Search OEDI Data

Showing results 26 - 50 of 88.
Show results per page.
Order by:
Available Now:
Clear All Filters ×
Research Areas
Accessibility
Data Type
Organization
Source
"shear failure"×
Geothermal Data Repository (GDR)×

Post-Test SEM Examination of Brady Core, Desert Peak Core, and Stripa Granite Samples

As part of the shear-induced permeability test of Brady well BCH-03, Desert Peak well DP 35-13, and Stripa granite samples, the three post-test (reacted) rock samples were examined using a Scanning Electron Microscope (SEM). The SEM images of the core and elemental analysis are in...
Kneafsey, T. et al Lawrence Berkeley National Laboratory
Dec 23, 2015
4 Resources
0 Stars
Publicly accessible

Utah FORGE Well 16A(78)-32 Stimulation Data (April, 2022)

This is a set of data related to the stimulation program at Utah FORGE well 16A(78)-32 during April, 2022. This includes daily reports, 1 second Pason data, tracer data, and shear stimulation data and information including a report of an evolving prognosis for the stimulation oper...
McLennan, J. Energy and Geoscience Institute at the University of Utah
May 18, 2022
11 Resources
0 Stars
Publicly accessible

Hydroshear Simulation Lab Test 2

This data file is for test 2. In this test a sample of granite with a pre-cut (man made fracture) is confined, heated and differential stress is applied. The max temperature in this this system development test is 95C. More test details can be found on the spreadsheets--note that ...
Bauer, S. Sandia National Laboratories
Aug 01, 2014
3 Resources
0 Stars
Publicly accessible

Utah FORGE Core Material Friction Experiments

The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...
Marone, C. et al The Pennsylvania State University
Mar 15, 2023
7 Resources
0 Stars
Publicly accessible

Fallon FORGE: Analogue Outcrop Samples

Compilation of results for mechanical and fluid flow properties of analogue outcrop samples experimental data for compressional and shear wave velocities, tensile strengths, and compressive strengths. Outcrop location and sample orientation data are documented in a separate csv file.
Blankenship, D. et al Sandia National Laboratories
Mar 12, 2018
2 Resources
0 Stars
Publicly accessible

Active Source Seismic (Ultrasonic) Data from Double-Direct Shear Lab Experiments

Active source ultrasonic data from lab experiments p5270 and p5271 including raw waveforms (WF) and mechanical data (mat). From the PSU team working on the "Machine Learning Approaches to Predicting Induced Seismicity and Imaging Geothermal Reservoir Properties" project. The fric...
Marone, C. Pennsylvania State University
May 05, 2021
1 Resources
0 Stars
Publicly accessible

Water chemistry data and calculations for Fracture Sustainability Tests

Measured cation, anion, and silica are presented as well as calculations evaluating mass balance performed for 4 fracture sustainability tests under EGS conditions: Stripa granite, Metamudstone, Rhyolitic Ashflow Tuff, and Silicified Rhyolitic Tuff. Calculations of charge balance ...
Kneafsey, T. et al Lawrence Berkeley National Laboratory
Sep 30, 2020
2 Resources
0 Stars
Publicly accessible

Washington Play Fairway Analysis Analysis of High Precision GPS Time Series and Strain Rates for the Cascade Range

Global Positioning System (GPS) time series from the National Science Foundation (NSF) Earthscope's Plate Boundary Observatory (PBO) and Central Washington University's Pacific Northwest Geodetic Array (PANGA). GPS station velocities were used to infer strain rates using the "spli...
Swyer, M. AltaRock Energy Inc
Feb 22, 2015
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: In-situ observation of pre-, co and post-seismic shear slip preceding hydraulic fracturing

Understanding the initiation and arrest of earthquakes is one of the long-standing challenges of seismology. Here we report on direct observations of borehole displacement by a meter-sized shear rupture induced by pressurization of metamorphic rock at 1.5 km depth. We observed the...
Guglielmi, Y. et al Lawrence Berkeley National Laboratory
May 22, 2018
2 Resources
0 Stars
Publicly accessible

Fallon FORGE: Distinct Element Reservoir Modeling

Archive containing input/output data for distinct element reservoir modeling for Fallon FORGE. Models created using 3DEC, InSite, and in-house Python algorithms (ITASCA). List of archived files follows; please see 'Modeling Metadata.pdf' (included as a resource below) for addition...
Blankenship, D. et al Sandia National Laboratories
Mar 12, 2018
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Baseline Cross-well Seismic

As part of the geophysical characterization suite for the first EGS Collab tesbed, here are the baseline cross-well seismic data and resultant models. The campaign seismic data have been organized, concatenated with geometry and compressional (P-) & and shear (S-) wave picks, and ...
Schwering, P. et al Sandia National Laboratories
Apr 30, 2018
9 Resources
0 Stars
Publicly accessible

Utah FORGE: 2019 ARMA Overview Slide Presentation

This is an overview presentation of the Utah FORGE project given by Joseph Moore, Ph.D., at the 2019 American Rock Mechanics Associate meeting. It details the state of the Utah FORGE project at on 8/17/2019.
Moore, J. Energy and Geoscience Institute at the University of Utah
Aug 17, 2019
1 Resources
0 Stars
Publicly accessible

Utah FORGE Project 2439: Machine Learning for Well 16A(78)-32 Stress Predictions

This report reviews the training of machine learning algorithms to laboratory triaxial ultrasonic velocity data for Utah FORGE Well 16A(78)-32. Three machine learning (ML) predictive models were developed for the prediction of vertical and two orthogonally oriented horizontal str...
Kelley, M. et al Battelle Memorial Institute
Jun 19, 2023
1 Resources
0 Stars
Publicly accessible

Laboratory Evaluation of EGS Shear Stimulation-Test 001

This is the results of an initial setup-shakedon test in order to develop the plumbing system for this test design. a cylinder of granite with offset holes was jacketed and subjected to confining pressure and low temperature (85C) and pore water pressure. Flow through the sample w...
Bauer, S. Sandia National Laboratories
Jul 29, 2014
1 Resources
0 Stars
Publicly accessible

Fallon FORGE: Lithology Logs and Well 21-31 Drilling Data

This submission includes lithology logs for all Fallon FORGE area wells; determined from core, cuttings, and thin section. Wells included are 84-31, 21-31, 82-36, FOH-3D, 62-36, 18-5, 88-24, 86-25, FOH-2, 14-36, 17-16, 34-33, 35A-11, 51A-20, 62-15, 72-7, 86-15, Carson_Strat_1_36-3...
Blankenship, D. et al Sandia National Laboratories
Mar 11, 2018
2 Resources
0 Stars
Publicly accessible

Grain-Scale Failure in Thermal Spallation Drilling

Geothermal power promises clean, renewable, reliable and potentially widely-available energy, but is limited by high initial capital costs. New drilling technologies are required to make geothermal power financially competitive with other energy sources. One potential solution is ...
Walsh, S. et al Lawrence Livermore National Laboratory
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible

SMP and Fracture Modeling

The problem of loss circulation in geothermal wells is inherently challenging due to high temperatures, brittle rocks, and presence of abundant fractures. Because of the inherent challenges in geothermal environments, there are limitations in selecting proper lost circulation mate...
Salehi, S. et al University of Oklahoma
Oct 01, 2021
4 Resources
0 Stars
Publicly accessible

SMP Preparation, Programming, and Characterization

The problem of loss circulation in geothermal wells is inherently challenging due to high temperatures, brittle rocks, and presence of abundant fractures. Because of the inherent challenges in geothermal environments, there are limitations in selecting proper lost circulation mate...
Salehi, S. et al University of Oklahoma
Oct 01, 2021
4 Resources
0 Stars
Publicly accessible

Illite Dissolution Rates and Equation (100 to 280 deg C)

The objective of this suite of experiments was to develop a useful kinetic dissolution expression for illite applicable over an expanded range of solution pH and temperature conditions representative of subsurface conditions in natural and/or engineered geothermal reservoirs. Usi...
Carroll, S. Lawrence Livermore National Laboratory
Oct 17, 2014
1 Resources
0 Stars
Publicly accessible

Utah FORGE Hydrothermal Friction-Hydraulic Transmissivity Laboratory Experiments

Submission includes data from laboratory slide-hold-slide tests, combined with flow through tests, conducted on Westerly granite with 30 degree sawcut. Tests were conducted with a constant confining pressure of 30 MPa with an average pore pressure of 10 MPa at temperatures of 23 a...
Jeppson, T. and Lockner, D. U.S. Geological Survey
Feb 24, 2022
1 Resources
0 Stars
Publicly accessible

Laboratory Experiments Examining the Effect of Thermal and Mechanical Processes on Hydraulic Transmissivity Evolution

Using laboratory slide-hold-slide experiments, at temperatures from 22 to 200 degrees C, to examine effects of fracture reactivation and quasi-static loading on the evolution of fluid transport properties of simulated fractures in Westerly granite. At all temperatures, the in-plan...
Lockner, D. et al U.S. Geological Survey
Apr 03, 2023
2 Resources
0 Stars
Publicly accessible

Fracture Sustainability Test, Pre and Post-Test Photomicrographs

The primary objective of this research is to understand how different rock types, mineral and fluid compositions, and fracture surface textures determine the longevity of fracture apertures, so that selection of reservoir rock can be economically optimized to reduce future refract...
Dobson, P. et al Lawrence Berkeley National Laboratory
Sep 26, 2016
9 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: SIMFIP Notch-164 GRL Paper

Characterizing the stimulation mode of a fracture is critical to assess the hydraulic efficiency and the seismic risk related to deep fluid manipulations. We have monitored the three-dimensional displacements of a fluid-driven fracture during water injections in a borehole at ~1.5...
Guglielmi, Y. Lawrence Berkeley National Laboratory
Sep 24, 2020
9 Resources
0 Stars
Publicly accessible

Using Fully Coupled Hydro-Geomechanical Numerical Test Bed to Study Reservoir Stimulation with Low Hydraulic Pressure

This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimu...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 31, 2012
2 Resources
0 Stars
Publicly accessible

Chlorite, Biotite, Illite, Muscovite and Feldspar Dissolution Kinetics at Variable pH and Temperatures up to 280 deg C

Chemical reactions pose an important but poorly understood threat to EGS long-term success because of their impact on fracture permeability. This report summarizes the dissolution rate equations for layered silicates where data were lacking for geothermal systems. Here we report ...
Carroll, S. et al Lawrence Livermore National Laboratory
Feb 24, 2017
2 Resources
0 Stars
Publicly accessible
<< Previous1234Next >>