Search OEDI Data
Showing results 51 - 75 of 678.
Show
results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
BOBr Raw Breaking Wave Data, Agate Beach, OR
Raw data from the BOBr (Buoy to Observe Breaking) wave measurement buoy. Data was recorded off the coast of Newport, OR at Agate Beach, in the surf zone.
C, A. Oregon State University
Oct 31, 2013
12 Resources
0 Stars
Publicly accessible
12 Resources
0 Stars
Publicly accessible
NREL GIS data: Bhutan Wind Power Density at 50m Above Ground Level
GIS data for Bhutan's Wind Power Density at 50m Above Ground Level. NREL developed estimates of Bhutans wind resources at a spatial resolution of 1 km^2 using NREL?s Wind Resource Assessment and Mapping System (WRAMS). Wind turbine output at a given site can be predicted using win...
Heimiller, D. et al National Renewable Energy Laboratory
Nov 25, 2014
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Life Cycle Analysis Data and Results for Geothermal and Other Electricity Generation Technologies
Life cycle analysis (LCA) is an environmental assessment method that quantifies the environmental performance of a product system over its entire lifetime, from cradle to grave. Based on a set of relevant metrics, the method is aptly suited for comparing the environmental performa...
Sullivan, J. Argonne National Laboratory
Jun 04, 2013
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Ocean Thermal Energy Conversion (OTEC) Cold Water Depth (Annual Average)
This shapefile represents annual average cold water depth recordings.
The cold water is defined by locating the depth that leads to the greatest average annual net power at each location when depth and its corresponding ?T are input into the power equation. This optimization ba...
Langle, N. and Laboratory, N. National Renewable Energy Laboratory
Nov 25, 2014
2 Resources
0 Stars
In curation
2 Resources
0 Stars
In curation
Ocean Thermal Energy Conversion (OTEC) Cold Water Depth (Summer Average)
This shapefile represents seasonal summer average cold water depth recordings.
The cold water is defined by locating the depth that leads to the greatest average annual net power at each location when depth and its corresponding ΔT are input into the power equation. This optim...
Langle, N. and Laboratory, N. National Renewable Energy Laboratory
Nov 25, 2014
2 Resources
0 Stars
In curation
2 Resources
0 Stars
In curation
Ocean Thermal Energy Conversion (OTEC) Cold Water Depth (Winter Average)
This shapefile represents seasonal winter average cold water depth recordings.
The cold water is defined by locating the depth that leads to the greatest average annual net power at each location when depth and its corresponding ΔT are input into the power equation. This optim...
Langle, N. and Laboratory, N. National Renewable Energy Laboratory
Nov 25, 2014
2 Resources
0 Stars
In curation
2 Resources
0 Stars
In curation
Control-based optimization for tethered tidal kite
This submission includes three peer-reviewed (under review) papers from the researchers at North Carolina State University presenting control-based techniques to maximize effectiveness of a tethered tidal kite. Below are the abstracts of each file included in the submission.
Cobb...
Vermillion, C. et al North Carolina State University
Mar 02, 2020
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
County-Level Hourly Renewable Capacity Factor Dataset for the ReEDS Model
This dataset contains hourly capacity factors for each renewable resource class and region (in this case, county). Technologies like large-scale utility PV (UPV), onshore wind, offshore wind, and concentrating solar power (CSP) are included. The dataset contains 7 years of hourly ...
Cole, W. et al National Renewable Energy Laboratory (NREL)
Aug 01, 2023
5 Resources
1 Stars
Publicly accessible
5 Resources
1 Stars
Publicly accessible
Utility-Scale Solar, 2022 Edition: Analysis of Empirical Plant-level Data from U.S. Ground-mounted PV, PV+battery, and CSP Plants (exceeding 5 MWAC)
Berkeley Labs "Utility-Scale Solar", 2022 Edition presents analysis of empirical plant-level data from the U.S. fleet of ground-mounted photovoltaic (PV), PV+battery, and concentrating solar-thermal power (CSP) plants with capacities exceeding 5 MWAC. While focused on key developm...
Seel, J. et al Lawrence Berkeley National Lab
Sep 20, 2022
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
McGee Mountain Geoprobe Study, Humboldt County, Nevada
Geoprobes were developed by the environmental industry to collect water, gas and soil samples from contaminated sites at shallow depths (10-40 meters), with a minimum of environmental disturbance. A modified Geoprobe was used to collect bottom hole temperatures, and attempt to col...
Tullar, K. Geothermal Technical Partners, Inc.
Jun 19, 2010
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Wave Classification Statistical Data for US Waters
Wave statistics computed using output from the NOAA WWIII hindcast simulations, spanning thirty years from 1980 to 2009. The statistics are computed based on frequency-directional variance density spectra every three hours for 1951 locations in US waters.
Haas, K. Georgia Tech Research Corporation
Sep 21, 2016
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Lift Equivalence and Cancellation for Airfoil Surge-Pitch-Plunge Oscillations
A NACA 0018 airfoil in freestream velocity is oscillated in longitudinal, transverse, and angle-of-attack directions with respect to the freestream velocity, known as surge, plunge, and pitch. The lift-based equivalence method introduces phase shifts between these three motions to...
Elfering, K. and Granlund, K. North Carolina State University
Jan 01, 2020
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utility-Scale Solar, 2023 Edition: Analysis of Empirical Plant-level Data from U.S. Ground-mounted PV, PV+battery, and CSP Plants (exceeding 5 MWAC)
Berkeley Labs "Utility-Scale Solar", 2023 Edition presents analysis of empirical plant-level data from the U.S. fleet of ground-mounted photovoltaic (PV), PV+battery, and concentrating solar-thermal power (CSP) plants with capacities exceeding 5 MWAC. While focused on key developm...
Seel, J. et al Lawrence Berkeley National Lab
Sep 05, 2023
5 Resources
1 Stars
Publicly accessible
5 Resources
1 Stars
Publicly accessible
StingRAY Structural Optimization Final Technical Report
The overall project objective is to materially decrease the leveled cost of energy (LCOE) of the Columbia Power (CPower) StingRAY utility-scale wave energy converter (WEC). This will be achieved by reducing structural material and manufacturing costs and increasing energy output. ...
Lenee-Bluhm, P. Columbia Power Technologies, Inc.
Aug 05, 2020
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Deep Direct-Use Feasibility Study Numerical Modeling and Uncertainty Analysis using iTOUGH2 for West Virginia University
To reduce the geothermal exploration risk, a feasibility study is performed for a deep direct-use system proposed at the West Virginia University (WVU) Morgantown campus. This study applies numerical simulations to investigate reservoir impedance and thermal production. Because of...
Garapati, N. et al West Virginia University
Dec 20, 2019
13 Resources
0 Stars
Publicly accessible
13 Resources
0 Stars
Publicly accessible
Reference Model 3 Scaled Geometry (RM3: Wave Point Absorber)
Contains the Reference Model 3 (RM3) scaled scale geometry files of the Wave Point Absorber, developed by the Reference Model Project (RMP). These scaled geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. The scaled RM3 device ...
Neary, V. et al Sandia National Laboratories
Sep 30, 2014
7 Resources
0 Stars
Publicly accessible
7 Resources
0 Stars
Publicly accessible
1D Heat Loss Models Validation Experiment
Contains data from the model validation in the 1D Heat Loss Models to Predict the Aquifer Temperature Profile during Hot/Cold Water Injection Project. The data include two COMSOL models (2D axisymmetric benchmark model and 2D Vinsome model), one python code (1D Vinsome based FEM n...
Chen, K. et al UC Berkeley
Jan 18, 2022
8 Resources
0 Stars
Publicly accessible
8 Resources
0 Stars
Publicly accessible
Active Management of Integrated Geothermal-CO2 Storage Reservoirs in Sedimentary Formations
The purpose of phase 1 is to determine the feasibility of integrating geologic CO2 storage (GCS) with geothermal energy production. Phase 1 includes reservoir analyses to determine injector/producer well schemes that balance the generation of economically useful flow rates at the ...
A., T. Lawrence Livermore National Laboratory
Jan 01, 2012
9 Resources
0 Stars
Publicly accessible
9 Resources
0 Stars
Publicly accessible
Model and experimental validation of ocean kite dynamics and controls
This submission includes two peer-reviewed papers from researchers at North Carolina State University presenting the modeling and lab-scale experimentation of the dynamics and control of a tethered tidal ocean kite. Below are the abstracts of each file included in the submission.
...
Vermillion, C. et al North Carolina State University
Mar 01, 2020
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Reactive Transport Simulations of High-Tempertature Geologic Thermal Energy Storage (GeoTES) in Deep Saline Formations I/O Files
Simulation input and output files, post-processed figures and excel tables, and tecplot layout files for generating figures. These simulations were run with TOUGHREACT V4.12 by Lawrence Berkeley National Laboratory in 2021. This work was completed as part of the geologic thermal e...
Spycher, N. and Doughty, C. Lawrence Berkeley National Laboratory
Dec 31, 2021
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Active Management of Integrated Geothermal-CO2 Storage Reservoirs in Sedimentary Formations
Active Management of Integrated Geothermal-CO2 Storage Reservoirs in Sedimentary Formations: An Approach to Improve Energy Recovery and Mitigate Risk : FY1 Final Report
The purpose of phase 1 is to determine the feasibility of integrating geologic CO2 storage (GCS) with geothermal...
A., T. Lawrence Livermore National Laboratory
Jan 01, 2012
7 Resources
0 Stars
Publicly accessible
7 Resources
0 Stars
Publicly accessible
Active Management of Integrated Geothermal-CO2 Storage Reservoirs in Sedimentary Formations
Active Management of Integrated Geothermal-CO2 Storage Reservoirs in Sedimentary Formations: An Approach to Improve Energy Recovery and Mitigate Risk : FY1 Final Report
The purpose of phase 1 is to determine the feasibility of integrating geologic CO2 storage (GCS) with geothermal...
A., T. Lawrence Livermore National Laboratory
Jan 01, 2012
7 Resources
0 Stars
Publicly accessible
7 Resources
0 Stars
Publicly accessible
Simulations of Brady's-Type Fault Undergoing CO2 Push-Pull: Pressure-Transient and Sensitivity Analysis
Input and output files used for fault characterization through numerical simulation using iTOUGH2. The synthetic data for the push period are generated by running a forward simulation (input parameters are provided in iTOUGH2 Brady GF6 Input Parameters.txt [InvExt6i.txt]). In gene...
Jung, Y. and Doughty, C. Lawrence Berkeley National Laboratory
Mar 09, 2018
11 Resources
0 Stars
Publicly accessible
11 Resources
0 Stars
Publicly accessible
Fallon FORGE: Thermal-Hydrological-Mechanical Models
Archive contains thermal-mechanical simulation input/output files. Included are files which fall into the following categories:
( 1 ) Spreadsheets with various input parameter calculations
( 2 ) Final Simulation Inputs
( 3 ) Native-State Thermal-Hydrological Model Input File Fol...
Blankenship, D. and Sonnenthal, E. Sandia National Laboratories
Mar 12, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Groundwater Data
This submission includes two modeled drawdown scenarios with new supply well locations, a total dissolved solids (TDS) concentration grid (raster dataset representing the spatial distribution of TDS), and an excel spreadsheet containing well data.
Moore, J. Energy and Geoscience Institute at the University of Utah
Jul 20, 2016
5 Resources
0 Stars
Publicly accessible
5 Resources
0 Stars
Publicly accessible