Search OEDI Data
Showing results 51 - 75 of 272.
Show
results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
Caldwell Ranch Exploration and Confirmation Project, Northwest Geysers, CA: 2011 Geothermal Technologies Peer Review Project Summary
Caldwell Ranch Exploration and Confirmation Project, Northwest Geysers, CA: 2011 Geothermal Technologies Peer Review Project Summary
The Caldwell Ranch Exploration and Confirmation Project was to drill, test, and confirm the present economic viability of the undeveloped geothermal...
Walters, M. Geysers Power Company, LLC
Jan 01, 2011
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Technical Report-Rare Earth Element Data Associated with Oil and Gas Reservoir Rock
This work was developed to complement the geochemical assessments of produced water and geothermal water samples. Specifically, this task was designed to test the influence of reservoir rock-type and corresponding mineralogy/geochemistry on the concentrations of REE found in oil a...
McLaughlin, J. et al University of Wyoming
Jul 01, 2017
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Leapfrog 3D Geologic Movie
This is a 3D geological movie of the Utah FORGE area created with Leapfrog Geothermal 3D modelling software. The movie shows the Utah FORGE site, wells, seismic and lithologic cross-sections, and rock unit tops. This illustrates the thick crystalline granitoid EGS reservoir.
Podgorney, R. Energy and Geoscience Institute at the University of Utah
May 18, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Advanced TidGen Power System Environmental Assessment
The TidGen Power System generates emission-free electricity from tidal currents and connects directly into existing grids using smart grid technology. The power system consists of three major subsystems: shore-side power electronics, mooring system, and turbine generator unit (TGU...
Marnagh, C. et al Ocean Renewable Power Company
Jun 14, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
NASA Building 12 Wind Turbines Phase 1 Data
Completed in December 2014, the NASA Building 12 installation consists of four Urban Green Energy Eddy GT turbines. The NASA Building 12 project involved detailed pre-construction and post-construction measurements. NREL researchers initiated a measurement campaign consisting of m...
Fields, J. and NREL, . National Renewable Energy Laboratory
Dec 28, 2015
2 Resources
0 Stars
In curation
2 Resources
0 Stars
In curation
DAISY Acoustic Measurements in Agate Pass, WA
Acoustic data and metadata from Drifting Acoustic Instrumentation SYstem (DAISY) testing in Agate Pass (separating the north end of Bainbridge Island and the Kitsap Peninsula in Puget Sound), WA in April 2022. The goal was to characterize radiated noise from a cross-flow turbine d...
Polagye, B. et al University of Washington
Apr 20, 2022
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Global innovation contest for future solar energy solutions
Stockholm Royal Seaport is one of Europe’s largest urban development projects and is a leader when it comes to next generation sustainable neighborhoods. As part of Stockholm Royal Seaport’s sustainability focus the competition is organized to find long-term solar energy solut...
Competitions, S. National Renewable Energy Laboratory
Dec 21, 2014
1 Resources
0 Stars
In curation
1 Resources
0 Stars
In curation
Thermal Drawdown Induced Flow Channeling in Fractured Geothermal Reservoirs: Rock Mechanics and Rock Engineering
We investigate the flow-channeling phenomenon caused by thermal drawdown in fractured geothermal reservoirs. A discrete fracture network-based, fully coupled thermal "hydrological" mechanical simulator is used to study the interactions between fluid flow, temperature change, and t...
Fu, P. et al Lawrence Livermore National Laboratory
Nov 15, 2015
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Earth Model Native State Simulation Results
Utah FORGE phase 2C Native State Simulation zip contains the data used for the boundary conditions and subsequent native state simulation results obtained using the simulation code FALCON. Data are from the nodes of the simulation domain, with used a uniform 50m spacing over a 250...
Podgorney, R. Energy and Geoscience Institute at the University of Utah
Jul 16, 2019
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Analysis of downhole data from USU-1 well Leidos Technical Report
USU Camas-1 is a geothermal test well drilled in Camas Prairie, Idaho, in the Summer and Fall of 2018. The purpose of this test well was to validate Play Fairway methodologies of the Snake River Plain Play Fairway Analysis project.
In this report, test data are analyzed to infer...
Garg, S. and Goranson, C. Utah State University
Dec 04, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Dynamic Earth Energy Storage: Terawatt-year, Grid-scale Energy Storage Using Planet Earth as a Thermal Battery (GeoTES): Phase I Project Final Report
Final report for the DOE GTO funded research on geologic thermal energy storage (GeoTES), or commonly known as reservoir thermal energy storage (RTES).
The results described in this report shed light on various aspects of RTES including project siting, operational performance, m...
Atkinson, T. et al Idaho National Laboratory
Sep 02, 2022
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Model and experimental validation of ocean kite dynamics and controls
This submission includes two peer-reviewed papers from researchers at North Carolina State University presenting the modeling and lab-scale experimentation of the dynamics and control of a tethered tidal ocean kite. Below are the abstracts of each file included in the submission.
...
Vermillion, C. et al North Carolina State University
Mar 01, 2020
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Using Fully Coupled Hydro-Geomechanical Numerical Test Bed to Study Reservoir Stimulation with Low Hydraulic Pressure
This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimu...
Fu, P. et al Lawrence Livermore National Laboratory
Jan 31, 2012
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Preliminary Monitoring, Analyses, and Impact Assessment
Preliminary monitoring and analyses for the Utah FORGE Milford Site.
Includes a report detailing the seismic monitoring goals and results, a detailed techno-economic infrastructure assessment with an analysis, a budget, schedules, and cost summaries, and a summary of environmental...
Pankow, K. Energy and Geoscience Institute at the University of Utah
Feb 09, 2017
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Extraction/Injection Well Design for Deep Direct Use at University of Illinois at Urban-Champaign
The large scale Deep Direct Use (DDU) geothermal project in the low temperature environment of the Illinois Basin requires drilling and completing two wells. One well would be the extraction (producing) well and would be built to deliver a flow rate of approximately 6000 barrels ...
Kirksey, J. and Lu, Y. University of Illinois
Mar 31, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Final Report Earth Source Heat: A Cascaded Systems Approach to DDU of Geothermal Energy on the Cornell Campus
The purpose of this document is to describe the contents contained within Geothermal Data Repository (GDR) node of the National Geothermal Data System (NGDS) that serves as the final report for the project "Earth Source Heat: A Cascaded Systems Approach to DDU of Geothermal Energy...
Tester, J. et al Cornell University
Oct 27, 2019
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Utah FORGE: Optimization of a Plug-and-Perf Stimulation (Fervo Energy)
Information around the plug-and-perf treatment design at Utah FORGE by Fervo Energy.
Objective and Purpose:
Develop a multistage hydraulic stimulation approach designed specifically to target the top three factors that control the technical and commercial viability of an EGS sys...
Norbeck, J. et al Fervo Energy
Feb 08, 2023
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Hybrid machine learning model to predict 3D in-situ permeability evolution
Enhanced geothermal systems (EGS) can provide a sustainable and renewable solution to the new energy transition. Its potential relies on the ability to create a reservoir and to accurately evaluate its evolving hydraulic properties to predict fluid flow and estimate ultimate therm...
Elsworth, D. and Marone, C. Pennsylvania State University
Nov 22, 2022
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Risk Factor Analysis in Low-Temperature Geothermal Play Fairway Analysis for the Appalachian Basin (GPFA-AB)
This submission contains information used to compute the risk factors for the GPFA-AB project. The risk factors are natural reservoir quality, thermal resource quality, potential for induced seismicity, and utilization. The methods used to combine the risk factors included taking ...
E., T. Cornell University
Sep 30, 2015
191 Resources
0 Stars
Publicly accessible
191 Resources
0 Stars
Publicly accessible
EGS Collab: 3D Geophysical Model Around the Sanford Underground Research Facility
This package contains data associated with a proceedings paper (linked below) submitted to the 44th Workshop on Geothermal Reservoir Engineering. The Geophysical Model text file contains density, P and S-wave seismic speeds on a 3D grid. The file has six columns and provides latit...
Chai, C. et al Lawrence Berkeley National Laboratory
Feb 06, 2019
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Western USA Assessment of High Value Materials in Geothermal Fluids and Produced Fluids
This submission includes the following:
Field Characteristics: Describes the geological and production field characteristics of sampling sites
Geochemistry of Produced Fluids Idaho-Nevada-New Mexico-Oregon-Utah: Summarizes the all the analytical results for aqueous samples...
Simmons, S. et al Energy and Geoscience Institute at the University of Utah
Oct 31, 2018
5 Resources
0 Stars
Publicly accessible
5 Resources
0 Stars
Publicly accessible
Utah FORGE GeoThermOPTIMAL Video
This is a project description video by Dr. William W. Fleckenstein related to their "Development of Multi-Stage Fracturing System and Wellbore Tractor to Enable Zonal Isolation During Stimulation and EGS Operations in Horizontal Wellbores" R&D project at Utah FORGE which is linked...
Fleckenstein, W. Colorado School of Mines
Dec 12, 2022
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Thermal-Hydrological-Mechanical Modelling of Stockton University Reservoir Cooling System, Large Scale Grid
Mesh, properties, initial conditions, injection/withdrawal rates for modeling thermal, hydrological, and mechanical effects of fluid injection to and withdrawal from ground for Stockton University reservoir cooling system (aquifer storage cooling system), Galloway, New Jersey, on ...
Smith, J. et al Lawrence Berkeley National Laboratory
Feb 26, 2021
15 Resources
0 Stars
Publicly accessible
15 Resources
0 Stars
Publicly accessible
2016 Passive Seismic Imaging of the Dixie Valley Geothermal Well Field for EGS Favorability and Fault Mapping
This submission provides reports on the results of seismic data analyses, statistical data sets of rock properties under the DVGWF, GIS data for new maps of EGS favorability, and a link to raw seismogram data archived by the IRIS-DMS.
Louie, J. et al University of Nevada, Reno
Nov 01, 2015
7 Resources
0 Stars
Publicly accessible
7 Resources
0 Stars
Publicly accessible
Seismic Analysis of Spatio-Temporal Fracture Generation During EGS Resource Development Full Moment Tensors and Stress Inversion Catalogs
This submission contains 167 full moment tensor (MT) solutions for the seismicity observed two years prior and three years post start of injection activities.
Also included are the azimuth and plunge angles for the three main stress directions sigma1, sigma 2 and sigma 3 at the P...
Gritto, R. et al Array Information Technology
Sep 26, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible