates and algal composition. The goal of the third Unified Field Study (UFS-3), performed June t...
Wolfrum, E. et al National Renewable Energy Laboratory
Sep 29, 2016
24 Resources
0 Stars
Publicly accessible
24 Resources
0 Stars
Publicly accessible
Unified Field Study 4 (UFS-4)
The Unified Field Studies (UFS), established by the Algae Testbed Public-Private Partnership (ATP3), produced data on the effect of environmental and process conditions on algal growth rates and algal composition. The goal of the fourth Unified Field Study (UFS-4), performed Septe...
Wolfrum, E. et al National Renewable Energy Laboratory
Sep 27, 2016
24 Resources
0 Stars
Publicly accessible
24 Resources
0 Stars
Publicly accessible
Unified Field Study 6 (UFS-6)
The Unified Field Studies (UFS), established by the Algae Testbed Public-Private Partnership (ATP3), produced data on the effect of environmental and process conditions on algal growth rates and algal composition. The goal of the sixth Unified Field Study (UFS-6), performed March ...
Wolfrum, E. et al National Renewable Energy Laboratory
Oct 20, 2017
24 Resources
0 Stars
Publicly accessible
24 Resources
0 Stars
Publicly accessible
Utah FORGE: Drilling Data for Student Competition
Diagnostic drilling data (Pason log files) from Well 58-32 (previously labeled MU-ESW1), which was drilled near Milford Utah during Phase 2B of the FORGE Project to confirm geothermal reservoir characteristics met requirements for the final FORGE site. This dataset includes both ...
Podgorney, R. et al Idaho National Laboratory
Dec 07, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Ionic Fluids for EGS: Thermogravimetric Analysis of Ionic Liquids
This dataset contains non-isothermal thermogravimetric analysis (TGA) results for ten ionic liquids. The tests were performed using a TGA 5500 system under an air atmosphere, with platinum pans and a 10 Hz sampling rate. Each test includes multiple thermal segments, typically invo...
Akhtarmanesh, S. et al Oklahoma State University
Dec 14, 2023
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 16A(78)-32 X-ray Diffraction Data
This submission contains x-ray diffraction data taken from 3,600 to 10,987 feet deep in well 16A(78)-32 in the Roosevelt Hot Springs Geothermal Area as part of the Utah FORGE project. 78 rock samples were taken. Samples are taken in a range of ten feet at 100 foot increments. Mine...
Jones, C. Energy and Geoscience Institute at the University of Utah
Jul 29, 2021
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Unified Field Study 2 (UFS-2)
The Unified Field Studies (UFS), established by the Algae Testbed Public-Private Partnership (ATP3), produced data on the effect of environmental and process conditions on algal growth rates and algal composition. The goal of the second Unified Field Study (UFS-2), performed April...
Wolfrum, E. et al National Renewable Energy Laboratory
Sep 27, 2016
18 Resources
0 Stars
Publicly accessible
18 Resources
0 Stars
Publicly accessible
Unified Field Study 7 (UFS-7)
The Unified Field Studies (UFS), established by the Algae Testbed Public-Private Partnership (ATP3), produced data on the effect of environmental and process conditions on algal growth rates and algal composition. The goal of the seventh Unified Field Study (UFS-7), performed June...
Wolfrum, E. et al National Renewable Energy Laboratory
Oct 20, 2017
18 Resources
0 Stars
Publicly accessible
18 Resources
0 Stars
Publicly accessible
Microhole drilling technology utilizing a golden section search algorithm
A fundamental issue in microhole drilling is that delivering high weight-on-bit (WOB), high torque rotational horsepower to a conventional drill bit does not scale down to the hole sizes necessary to realize the envisioned cost savings An optimization algorithm called a golden sec...
Su, J. et al Sandia National Laboratories
Jun 23, 2021
7 Resources
0 Stars
Publicly accessible
7 Resources
0 Stars
Publicly accessible
Practices Maintain Straight Hole in Crooked Hole Conditions, While Also Enabling Significant Gains in Drill Rate
Bottom hole assembly (BHA) designs were assessed in field trials for their ability to achieve critical low inclination requirements, while simultaneously enabling high drill rates. Because angle has historically been controlled by reducing weight on bit (WOB), these are often com...
Knudsen, S. et al Sandia National Laboratories
Apr 30, 2014
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Unified Field Study 1 (UFS-1)
The Unified Field Studies (UFS), established by the Algae Testbed Public-Private Partnership (ATP3), produced data on the effect of environmental and process conditions on algal growth rates and algal composition. The goal of the UFS-1 experiment, performed October to December 201...
Wolfrum, E. et al National Renewable Energy Laboratory
Sep 27, 2016
16 Resources
0 Stars
Publicly accessible
16 Resources
0 Stars
Publicly accessible
HydroAir Power Take Off Combined Design Report
The submission is the combined design report for the HydroAir Power Take Off (PTO). CAD drawings, circuit diagrams, design report, test plan, technical specifications and data sheets are included for the Main and auxiliary control cabinets and three-phase-synchronous-motor with a ...
Pearson, G. et al Dresser-Rand Company
Jun 26, 2015
15 Resources
0 Stars
Publicly accessible
15 Resources
0 Stars
Publicly accessible
Design Specifications for Manufacturer for the HydroAir Power Take Off System
Includes Design Specs for Manufacturer, PTO Weight, PTO Dimensions, Turbine (Rotor and Ductwork) Design, CAD Drawings of the turbine and rotor, List of components and weights, Materials Used, Generator, List of components and weights, Structural Design, CAD drawings of the structu...
Natanzi, S. and Hall, R. Siemens Government Technologies, Inc.
Oct 02, 2020
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 56-32 Drilling Data and Logs
This dataset consists of drilling data (Pason data spreadsheets, daily reports, days v. depth, mud logs), Schlumberger logs (FMI, shear anisotropy analysis, memory, sonic, array induction/spectral density/dual spaced neutron/gamma ray/caliper, spectral GR/temperature, and Gardner ...
Bristol, J. et al Energy and Geoscience Institute at the University of Utah
Mar 19, 2021
18 Resources
0 Stars
Publicly accessible
18 Resources
0 Stars
Publicly accessible
Play Fairway Analysis CA-NV-OR: 2km Grid Based Analysis
Combined geochemical and geophysical data, weighted and ranked for geothermal prospect favorability.
M, C. University of California
Aug 20, 2015
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Direct-Drive Electrical Generator and PTO System for Flap-type Wave Energy Converters
Project and generator specifications and initial prototype test data for flap-type wave energy converters (WEC)
Englebretson, S. ABB Inc.
Mar 20, 2015
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible