Search OEDI Data

Showing results 1 - 25 of 171.
Show results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
"stress roughness"×

Utah FORGE 2-2446: Characterizing Stress Roughness Through Simulation of Hydraulic Fracture Growth

This dataset covers work that investigated the apparent toughness anisotropy at Utah FORGE by comparing microseismic data with stress profiles from field measurements. The study analyzes the hydraulic fracture growth of Stage 3 at Well 16A(78)-32 using MEQ data, calibrating a nume...
Cusini, M. and Fei, F. Lawrence Livermore National Laboratory
Jan 30, 2025
3 Resources
0 Stars
Publicly accessible

Utah FORGE: Triaxial Direct Shear Results February 2025

This dataset contains results from nine triaxial direct shear tests conducted by Los Alamos National Laboratory on samples from FORGE Well 16A(78)-32. The primary objectives of this work were to determine the shear strength in both intact and residual states, evaluate dilation aga...
Frash, L. et al Los Alamos National Laboratory
Feb 28, 2025
1 Resources
0 Stars
Publicly accessible

Owner Reports Airfoil Performance Degradation due to Roughness and Leading-edge Erosion, data and plots Raw Data

**Overview** Airfoil Performance Degradation due to Roughness and Leading-edge Erosion. The zip file contains analysis, charts, and photos.
Maniaci, D. and White, E. Wind Energy Technologies Office (WETO)
Jul 27, 2017
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Fault Shear Reactivation Experimental Data for Fluid Injection-Rate Controls on Seismic Moment

Included are experimental data recorded from shear experiments that specifically explore the link between fluid-injection rate and seismic moment resulting from shear reactivation of laboratory faults. Raw mechanical data from three experiments are included alongside corresponding...
Roseboom, M. et al Pennsylvania State University
Nov 07, 2023
6 Resources
0 Stars
Publicly accessible

ALFA Biological Monitoring Density Values South Energy Test Site, Newport, Oregon

Density values from active acoustic measurements at South Energy Test Site. This data correspond to a bottom mounted upward-looking WBAT, deployed from April 19th to September 30th. Samples (175 pings) were collected hourly at 1Hz.
Horne, J. Northwest National Marine Renewable Energy Center
Apr 11, 2017
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Stress Logging Data

This spreadsheet consist of data and graphs from deep well 58-32 stress testing from 6900 7500 ft depth. Measured stress data were used to correct logging predictions of in situ stress. Stress plots shows pore pressure (measured during the injection testing), the total vertical in...
McLennan, J. Energy and Geoscience Institute at the University of Utah
Mar 14, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2439v2: Characterizing In-Situ Stress with Laboratory Modelling and Field Measurements 2024 Annual Workshop Presentation

This is a presentation on A Multi-Component Approach to Characterizing In-Situ Stress at the Utah FORGE Site: Laboratory Modelling and Field Measurements project by The University of Pittsburgh, presented by Andrew Bunger. The project characterizes the stress in the Utah FORGE EGS...
Bunger, A. Energy and Geoscience Institute at the University of Utah
Sep 04, 2024
1 Resources
0 Stars
Publicly accessible

Slip and Dilation Tendency Analysis of the Patua Geothermal Area

Critically stressed fault segments have a relatively high likelihood of acting as fluid flow conduits (Sibson, 1994). As such, the tendency of a fault segment to slip or to dilate provides an indication of which faults or fault segments within a geothermal system are critically st...
E., J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Slip and Dilation Tendency Analysis of the Salt Wells Geothermal Area

Critically stressed fault segments have a relatively high likelihood of acting as fluid flow conduits (Sibson, 1994). As such, the tendency of a fault segment to slip (slip tendency; Ts; Morris et al., 1996) or to dilate (dilation tendency; Td; Ferrill et al., 1999) provides an in...
E., J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Slip and Dilation Tendency Analysis of the San Emidio Geothermal Area

Critically stressed fault segments have a relatively high likelihood of acting as fluid flow conduits (Sibson, 1994). As such, the tendency of a fault segment to slip (slip tendency; Ts; Morris et al., 1996) or to dilate (dilation tendency; Td; Ferrill et al., 1999) provides an in...
E., J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Bottom Shear Stress in Lake Erie for Parameterization

2008-2009 bottom currents, turbidity, wind and waves in Lake Erie. The dataset is used for calculating bottom shear stress and evaluating bottom shear stress parameterization methods. Bottom shear stress is the driving force of sediment entrainment. Understanding bottom shear stre...
Lin, S. Uppsala University
Mar 18, 2022
1 Resources
0 Stars
Publicly accessible

Slip and Dilation Tendency Analysis of McGinness Hills Geothermal Area

Slip and Dilation Tendency in focus areas Critically stressed fault segments have a relatively high likelihood of acting as fluid flow conduits (Sibson, 1994). As such, the tendency of a fault segment to slip (slip tendency; Ts; Morris et al., 1996) or to dilate (dilation tendency...
E., J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Slip and Dilation Tendency Analysis of Neal Hot Springs Geothermal Area

Slip and Dilation Tendency in focus areas Critically stressed fault segments have a relatively high likelihood of acting as fluid flow conduits (Sibson, 1994). As such, the tendency of a fault segment to slip (slip tendency; Ts; Morris et al., 1996) or to dilate (dilation tendency...
E., J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Slip and Dilation Tendency Analysis of the Tuscarora Geothermal Area

Critically stressed fault segments have a relatively high likelihood of acting as fluid flow conduits (Sibson, 1994). As such, the tendency of a fault segment to slip (slip tendency; Ts; Morris et al., 1996) or to dilate (dilation tendency; Td; Ferrill et al., 1999) provides an in...
E., J. University of Nevada
Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

STRESSINVERSE Software for Stress Inversion

The STRESSINVERSE code uses an iterative method to find the nodal planes most consistent with the stress field given fault frictional properties. STRESINVERSE inverts the strike, rake and dip from moment tensor solutions for the in-situ state of stress. The code iteratively solves...
Gritto, R. Array Information Technology
Oct 31, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2439: Report on Minifrac Tests for Stress Characterization

This report describes minifrac tests conducted in the 16B(78)-32 well at the Utah FORGE site to characterize subsurface stresses, including the magnitude and orientation of the minimum and maximum horizontal stresses and the magnitude of the vertical stress. A minifrac test was co...
Kelley, M. et al Battelle Memorial Institute
Feb 22, 2024
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2404: Application of Advanced Techniques for Determination of Reservoir-Scale Stress State at Utah FORGE Workshop Presentation

This is a presentation on the Application of Advanced Techniques for Determination of Reservoir-Scale Stress State at Utah FORGE project by the University of Oklahoma, presented by Dr. Ahmad Ghassemi, McCasland Chair Professor. The project's objective was to develop a methodology ...
Ghassemi, A. University of Oklahoma
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Fault Reactivation Through Fluid Injection Induced Seismicity Laboratory Experiments

Included are results from shear reactivation experiments on laboratory faults pre-loaded close to failure and reactivated by the injection of fluid into the fault. The sample comprises a single-inclined-fracture (SIF) transecting a cylindrical sample of Westerly granite. All expe...
Yu, J. et al Pennsylvania State University
Jul 01, 2023
27 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2446: Connecting In Situ Stress and Wellbore Deviation to Near-Well Fracture Complexity using Phase-Field Simulations

This report presents a series of numerical experiments investigating the relationships among near-well fracture complexity, in situ stress conditions, and wellbore deviation. Using a phase-field modeling approach, the study explores how factors such as stress regimes, wellbore ori...
Cusini, M. and Fei, F. Lawrence Livermore National Laboratory
Jan 30, 2025
2 Resources
0 Stars
Publicly accessible

Castlegate Sandstone True Triaxial Test Data

Data set containing results from constant mean stress constant Lode angle true triaxial compression tests performed on Castlegate Sandstone. From the test preformed, the bedding plane and the strain type inside the band of sedimentary rocks can be related to stress histories. The ...
Ingraham, M. et al Sandia National Laboratories
May 06, 2012
8 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2439: A Multi-Component Approach to Characterizing In-Situ Stress: Laboratory, Modeling and Field Measurement Workshop Presentation

This is a presentation on A Multi-Component Approach to Characterizing In-Situ Stress at the U.S DOE FORGE EGS Site: Laboratory, Modeling and Field Measurement project by Battelle [Columbus, OH], presented by Mark Kelley. The project's objective was to characterize stress in the U...
Kelley, M. and Bunger, A. Battelle Memorial Institute
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

Preliminary Analysis of Stress in the Newberry EGS Well NWG 55-29

As part of the planning for stimulation of the Newberry Volcano Enhanced Geothermal Systems (EGS) Demonstration project in Oregon, a high-resolution borehole televiewer (BHTV) log was acquired using the ALT ABI85 BHTV tool in the slightly deviated NWG 55-29 well. The image log rev...
Davatzes, N. and Hickman, S. National Energy Technology Laboratory
Jan 01, 2011
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2446: Closing the Loop Between In-Situ Stress Complexity and EGS Fracture Complexity 2024 Annual Workshop Presentation

This is a presentation on Closing the Loop Between In-Situ Stress Complexity and EGS Fracture Complexity by Lawrence Livermore National Laboratory, presented by Matteo Cusini. The video discusses the combination of high-fidelity simulations and true-triaxial block fracturing tests...
Cusini, M. et al Energy and Geoscience Institute at the University of Utah
Aug 26, 2024
1 Resources
0 Stars
Publicly accessible

The measurement of depth of water in oceans, seas, or lakes GEBCO bathymetry gridded data for North Sea / Baltic Sea Derived Data

**Overview** This dataset contains global bathymetry, or water depth, measurements from the General Bathymetric Chart of the Oceans (GEBCO), converted into the format needed for WRF's Pre-processing System (WPS). The data are read in for the use of a depth-dependent water surface...
Hawbecker, P. Wind Energy Technologies Office (WETO)
Dec 31, 2019
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2404: Application of Advanced Techniques for Determination of Reservoir-Scale Stress State 2024 Annual Workshop Presentation

This is a presentation on the Application of Advanced Techniques for Determination of Reservoir-Scale Stress State at FORGE by the University of Oklahoma, presented by Ahmad Ghassemi. This video discusses how magnitude and orientation of natural in-situ principal stresses at dept...
Ghassemi, A. et al Energy and Geoscience Institute at the University of Utah
Aug 28, 2024
1 Resources
0 Stars
Publicly accessible
12345Next >>