Search OEDI Data

Utah FORGE Core Material Friction Experiments

The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...

Marone, C. et al The Pennsylvania State University

Mar 15, 2023
7 Resources
0 Stars
Publicly accessible

Resource Analysis for Deep Direct-Use Feasibility Study in East Texas

The National Renewable Energy Laboratory, Southern Methodist University Geothermal Laboratory, Eastman Chemical, Turbine Air Systems, and the Electric Power Research Institute are evaluating the feasibility of using geothermal heat to improve the efficiency of natural gas power pl...

Richards, M. et al Southern Methodist University

Jun 28, 2018
13 Resources
0 Stars
Publicly accessible

High-Pressure Combustion and Deflagration-to-Detonation Transition in Ethylene/Nitrous Oxide Mixtures

In this paper, the combustion of nitrous oxide with a simple hydrocarbon, ethylene, at high initial pressures is investigated. A series of experiments were conducted using a stoichiometric C2H4-N2O mixture in a round, smooth-walled tube with initial pressures of 125 to 337 psi. ...

Grubelich, M. Sandia National Laboratories

Nov 01, 2013
1 Resources
0 Stars
Publicly accessible

TidGen MHK Generator Composite Fatigue Analysis Procedure

A procedure was described for performing a fatigue analysis of composite foils for an MHK generator. The steps included generating load data, S-N (Stress versus Number of cycles to failure) diagrams through fatigue testing, cycle counts, damage versus load, and cumulative damage. ...

Krumpe, A. ORPC Inc.

Apr 14, 2020
2 Resources
0 Stars
Publicly accessible

Utah FORGE: 2023 Induced Seismicity Mitigation Plan

This is the updated Utah FORGE Phase 3B induced seismicity mitigation plan (ISMP) covering the general Utah FORGE area. This new version incorporates newly collected seismic data, including data collected during the 2022 stimulation and a probabilistic seismic hazard assessment (...

Pankow, K. et al University of Utah Seismograph Stations

Aug 09, 2023
1 Resources
0 Stars
Publicly accessible

Bradys Geothermal Field MEQ Relocations 3D Velocity Models

Hypocenters of local microearthquakes and 3D P and S-velocity models computed by simultaneous inversion of arrival times recorded by the Brady seismic network Nov 2010-Mar 2015.

Foxall, W. University of Wisconsin

Jul 01, 2015
4 Resources
0 Stars
Publicly accessible

Hydrokinetic Canal Measurements: Inflow Velocity, Wake Flow Velocity, and Turbulence

The dataset consist of acoustic Doppler current profiler (ADCP) velocity measurements in the wake of a 3-meter diameter vertical-axis hydrokinetic turbine deployed in Roza Canal, Yakima, WA, USA. A normalized hub-centerline wake velocity profile and two cross-section velocity con...

Gunawan, B. Sandia National Laboratories

Jun 11, 2014
4 Resources
0 Stars
Publicly accessible

Utah FORGE LBNL 3-2535 Preliminary Report on Development of a Reservoir Seismic Velocity Model

This report describes the development of a preliminary 3D seismic velocity model at the Utah FORGE site and first results from estimating seismic resolution in the generated fracture volume during Stage 3 of the April 2022 stimulation. A preliminary 3D velocity model for the larg...

Gritto, R. Array Information Technology

Jan 30, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE Development of a Reservoir Seismic Velocity Model and Seismic Resolution Study

This is data from and a final report on the development of a 3D velocity model for the larger FORGE area and on the seismic resolution in the stimulated fracture volume at the bottom of well 16A-32. The velocity model was developed using RMS velocities of the seismic reflection su...

Vasco, D. and Chan, C. Array Information Technology

Apr 30, 2022
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: 3D Seismic Velocity Model and Updated Microseismic Catalog Using Transfer-Learning Aided Double-Difference Tomography

This package contains a 3D Seismic velocity model and an updated microseismic catalog associated with a proceedings paper (Chai et al., 2020) published in the 45th Workshop on Geothermal Reservoir Engineering. The 3D_seismic_velocity_model text file contains x (m), y(m), z(m), P-w...

Chai, C. et al Oak Ridge National Laboratory

Apr 20, 2020
7 Resources
0 Stars
Publicly accessible

Brady Geothermal 1D Seismic Velocity Model

This submission contains an ASCII text file of seismic velocities derived from ambient noise cross-correlation used to create a model of seismic velocity as a 1-D function of depth in addition to a quarterly report describing the creation and use of the model. Model uses 28 Green'...

Matzel, E. Lawrence Livermore National Laboratory

Feb 17, 2015
2 Resources
0 Stars
Publicly accessible

Utah FORGE Well 58-32 Granite Core Thermal Properties Test Results Report (Oct. 2021)

This is a presentaiton from Metarock Laboratories on the thermal properties of Utah FORGE well 58-32 granite core. The presentation includes pictures of core samples, core details for the samples (sample depths and size), sample thermal expansion test results, and radial velocity ...

Laboratories, M. Energy and Geoscience Institute at the University of Utah

Oct 29, 2021
1 Resources
0 Stars
Publicly accessible

Techno-Economic Assessment for Integrating Biosorption into Rare Earth Recovery Process

The current uncertainty in the global supply of rare earth elements (REEs) necessitates the development of novel extraction technologies that utilize a variety of REE source materials. Herein, we examined the techno-economic performance of integrating a biosorption approach into a...

Jiao, Y. et al Lawrence Livermore National Laboratory

Oct 09, 2017
1 Resources
0 Stars
Publicly accessible

Advanced TidGen Power System Composites Structural Testing

Seawater aging response was investigated in marine-grade glass/epoxy, glass/vinyl ester, carbon/epoxy and carbon/vinyl ester composites with respect to water uptake, interlaminar shear strength, flexural strength, tensile strength, and tensile fracture surface observations. The re...

Krumpe, A. ORPC Inc.

Jan 06, 2020
2 Resources
0 Stars
Publicly accessible

Test Report for Detonation Velocity Measurements

Test report for detonation velocity measurements. A series of tests were conducted to determine reaction rate and general behavior of aluminum (AL) and magnesium (MG) powder mixtures (metalized explosives) with Bullseye double-base smokeless propellant. Given the indeterminate sen...

Grubelich, M. Sandia National Laboratories

Jan 13, 2014
1 Resources
0 Stars
Publicly accessible

ORPC RivGen Hydrokinetic Turbine Wake Characterization

Field measurements of mean flow and turbulence parameters at the Kvichak river prior to and after the deployment of ORPC's RivGen hydrokinetic turbine. Data description and turbine wake analysis are presented in the attached manuscript "Wake measurements from a hydrokinetic river ...

Thomson, J. and Guerra, M. University of Washington

Feb 27, 2018
4 Resources
0 Stars
Publicly accessible

Observation-Based Resource Assessment of Gulf Stream MHK

Multi-year measurements of current velocity, salinity, and temperature from fixed and vessel-mounted sensors quantify Gulf Stream (GS) MHK resource variability and inform development off Cape Hatteras, NC. Vessel transects across the GS demonstrate a jet-like velocity structure wi...

Muglia, M. et al North Carolina State University

Jan 01, 2020
1 Resources
0 Stars
Publicly accessible

Utah FORGE Project 2439: A Multi-Component Approach to Characterizing In-Situ Stress

Core-based in-situ stress estimation, Triaxial Ultrasonic Velocity (labTUV) data, and Deformation Rate Analysis (DRA) data for Utah FORGE well 16A(78)-32 using triaxial ultrasonic velocity and deformation rate analysis. Report documenting a multi-component approach to characterizi...

Bunger, A. et al Battelle Memorial Institute

Dec 13, 2022
4 Resources
0 Stars
Publicly accessible

Active Source 3D Seismic Tomography of Brady Hot Springs Geothermal Field, Nevada

We deployed a dense seismic array to image the shallow structure in the injection area of the Brady Hot Springs geothermal site in Nevada. The array was composed of 238 5 Hz, three-component nodal instruments and 8,700 m of distributed acoustic sensing (DAS) fiber-optic cable inst...

Parker, L. University of Wisconsin

Aug 09, 2017
1 Resources
0 Stars
Publicly accessible

Admiralty Inlet Hub-Height Turbulence Measurements from June 2012

This data is from measurements at Admiralty Head, in Admiralty Inlet. The measurements were made using an IMU equipped ADV mounted on a mooring, the 'Tidal Turbulence Mooring' or 'TTM'. The inertial measurements from the IMU allows for removal of mooring motion in post processing....

Kilcher, L. National Renewable Energy Laboratory

Jun 18, 2012
7 Resources
0 Stars
Publicly accessible

Aquantis 2.5 MW Ocean Current Generation Device Design Details

Items in this submission provide the detailed design of the Aquantis Ocean Current Turbine and accompanying analysis documents, including preliminary designs, verification of design reports, CAD drawings of the hydrostatic drivetrain, a test plan and an operating conditions simula...

Banko, R. et al Dehlsen Associates, LLC

Jun 03, 2015
22 Resources
0 Stars
Publicly accessible

Resource Analysis for Deep Direct-Use Feasibility Study in East Texas, Part 2

Richards, M. et al Southern Methodist University

Mar 01, 2019
6 Resources
0 Stars
Publicly accessible

Next Generation RivGen Power System: Kvichak River, AK Overwinter Ice Study

The University of Alaska Fairbanks (UAF) Alaska Hydrokinetic Energy Research Center was tasked with developing a real-time data telemetry / remote power generation system to monitor frazil ice conditions in the Kvichak River in support of the U.S. Department of Energy funded "Next...

Kasper, J. et al Igiugig Village Council

Oct 04, 2017
5 Resources
0 Stars
Publicly accessible

Tidal Turbine Test, Downeast Turbines, July 12, 2021

Downeast Turbines tested a tidal turbine prototype with novel rotor/channel system and lateral effluent discharge apparatus (LEDA), during five days of testing in the flume at Alden Lab. Three days of testing (July 12-14, 2021) focused on turbine power metrics of torque and rpm, w...

McBride, G. Downeast Turbines

Mar 26, 2022
6 Resources
0 Stars
Publicly accessible

Directional Cooling-Induced Fracturing Westerly Granite Test Results

Directional Cooling-Induced Fracturing (DCIF) experiments were conducted on a short, cylindrical sample of Westerly granite (diameter = 4 inches, height ~ 2 inches). Liquid nitrogen was poured in a copper cup attached to the top of the sample, and the resulting acoustic emissions ...

Nakagawa, S. Lawrence Berkeley National Laboratory

Dec 18, 2020
5 Resources
0 Stars
Publicly accessible

1 2 3 Next >>