Search OEDI Data

Analysis of Joist Masonry Moisture Content Monitoring

BSC TO5 Task 7.2 Analysis of Joist Masonry Moisture Content Monitoring House Lawrence, MA 01840 This work involved the field monitoring of embedded wood joist ends in a solid brick building in zone 5A that was retrofitted with interior insulation. Eleven joists throughout the bui...

Ueno, K. Building Science Corporation

Apr 27, 2016
3 Resources
0 Stars
Publicly accessible

TidGen MHK Generator Composite Fatigue Analysis Procedure

A procedure was described for performing a fatigue analysis of composite foils for an MHK generator. The steps included generating load data, S-N (Stress versus Number of cycles to failure) diagrams through fatigue testing, cycle counts, damage versus load, and cumulative damage. ...

Krumpe, A. ORPC Inc.

Apr 14, 2020
2 Resources
0 Stars
Publicly accessible

DCIF (Directional Cooling-Induced Fracturing) Westerly Granite AE Borehole Damage Effect Test (Task 3-0)

Directional Cooling-Induced Fracturing (DCIF) experiments were conducted on three rectangular Westerly granite blocks (width=depth=4.0", height=2.0") which were preheated to 200, 400, and 600 degree C to induce damage (microcracks) with varying degrees. Liquid nitrogen was poured...

Nakagawa, S. Lawrence Berkeley National Laboratory

Jan 27, 2022
13 Resources
0 Stars
Publicly accessible

2014 Wind Turbine Gearbox Damage Distribution based on the NREL Gearbox Reliability Database

Despite the improvements in wind turbine gearbox design and manufacturing practices, the wind industry is still challenged by premature wind turbine gearbox failures. To help address this industry-wide challenge, a consortium called the Gearbox Reliability Collaborative (GRC) was ...

Sheng, S. National Renewable Energy Laboratory

Feb 09, 2015
1 Resources
0 Stars
In curation

Moisture Risk in Unvented Attics Due to Air Leakage Paths Minneapolis Minnesota

IBACOS completed an initial analysis of moisture damage potential in an unvented attic insulated with closed-cell spray polyurethane foam. To complete this analysis, the research team collected field data, used computational fluid dynamics to quantify the airflow rates through ind...

Rapport, A. et al Ibacos Innovation

Apr 27, 2016
6 Resources
0 Stars
Publicly accessible

Advanced TidGen Power System Composites Structural Testing

Seawater aging response was investigated in marine-grade glass/epoxy, glass/vinyl ester, carbon/epoxy and carbon/vinyl ester composites with respect to water uptake, interlaminar shear strength, flexural strength, tensile strength, and tensile fracture surface observations. The re...

Krumpe, A. ORPC Inc.

Jan 06, 2020
2 Resources
0 Stars
Publicly accessible

Simulations of Brady's-Type Fault Undergoing CO2 Push-Pull: Pressure-Transient and Sensitivity Analysis

Input and output files used for fault characterization through numerical simulation using iTOUGH2. The synthetic data for the push period are generated by running a forward simulation (input parameters are provided in iTOUGH2 Brady GF6 Input Parameters.txt [InvExt6i.txt]). In gene...

Jung, Y. and Doughty, C. Lawrence Berkeley National Laboratory

Mar 09, 2018
11 Resources
0 Stars
Publicly accessible

Repetitive Regeneration of Media #1 in a Dynamic Column Extraction using Brine #1

This data is from a regeneration study from a dynamic column extraction experiment where we ran a solution of REE's through a column of media #1 then stripped the REE's off the media using 2M HNO3 solution. We then re-equilibrated the media and repeated the process of running a RE...

Garland, G. Tusaar Corp.

Oct 14, 2015
4 Resources
0 Stars
Publicly accessible

Wind Turbine Gearbox Condition Monitoring Vibration Analysis Benchmarking Datasets

Wind turbine condition monitoring (CM) can potentially help the wind industry reduce turbine downtime and operation and maintenance (O&M) cost. NREL CM research has investigated various condition-monitoring techniques such as acoustic emission (AE specifically stress wave), vibrat...

Sheng, S. National Renewable Energy Laboratory

Mar 28, 2014
5 Resources
2 Stars
Publicly accessible

Measure Guideline: Deep Energy Enclosure Retrofit for Interior Insulation of Masonry Walls and Flat Roofs

Measure Guideline: Deep Energy Enclosure Retrofit for Zero Energy Ready House Flat Roofs BSC TO5 Task 7.4 Deep Energy Enclosure Retrofit (DEER) for Interior Insulation of Masonry Walls Lawrence, MA 01840 This Measure Guideline describes a deep energy enclosure retrofit solution ...

Musunuru, S. et al Building Science Corporation

Apr 27, 2016
5 Resources
0 Stars
Publicly accessible

Observation-Based Resource Assessment of Gulf Stream MHK

Multi-year measurements of current velocity, salinity, and temperature from fixed and vessel-mounted sensors quantify Gulf Stream (GS) MHK resource variability and inform development off Cape Hatteras, NC. Vessel transects across the GS demonstrate a jet-like velocity structure wi...

Muglia, M. et al North Carolina State University

Jan 01, 2020
1 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2417: Pulsed Interference Tests at Wells 16A(78)-32 and 16B(78)-32 September 2024

This archive contains data and a report from Pulse Interference Tests (PITs), which were conducted on September 4, 2024, immediately following a 30-day recirculation test at the Utah FORGE site. Injection and backflow were induced in well 16A(78)-32 while pressures were measured i...

W Becker, M. et al Rice University

Mar 18, 2025
3 Resources
0 Stars
Publicly accessible

CO2 Push-Pull Single Fault Injection Simulations

ASCII text files containing grid-block name, X-Y-Z location, and multiple parameters from TOUGH2 simulation output of CO2 injection into an idealized single fault representing a dipping normal fault at the Desert Peak geothermal field (readable by GMS). The fault is composed of a ...

Borgia, A. et al Lawrence Berkeley National Laboratory

Sep 21, 2017
5 Resources
0 Stars
Publicly accessible

Active Source 3D Seismic Tomography of Brady Hot Springs Geothermal Field, Nevada

We deployed a dense seismic array to image the shallow structure in the injection area of the Brady Hot Springs geothermal site in Nevada. The array was composed of 238 5 Hz, three-component nodal instruments and 8,700 m of distributed acoustic sensing (DAS) fiber-optic cable inst...

Parker, L. University of Wisconsin

Aug 09, 2017
1 Resources
0 Stars
Publicly accessible

TEAMER: OSU X Hinsdale & Sandia LUPA Uncertainty Testing

This processed data is from TEAMER testing through RFTS 7 at the O.H. Hinsdale Wave Research Laboratory in Corvallis, Oregon. This testing was conducted by Oregon State University (OSU) and Sandia National Laboratories in October and November 2023. The Laboratory Upgrade Point Abs...

Robertson, B. et al Oregon State University

Oct 19, 2023
6 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Continuous Active-Source Seismic Monitoring (CASSM) Data

The U.S. Department of Energy's Enhanced Geothermal System (EGS) Collab project aims to improve our understanding of hydraulic stimulations in crystalline rock for enhanced geothermal energy production through execution of intensely monitored meso-scale experiments. The first expe...

Schoenball, M. and Sprinkle, P. Lawrence Berkeley National Laboratory

Apr 25, 2018
6 Resources
0 Stars
Publicly accessible

Spray Foam Exterior Insulation with Stand-Off Furring New York

IBACOS and Green Homes America 1 (GHA) collaborated with the New York State Energy Research and Development Authority (NYSERDA) Advanced Buildings Program to research a variation of a commercial curtain wall assembly for residential construction as part of a comprehensive whole-ho...

Rapport, A. et al Ibacos Innovation

Apr 27, 2016
2 Resources
0 Stars
Publicly accessible

Material Properties for Brady Hot Springs Nevada USA from PoroTomo Project

The PoroTomo team has completed inverse modeling of the three data sets (seismology, geodesy, and hydrology) individually, as described previously. The estimated values of the material properties are registered on a three-dimensional grid with a spacing of 25 meters between nodes....

Feigl, K. and PoroTomo Team, . University of Wisconsin

Mar 06, 2019
10 Resources
0 Stars
Publicly accessible

A Conceptual Geologic Model for the Newberry Volcano EGS Site in Central Oregon: Constraining Heat Capacity and Permeability through Interpretation of Multicomponent Geosystems Data

Newberry Volcano, a voluminous (500 km3) basaltic/andesitic/rhyolitic shield volcano located near the intersection of the Cascade volcanic arc, the Oregon High Lava Plains and Brothers Fault Zone, and the northern Basin and Range Province, has been the site of geothermal explorati...

Mark-Moser, M. et al National Energy Technology Laboratory

Feb 22, 2016
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 58-32 Stimulation Conference Paper and Data

The U.S. Department of Energy's (U.S. DOE) Frontier Observatory for Research in Geothermal Energy (FORGE) is a field laboratory that provides a unique opportunity to develop and test new technologies for characterizing, creating and sustaining Enhanced Geothermal Systems (EGS) in ...

Best, S. Energy and Geoscience Institute at the University of Utah

Apr 24, 2019
2 Resources
0 Stars
Publicly accessible

Monitoring of Double-Stud Wall Moisture Conditions in the Northeast

BSC TO5 Task 2.2 Monitoring of Double Stud Wall Moisture Conditions in the Northeast Field test data available for wood moisture contents, temperature, and relative humidity. STRUCTURE House Devens, MA 01432 Three double-stud assemblies were compared: 12-in. ocSPF, 12-in. cellulo...