Search OEDI Data

Showing results 176 - 200 of 924.
Show results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
"test results"×

SiC Diode Test Data

Fabricated SiC diodes are tested in the temperature range of 300 degrees C to 600 degrees C.
Gilbert, G. Sandia National Laboratories
Aug 01, 2014
1 Resources
0 Stars
Publicly accessible

Ground Source Heat Pump Computational Results

This data submission includes simulation results for ground loop heat pump systems located in 6 different cities across the United States. The cities are Boston, MA, Dayton, OH, Omaha, NE, Orlando, FL, Sacramento, CA, and St. Paul, MN. These results were obtained from the two-dime...
Menart, J. Wright State University
Jul 31, 2013
6 Resources
0 Stars
Publicly accessible

Hydrothermal mineral alterations in the Brady and Desert Peak geothermal fields

Results of the analysis of HyMap's spectra against know hydrothermally altered minerals in the Brady-Desert Peak Geothermal Areas. The analysis was performed using ENVI's Target Detection process against USGS library spectra for Chalcedony, Kaolinite, Gypsum, Hematite and Epsomite...
Moraga, J. Colorado School of Mines
Oct 01, 2021
4 Resources
0 Stars
Publicly accessible

Advanced Direct-Drive Generator for Improved Availability of Oscillating Wave Surge Converter Power Generation Systems: 1hp 300rpm Axial-Flux Magnetically Geared Generator Test Data

Static torque and no load test data for a 1hp, 300rpm axial-flux magnetically geared generator prototype developed by Texas A&M EMPE Lab.
Toliyat, H. et al ABB Inc.
May 02, 2017
1 Resources
0 Stars
Publicly accessible

Sample IEEE123 Bus system for OEDI SI

Time series load and PV data from an IEEE123 bus system. An example electrical system, named the OEDI SI feeder, is used to test the workflow in a co-simulation. The system used is the IEEE123 test system, which is a well studied test system (see link below to IEEE PES Test Feeder...
Elgindy, T. and Balasubramaniam, K. National Renewable Energy Laboratory
Sep 01, 2022
4 Resources
0 Stars
Publicly accessible

Focusing Wave Energy for Wave Energy Converter Applications

Wave tank tests at Stevens Institute of Technology quantified the ability of near-surface platforms to concentrate wave energy over the platform. Due to the instantaneous change in water depth, mass, energy, and power are conserved in this process. The energy and power concentrat...
Raftery, M. Stevens Institute of Technology
Aug 10, 2010
7 Resources
0 Stars
Publicly accessible

TEAMER: Mass of Water Turbine Current Energy Converter CFD Results

The CFD (computational fluid dynamics) results for the Mass of Water Turbine (MOWT) current energy converter from MWNW Consulting (formerly Ecosse IP). Each case is self-contained in its own tar.gz archive file. The archive contains the scripts required to perform a full simulati...
Chartrand, C. and Moir, S. Sandia National Laboratories
May 27, 2022
75 Resources
0 Stars
Publicly accessible

Ocean Sentinel Mooring and Environmental Data 2013

Load cell data of Ocean Sentinel (OS) mooring, OS locations data and environmental conditions data (wave, wind, current) measured in the 2013 field test.
C., S. Oregon State University
Jul 29, 2013
6 Resources
0 Stars
Publicly accessible

USU Camas-1 Test Well: Documentation

This submission contains documents that describe the USU Camas-1 test well, drilled in Camas Prairie, Idaho, in Fall 2018 and Fall 2019. The purpose of this well is to validate exploration methodologies of the Snake River Plain (SRP) Play Fairway Analysis (PFA) project.
Shervais, J. Utah State University
Oct 31, 2018
13 Resources
0 Stars
Publicly accessible

Washington Air-Sea Interaction Research Facility Waves and Currents Test Data

This archive includes data from the University of Washington WASIRF (Washington Air-Sea Interaction Research Facility) flume. WASIRF is a laboratory testing tank at the Northwest National Marine Renewable Energy Center designed to investigate wind-wave-current interactions. It inc...
Colosimo, P. University of Washington (NNMREC) Applied Physics Lab
Feb 23, 2022
1 Resources
0 Stars
Publicly accessible

EGS-Collab Experiment 1: Time-lapse ERT Data and E4D Inversion Files for 10-24-2018 through 11-07-2018 Flow Test

This data submission includes the raw time-lapse ERT (electrical resistivity tomography) monitoring data, flow system data, operator logs, E4D (https://e4d.pnnl.gov) inversion files, and metadata necessary to reproduce the 4D ERT inversion for the Oct. 24 through Nov. 7 2018 post-...
Johnson, T. Pacific Northwest National Laboratory
Jul 30, 2021
5 Resources
0 Stars
Publicly accessible

Topology-Based Machine-Learning for Modeling Power-System Responses to Contingencies

This is the companion dataset to the presentation NREL/PR-6A20-77485, which was presented at the 2020 Joint Statistical Meeting on August 3, 2020. Developed for the machine-learning predictive modeling of power-system responses to disruptions, it contains results of power-system c...
BushNational Renewable Energy Laboratory
Aug 01, 2020
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Wells 16A(78)-32 and 16B(78)-32 Stimulation Pressure and Circulation Data April, 2024

This dataset consists of all of the pressure pumping data for Utah FORGE Well16A78-32 fracturing stages, Well 16B78-32 fracturing stages, and a 9-hour circulation test which took place after all of the frac plugs were drilled out. Fracturing in the wells took place in stages from ...
England, K. Energy and Geoscience Institute at the University of Utah
Jun 03, 2024
4 Resources
0 Stars
Publicly accessible

Shear Induced Permeability Test: Stripa Granite Temperature Pressure and Displacement Data

Spreadsheet containing the raw measured data, calibrated data, and brief explanation of data for Test1 Stripa Granite Geomechanical/Geochemical Test. Stress on fracture ~20.7 MPa.
Kneafsey, T. Lawrence Berkeley National Laboratory
Jun 21, 2014
1 Resources
0 Stars
Publicly accessible

West Flank Coso, CA FORGE Test Area

A map with the Coso West Flank FORGE test area outlined, along with regional seismicity, the aeromagnetic data set and the area currently being utilized for the creation of the 3D model.
Blankenship, D. Sandia National Laboratories
Nov 15, 2015
1 Resources
0 Stars
Publicly accessible

Pressure Data from Cranfield CO2 Thermosiphon Test

Pressure data acquired in well F2 and F3 during the CO2 geothermal thermosiphoning test, Cranfield MS.
Freifeld, B. Lawrence Berkeley National Laboratory
Jan 21, 2015
2 Resources
0 Stars
Publicly accessible

HERO WEC Belt Test Data

The following submission includes raw and processed data from the 2024 Hydraulic and Electric Reverse Osmosis Wave Energy Converter (HERO WEC) belt tests conducted using NREL's Large Amplitude Motion Platform (LAMP). A description of the motion profiles run during testing can be f...
Jenne, S. et al National Renewable Energy Laboratory
Sep 01, 2024
7 Resources
0 Stars
Publicly accessible

Solar Permitting, Inspection, and Interconnection Cycletimes and Requirements

Sixteen small-to-large residential PV installers submitted project-level data for analysis, which included timestamps for major components of the permitting, inspection, and interconnection process as well as contract and installation dates. NREL calculated median timelines for th...
Cook. . et al National Renewable Energy Laboratory
Mar 31, 2021
2 Resources
0 Stars
Publicly accessible

Triton: Survivability Enhancement of a Multi-Mode Point Absorber

The overall goal of this project was to design and validate a survival mode for the Triton WEC that allows for a reduction in peak loads, while simultaneously allowing for a reduction of capital cost due to the elimination of overdesign to account for uncertainty. In addition, the...
Mundon, T. and Rosenberg, B. Oscilla Power, Inc.
Sep 28, 2018
11 Resources
0 Stars
Publicly accessible

SeaRAY WEC Preliminary Design and Test Planning

The SeaRAY is a deployable power system for maritime sensors, monitoring equipment, communications, unmanned underwater vehicles, and other similar payloads. This project is to design, deliver, and test a prototype low-power WEC that lowers the total cost of ownership and provides...
Hammagren, E. et al Columbia Power Technologies, Inc.
May 18, 2020
4 Resources
0 Stars
Publicly accessible

First Tracer Test After Circulation in Desert Peak 27-15

Following the successful stimulation of Desert Peak target EGS well 27-15, a circulation test was initiated by injecting a conservative tracer (1,5-nds) in combination with a reactive tracer (7-amino-1,3-naphthalene disulfonate). The closest production well 74-21 was monitored ove...
Rose, P. University of Utah
Nov 16, 2013
1 Resources
0 Stars
Publicly accessible

Ground Source Heat Pump Computational Results

This data submission includes simulation results for ground loop heat pump systems located in 6 different cities across the United States. The cities are Boston, MA, Dayton, OH, Omaha, NE, Orlando, FL, Sacramento, CA, and St. Paul, MN. These results were obtained from the two-dime...
Menart, J. Wright State University
Jul 31, 2013
6 Resources
0 Stars
Publicly accessible

ARPA-E Grid Optimization (GO) Competition Challenge 3

Synthetic Input Data and Team Results for the GO Competition Challenge 3 for Events 1 4 and the Sandbox, along with problem and format descriptions and code to validate data and solutions, are available here. Data for industry scenarios will not be made public. The Grid Optimizat...
Elbert, S. et al Pacific Northwest National Laboratory
May 02, 2024
39 Resources
1 Stars
Publicly accessible

kISMET Final Report and Highlights

The files in this submission describes the results of a series of stress measurement and hydraulic fracturing experiments conducted at the Sanford Underground Research Facility (SURF) in Lead, SD. This report describes the accomplishments of the kISMET (permeability (k) and Induce...
Oldenburg, C. et al Lawrence Berkeley National Laboratory
Oct 31, 2016
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Well Locations and Orientations.

The EGS Collab is conducting experiments in hydraulic fracturing at a depth of 1.5 km in the Sanford Underground Research Facility (SURF) on the 4850 Level. A total of eight ~60m-long subhorizontal boreholes were drilled at that depth on the western rib of the West Access Drift. S...
Neupane, G. et al Idaho National Laboratory
Sep 05, 2018
12 Resources
0 Stars
Publicly accessible
<< Previous3456789101112Next >>