Search OEDI Data
Showing results 326 - 350 of 1814.
Show
results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
Chlorite Dissolution Rates From 25 to 275 degrees and pH 3 to 10
We have calculated a chlorite dissolution rate equation at far from equilibrium conditions by combining new data (20 experiments at high temperature) with previously published data Smith et al. 2013 and Lowson et al. 2007. All rate data (from the 127 experiments) are tabulated in...
Lawrence Livermore National Laboratory
Sep 27, 2013
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Hourly Dynamic Line Ratings for Existing Transmission Across the Contiguous United States (Preliminary)
This dataset provides estimated hourly dynamic line ratings for ~84,000 transmission lines across the contiguous United States from 2007-2013. The calculation methods are described in the presentation linked below, and the associated open-source Python code repository is linked in...
Obika, K. et al National Renewable Energy Laboratory
Sep 25, 2024
16 Resources
0 Stars
Publicly accessible
16 Resources
0 Stars
Publicly accessible
Lancaster County Adult Detention Facility Geothermal Well Field Configuration
Drawing showing the configuration of 667 bore holes drilled to depth of 300 ft. for the Lancaster County Adult Detention Facility geothermal heat pump system.
Davlin, T. District Energy Corporation
Feb 24, 2009
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Sedimentary Geothermal Feasibility in Nevada, Western Utah, Colorado, and the Gulf Coast Region of Texas Final Report
The objectives of this project were to (1) perform a literature review of sedimentary geothermal resources, (2) identify data sources and develop data-collection methodologies that characterize selected resources, (3) screen sedimentary basins and formations for sedimentary geothe...
Johnston, H. et al National Renewable Energy Laboratory
Jul 01, 2020
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Laboratory Evaluation of EGS Shear Stimulation-Test 001
This is the results of an initial setup-shakedon test in order to develop the plumbing system for this test design. a cylinder of granite with offset holes was jacketed and subjected to confining pressure and low temperature (85C) and pore water pressure. Flow through the sample w...
Bauer, S. Sandia National Laboratories
Jul 29, 2014
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Raw Data from National Wind Technology Center M2 Tower (2001 2011)
This raw data reflects readings from instruments mounted on or near a 82 meter meteorological tower located at the [National Wind Technology Center (NWTC)](http://www.nrel.gov/wind/ "NWTC website"), approximately 5 miles south of Boulder, CO (specifically: 39.9107 N, 105.2348 W, d...
Hallett, K. and Laboratory, N. National Renewable Energy Laboratory
Nov 25, 2014
2 Resources
0 Stars
In curation
2 Resources
0 Stars
In curation
Utah FORGE: Hydrothermal Friction-Hydraulic Transmissivity Laboratory Experiments
Submission includes data from laboratory slide-hold-slide tests, combined with flow through tests, conducted on Westerly granite with 30 degree sawcut. Tests were conducted with a constant confining pressure of 30 MPa with an average pore pressure of 10 MPa at temperatures of 23 a...
Jeppson, T. and Lockner, D. United States Geological Survey
Feb 24, 2022
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
NREL National Wind Technology Center (NWTC): M2 Tower; Boulder, Colorado (Data)
The National Wind Technology Center (NWTC), located at the foot of the Rocky Mountains near Boulder, Colorado, is a world-class research facility managed by NREL for the U.S. Department of Energy. NWTC researchers work with members of the wind energy industry to advance wind power...
Jager and AndreasNational Renewable Energy Laboratory
Dec 17, 2014
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Geothermal Geodatabase for Wagon Wheel Hot Springs, Mineral County, Colorado
This geodatabase was built to cover several geothermal targets developed by Flint Geothermal in 2012 during a search for high-temperature systems that could be exploited for electric power development. Several of the thermal springs at Wagon Wheel Gap have geochemistry and geother...
Zehner, R. Flint Geothermal, LLC
Nov 01, 2012
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Neubrex Well 16B(78)-32 Stimulation Fiber Optic Monitoring Reports April and May, 2024
These reports contain information on the distributed temperature sensing (DTS), distributed strain sensing (DSS), and pressure monitoring during the stimulation of Well 16(B)78-32 at Utah FORGE, in April and May 2024. Reports include information on data collection and calibrations...
Jurick, D. and Guzik, D. Neubrex Energy Services (US), LLC
Apr 30, 2024
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 14-2 Logs and Data from Roosevelt Hot Spring Area
This is a compilation of logs and data from Well 14-2 in the Roosevelt Hot Springs area in Utah. This well is also in the Utah FORGE study area.
Data includes: flowmeter survey (1989), geochemistry (1977-1978, 1977-1983), injection test data (1979, 1982), and spinner surveys (19...
Moore, J. Energy and Geoscience Institute at the University of Utah
Mar 03, 2016
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: North Milford Groundwater Geochemistry
This dataset contains groundwater geochemistry from several wells in North Milford Valley, Utah, in the region of the Utah FORGE project (Phase 2c). Readme file that discusses the data contained in the Excel spreadsheet. Data include GPS coordinates (UTM, Lat-Long), sampling tempe...
Simmons, S. and Kirby, S. Energy and Geoscience Institute at the University of Utah
Jun 20, 2019
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Pressure Sensor and Telemetry Methods for Measurement while Drilling in Geothermal Wells
Project status report as of end of 2011. Key milestones and accomplishments in the year 2011 include:
Proof of feasibility of analog and digital components with their lifetime tested for more than 500 hours at 300 degrees C,
Demonstration of ceramic-based packaging capable of su...
Vert, A. GE Global Research
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Subsurface Characterization and Machine Learning Predictions at Brady Hot Springs
Subsurface data analysis, reservoir modeling, and machine learning (ML) techniques have been applied to the Brady Hot Springs (BHS) geothermal field in Nevada, USA to further characterize the subsurface and assist with optimizing reservoir management. Hundreds of reservoir simulat...
Beckers, K. et al National Renewable Energy Laboratory
Feb 18, 2021
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Ground Source Heat Pump Computational Results
This data submission includes simulation results for ground loop heat pump systems located in 6 different cities across the United States. The cities are Boston, MA, Dayton, OH, Omaha, NE, Orlando, FL, Sacramento, CA, and St. Paul, MN. These results were obtained from the two-dime...
Menart, J. Wright State University
Jul 31, 2013
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Stability of Elastomers Subjected to Geothermal Well-Like Conditions
The aim of this study is to understand how commercially available elastomers perform under geothermal well-like conditions and make recommendations to the community based on these results. This poster highlights the mechanical performance of several elastomers (including EPDM, Vit...
Redline, E. et al Sandia National Laboratories
Aug 10, 2014
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Core Material Friction Experiments
The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...
Marone, C. et al Pennsylvania State University
Mar 15, 2023
7 Resources
0 Stars
Publicly accessible
7 Resources
0 Stars
Publicly accessible
Utah FORGE: Phase 2C Seismic Observation and Ground Water Well Data and Well Locations
This submission contains the following data associated with Utah FORGE Phase 2C within the Roosevelt Hot Springs geothermal area:
An ArcGIS shapefile with well locations for wells 58-32, 78-32, 68-32, OH-3, OH-4, WOW-2, and WOW-3. Well 58-32 is the deep test well, wells 68-32 an...
Abraham, S. et al Energy and Geoscience Institute at the University of Utah
Mar 26, 2019
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Ground Source Heat Pump Computational Results
This data submission includes simulation results for ground loop heat pump systems located in 6 different cities across the United States. The cities are Boston, MA, Dayton, OH, Omaha, NE, Orlando, FL, Sacramento, CA, and St. Paul, MN. These results were obtained from the two-dime...
Menart, J. Wright State University
Jul 31, 2013
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Utah FORGE 2-2439v2: Report on Predicting Far-Field Stresses Using Finite Element Modeling and Near-Wellbore Machine Learning for Well 16A(78)-32
This report presents the far-field stress predictions at two locations along the vertical section of Utah FORGE Well 16A (78)-32 using a physics-based thermo-poro-mechanical model. Three principal stresses in far-field were obtained by solving an inverse problem based on the near-...
Lu, G. et al University of Pittsburgh
Aug 30, 2024
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE 5-2419: Temperature Testing of Proppants for EGS and Stimulation of Electromagnetic Fracture Mapping Using Electrically-Conducive Proppants 2024 Annual Workshop Presentation
This is a presentation on the Temperature Testing of Proppants for EGS and Stimulation of Electromagnetic Fracture Mapping Using Electrically-Conducive Proppants by Stevens Institute of Technology, presented by Cheng Chen. This video slide presentation discusses well controlled la...
Chen, C. et al Energy and Geoscience Institute at the University of Utah
Sep 14, 2024
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Machine Learning to Identify Geologic Factors Associated with Production in Geothermal Fields: A Case-Study Using 3D Geologic Data from Brady Geothermal Field and NMFk
In this paper, we present an analysis using unsupervised machine learning (ML) to identify the key geologic factors that contribute to the geothermal production in Brady geothermal field. Brady is a hydrothermal system in northwestern Nevada that supports both electricity producti...
Siler, D. et al United States Geological Survey
Oct 01, 2021
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Closed Loop Geothermal Working Group: GeoCLUSTER App, Subsurface Simulation Results, and Publications
To better understand the heat production, electricity generation performance, and economic viability of closed-loop geothermal systems in hot-dry rock, the Closed-Loop Geothermal Working Group a consortium of several national labs and academic institutions has tabulated time-depe...
Beckers, K. et al Pacific Northwest National Laboratory
Feb 03, 2023
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Surface Meteorological Station UND 10m, (2) Sonics 3m 10m, (2) T/RH 3m 10m (1) Licor 3m, Physics site-1 Raw Data
**Overview**
The data included features wind, temperature, and turbulence measurements.
**Data Details**
Each met station (met.z18, met.z19, met.z21, and met.z23) consists of multiple levels of three-dimensional ultrasonic anemometers, RM Young 81000 (sampling frequency = 20 ...
Fernando, J. et al Wind Energy Technologies Office (WETO)
Feb 13, 2016
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Surface Meteorological Station UND 10m, (2) Sonics 3m 10m, (2) T/RH 3m 10m, Physics site-11 Raw Data
**Overview**
The data included features wind, temperature, and turbulence measurements.
**Data Details**
Each met station (met.z18, met.z19, met.z21, and met.z23) consists of multiple levels of three-dimensional ultrasonic anemometers, RM Young 81000 (sampling frequency = 20 ...
Fernando, J. et al Wind Energy Technologies Office (WETO)
Feb 14, 2016
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible