Search OEDI Data

Showing results 126 - 150 of 2676.
Show results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
"rate of penetration"×

Dataset and SUTRA model used to evaluate Reservoirs for Thermal Energy Storage in the Portland Basin, Oregon.

This is a link to the open access, published dataset and modeling that supports a feasibility study of Reservoir Thermal Energy Storage (RTES) in the Portland Basin, Oregon, USA. Citation: Burns, E.R., 2020, SUTRA model used to evaluate Saline or Brackish Aquifers as Reservoirs f...
Bershaw, J. et al Portland State University
Jun 29, 2020
2 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2439: A Multi-Component Approach to Characterizing In-Situ Stress: Laboratory, Modeling and Field Measurement Workshop Presentation

This is a presentation on A Multi-Component Approach to Characterizing In-Situ Stress at the U.S DOE FORGE EGS Site: Laboratory, Modeling and Field Measurement project by Battelle [Columbus, OH], presented by Mark Kelley. The project's objective was to characterize stress in the U...
Kelley, M. and Bunger, A. Battelle Memorial Institute
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

Long-Run Marginal Emission Rates for Electricity Workbooks for 2023 Cambium Data

These workbooks contain modeled estimates of long-run marginal emission rates (LRMER) for the contiguous United States' electric sector. A LRMER is an estimate of the rate of emissions that would be either induced or avoided by a change in electric demand, taking into account how ...
GagnonNational Renewable Energy Laboratory
Feb 15, 2024
2 Resources
0 Stars
Publicly accessible

Lidar HilFlowS LLNL WindCube v2 EOP Processed Data

**Overview** The WindCube v2 is a pulsed LIDAR and uses four beams sent in succession in the four cardinal directions along a 28°scanning cone angle to measure horizontal velocity and wind direction. A fifth beam is sent in the vertical direction to measure vertical velocity. Me...
Wharton, S. and , . Wind Energy Technologies Office (WETO)
Jul 07, 2019
1 Resources
0 Stars
Publicly accessible

Community Geothermal: Thermal Conductivity Test and Data Analysis Report Wallingford, CT

Report on a formation thermal conductivity test that was performed on the geothermal test bore at Ulbrich Heights at 38 Louis Circle Lane in Wallingford, Connecticut. Data are applicable only within the Wallingford region and should not be extrapolated for other climatic and geogr...
Martin, C. Connecticut Department of Energy and Environmental Protection (CT DEEP)
Feb 20, 2024
1 Resources
0 Stars
Publicly accessible

Solar Resources by Class and Country

These estimates are derived from the best available solar resource data available to NREL. Resources are organized by class and country. Resolution varies spatially from 1 km to 1 degree (approximately 100 km) depending on the data source. High spatial resolution datasets (1 km...
Heimiller, D. and Laboratory, N. National Renewable Energy Laboratory
Nov 25, 2014
4 Resources
1 Stars
In curation

Utah FORGE 2439: Well 16B(78)-32 Field-Test Data from Mini-Frac Tests

This submittal includes the field-test data collected during stress tests conducted in the Utah FORGE 16B(78)-32 wellbore to measure/characterize the stresses in the geothermal reservoir. The type of stress test performed is referred to as a mini-frac test or a micro-frac test. Th...
Kelley, M. et al Battelle Memorial Institute
Jul 02, 2023
3 Resources
0 Stars
Publicly accessible

Low Temperature Geothermal Resource Assessment for Desalination in United States

This data is a compilation of well observations from the Southern Methodist University (SMU) and Association of American State Geologists (AASG), location of identified low temperature geothermal systems from United States Geological Survey (USGS), and low temperature geothermal w...
Akar, S. and Turchi, C. National Renewable Energy Laboratory
Sep 30, 2016
6 Resources
0 Stars
Publicly accessible

Advanced Sorbent Structure Recovery of Rare Earths, Precious Metals and Other Critical Materials from Geothermal Waters and Its Associated Technoeconomics

The work evaluates, develops and demonstrates flexible, scalable mineral extraction technology for geothermal brines based upon solid phase sorbent materials with a specific focus upon rare earth elements (REEs). The selected organic and inorganic sorbent materials (silica and MOF...
Addleman, R. et al Pacific Northwest National Laboratory
Sep 21, 2016
1 Resources
0 Stars
Publicly accessible

Long-Run Marginal Emission Rates for Electricity Workbooks for 2022 Cambium Data

These workbooks contain modeled estimates of long-run marginal emission rates (LRMER) for the contiguous United States. A LRMER is an estimate of the rate of emissions that would be either induced or avoided by a change in electric demand, taking into account how the change could ...
Gagnon, . et al National Renewable Energy Laboratory
Jan 15, 2023
2 Resources
0 Stars
Publicly accessible

Moisture Risk in Unvented Attics Due to Air Leakage Paths Minneapolis Minnesota

IBACOS completed an initial analysis of moisture damage potential in an unvented attic insulated with closed-cell spray polyurethane foam. To complete this analysis, the research team collected field data, used computational fluid dynamics to quantify the airflow rates through ind...
Rapport, A. et al Ibacos Innovation
Apr 27, 2016
6 Resources
0 Stars
Publicly accessible

Literature Data on Foam Fracturing Fluid

At the beginning of this project, the Temple team spent significant effort to collect data relevant to foam fracturing. More than 40 articles/reports were found in the open literature that reported the properties of aqueous foams under various testing conditions. The foam properti...
Thakor, V. et al Temple University
Nov 08, 2021
2 Resources
0 Stars
Publicly accessible

INGENIOUS Great Basin Regional Dataset Compilation

This is the regional dataset compilation for the INnovative Geothermal Exploration through Novel Investigations Of Undiscovered Systems (INGENIOUS) project. The primary goal of this project is to accelerate discoveries of new, commercially viable hidden geothermal systems while re...
Ayling, B. et al GBCGE, NBMG, UNR
Jun 30, 2022
17 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence H Raw Data

**Overview** Sequences H, I, and J: Upwind Baseline (F), Upwind Low Pitch (F), Upwind High Pitch (F) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of –30 to 180° were achieved at low wind speeds,...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence I Raw Data

**Overview** Sequences H, I, and J: Upwind Baseline (F), Upwind Low Pitch (F), Upwind High Pitch (F) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of –30° to 180° were achieved at low wind speed...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence J Raw Data

**Overview** Sequences H, I, and J: Upwind Baseline (F), Upwind Low Pitch (F), Upwind High Pitch (F) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of –30° to 180° were achieved at low wind speed...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence M Raw Data

**Overview** Sequence M: Transition Fixed (P) Test sequence M used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 15 m/s. Yaw angles ranged from 0° to 90°. The blade tip pitch was 3°. The rotor rotated at 72 RPM. Blade pressure measurement...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

DCIF (Directional Cooling-Induced Fracturing) Westerly Granite AE Borehole Damage Effect Test (Task 3-0)

Directional Cooling-Induced Fracturing (DCIF) experiments were conducted on three rectangular Westerly granite blocks (width=depth=4.0", height=2.0") which were preheated to 200, 400, and 600 degree C to induce damage (microcracks) with varying degrees. Liquid nitrogen was poured...
Nakagawa, S. Lawrence Berkeley National Laboratory
Jan 27, 2022
13 Resources
0 Stars
Publicly accessible

Life Cycle Water Consumption and Water Resource Assessment for Utility-Scale Geothermal Systems: An In-Depth Analysis of Historical and Forthcoming EGS Projects

This report is the third in a series of reports sponsored by the U.S. Department of Energy Geothermal Technologies Program in which a range of water-related issues surrounding geothermal power production are evaluated. The first report made an initial attempt at quantifying the li...
Schroeder, J. et al Argonne National Laboratory
Aug 31, 2013
11 Resources
0 Stars
Publicly accessible

Fort Bliss Geothermal Area Data: Temperature Profile, Logs, Schematic Model and Cross Section

This dataset contains a variety of data about the Fort Bliss geothermal area, part of the southern portion of the Tularosa Basin, New Mexico. The dataset contains schematic models for the McGregor Geothermal System, a shallow temperature survey of the Fort Bliss geothermal area. ...
Brandt, A. University of Utah
Nov 15, 2015
14 Resources
0 Stars
Publicly accessible

Mass Customization of Prefabricated Panel Blocks for Deep Wall Insulation Retrofits

The project this data comes from looks to make building wall retrofits less expensive and easier to install by using exterior insulating panels. This is done to make buildings more energy efficient without expensive wall retrofits or reconstruction. The "Measurement and Verificati...
Sharon, A. et al Fraunhofer Center for Manufacturing Innovation CMI
Dec 14, 2021
2 Resources
0 Stars
Publicly accessible

Development of 3D Geological Model of Tuscarora Sandstone for Feasibility of Deep Direct-Use Geothermal at West Virginia University Main Campus

The subsurface uncertainty at West Virginia University Main Campus is dominated by the uncertainty in the projections of geofluid flowrate in the target formation, the Tuscarora Sandstone. In this paper, three cores from the heterogeneous reservoir, available through West Virginia...
Moore, J. et al West Virginia University
Oct 23, 2018
5 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence Q Raw Data

**Overview** Sequence Q: Dynamic Inflow (P) This sequence was designed to characterize the dynamic inflow variation using the five-hole probes that extend upwind of the leading edge of the blade. This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind sp...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 11, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence S Raw Data

**Overview** Sequences S, T, and U: Upwind, No Probes (F); Upwind 2° Pitch (F); Upwind 4° Pitch (F) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of 0° to 180° were achieved for Sequence S, but ...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible

UAE6 Wind Tunnel Tests Data UAE6 Sequence T Raw Data

**Overview** Sequences S, T, and U: Upwind, No Probes (F); Upwind 2° Pitch (F); Upwind 4° Pitch (F) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of 0° to 180° were achieved for Sequence S, but ...
Fingersh, L. Wind Energy Technologies Office (WETO)
Nov 28, 2018
1 Resources
0 Stars
Publicly accessible
<< Previous12345678910Next >>