Search OEDI Data

Utah FORGE: Well 58-32 Stimulation Conference Paper and Data

The U.S. Department of Energy's (U.S. DOE) Frontier Observatory for Research in Geothermal Energy (FORGE) is a field laboratory that provides a unique opportunity to develop and test new technologies for characterizing, creating and sustaining Enhanced Geothermal Systems (EGS) in ...

Best, S. Energy and Geoscience Institute at the University of Utah

Apr 24, 2019
2 Resources
0 Stars
Publicly accessible

Evaluation of a Wave Powered Water Pump Performance by Ocean Field Testing and WEC-Sim Modeling

This submission from AMEC (the Atlantic Marine Energy Center) includes data from an ocean field deployment of a wave powered water pump in March 2023. The wave pump is an upweller device, designed to enhance macroalgal aquaculture. The wave pump device was deployed off the coast ...

Kimball, C. et al University of New Hampshire, Atlantic Marine Energy Center (AMEC)

Mar 21, 2023
3 Resources
0 Stars
Publicly accessible

ALFA Shared Autonomy Manipulation Data with a Seabotix vLBV300

This report outlines marine field demonstrations for manipulation tasks with a semi-Autonomous Underwater Vehicle (sAUV). The vehicle is built off a Seabotix vLBV300 platform with custom software interfacing it with the Robot Operating System (ROS). The vehicle utilizes an inertia...

Hollinger, G. and Lawrance, N. Oregon State University

Jun 19, 2017
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 3 Magnetotelluric (MT) Data

New high-quality tensor MT data at 122 sites, including the vertical magnetic field and utilizing ultra-remote referencing, have been acquired over the Utah FORGE project area. The results will be used to delineate the densities of faults and fractures in crystalline basement rock...

Wannamaker, P. and Maris, V. Energy and Geoscience Institute at the University of Utah

Oct 01, 2020
5 Resources
0 Stars
Publicly accessible

Field Testing Unvented Roofs with Asphalt Shingles in Cold and Hot-humid Climates

BSC TO5 Task 7.1 Field Testing Unvented Roofs with Asphalt Shingles in Cold Climates Bolingbrook, IL 60440 BSC TO5 Task 7.1 Field Testing Unvented Roofs with Asphalt Shingles in Hot-Humid Climates Friendswood, TX 77546 To understand the long-term moisture performance of unvented ...

Ueno, K. and Lstiburek, J. Building Science Corporation

Apr 27, 2016
3 Resources
0 Stars
Publicly accessible

Community Geothermal: Final Thermal Conductivity Test Report and Data Logs Carbondale, CO

Provided here are a final thermal conductivity test report, a drilling log, and a heat rejection log from Carbondale, CO. Also attached is a report made before drilling, which contains predictions on the hydrogeologic conditions of the drill site. The forty-eight (48.9) hour in-si...

Ewbank, G. et al Clean Energy Economy for the Region (CLEER)

Oct 20, 2023
4 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2417: Pulsed Interference Tests at Wells 16A(78)-32 and 16B(78)-32 September 2024

This archive contains data and a report from Pulse Interference Tests (PITs), which were conducted on September 4, 2024, immediately following a 30-day recirculation test at the Utah FORGE site. Injection and backflow were induced in well 16A(78)-32 while pressures were measured i...

W Becker, M. et al Rice University

Mar 18, 2025
3 Resources
0 Stars
Publicly accessible

Hydraulic Studies of Drilling Microbores with Supercritical Steam, Nitrogen and Carbon Dioxide

Hydraulic studies of drilling micropores at various depths and with various hole sizes, tubing, fluids and rates to show theoretical feasibility. WELLFLO Simulations Report separated into three parts: Step 4: Drilling 10,000 ft Wells with Supercritical Steam, Nitrogen, and Carbon...

Karaaslan, M. Impact Technologies LLC

Jan 01, 2010
3 Resources
0 Stars
Publicly accessible

Centipod WEC, Survivable Wave Energy Converters, Final Technical Report

This project shows that the choice of a secondary DOF for survivability is a viable option to reduce the levelized cost of energy (LCOE) in WEC designs. This report will cover the calculation of the concluded LCOE advantage using Dehlsen Associates’ “Centipod” WEC, but will ...

McCall, A. Dehlsen Associates, LLC

Oct 16, 2020
1 Resources
0 Stars
Publicly accessible

Gravity Survey on the Glass Buttes Geothermal Exploration Project Lake County, Oregon

This report covers data acquisition, instrumentation and processing of a gravity survey performed on the Glass Buttes Geothermal Exploration Project, located in Lake County, Oregon for ORMAT Technologies Inc. The survey was conducted during 21 June 2010 to 26 June 2010. The surve...

Akerley, J. Ormat Nevada Inc

Oct 12, 2011
2 Resources
0 Stars
Publicly accessible

In-Situ Blade Strain Measurements of a Crossflow Turbine Operating in a Tidal Flow

This data was collected between October 25 and December 12 of 2022 at the University of New Hampshire (UNH) and Atlantic Marine Energy Center (AMEC) turbine deployment platform (TDP). The goal was to collect blade strain data from a crossflow turbine operating in a tidal flow. A t...

Bharath, A. et al National Renewable Energy Laboratory

Dec 16, 2022
17 Resources
0 Stars
Publicly accessible

ATP3 Unified Field Study Data

ATP3 Unified Field Study DataThe Algae Testbed Public-Private Partnership ATP3 was established with the goal of investigating open pond algae cultivation across different geographic climatic seasonal and operational conditions while setting the benchmark for quality data collectio...

Wolfrum. . et al National Renewable Energy Laboratory

Oct 19, 2017
17 Resources
0 Stars
Publicly accessible

Geothermal Technologies Program GETEM and LCOE Improvements Review (March 21, 2013)

This file was a report submitted to GTO by Mark Paster, a consultant to the GETEM project, to outline the improvements that were made between summer 2011 and spring 2013. The report focuses on six areas of model improvement: (1) Site Specific Cost Variability; (2) Consistency wi...

Paster, M. Idaho National Laboratory

Mar 21, 2013
1 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Building a 3D Resistivity Model for Simulation and Survey Design of EM Measurements

The included report outlines the creation of three 3D resistivity models that will be used to determine the sensitivity of EM measurements for the hypothetical stimulated reservoir at FORGE as well as for EM survey design. FORGE project 3-2535 is planning on using a casing source ...

Alumbaugh, D. et al Lawrence Berkeley National Laboratory

Dec 01, 2022
5 Resources
0 Stars
Publicly accessible

Moisture Risk in Unvented Attics Due to Air Leakage Paths Minneapolis Minnesota

IBACOS completed an initial analysis of moisture damage potential in an unvented attic insulated with closed-cell spray polyurethane foam. To complete this analysis, the research team collected field data, used computational fluid dynamics to quantify the airflow rates through ind...

Rapport, A. et al Ibacos Innovation

Apr 27, 2016
6 Resources
0 Stars
Publicly accessible

Underwater Mapping Results for Seabotix vLBV300 Vehicle with Tritech Gemini 720i Imaging Sonar near Newport, OR

This document presents results from tests to demonstrate underwater mapping capabilities of an underwater vehicle in conditions typically found in marine renewable energy arrays. These tests were performed with a tethered Seabotix vLBV300 underwater vehicle. The vehicle is equippe...

Hollinger, G. Oregon State University

May 15, 2017
5 Resources
0 Stars
Publicly accessible

MASK3 for Advanced WEC Dynamics and Controls

This report outlines the "MASK3" wave tank test within the Advanced WEC Dynamics and Controls (AWDC) project. This test represents the final test in the AWDC project. The focus of the MASK3 test was to consider coordinated 3-degree-of-freedom (3DOF) control of a WEC in a realistic...

Coe, R. et al Sandia National Laboratories

May 01, 2019
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Mineral Mountains West Fault System Report

This archive contains a report on the Mineral Mountains West fault system as part of phase 2C and the evidence for the northern terminus of this structure. Geologic field mapping, reprocessing of 3D seismic reflection data, and soil gas surveys contributed to this effort.

Simmons, S. and Miller, J. Energy and Geoscience Institute at the University of Utah

Jul 01, 2019
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16B(78)-32 Post Hydraulic Fracturing 9 Hour Dual Well Circulation Test Fiber Optic Monitoring Report April 2024

This report examines the fiber optic measurements made on the Utah FORGE well 16B(78)-32 after it and well 16A(78)-32 were hydraulically stimulated and shortly thereafter a 9 hour cross well circulation test was run between them. The report reviews distributed fiber optic signal p...

Guzik, A. and Davidson, E. Neubrex Energy Services (US), LLC

Apr 27, 2024
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2446: Report on Laboratory Block Experiments with Six Different Combinations of Stresses and Rock Fabrics

This report documents a series of block-scale hydraulic fracturing experiments, simulating Utah FORGE conditions to investigate how different combinations of in situ stress regimes, well orientations, and thermal stress conditions influence fracture initiation and propagation. The...

Bunger, A. and Lu, Y. Lawrence Livermore National Laboratory

Jan 30, 2025
1 Resources
0 Stars
Publicly accessible

TidGen: Permits for Installation of Single Turbine Test System, Cobscook Bay, Maine

This is a summary of permits required and obtained for installation, operation, removal of the TidGen Single Turbine Test system in Cobscook Bay, May in 2023. The Ocean Renewable Power Company (ORPC) worked with federal and state entities to gain required permits and approvals tha...

Sellers-Reynolds, K. Ocean Renewable Power Company

Feb 27, 2024
1 Resources
0 Stars
Publicly accessible

ORNL NILMS Project Yarnell Station Research House

DOE funded research for NILMS and fault detection for small and medium commercial buildings. This contains notes, documentation, and data from testing at the Yarnell Station research house. The data can be used to study non-intrusive load monitoring approaches.

Fugate, D. and Laboratory, O. Oak Ridge National Laboratory

Mar 22, 2017
3 Resources
0 Stars
In curation

M3 Wave DMP/APEX WEC 1:50 Small Scale Tank Testing Plan

Detailed laboratory test plan for the Delos-Reyes Morrow Pressure Device (DMP), commercialized by M3 Wave LLC as "APEX." Includes test points, materials and methods, and sensors/telemetry to be used. Includes schematics of test apparatus and sensor type and locations.

Delos-Reyes, M. and Morrow, M. M3 Wave

Feb 17, 2017
1 Resources
0 Stars
Publicly accessible

Structural Controls of the Tuscarora Geothermal Field, Elko County, Nevada MS Thesis

Detailed geologic mapping, structural analysis, and well data have been integrated to elucidate the stratigraphic framework and structural setting of the Tuscarora geothermal area. Tuscarora is an amagmatic geothermal system that lies in the northern part of the Basin and Range pr...

Dering, G. and Faulds, J. University of Nevada

May 31, 2013
1 Resources
0 Stars
Publicly accessible

The Performance House: A Cold Climate Challenge Home Old Greenwich

Working with builder partners on test homes allows for vetting of whole-house building strategies to eliminate any potential unintended consequences prior to implementing these solution packages on a production scale. To support this research, the Consortium for Advanced Residenti...

Williamson, J. et al Steven Winter Associates of the Consortium for Advanced Residential Buildings

Apr 27, 2016
4 Resources
0 Stars
Publicly accessible

<< Previous 17 18 19 20 21 22 23 24 25 26 Next >>