Search OEDI Data

Showing results 1 - 25 of 86.
Show results per page.
Order by:
Available Now:
Clear All Filters ×
Research Areas
Accessibility
Data Type
Organization
Source
"hydraulic properties"×
Website×

Hybrid machine learning model to predict 3D in-situ permeability evolution

Enhanced geothermal systems (EGS) can provide a sustainable and renewable solution to the new energy transition. Its potential relies on the ability to create a reservoir and to accurately evaluate its evolving hydraulic properties to predict fluid flow and estimate ultimate therm...
Elsworth, D. and Marone, C. Pennsylvania State University
Nov 22, 2022
4 Resources
0 Stars
Publicly accessible

Resource Analysis for Deep Direct-Use Feasibility Study in East Texas

The National Renewable Energy Laboratory, Southern Methodist University Geothermal Laboratory, Eastman Chemical, Turbine Air Systems, and the Electric Power Research Institute are evaluating the feasibility of using geothermal heat to improve the efficiency of natural gas power pl...
Richards, M. et al Southern Methodist University
Jun 28, 2018
13 Resources
0 Stars
Publicly accessible

STRESSINVERSE Software for Stress Inversion

The STRESSINVERSE code uses an iterative method to find the nodal planes most consistent with the stress field given fault frictional properties. STRESINVERSE inverts the strike, rake and dip from moment tensor solutions for the in-situ state of stress. The code iteratively solves...
Gritto, R. Array Information Technology
Oct 31, 2018
1 Resources
0 Stars
Publicly accessible

Distributed Acoustic Sensing (DAS) of Strain at Earth Tide Frequencies: Laboratory Tests

The solid Earth strains in response to the gravitational pull from the Moon, Sun, and other planetary bodies. Measuring the flexure of geologic material in response to these Earth tides provides information about the geomechanical properties of rock and sediment. Such measurements...
Coleman, T. and Becker, M. California State University
Jan 24, 2018
2 Resources
0 Stars
Publicly accessible

Seismic Analysis of Spatio-Temporal Fracture Generation During EGS Resource Development Deviatoric MT, Fracture Network, and Final Report

This submission contains 167 deviatoric moment tensor (MT) solutions for the seismicity observed two years prior and three years post start of injection activities at The Geysers Prati 32 EGS Demonstration. Also included is a statistical representation of the properties of 751 fra...
Gritto, R. et al Array Information Technology
Sep 01, 2018
3 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: 4100 Foot Level Elastic Property Data

Static and dynamic elastic properties (Young's modulus, Shear Modulus, P-wave Modulus, and Poisson's Ratio) of amphibolites and rhyolites from the TV4100 and TH4100 boreholes at the Sanford Underground Research Laboratory (SURF). Elastic properties include Young's modulus, Poisson...
Jahnke, B. et al Lawrence Berkeley National Laboratory
Dec 18, 2020
4 Resources
0 Stars
Publicly accessible

University of Illinois Campus Deep Direct-Use Feasibility Study Thermal Properties of Geologic Formations in Illinois Basin

Thermal property data for rocks and and minerals and unconsolidated (glacial) sediments units from within and outside the Illinois Basin were compiled for modeling heat transport in the subsurface.
Lin, Y. et al University of Illinois
Mar 30, 2018
6 Resources
0 Stars
Publicly accessible

Advanced TidGen Power System Composites Structural Testing

Seawater aging response was investigated in marine-grade glass/epoxy, glass/vinyl ester, carbon/epoxy and carbon/vinyl ester composites with respect to water uptake, interlaminar shear strength, flexural strength, tensile strength, and tensile fracture surface observations. The re...
Krumpe, A. ORPC Inc.
Jan 06, 2020
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Shear Stimulation ERT Monitoring Data

This repository contains the electrical resistivity tomography (ERT) monitoring data that was collected before, during, and after shear stimulation attempts were conducted at EGS Collab. These tests were carried out on the SURF 4100 level during Experiment 2 in March, 2022. Flow a...
Johnson, T. Pacific Northwest National Laboratory
Mar 06, 2023
4 Resources
0 Stars
Publicly accessible

HERO WEC V1 Upgrade 2023 Laboratory Testing (Raw Data)

This submission contains the original, unprocessed data from the 2023 Large Amplitude Motion Platform (LAMP) testing of NREL's Hydraulic and Electric Reverse Osmosis Wave Energy Converter (HERO WEC). This data serves as a companion to MHKDR #520. Data was collected using NREL's Mo...
Jenne, S. et al National Renewable Energy Laboratory
Jan 01, 2024
6 Resources
0 Stars
Publicly accessible

HERO WEC V1 Upgrade 2023 Laboratory Testing (processed data)

The following submission includes processed laboratory data from NREL's Hydraulic and Electric Reverse Osmosis Wave Energy Converter (HERO WEC), in the form of MATLAB workspaces. This dataset was created using NREL's Large Amplitude Motion Platform (LAMP) and collected between Aug...
Panzarella, J. et al National Renewable Energy Laboratory
Jan 01, 2024
12 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2446: Characterizing Stress Roughness Through Simulation of Hydraulic Fracture Growth

This dataset covers work that investigated the apparent toughness anisotropy at Utah FORGE by comparing microseismic data with stress profiles from field measurements. The study analyzes the hydraulic fracture growth of Stage 3 at Well 16A(78)-32 using MEQ data, calibrating a nume...
Cusini, M. and Fei, F. Lawrence Livermore National Laboratory
Jan 30, 2025
3 Resources
0 Stars
Publicly accessible

HERO WEC V1.0 WEC-Sim Model

This zip file contains the files that are needed to simulate NREL's HERO WEC (hydraulic and electric reverse osmosis wave energy converter). This requires the user to have already installed WEC-Sim. In addition to the standard toolboxes that are required to run WEC-Sim the user wi...
Jenne, S. National Renewable Energy Laboratory
Aug 12, 2022
2 Resources
0 Stars
Publicly accessible

Geocellular model of St. Peter Sandstone for University of Illinois at Urbana-Champaign DDU Feasibility Study

The geocellular model of the St. Peter Sandstone was constructed for the University of Illinois at Urbana-Champaign DDU feasibility study. Starting with the initial area of review (18.0 km by 18.1 km [11.2 miles by 11.3 miles]) the boundaries of the model were trimmed down to 9.7 ...
Damico, J. University of Illinois
Dec 31, 2018
5 Resources
0 Stars
Publicly accessible

Chemical, Calcium Phosphate Cements for Geothermal Wells Corrosion Protection, Bond Strength and Matrix Self-Healing

The data set shows performance of economical calcium phosphate cement (Fondu) blended with fly ash, class F (FAF) in carbon steel corrosion protection tests (corrosion rate, corrosion current and potential), bond and matrix strength, as well as matrix strength recovery after impos...
Sugama, T. Brookhaven National Laboratory
Sep 26, 2017
2 Resources
0 Stars
Publicly accessible

Distributed Acoustic Sensing (DAS) for Periodic Hydraulic Tests: Laboratory Data

These data were collected in the laboratory located at California State University Long Beach. They consist of DAS data collected from a fiber optic cable placed in a tank of water, subjected to oscillating head. These tests are described in the article linked below.
Coleman, T. California State University
Feb 27, 2015
5 Resources
0 Stars
Publicly accessible

Final Report Earth Source Heat: A Cascaded Systems Approach to DDU of Geothermal Energy on the Cornell Campus

The purpose of this document is to describe the contents contained within Geothermal Data Repository (GDR) node of the National Geothermal Data System (NGDS) that serves as the final report for the project "Earth Source Heat: A Cascaded Systems Approach to DDU of Geothermal Energy...
Tester, J. et al Cornell University
Oct 27, 2019
6 Resources
0 Stars
Publicly accessible

HERO WEC V1.0 WEC-Sim Model (July 2024)

**This submission supersedes submission MHKDR-483** This submission file contains the files that are needed to simulate NREL's HERO WEC (hydraulic and electric reverse osmosis wave energy converter). This requires the user to have already installed WEC-Sim. In addition to the sta...
Panzarella, J. et al National Renewable Energy Laboratory
Jul 01, 2024
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Common Discrete Fracture Network

This package includes data and models that support hydraulic fracture stimulation and fluid circulation experiments in the Sanford Underground Research Facility (SURF). A paper by Schwering et al. (2020) describes the deterministic basis for developing a "common" discrete fracture...
Schwering, P. et al Sandia National Laboratories
Sep 18, 2019
4 Resources
0 Stars
Publicly accessible

HERO WEC V1.0 SolidWorks Model

The attached zip file includes a SolidWorks pack-and-go assembly of NREL's HERO WEC (hydraulic and electric reverse osmosis wave energy converter) V1.0. This model does not include all aspects of the design (i.e. RO (reverse osmosis) system, electrical enclosure, hose, cable) it o...
Jenne, S. National Renewable Energy Laboratory
Aug 12, 2022
2 Resources
0 Stars
Publicly accessible

Active Source Seismic (Ultrasonic) Data from Double-Direct Shear Lab Experiments

Active source ultrasonic data from lab experiments p5270 and p5271 including raw waveforms (WF) and mechanical data (mat). From the PSU team working on the "Machine Learning Approaches to Predicting Induced Seismicity and Imaging Geothermal Reservoir Properties" project. The fric...
Marone, C. Pennsylvania State University
May 05, 2021
1 Resources
0 Stars
Publicly accessible

Alternative CAES Technology Using Depleted Unconventional Gas Wells and Subsurface Thermal Energy Storage (GeoCAES)

This project assessed the technical viability of a process called GeoCAES. The process stores electrical energy by injecting natural gas into shale gas formations using a compressor, storing it, and producing it through an expander to generate electricity. This data submission inc...
Johnston, H. and Young, D. National Renewable Energy Laboratory
May 23, 2019
8 Resources
0 Stars
Publicly accessible

HERO WEC V1.0 WEC-Sim Detailed Simulation Runs and Summary Data

Data sets from simulation runs include 144 wave cases that were run based on the WEC-Sim model (https://mhkdr.openei.org/submissions/483). The 144 wave cases represent waves with the following wave height and wave period ranges: Significant Wave Height: 0.25 4.0m in 0.25m incre...
Jenne, S. National Renewable Energy Laboratory
Aug 12, 2022
9 Resources
0 Stars
Publicly accessible

Laboratory Upgrade Point Absorber (LUPA) CAD Files

The Laboratory Upgrade Point Absorber (LUPA) is an open-source wave energy converter designed and tested by Oregon State University. The computer-aided design (CAD) files are provided here in two forms: the original SOLIDWORKS (2021) model as "LUPA SOLIDWORKS.zip" and as a STEP fi...
Beringer, C. et al Oregon State University
Nov 04, 2024
7 Resources
0 Stars
Publicly accessible

HERO WEC V1.0 Electrical PTO Deployment Data and Analysis

This submission includes the processed and raw field electrical data from NREL's August 2022 HERO WEC (hydraulic and electric reverse osmosis wave energy converter) deployment at Jennette's Pier for the electrical PTO (power take-off).
Nakhai, A. et al National Renewable Energy Laboratory
Aug 12, 2022
4 Resources
0 Stars
Publicly accessible
1234Next >>