Search OEDI Data

Tidal Current Cross-flow Turbine Wake ADV and PIV Data

Measurements in the wake of a high-solidity cross-flow turbine in a laboratory flume obtained using Acoustic Doppler Velocimetry and Particle Image Velocimetry for the purposes of characterizing the turbine wake and comparing the methods.

Polagye, B. University of Washington

Dec 06, 2016
6 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2439v2: Reports on Stress Prediction and Modeling for Well 16B(78)-32 May 2025

These two reports from the University of Pittsburgh document related efforts under Utah FORGE Project 2-2439v2 to estimate in-situ stresses in well 16B(78)-32 using laboratory data, machine learning models, and physics-based simulations. One report focuses on developing and valida...

Lu, G. et al University of Pittsburgh

Jun 05, 2025
2 Resources
0 Stars
Publicly accessible

ALFA Station Keeping Results for Seabotix vLBV300 Underwater Vehicle near Newport, OR

This data set presents results testing the station keeping abilities of a tethered Seabotix vLBV300 underwater vehicle equipped with an inertial navigation system. These results are from an offshore deployment on April 20, 2016 off the coast of Newport, OR (44.678 degrees N, 124.1...

Hollinger, G. Oregon State University

Apr 20, 2016
8 Resources
0 Stars
Publicly accessible

Acoustic Doppler Velocimeter (ADV) data from the University of New Hampshire Atlantic Marine Energy Center (UNH-AMEC ) Tidal Energy Test Site during a Perigean Spring Tide

The ADV measurements contained in this submission were taken on the floating turbine deployment platform (TDP) located at the Memorial Bridge in Portsmouth, NH. The measurements were conducted 11/4/2021-11/9/2021 with the fastest currents occurring on 11/7/2021. Along with the sub...

Bichanich, M. and Wosnik, M. University of New Hampshire, Atlantic Marine Energy Center (AMEC)

Nov 09, 2021
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 2C Seismic Observation and Ground Water Well Data and Well Locations

This submission contains the following data associated with Utah FORGE Phase 2C within the Roosevelt Hot Springs geothermal area: An ArcGIS shapefile with well locations for wells 58-32, 78-32, 68-32, OH-3, OH-4, WOW-2, and WOW-3. Well 58-32 is the deep test well, wells 68-32 an...

Abraham, S. et al Energy and Geoscience Institute at the University of Utah

Mar 26, 2019
6 Resources
0 Stars
Publicly accessible

Filenames of Data from the Distributed Acoustic Sensing Experiment at Garner Valley, California

In September 2013, an experiment using Distributed Acoustic Sensing (DAS) was conducted at Garner Valley, a test site of the University of California Santa Barbara (Lancelle et al., 2014). This submission lists all file names from Distributed Acoustic Sensing (DAS) data collected...

Lancelle, C. et al University of Wisconsin

Jul 01, 2015
2 Resources
0 Stars
Publicly accessible

Spatial Analysis of CIRES ASTER and LANDSAT thermal infrared anomalies

CIRES provided polygon shapefiles showing areas of anomalously warm ground, derived from ASTER and LANDSAT remotely sensed thermal infrared imagery. Partly from these anomalies, and partly through other evidence layers, CIRES came up with 'polygons' representing areas prospective ...

Zehner, R. Flint Geothermal, LLC

May 26, 2011
1 Resources
0 Stars
Publicly accessible

Utility-Scale Solar, 2023 Edition: Analysis of Empirical Plant-level Data from U.S. Ground-mounted PV, PV+battery, and CSP Plants (exceeding 5 MWAC)

Berkeley Labs "Utility-Scale Solar", 2023 Edition presents analysis of empirical plant-level data from the U.S. fleet of ground-mounted photovoltaic (PV), PV+battery, and concentrating solar-thermal power (CSP) plants with capacities exceeding 5 MWAC. While focused on key developm...

Seel, J. et al Lawrence Berkeley National Lab

Sep 05, 2023
5 Resources
1 Stars
Publicly accessible

Utah FORGE: Report and Associated Data from Measuring and Modeling Deformation 2018 through 2024

The report provided here describes research activities between August 16th, 2018 and July 30th, 2024. The goals of the research activities are to conduct an Interferometric Synthetic Aperture Radar (InSAR) analysis and Ground Surface Deformation Modeling at the Utah FORGE site. In...

Feigl, K. and Batzli, S. University of Wisconsin Madison

Aug 16, 2018
6 Resources
0 Stars
Publicly accessible

Lift Equivalence and Cancellation for Airfoil Surge-Pitch-Plunge Oscillations

A NACA 0018 airfoil in freestream velocity is oscillated in longitudinal, transverse, and angle-of-attack directions with respect to the freestream velocity, known as surge, plunge, and pitch. The lift-based equivalence method introduces phase shifts between these three motions to...

Elfering, K. and Granlund, K. North Carolina State University

Jan 01, 2020
1 Resources
0 Stars
Publicly accessible

Utility-Scale Solar, 2024 Edition: Analysis of Empirical Plant-level Data from U.S. Ground-mounted PV, PV+battery, and CSP Plants (exceeding 5 MWAC)

Berkeley Labs "Utility-Scale Solar", 2024 Edition presents analysis of empirical plant-level data from the U.S. fleet of ground-mounted photovoltaic (PV), PV+battery, and concentrating solar-thermal power (CSP) plants with capacities exceeding 5 MWAC. While focused on key developm...

Seel, J. et al Lawrence Berkeley National Lab

Sep 27, 2024
5 Resources
1 Stars
Publicly accessible

Wave Tank Testing Report for Controls Validation of a Heaving Point Absorber

The core objectives of this project is to improve the power capture of three different wave energy conversion (WEC) devices by more than 50% using an advanced control system and validate the attained improvements using wave tank and full scale testing. In parallel, we will bring a...

Previsic, M. et al Re Vision Consulting

Aug 26, 2020
3 Resources
0 Stars
Publicly accessible

NREL GIS data: Bhutan Wind Power Density at 50m Above Ground Level

GIS data for Bhutan's Wind Power Density at 50m Above Ground Level. NREL developed estimates of Bhutans wind resources at a spatial resolution of 1 km^2 using NREL's Wind Resource Assessment and Mapping System (WRAMS). Wind turbine output at a given site can be predicted using win...

Heimiller, D. et al National Renewable Energy Laboratory

Nov 25, 2014
3 Resources
0 Stars
Publicly accessible

Measured Performance of a Varied Airflow Small-Diameter Duct System

In this study, researchers with the U.S. Department of Energy's Building America team IBACOS built on research previously done in two new-construction unoccupied test houses-one in Pittsburgh, Pennsylvania (Poerschke and Stecher 2014) and one in Fresno, California (Stecher and Poe...

Poerschke, A. Ibacos Innovation

Apr 27, 2016
5 Resources
0 Stars
Publicly accessible

Phased Retrofits in Existing Homes in Florida Phase I: Shallow and Deep Retrofits

The U.S. Department of Energy's Building America research team Building America Partnership for Improved Residential Construction is collaborating with Florida Power & Light (FPL) to conduct a phased residential energy-efficiency retrofit program. This research seeks to establish ...

Beal, D. et al University of Central Florida Florida Solar Energy Center

Apr 27, 2016
10 Resources
0 Stars
Publicly accessible

Utah FORGE: Induced Seismicity Mitigation Plan

This is the current induced seismicity mitigation plan (ISMP) for the Utah FORGE project. Information that was collected during Phases 1 and 2 of the Utah FORGE project has been incorporated, as have literature searches and risk assessments. The purpose of this report is to identi...

Utah, U. et al Energy and Geoscience Institute at the University of Utah

Dec 30, 2020
2 Resources
0 Stars
Publicly accessible

Update on Geothermal Direct-Use Installations in the United States

An updated database of geothermal direct-use systems in the U.S. has been compiled and analyzed, building upon the Oregon Institute of Technology (OIT) Geo-Heat Center direct-use database. Types of direct-use applications examined include hot springs resorts and pools, aquaculture...

Beckers, K. et al National Renewable Energy Laboratory

Mar 02, 2017
2 Resources
0 Stars
Publicly accessible

Hybrid machine learning model to predict 3D in-situ permeability evolution

Enhanced geothermal systems (EGS) can provide a sustainable and renewable solution to the new energy transition. Its potential relies on the ability to create a reservoir and to accurately evaluate its evolving hydraulic properties to predict fluid flow and estimate ultimate therm...

Elsworth, D. and Marone, C. Pennsylvania State University

Nov 22, 2022
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Rock Properties

This is an Excel spreadsheet that contains rock properties from several wells in the Utah FORGE study area. This includes a map of the wells. Data is described in the Final Topical Report included in the resources below.

Gwynn, M. Energy and Geoscience Institute at the University of Utah

Apr 07, 2018
2 Resources
0 Stars
Publicly accessible

CO2 Push-Pull Single Fault Injection Simulations

ASCII text files containing grid-block name, X-Y-Z location, and multiple parameters from TOUGH2 simulation output of CO2 injection into an idealized single fault representing a dipping normal fault at the Desert Peak geothermal field (readable by GMS). The fault is composed of a ...

Borgia, A. et al Lawrence Berkeley National Laboratory

Sep 21, 2017
5 Resources
0 Stars
Publicly accessible

Utah FORGE 6-3712: Report on a Data Foundation for Real-Time Identification of Microseismic Events

This submission is a technical report for the Probabilistic Estimation of Seismic Response Using Physics Informed Recurrent Neural Networks project. The report describes the process of extracting events from the borehole seismic sensors. To be effective once deployed, the process ...

Williams, J. et al Global Technology Connection, Inc.

Jan 21, 2025
3 Resources
0 Stars
Publicly accessible

2017 Western Passage Tidal Energy Resource Characterization Measurements

These data are from tidal resource characterization measurements collected between April and July 2017 in Western Passage near Eastport, Maine, USA. The dataset contains the following four sub-datasets, each of which is described in more detail in the README.pdf. 1. A bottom-mou...

Kilcher, L. et al National Renewable Energy Laboratory

Jul 31, 2017
33 Resources
0 Stars
Publicly accessible

Oilwell Conversion (Well API 121913310501) to Geothermal Heat Storage Well for Flexible Electricity Storage

Geothermal growth is limited by a lack of geographically dispersed high-temperature thermal resources and high initial upfront investment in characterization and well construction. This project intended to address the challenges of energy supply intermittency and enhance grid resi...

Malkewicz, N. et al University of Illinois

May 05, 2021
8 Resources
0 Stars
Publicly accessible

Utah FORGE: Core Material Friction Experiments

The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...

Marone, C. et al Pennsylvania State University

Mar 15, 2023
7 Resources
0 Stars
Publicly accessible

EGS Collab: Hydraulic Fracturing Test Measurements on the 4100L of SURF

This package includes data from two days of testing at the Sanford Underground Research Facility (SURF) on the 4100 level. The tests were performed in borehole TV4100 in the battery charging alcove south of the Yates shaft. TV4100 is a vertical borehole ~50 meters deep. A series o...

Ingraham, M. et al Sandia National Laboratories

Aug 15, 2019
3 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 6 7 Next >>