Search OEDI Data

Measured Performance of a Varied Airflow Small-Diameter Duct System

In this study, researchers with the U.S. Department of Energy's Building America team IBACOS built on research previously done in two new-construction unoccupied test houses-one in Pittsburgh, Pennsylvania (Poerschke and Stecher 2014) and one in Fresno, California (Stecher and Poe...

Poerschke, A. Ibacos Innovation

Apr 27, 2016
5 Resources
0 Stars
Publicly accessible

Commercial and Residential Hourly Load Profiles for all TMY3 Locations in the United States

Note: This dataset has been superseded by the dataset found at "End-Use Load Profiles for the U.S. Building Stock" (submission 4520; linked in the submission resources), which is a comprehensive and validated representation of hourly load profiles in the U.S. commercial and reside...

Ong, S. and Clark, N. National Renewable Energy Laboratory

Nov 25, 2014
22 Resources
1 Stars
Publicly accessible

GeoVision: Harnessing the Heat Beneath Our Feet Analysis Inputs and Results

This submission includes input and results data from analysis done as part of the Geothermal Technology Office's Geothermal Vision Study (GeoVision). The submission includes data for both analysis of the electricity sector and the heating and cooling sector. For the electricity se...

Geothermal Technologies Office, U. National Renewable Energy Laboratory

Sep 30, 2019
16 Resources
0 Stars
Publicly accessible

Practices Maintain Straight Hole in Crooked Hole Conditions, While Also Enabling Significant Gains in Drill Rate

Bottom hole assembly (BHA) designs were assessed in field trials for their ability to achieve critical low inclination requirements, while simultaneously enabling high drill rates. Because angle has historically been controlled by reducing weight on bit (WOB), these are often com...

Knudsen, S. et al Sandia National Laboratories

Apr 30, 2014
2 Resources
0 Stars
Publicly accessible

SeaRAY WEC Preliminary Design and Test Planning

The SeaRAY is a deployable power system for maritime sensors, monitoring equipment, communications, unmanned underwater vehicles, and other similar payloads. This project is to design, deliver, and test a prototype low-power WEC that lowers the total cost of ownership and provides...

Hammagren, E. et al Columbia Power Technologies, Inc.

May 18, 2020
4 Resources
0 Stars
Publicly accessible

Net Shape Fabricated Low Cost MHK Pass-Through the Hub Turbine Blades with Integrated Health Management Technology

The primary objective of this project is to develop a three-blade MHK rotor with low manufacturing and maintenance costs. The proposed program will design, fabricate and test a novel half-scale low cost, net shape fabricated single piece three-blade MHK rotor with integrated healt...

Wess, D. ARL Penn State

Feb 09, 2016
24 Resources
0 Stars
Publicly accessible

Mt. Simon Sandstone Brine Chemistry for DDU Technology at the U of IL Campus

A review of brine chemistry data for the Mt. Simon Sandstone in the Illinois Basin is provided for calculations to predict the potential for mineral scaling and precipitation. The assessment includes expected changes in temperature, pressure, and/or exposure to air or other materi...

Lu, Y. and McKaskle, R. University of Illinois

Mar 31, 2019
1 Resources
0 Stars
Publicly accessible

Newberry EGS Seismic Velocity Model

We use ambient noise correlation (ANC) to create a detailed image of the subsurface seismic velocity at the Newberry EGS site down to 5 km. We collected continuous data for the 22 stations in the Newberry network, together with 12 additional stations from the nearby CC, UO and UW ...

Templeton, D. Lawrence Livermore National Laboratory

Oct 01, 2013
1 Resources
0 Stars
Publicly accessible

High-Pressure Combustion and Deflagration-to-Detonation Transition in Ethylene/Nitrous Oxide Mixtures

In this paper, the combustion of nitrous oxide with a simple hydrocarbon, ethylene, at high initial pressures is investigated. A series of experiments were conducted using a stoichiometric C2H4-N2O mixture in a round, smooth-walled tube with initial pressures of 125 to 337 psi. ...

Grubelich, M. Sandia National Laboratories

Nov 01, 2013
1 Resources
0 Stars
Publicly accessible

Risk Management Plan and Risk Register for Design Low-Power Wave Energy Converter for Non-Grid Applications

Risk Registers for major subsystems completed according to the methodology described in the Risk Management Plan [DE-EE0008627 D1.2 Risk Management Plan PD v1.1 07-19-2019.pdf], also included here.

Amon, E. Columbia Power Technologies, Inc.

Jul 19, 2019
17 Resources
0 Stars
Publicly accessible

Comfort in High-Performance Homes in a Hot-Humid Climate

TO5 2.3.2: Large-Scale Temperature Study Although space-conditioning systems are required to meet standards such as those in the Air Conditioning Contractors of America (ACCA) Manual RS (Rutkowski 1997) and the ASHRAE Standard 55 (ASHRAE 2013) comfort criteria, little is known ab...

Poerschke, A. and Beach, R. Ibacos Innovation

Apr 27, 2016
3 Resources
0 Stars
Publicly accessible

Elevation Grid for top Columbia River Basalt (CRBG) in the Portland Basin used in DDU Feasibility Study

The Portland Basin is a prime location to assess the feasibility of DDU-TES because natural geologic conditions provide thermal and hydraulic separation from overlying aquifers that would otherwise sweep away stored heat. Under the Portland Basin, the lower Columbia River Basalt G...

Bershaw, J. and Scanlon, D. Portland State University

Dec 01, 2018
5 Resources
0 Stars
Publicly accessible

LCOE Baseline for OE Buoy WEC Device

Capex numbers are in $/kW, Opex numbers in $/kW-yr. Cost Estimates provided herein are based on concept design and basic engineering data and have high levels of uncertainties embedded. This reference economic scenario was done for a very large device version of the Ocean Energy ...

Previsic, M. et al Re Vision Consulting

Jul 26, 2017
2 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence G Raw Data

**Overview** Sequence G: Upwind Teetered (F) Test sequence G used an upwind, teetered turbine with a 0° cone angle. The wind speeds ranged from 5 m/s to 25 m/s. Yaw angles of ±180° were achieved at low wind speeds and angles of ±10° were achieved at the high wind speeds. Th...

Fingersh, L. Wind Energy Technologies Office (WETO)

Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

Colorado Potential Geothermal Pathways

This layer contains the weakened basement rocks. Isostatic gravity was utilized to identify structural basin areas, characterized by gravity low values reflecting weakened basement rocks. Together interpreted regional fault zones and basin outlines define geothermal "exploration f...

E., R. Flint Geothermal, LLC

Feb 01, 2012
1 Resources
0 Stars
Publicly accessible

University of Illinois Campus Deep Direct-Use Feasibility Study Energy Farm Propane Use Logs

This submission includes an excel workbook containing propane energy logs for the UIUC Energy Farm from March 2013 to March 2016. It also includes heating degree day information for the region from the period October 1 to March 31, for the years 2008 to 2013. The propane logs are...

Lin, Y. University of Illinois

Dec 18, 2017
1 Resources
0 Stars
Publicly accessible

Sup3rWind Data (CONUS)

This data contains paired European Centre for Medium-Range Weather Forecasts Reanalysis version 5 (ERA5) and the Wind Integration National Dataset Toolkit (WTK) images for 2007 and 2010 over two regions in the US, with domain sizes ~800x800 (latitudes from 25.89 to 41.58, and long...

Sinha, S. et al National Renewable Energy Laboratory (NREL)

Jul 16, 2024
6 Resources
0 Stars
Publicly accessible

Applications of Geothermally-Produced Colloidal Silica in Reservoir Management Smart Gels

In enhanced geothermal systems (EGS) the reservoir permeability is often enhanced or created using hydraulic fracturing. In hydraulic fracturing, high fluid pressures are applied to confined zones in the subsurface usually using packers to fracture the host rock. This enhances r...

Hunt, J. et al Lawrence Livermore National Laboratory

Jan 31, 2013
2 Resources
0 Stars
Publicly accessible

Design of an Airlift Bioreactor

An important consideration for the process design is cell immobilization-enabled flow-through operation. Large-scale biosorption relies on cells that are immobilized on a supporting substrate and used to 'attract' metal ions. Cell immobilization allows easy separation of the feed...

Jiao, Y. et al Lawrence Livermore National Laboratory

Mar 13, 2017
1 Resources
0 Stars
Publicly accessible

Community Resilience through Low-Temperature Geothermal Reservoir Thermal Energy Storage

Submitted data include simulations related to underground thermal battery (UTB) simulations described in Modeling and efficiency study of large scale underground thermal battery deployment, presented at GRC, October 2021. The UTB is comprised of a tank of water, a helical heat ex...

Nico, P. et al Lawrence Berkeley National Laboratory

Jan 29, 2022
4 Resources
0 Stars
Publicly accessible

Model and experimental validation of ocean kite dynamics and controls

This submission includes two peer-reviewed papers from researchers at North Carolina State University presenting the modeling and lab-scale experimentation of the dynamics and control of a tethered tidal ocean kite. Below are the abstracts of each file included in the submission. ...

Vermillion, C. et al North Carolina State University

Mar 01, 2020
2 Resources
0 Stars
Publicly accessible

ORNL Air Handling Fault Test Data FRP#2

ORNL test data for air handling faults. Data contains electrical measurements and power consumption measurements.

Fugate, D. and Laboratory, O. Oak Ridge National Laboratory

Mar 22, 2017
4 Resources
0 Stars
In curation

University of Illinois Campus Deep Direct-Use Feasibility Study Geology Log and Drilling Prospectus

Geology log and drilling prospectus for University of Illinois at Urbana-Champaign (UIUC) Energy Farm.

Nelson, W. University of Illinois

Apr 16, 2018
1 Resources
0 Stars
Publicly accessible

University of Illinois Campus Deep Direct-Use Feasibility Study Design of Injection Well #1 (CCS1)

Includes specification sheet, wellbore geometry, and drilling fluids at section target depth associated with the design of Injection Well #1 (CCS1) for the Illinois Basin Decatur Project (IBDP).

Greenberg, S. University of Illinois

Mar 30, 2018
1 Resources
0 Stars
Publicly accessible

WISE-CASING: Time Domain Reflectometry Data from Lab Experiment on Steel Pipe

The steel pipe experiment conducted in the lab was using 6 meter low-carbon steel pipe. We tested it with both dry and in-water condition. In the dry experimental setup, a coaxial cable acting as a return path in the air.

Wang, J. and Wu, Y. Lawrence Berkeley National Laboratory

Jul 23, 2019
9 Resources
0 Stars
Publicly accessible

<< Previous 3 4 5 6 7 8 9 10 11 12 Next >>