Search OEDI Data

Modeling Responses of Naturally Fractured Geothermal Reservoir to Low-Pressure Stimulation

Hydraulic shearing is an appealing reservoir stimulation strategy for Enhanced Geothermal Systems. It is believed that hydro-shearing is likely to simulate a fracture network that covers a relatively large volume of the reservoir whereas hydro-fracturing tends to create a small nu...

Fu, P. and Carrigan, C. Lawrence Livermore National Laboratory

Jan 01, 2012
2 Resources
0 Stars
Publicly accessible

Hawaii Play Fairway Analysis: Oahu Groundwater Flow Model

Groundwater flow model for the island of Oahu. Data is from the following sources: Rotzoll, K., A.I. El-Kadi. 2007. Numerical Ground-Water Flow Simulation for Red Hill Fuel Storage Facilities, NAVFAC Pacific, Oahu, Hawaii Prepared TEC, Inc. Water Resources Research Center, Univer...

Lautze, N. University of Hawaii

Jan 01, 2015
1 Resources
0 Stars
Publicly accessible

Direct-Drive Electrical Generator and PTO System for Flap-type Wave Energy Converters

Project and generator specifications and initial prototype test data for flap-type wave energy converters (WEC)

Englebretson, S. ABB Inc.

Mar 20, 2015
2 Resources
0 Stars
Publicly accessible

3D Model of the San Emidio Geothermal Area

The San Emidio geothermal system is characterized by a left-step in a west-dipping normal fault system that bounds the western side of the Lake Range. The 3D geologic model consists of 5 geologic units and 55 faults. Overlying Jurrassic-Triassic metasedimentary basement is a ~500 ...

E., J. University of Nevada

Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Assessing REE Concentrations in Geothermal and Oil and Gas Produced Waters: A Potential Domestic Source of Strategic Mineral Commodities

The project team collected and analyzed 224 water samples and 101 matching rock samples. INL's improved method of measuring aqueous REEs allows study of samples previously thought too volume limited to measure. The study found that aqueous REEs occur at trace levels in all analyz...

Quillinan, S. et al University of Wyoming

Mar 08, 2019
1 Resources
0 Stars
Publicly accessible

Altona Field Lab Inverse Model WRR 2020

Includes data for measured inert tracer breakthrough curves first reported in Hawkins (2020) (Water Resources Research). In addition, this submission includes the production well temperature measurements first reported in Hawkins et al. (2017a) (Water Resources Research, volume 53...

Tester, J. Cornell University

Jan 01, 2015
3 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 3 Native State Model 2022 Update

This is the Phase 3 native state model update. The Phase 3 numerical model represents a significant subsurface volume below the FORGE site footprint. The model domain of 4.0 km x 4.0 km x 4.2 km is located approximately between depths of 4000 to 4200 meters below land surface. Thi...

Podgorney, R. and Liu, R. Idaho National Laboratory

Jul 29, 2022
1 Resources
0 Stars
Publicly accessible

Dataset and SUTRA model used to evaluate Reservoirs for Thermal Energy Storage in the Portland Basin, Oregon.

This is a link to the open access, published dataset and modeling that supports a feasibility study of Reservoir Thermal Energy Storage (RTES) in the Portland Basin, Oregon, USA. Citation: Burns, E.R., 2020, SUTRA model used to evaluate Saline or Brackish Aquifers as Reservoirs f...

Bershaw, J. et al Portland State University

Jun 29, 2020
2 Resources
0 Stars
Publicly accessible

Simulating Complex Fracture Systems in Geothermal Reservoirs Using an Explicitly Coupled Hydro-Geomechanical Model

Low permeability geothermal reservoirs can be stimulated by hydraulic fracturing to create Enhanced (or Engineered) Geothermal Systems (EGS) with higher permeability and improved heat transfer to increase heat production. In this paper, we document our effort to develop a numerica...

Carrigan, C. et al Lawrence Livermore National Laboratory

Jan 01, 2011
2 Resources
0 Stars
Publicly accessible

GEO3D Three-Dimensional Computer Model of a Ground Source Heat Pump System

This file is the setup file for GEO3D, a computer program written by Jim Menart to simulate vertical wells in conjunction with a heat pump for ground source heat pump (GSHP) systems. This is a very detailed three-dimensional computer model. This program produces detailed heat tran...

Menart, J. Wright State University

Jun 07, 2013
3 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 3 Magnetotelluric (MT) Data

New high-quality tensor MT data at 122 sites, including the vertical magnetic field and utilizing ultra-remote referencing, have been acquired over the Utah FORGE project area. The results will be used to delineate the densities of faults and fractures in crystalline basement rock...

Wannamaker, P. and Maris, V. Energy and Geoscience Institute at the University of Utah

Oct 01, 2020
5 Resources
0 Stars
Publicly accessible

Tularosa Basin Play Fairway Analysis: Temperature, Geochemistry, and Gravity Data

This submission contains multiple excel spreadsheets and associated written reports. The datasets area are representative of shallow temperature, geochemistry, and other well logging observations made across WSMR (white sands missile range); located to the west of the Tularosa Bas...

Nash, G. Energy and Geoscience Institute at the University of Utah

Jun 16, 2017
9 Resources
0 Stars
Publicly accessible

Comparative Analysis of Alternative Means for Removing Noncondensable Gases from Flashed-Steam Geothermal Power Plants:April 1999 March 2000

This dataset corresponds to the final report on a screening study to compare six methods of removing noncondensable gases from direct-use geo-thermal steam power plants. This report defines the study methodologies and compares the performance and economics of selected gas-removal ...

Hallett, K. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
3 Resources
0 Stars
In curation

TEAMER: Tidal Currents in San Juan Archipelago, Washington

Re-analyzed acoustic Doppler current profiler (ADCP) data originally collected by NOAA CO-OPS (Center for Operational Oceanographic Products and Services) and equivalent point data from Pacific Northwest National Laboratory's FVCOM (Finite Volume Community Ocean Model) model of th...

Polagye, B. et al University of Washington

Dec 15, 2022
3 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Second Set Tracer Test Results

The EGS Collab project is developing ~10-20 m-scale field sites where fracture stimulation and flow models can be validated against controlled, small-scale, in-situ experiments. The first multi-well experimental site was established at the 4850 level in the Homestake Mine in Lead,...

Neupane, G. et al Idaho National Laboratory

Dec 19, 2019
4 Resources
0 Stars
Publicly accessible

Thermal-Hydrological-Mechanical Modelling of Stockton University Reservoir Cooling System, Fine Scale Stress Test Modelling

Mesh, properties, initial conditions, injection/withdrawal rates for modelling thermal, hydrological, and mechanical effects of fluid injection to and withdrawal from ground for Stockton University reservoir cooling system (aquifer storage cooling system), Galloway, New Jersey, fo...

Smith, J. et al Lawrence Berkeley National Laboratory

Feb 22, 2021
14 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 56-32 Drilling Data and Logs

This dataset consists of drilling data (Pason data spreadsheets, daily reports, days v. depth, mud logs), Schlumberger logs (FMI, shear anisotropy analysis, memory, sonic, array induction/spectral density/dual spaced neutron/gamma ray/caliper, spectral GR/temperature, and Gardner ...

Bristol, J. et al Energy and Geoscience Institute at the University of Utah

Mar 19, 2021
18 Resources
0 Stars
Publicly accessible

Development of a Neutron Diffraction Based Experimental Capability for Investigating Hydraulic Fractures for EGS-like Conditions

Understanding the relationship between stress state, strain state and fracture initiation and propagation is critical to the improvement of fracture simulation capability if it is to be used as a tool for guiding hydraulic fracturing operations. The development of fracture predict...

Polsky, Y. et al Oak Ridge National Laboratory

Feb 01, 2013
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 58-32 Schlumberger FMI Logs DLIS and XML files

This zipped data set includes Schlumberger FMI logs DLIS and XML files from Utah FORGE deep well 58-32. These include runs 1 (2226-7550 ft) and 2 (7440-7550 ft). Run 3 (7390-7527ft) was acquired during phase 2C.

Nash, G. and Moore, J. Energy and Geoscience Institute at the University of Utah

Nov 17, 2017
4 Resources
0 Stars
Publicly accessible

Life Cycle Water Consumption and Water Resource Assessment for Utility-Scale Geothermal Systems: An In-Depth Analysis of Historical and Forthcoming EGS Projects

This report is the third in a series of reports sponsored by the U.S. Department of Energy Geothermal Technologies Program in which a range of water-related issues surrounding geothermal power production are evaluated. The first report made an initial attempt at quantifying the li...

Schroeder, J. et al Argonne National Laboratory

Aug 31, 2013
11 Resources
0 Stars
Publicly accessible

University of Illinois Campus Deep Direct-Use Feasibility Study Regional Geology

Links to papers and reports describing the structure and character of the Illinois Basin geology. Included are descriptions of the two reservoirs that are being modeled for the DDU feasibility project at University of Illinois, the St. Peter and Mt. Simon Sandstones.

Lin, Y. et al University of Illinois

Mar 30, 2018
4 Resources
0 Stars
Publicly accessible

Thermal-Hydrological-Mechanical Modelling of Stockton University Reservoir Cooling System, Large Scale Grid

Mesh, properties, initial conditions, injection/withdrawal rates for modeling thermal, hydrological, and mechanical effects of fluid injection to and withdrawal from ground for Stockton University reservoir cooling system (aquifer storage cooling system), Galloway, New Jersey, on ...

Smith, J. et al Lawrence Berkeley National Laboratory

Feb 26, 2021
15 Resources
0 Stars
Publicly accessible

Utah FORGE 2439: A Multi-Component Approach to Characterizing In-Situ Stress

Core-based in-situ stress estimation, Triaxial Ultrasonic Velocity (labTUV) data, and Deformation Rate Analysis (DRA) data for Utah FORGE well 16A(78)-32 using triaxial ultrasonic velocity and deformation rate analysis. Report documenting a multi-component approach to characterizi...

Bunger, A. et al Battelle Memorial Institute

Dec 13, 2022
4 Resources
0 Stars
Publicly accessible

Low-Temperature Hydrothermal Resource Potential Estimate

Compilation of data (spreadsheet and shapefiles) for several low-temperature resource types, including isolated springs and wells, delineated area convection systems, sedimentary basins and coastal plains sedimentary systems. For each system, we include estimates of the accessible...

Mullane, M. et al National Renewable Energy Laboratory

Jun 30, 2016
3 Resources
0 Stars
Publicly accessible

The Urban Energy-Water Nexus: Utility-Level Water Flows and Embedded Energy

There are limited open source data available for determining water production/treatment and required energy for cities across the United States. This database represents the culmination of a two-year effort to obtain data from cities across the United States via open records reque...

Chini, C. and Stillwell, A. University of Illinois at Urbana-Champaign

Feb 20, 2018
114 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 6 7 8 9 Next >>