Search OEDI Data
Showing results 76 - 100 of 294.
Show
results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
Water chemistry data and calculations for Fracture Sustainability Tests
Measured cation, anion, and silica are presented as well as calculations evaluating mass balance performed for 4 fracture sustainability tests under EGS conditions: Stripa granite, Metamudstone, Rhyolitic Ashflow Tuff, and Silicified Rhyolitic Tuff. Calculations of charge balance ...
Kneafsey, T. et al Lawrence Berkeley National Laboratory
Sep 30, 2020
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Seismic Analysis of Spatio-Temporal Fracture Generation During EGS Resource Development Deviatoric MT, Fracture Network, and Final Report
This submission contains 167 deviatoric moment tensor (MT) solutions for the seismicity observed two years prior and three years post start of injection activities at The Geysers Prati 32 EGS Demonstration. Also included is a statistical representation of the properties of 751 fra...
Gritto, R. et al Array Information Technology
Sep 01, 2018
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Mapping Fracture Network Creation with Microseismicity During EGS Demonstrations
This a report for the project "Mapping Fracture Network Creation with Microseismicity During EGS Demonstrations". Effective enhanced geothermal systems (EGS) require optimal fracture networks for efficient heat transfer between hot rock and fluid. Microseismic mapping is a key too...
Templeton, D. et al Lawrence Livermore National Laboratory
Apr 18, 2014
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE Core Material Friction Experiments
The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...
Marone, C. et al The Pennsylvania State University
Mar 15, 2023
7 Resources
0 Stars
Publicly accessible
7 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 58-32 (MU-ESW1) FMI Log Fracture Results
A Schlumberger Fullbore Formation Micro-Imager (FMI) log was run from 7390 feet to 7527 feet depth in well 58-32, originally known as well MU-ESW1. Well 58-32 was completed in 2017 as part of Utah FORGE Phase 2. It reached a depth of 7536 feet and recorded a bottom hole temperatur...
BLOCHOWICZ, A. Energy and Geoscience Institute at the University of Utah
Mar 06, 2021
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Development of a Neutron Diffraction Based Experimental Capability for Investigating Hydraulic Fractures for EGS-like Conditions
Understanding the relationship between stress state, strain state and fracture initiation and propagation is critical to the improvement of fracture simulation capability if it is to be used as a tool for guiding hydraulic fracturing operations. The development of fracture predict...
Polsky, Y. et al Oak Ridge National Laboratory
Feb 01, 2013
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Thermal Drawdown-Induced Flow Channeling in a Single Fracture in EGS
The evolution of flow pattern along a single fracture and its effects on heat production is a fundamental problem in the assessments of engineered geothermal systems (EGS). The channelized flow pattern associated with ubiquitous heterogeneity in fracture aperture distribution caus...
Guo, B. et al Lawrence Livermore National Laboratory
Nov 15, 2015
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Modeling Responses of Naturally Fractured Geothermal Reservoir to Low-Pressure Stimulation
Hydraulic shearing is an appealing reservoir stimulation strategy for Enhanced Geothermal Systems. It is believed that hydro-shearing is likely to simulate a fracture network that covers a relatively large volume of the reservoir whereas hydro-fracturing tends to create a small nu...
Fu, P. and Carrigan, C. Lawrence Livermore National Laboratory
Jan 01, 2012
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE Well 16A(78)-32 Simplified Discrete Fracture Network Data
The FORGE team is making these fracture models available to researchers wanting a set of natural fractures in the FORGE reservoir for use in their own modeling work. They have been used to predict stimulation distances during hydraulic stimulation at the open toe section of well 1...
Finnila, A. Golder Associates Inc.
Jun 01, 2021
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Generalized Displacement Correlation Method for Estimating Stress Intensity Factors
This paper presents a generalized form of the displacement correlation method (the GDC method), which can use any linear or quadratic finite element type with homogeneous meshing without local refinement. These two features are critical for modeling dynamic fracture propagation pr...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Poroelastic References
This file contains a list of relevant references on the Biot theory (forward and inverse approaches), the double-porosity and dual-permeability theory, and seismic wave propagation in fracture porous media, in RIS format, to approach seismic monitoring in a complex fractured porou...
Morency, C. Lawrence Livermore National Laboratory
Dec 12, 2014
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
SMP Preparation, Programming, and Characterization
The problem of loss circulation in geothermal wells is inherently challenging due to high temperatures, brittle rocks, and presence of abundant fractures. Because of the inherent challenges in geothermal environments, there are limitations in selecting proper lost circulation mate...
Salehi, S. et al University of Oklahoma
Oct 01, 2021
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Investigation of Stimulation-Response Relationships for Complex Fracture Systems in Enhanced Geothermal Reservoirs
Hydraulic fracturing is currently the primary method for stimulating low-permeability geothermal reservoirs and creating Enhanced (or Engineered) Geothermal Systems (EGS) with improved permeability and heat production efficiency. Complex natural fracture systems usually exist in ...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 01, 2011
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Using Fully Coupled Hydro-Geomechanical Numerical Test Bed to Study Reservoir Stimulation with Low Hydraulic Pressure
This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimu...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 31, 2012
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Improved Microseismicity Detection During Newberry EGS Stimulations
Effective enhanced geothermal systems (EGS) require optimal fracture networks for efficient heat transfer between hot rock and fluid. Microseismic mapping is a key tool used to infer the subsurface fracture geometry. Traditional earthquake detection and location techniques are oft...
Templeton, D. Lawrence Livermore National Laboratory
Oct 01, 2013
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
EGS Collab: Modeling and Simulation Working Group Teleconference Series (99-128)
This submission contains the presentation slides and recordings from EGS Collab Modeling and Simulation Working Group (MSWG) teleconferences number 99 through 128. These teleconferences served three objectives for the project: 1) share simulation results, 2) communicate field acti...
White, M. et al Pacific Northwest National Laboratory
Jun 07, 2022
31 Resources
0 Stars
Publicly accessible
31 Resources
0 Stars
Publicly accessible
Simulations of Brady's-Type Fault Undergoing CO2 Push-Pull: Pressure-Transient and Sensitivity Analysis
Input and output files used for fault characterization through numerical simulation using iTOUGH2. The synthetic data for the push period are generated by running a forward simulation (input parameters are provided in iTOUGH2 Brady GF6 Input Parameters.txt [InvExt6i.txt]). In gene...
Jung, Y. and Doughty, C. Lawrence Berkeley National Laboratory
Mar 09, 2018
11 Resources
0 Stars
Publicly accessible
11 Resources
0 Stars
Publicly accessible
EGS Collab Experiment 1: SIMFIP Notch-164 GRL Paper
Characterizing the stimulation mode of a fracture is critical to assess the hydraulic efficiency and the seismic risk related to deep fluid manipulations. We have monitored the three-dimensional displacements of a fluid-driven fracture during water injections in a borehole at ~1.5...
Guglielmi, Y. Lawrence Berkeley National Laboratory
Sep 24, 2020
9 Resources
0 Stars
Publicly accessible
9 Resources
0 Stars
Publicly accessible
Improved Microseismicity Detection During Newberry EGS Stimulations
Effective enhanced geothermal systems (EGS) require optimal fracture networks for efficient heat transfer between hot rock and fluid. Microseismic mapping is a key tool used to infer the subsurface fracture geometry. Traditional earthquake detection and location techniques are oft...
Templeton, D. Lawrence Livermore National Laboratory
Nov 01, 2013
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Snake River Plain FORGE: Well Data for WO-2
Well data for the WO-2 well located in eastern Snake River Plain, Idaho. This data collection includes lithology reports, borehole logs, temperature at depth data, neutron density and gamma data, and rock strength parameters for the WO-2 well.
This collection of data has been ass...
Podgorney, R. Idaho National Laboratory
Jul 29, 1991
9 Resources
0 Stars
Publicly accessible
9 Resources
0 Stars
Publicly accessible
Shear Induced Permeability Test: Stripa Granite Temperature Pressure and Displacement Data
Spreadsheet containing the raw measured data, calibrated data, and brief explanation of data for Test1 Stripa Granite Geomechanical/Geochemical Test. Stress on fracture ~20.7 MPa.
Kneafsey, T. Lawrence Berkeley National Laboratory
Jun 21, 2014
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE Well 16A(78)-32 Stage 1 Pressure Falloff Analysis
This is an analysis of the pressure falloff in stage 1 fracture stimulation of FORGE well 16A(78)-32. The objective of this research is to understand the information content of the well stimulation data of FORGE Well 16A(78)-32. The Stage 1 step-rate test, a variant of the classic...
Kazemi, H. et al Colorado School of Mines
Aug 04, 2022
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE Well 16A(78)-32 Stimulation DFN Fracture Plane Evaluation and Data
This dataset includes files used to fit planar fractures through the preliminary earthquake catalogs of the three stages of the April 2022 well 16A(78)-32 stimulation which is linked bellow. These planar features have been used to update the FORGE reference Discrete Fracture Netwo...
Finnila, A. WSP Golder
Oct 27, 2022
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Utah FORGE: Evaluation of Potential Geochemical Responses to Injection in the FORGE Geothermal Reservoir
Plugging of fracture porosity from mineral precipitation due to injecting cold water into a a geothermal reservoir can impact the overall permeability of the fracture network in the reservoir. This can have serious ramifications on the efficiency of the geothermal resource. Geoche...
Patil, V. and Simmons, S. Energy and Geoscience Institute at the University of Utah
Apr 03, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Hydroshear Simulation Lab Test 2, Additional Data Sheets
This file contains additional data for this test (hydroshear test 3.2). In this test a sample of granite with a pre-cut (man made fracture) is confined, heated and differential stress is applied. The max temperature in this this system development test is 95C. More test details ca...
Bauer, S. Sandia National Laboratories
Aug 01, 2014
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible