Search OEDI Data

Utah FORGE 3-2417: Pulsed Interference Tests at Wells 16A(78)-32 and 16B(78)-32 September 2024

This archive contains data and a report from Pulse Interference Tests (PITs), which were conducted on September 4, 2024, immediately following a 30-day recirculation test at the Utah FORGE site. Injection and backflow were induced in well 16A(78)-32 while pressures were measured i...

W Becker, M. et al Rice University

Mar 18, 2025
3 Resources
0 Stars
Publicly accessible

Illinois High Resolution Wind Resource

Annual average wind resource potential of Illinois at a 50 meter height. This data set was produced and validated by NREL using their WRAM model. This shapefile was generated from a raster dataset with a 1000 m resolution, in a Transverse Mercator projection with the following ...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
3 Resources
0 Stars
In curation

Identifying and Delineating Thermally Active Areas in Colorado Using Thermal Remote Sensing Data

This report outlines the approach and methodology of the utilization of thermal satellite imagery to find areas of warm ground that might indicate heat flow from a buried geothermal system. The satellite platforms, modeling equations and corrections to the data are discussed. Some...

Hussein, K. Flint Geothermal, LLC

Dec 26, 2012
1 Resources
0 Stars
Publicly accessible

ALFA Biological Monitoring Density Values South Energy Test Site, Newport, Oregon

Density values from active acoustic measurements at South Energy Test Site. This data correspond to a bottom mounted upward-looking WBAT, deployed from April 19th to September 30th. Samples (175 pings) were collected hourly at 1Hz.

Horne, J. Northwest National Marine Renewable Energy Center

Apr 11, 2017
2 Resources
0 Stars
Publicly accessible

Aquantis 2.5 MW Ocean Current Generation Device MHK Hydrofoils Design, Wind Tunnel Optimization and CFD Analysis Report

Dataset contains MHK Hydrofoils Design and Optimization and CFD Analysis Report for the Aquantis 2.5 MW Ocean Current Generation Device, as well as MHK Hydrofoils Wind Tunnel Test Plan and Checkout Test Report.

Shiu, H. et al Dehlsen Associates, LLC

Jun 03, 2015
16 Resources
0 Stars
Publicly accessible

TEAMER: Advanced Wave-to-Wire OWC model in WEC-Sim

Accurate numerical models are crucial for the development of wave energy converter (WEC) technologies, providing the means for power production and lifetime assessment, site selection, and design of mooring lines, PTO systems and controllers, among other aspects. This project aims...

Peñalba, M. et al Mondragon Goi Eskola Politeknikoa

Dec 20, 2024
5 Resources
0 Stars
Publicly accessible

Snake River (Idaho) Geothermal Drilling Project: Innovative Approaches to Geothermal Exploration

The goal of our project was to test innovative exploration technologies using existing and new data, and to ground-truth these technologies using slim-hole core technology. The slim-hole core allowed us to understand subsurface stratigraphy and alteration in detail, and to correla...

Shervais, J. et al Utah State University

Feb 21, 2014
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Borehole PSS Tools Status Report

This report summarizes the data quality from the Utah FORGE borehole passive seismic sensors (PSS) tools at well sites 58-32 and 78B-32. Two level Avalon tools were installed on 09-28-2022 and 09-29-2022 by representatives from Avalon, Schlumberger, University of Utah, and Instrum...

Stachnik, J. Instrumental Software Technologies, Inc.

Dec 29, 2022
1 Resources
0 Stars
Publicly accessible

Directional Cooling-Induced Fracturing Westerly Granite Test Results

Directional Cooling-Induced Fracturing (DCIF) experiments were conducted on a short, cylindrical sample of Westerly granite (diameter = 4 inches, height ~ 2 inches). Liquid nitrogen was poured in a copper cup attached to the top of the sample, and the resulting acoustic emissions ...

Nakagawa, S. Lawrence Berkeley National Laboratory

Dec 18, 2020
5 Resources
0 Stars
Publicly accessible

Hydrokinetic Canal Measurements: Inflow Velocity, Wake Flow Velocity, and Turbulence

The dataset consist of acoustic Doppler current profiler (ADCP) velocity measurements in the wake of a 3-meter diameter vertical-axis hydrokinetic turbine deployed in Roza Canal, Yakima, WA, USA. A normalized hub-centerline wake velocity profile and two cross-section velocity con...

Gunawan, B. Sandia National Laboratories

Jun 11, 2014
4 Resources
0 Stars
Publicly accessible

TEAMER Extreme Events Modeling for the MARMOK-OWC Wave Energy Converter

Through the TEAMER program, Sandia National Laboratories (SNL) collaborated with IDOM Incorporated to study their MARMOK-Oscillating Water Column (MARMOK-OWC) wave energy conversion device. The study yielded a quantitative understanding of hydrodynamic pressures on the oscillating...

De Miguel Para, B. et al IDOM Incorporated

Dec 27, 2024
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16B(78)-32 Extended Dual Well Circulation Testing Fiber Optic Monitoring Report August 2024

This report documents the post-hydraulic fracturing extended circulation test between Utah FORGE wells 16A and 16B conducted in August 2024. In well 16B, fiber optic measurements of Rayleigh frequency shift distributed strain sensing (RFS-DSS) and distributed temperature sensing ...

Jurick, D. et al Neubrex Energy Services (US), LLC

Aug 30, 2024
1 Resources
0 Stars
Publicly accessible

Approaches to 30% Energy Savings at the Community Scale in the Hot-Humid Climate

The Building America Partnership for Improved Residential Construction, formerly the Building America Industrialized Housing Partnership, has worked with several community-scale builders within the hot-humid climate zone to improve performance of production-, or community-scale, h...

Beal, D. et al University of Central Florida Florida Solar Energy Center

Apr 27, 2016
9 Resources
0 Stars
Publicly accessible

Indoor and Outdoor Temperature data

We have used three LM35 temperature sensors to sense indoor and outdoor temperature at Bangkok University , Thailand. Two sensors (Sensor A and B)were placed in a air-conditioned room in the Engineering Building (6th Floor) and kept once sensor outside (Sensor C)

Maduranga, P. National Renewable Energy Laboratory

Jan 21, 2018
1 Resources
0 Stars
In curation

Demand Response Across the Continental US for 2006

This project estimates hourly demand response availability across the continental U.S. for the year 2006. The resulting data set is disaggregated by balancing authority area, end use, and grid application. End uses include 14 categories across residential, commercial, industrial a...

Ma, S. Office of Energy Efficiency and Renewable Energy

Sep 12, 2016
6 Resources
0 Stars
Publicly accessible

DOE Challenge Home Multifamily Development Mixed Climate

The U.S. Department of Energys Zero Energy Ready Home (ZERH) recognition program builds upon the building science requirements of ENERGY STAR Certified Homes, Version 3 and best practices tested by the Building America research and demonstration program. Multifamily units (units i...

Dentz, J. and Alaigh, K. The Levy Partnership, Inc Systems Building Research Alliance

Apr 27, 2016
5 Resources
0 Stars
Publicly accessible

Technical Report-Rare Earth Element Concentrations in Wyoming's Produced Waters

This study is a joint effort by the University of Wyoming (UW), the UW Engineering Department (UW-ENG), and Idaho National Laboratories (INL) and the United States Geological Survey (USGS) to describe rare earth element concentrations in oil and gas produced waters. In this work w...

Quillinan, S. et al University of Wyoming

Jul 01, 2017
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Seismic Activity from April, 2019

This dataset contains seismic event detections acquired using the 151 Nodal geophones deployed at the Utah FORGE site in April 2019. Details regarding the publishing are available in the paper linked below (Mesimeri, M. and K. L. Pankow et al. 2020). A frequency-domain-based algor...

Pankow, K. University of Utah Seismograph Stations

May 01, 2019
2 Resources
0 Stars
Publicly accessible

Geothermal Exploration Cost and Time Metric

The National Renewable Energy Laboratory (NREL) was tasked with developing a metric in 2012 to measure the impacts of RD&D funding on the cost and time required for geothermal exploration activities. The development of this cost and time metric included collecting cost and time da...

Jenne, S. et al National Renewable Energy Laboratory

Jan 01, 2013
1 Resources
0 Stars
Publicly accessible

Utah FORGE: 2023 Induced Seismicity Mitigation Plan

This is the updated Utah FORGE Phase 3B induced seismicity mitigation plan (ISMP) covering the general Utah FORGE area. This new version incorporates newly collected seismic data, including data collected during the 2022 stimulation and a probabilistic seismic hazard assessment (...

Pankow, K. et al University of Utah Seismograph Stations

Aug 09, 2023
1 Resources
0 Stars
Publicly accessible

The Urban Energy-Water Nexus: Utility-Level Water Flows and Embedded Energy

There are limited open source data available for determining water production/treatment and required energy for cities across the United States. This database represents the culmination of a two-year effort to obtain data from cities across the United States via open records reque...

Chini, C. and Stillwell, A. University of Illinois at Urbana-Champaign

Feb 20, 2018
114 Resources
0 Stars
Publicly accessible

Field Testing Unvented Roofs with Asphalt Shingles in Cold and Hot-humid Climates

BSC TO5 Task 7.1 Field Testing Unvented Roofs with Asphalt Shingles in Cold Climates Bolingbrook, IL 60440 BSC TO5 Task 7.1 Field Testing Unvented Roofs with Asphalt Shingles in Hot-Humid Climates Friendswood, TX 77546 To understand the long-term moisture performance of unvented ...

Ueno, K. and Lstiburek, J. Building Science Corporation

Apr 27, 2016
3 Resources
0 Stars
Publicly accessible

Utah FORGE 2439: Machine Learning for Well 16A(78)-32 Stress Predictions September 2023 Report

This task completion report documents the development and implementation of machine learning (ML) models for the prediction of in-situ vertical (Sv), minimum horizontal (SHmin) and maximum horizontal (SHmax) stresses in well 16A(78)-32. The detailed description of the experimental...

Mustafa, A. et al Battelle Memorial Institute

Sep 28, 2023
3 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Numerical Modeling of Energized Steel-Casing Source for Imaging Stimulated Zone

This short report details and tests the workflow that will be used to simulate steel well casings in deviated production/extraction boreholes at at the Utah FORGE site. Boreholes will be electrically energized and will serve as data sources for future proposed electromagnetic bore...

Um, E. et al Lawrence Berkeley National Laboratory

Nov 15, 2022
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Optimization of a Plug-and-Perf Stimulation (Fervo Energy)

Information around the plug-and-perf treatment design at Utah FORGE by Fervo Energy. Objective and Purpose: Develop a multistage hydraulic stimulation approach designed specifically to target the top three factors that control the technical and commercial viability of an EGS sys...

Norbeck, J. et al Fervo Energy

Feb 08, 2023
3 Resources
0 Stars
Publicly accessible

<< Previous 23 24 25 26 27 28 29 30 31 32 Next >>