Search OEDI Data

Material Properties for Brady Hot Springs Nevada USA from PoroTomo Project

The PoroTomo team has completed inverse modeling of the three data sets (seismology, geodesy, and hydrology) individually, as described previously. The estimated values of the material properties are registered on a three-dimensional grid with a spacing of 25 meters between nodes....

Feigl, K. and PoroTomo Team, . University of Wisconsin

Mar 06, 2019
10 Resources
0 Stars
Publicly accessible

Finite Element Analysis (FEA) for Water-Foam Fracturing of Granite Rock

In addition to the foam data that were obtained from literature and that were collected from the current study, simulation data was also generated from finite element analysis (FEA) conducted in this study using COMSOL Multiphysics software. The FEA models were built to simulate t...

Thakor, V. et al Temple University

May 04, 2021
1 Resources
0 Stars
Publicly accessible

Transient Cold-Climate Building Foundation Hygrothermal Experimental Data

The data consist of two years of continuous transient experimental measurements on the hygrothermal performance of concrete masonry block walls in a full basement in a cold climate (US DOE climate zone 7). The walls were insulated in compliance with the thermal requirements of the...

Merket, N. and Laboratory, N. National Renewable Energy Laboratory

Jun 30, 2015
4 Resources
0 Stars
In curation

Community Resilience through Low-Temperature Geothermal Reservoir Thermal Energy Storage

Submitted data include simulations related to underground thermal battery (UTB) simulations described in Modeling and efficiency study of large scale underground thermal battery deployment, presented at GRC, October 2021. The UTB is comprised of a tank of water, a helical heat ex...

Nico, P. et al Lawrence Berkeley National Laboratory

Jan 29, 2022
4 Resources
0 Stars
Publicly accessible

Utah FORGE Phase 3 Native State Model: 2022 Update

This is the Phase 3 native state model update. The Phase 3 numerical model represents a significant subsurface volume below the FORGE site footprint. The model domain of 4.0 km x 4.0 km x 4.2 km is located approximately between depths of 4000 to 4200 meters below land surface. Thi...

Podgorney, R. and Liu, R. Idaho National Laboratory

Jul 29, 2022
1 Resources
0 Stars
Publicly accessible

Strengthening Effects of Surface Chemistry on the Consolidation of Silicate-Based Geomaterials Experimental Data

Experimental data for manuscript "Strengthening Effects of Surface Chemistry on the Consolidation of Silicate-Based Geomaterials" by R. C. Choens, J. Wilson, and A. G. Ilgen; Sandia National Laboratories. The data includes scanning electron microscope images along with experimenta...

Choens, R. et al Sandia National Laboratories

Jun 21, 2024
5 Resources
0 Stars
In curation

Castlegate Sandstone True Triaxial Test Data

Data set containing results from constant mean stress constant Lode angle true triaxial compression tests performed on Castlegate Sandstone. From the test preformed, the bedding plane and the strain type inside the band of sedimentary rocks can be related to stress histories. The ...

Ingraham, M. et al Sandia National Laboratories

May 06, 2012
8 Resources
0 Stars
Curated

Solar-to-Grid Public Data File for Utility-scale (UPV) and Distributed Photovoltaics (DPV) Generation, Capacity Credit, and Value for 2012-2020

Lawrence Berkeley National Laboratory (Berkeley Lab) estimates hourly project-level generation data for utility-scale solar projects and hourly county-level generation data for residential and non-residential distributed photovoltaic (PV) systems in the seven organized wholesale m...

Seel, J. et al Lawrence Berkeley National Lab

Oct 01, 2021
4 Resources
1 Stars
Curated

Utah FORGE Well 16A(78)-32 Stimulation DFN Fracture Plane Evaluation and Data

This dataset includes files used to fit planar fractures through the preliminary earthquake catalogs of the three stages of the April 2022 well 16A(78)-32 stimulation which is linked bellow. These planar features have been used to update the FORGE reference Discrete Fracture Netwo...

Finnila, A. WSP Golder

Oct 27, 2022
3 Resources
0 Stars
Publicly accessible

Regional Slip Tendency Analysis of the Great Basin Region

Slip and dilation tendency on the Great Basin fault surfaces (from the USGS Quaternary Fault Database) were calculated using 3DStress (software produced by Southwest Research Institute). Slip and dilation tendency are both unitless ratios of the resolved stresses applied to the f...

E., J. University of Nevada

Sep 30, 2013
1 Resources
0 Stars
Publicly accessible

Solar-to-Grid Public Data File for Utility-scale (UPV) and Distributed Photovoltaics (DPV) Generation, Capacity Credit, and Value

Seel, J. et al Lawrence Berkeley National Lab

Sep 30, 2020
5 Resources
0 Stars
Curated

Demand Response Across the Continental US for 2006

This project estimates hourly demand response availability across the continental U.S. for the year 2006. The resulting data set is disaggregated by balancing authority area, end use, and grid application. End uses include 14 categories across residential, commercial, industrial a...

Ma, S. Office of Energy Efficiency and Renewable Energy

Sep 12, 2016
6 Resources
0 Stars
Publicly accessible

TEAMER AquaHarmonics High Fidelity WEC Sim PTO and Control Model Validation

Collaborative effort between AquaHarmonics, Sandia National Laboratories (SNL), and the National Renewable Energy Laboratory (NREL) to revise and validate Aquaharmonics' full wave to wire model, allowing for reduced uncertainty and increased understanding of design requirements of...

Tom, N. and Leon, J. AquaHarmonics, Inc.

Dec 31, 2021
5 Resources
0 Stars
Publicly accessible

Utilization Analysis in Low-Temperature Geothermal Play Fairway Analysis for the Appalachian Basin (GPFA-AB)

This submission of Utilization Analysis data to the Geothermal Data Repository (GDR) node of the National Geothermal Data System (NGDS) is in support of Phase 1 Low Temperature Geothermal Play Fairway Analysis for the Appalachian Basin. The submission includes data pertinent to th...

E., T. Cornell University

Sep 30, 2015
8 Resources
0 Stars
Publicly accessible

Aquantis 2.5 MW Ocean Current Generation Device Scaled Tank Test Design and Results

Aquantis 2.5 MW Ocean Current Generation Device, Tow Tank Dynamic Rig Structural Analysis Results. This is the detailed documentation for scaled device testing in a tow tank, including models, drawings, presentations, cost of energy analysis, and structural analysis. This datase...

Swales, H. et al Dehlsen Associates, LLC

Jun 03, 2015
46 Resources
0 Stars
Publicly accessible

Commercial and Residential Hourly Load Profiles for all TMY3 Locations in the United States

Note: This dataset has been superseded by the dataset found at "End-Use Load Profiles for the U.S. Building Stock" (submission 4520; linked in the submission resources), which is a comprehensive and validated representation of hourly load profiles in the U.S. commercial and reside...

Ong, S. and Clark, N. National Renewable Energy Laboratory

Nov 25, 2014
22 Resources
0 Stars
Curated

Modeling the Integration of Marine Energy into Microgrids Wave Resource Assessment

This submission has wave resource assessments which were conducted for six locations based on IEC requirements using the DOE WPTO Hindcast data and MHKiT. The locations are chosen to provide varying wave climates and include PacWave South, OR; Wave Energy Testing Site (WETS), HI; ...

Mankle, H. and Robertson, B. University of Alaska Fairbanks

Jan 19, 2023
9 Resources
0 Stars
Publicly accessible

Reference Model 2 Scaled Geometry (RM2: River Current Turbine)

Contains the Reference Model 2 (RM2) scaled scale geometry files of the River Current Turbine, developed by the Reference Model Project (RMP). These scaled geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. The scaled RM2 devic...

Neary, V. and Hill, C. Sandia National Laboratories

Sep 30, 2014
5 Resources
0 Stars
Publicly accessible

Reference Model 2 Full Scale Geometry (RM2: River Current Turbine)

Contains the Reference Model 2 (RM2) full scale geometry files of the River Current Turbine, developed by the Reference Model Project (RMP). These full scale geometry files are saved as SolidWorks assembly, IGS, X_T, and STEP files, and require a CAD program to view. This data was...

Neary, V. et al Sandia National Laboratories

Sep 30, 2014
5 Resources
0 Stars
Publicly accessible

Reference Model 1 Scaled Geometry (RM1: Tidal Current Turbine)

Contains the Reference Model 1 (RM1) scaled scale geometry files of the Tidal Current Turbine, developed by the Reference Model Project (RMP). These scaled geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. The scaled RM1 devic...

Neary, V. and Hill, C. Sandia National Laboratories

Sep 30, 2014
8 Resources
0 Stars
Publicly accessible

Reference Model 1 Full Scale Geometry (RM1: Tidal Current Turbine)

Contains the Reference Model 1 (RM1) full scale geometry files of the Tidal Current Turbine, developed by the Reference Model Project (RMP). These full scale geometry files are saved as SolidWorks assembly, X_T, IGS, and STEP files, and require a CAD program to view. This data was...

Neary, V. et al Sandia National Laboratories

Sep 30, 2014
7 Resources
0 Stars
Publicly accessible

NREL Global Offshore Wind GIS Data

GIS data for offshore wind speed (meters/second). Specified to Exclusive Economic Zones (EEZ). Wind resource based on NOAA Blended Sea Winds and monthly wind speed at 30km resolution from 1987-2005, using a 0.11 wind sheer to extrapolate 10m 90m. Annual average >= 10 months o...

Langle, N. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
4 Resources
0 Stars
In curation

Next Generation RivGen Power System: Kvichak River, AK Overwinter Ice Study

The University of Alaska Fairbanks (UAF) Alaska Hydrokinetic Energy Research Center was tasked with developing a real-time data telemetry / remote power generation system to monitor frazil ice conditions in the Kvichak River in support of the U.S. Department of Energy funded "Next...

Kasper, J. et al Igiugig Village Council

Oct 04, 2017
5 Resources
0 Stars
Publicly accessible

Net Shape Fabricated Low Cost MHK Pass-Through the Hub Turbine Blades with Integrated Health Management Technology

The primary objective of this project is to develop a three-blade MHK rotor with low manufacturing and maintenance costs. The proposed program will design, fabricate and test a novel half-scale low cost, net shape fabricated single piece three-blade MHK rotor with integrated healt...

Wess, D. ARL Penn State

Feb 09, 2016
24 Resources
0 Stars
Publicly accessible

Coupling Subsurface and Above-Surface Models for Optimizing the Design of Borefields and District Heating and Cooling Systems

Accurate dynamic energy simulation is important for the design and sizing of district heating and cooling systems with geothermal heat exchange for seasonal energy storage. Current modeling approaches in building and district energy simulation tools typically consider heat conduct...

Hu, J. et al Lawrence Berkeley National Laboratory

Jan 31, 2022
10 Resources
0 Stars
Publicly accessible

1 2 Next >>