Search OEDI Data
Showing results 201 - 225 of 619.
Show
results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
Project Hotspot Petrology, Geochemistry and Stratigraphy of the Kimama core hole, Snake River Plain, Idaho
This submission contains links to two open source published papers on the Kimama core hole, Project Hotspot.
"Volcanic stratigraphy and age model of the Kimama deep borehole (Project Hotspot)" Basalts erupted in the Snake River Plain of central Idaho and sampled in the Kimama dri...
Shervais, J. et al Utah State University
Mar 19, 2019
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Western USA Assessment of High Value Materials in Geothermal Fluids and Produced Fluids Final Report
This report documents the results of investigations dealing with the concentrations and availabilities of strategic, critical and valuable materials (SCVM) in produced waters from geothermal and hydrocarbon reservoirs (50-250 degrees C) in Idaho, Nevada, New Mexico, Oregon, and Ut...
Simmons, S. Energy and Geoscience Institute at the University of Utah
Mar 18, 2019
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Assessing REE Concentrations in Geothermal and Oil and Gas Produced Waters: A Potential Domestic Source of Strategic Mineral Commodities
The project team collected and analyzed 224 water samples and 101 matching rock samples. INL's improved method of measuring aqueous REEs allows study of samples previously thought too volume limited to measure.
The study found that aqueous REEs occur at trace levels in all analyz...
Quillinan, S. et al University of Wyoming
Mar 08, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Material Properties for Brady Hot Springs Nevada USA from PoroTomo Project
The PoroTomo team has completed inverse modeling of the three data sets (seismology, geodesy, and hydrology) individually, as described previously. The estimated values of the material properties are registered on a three-dimensional grid with a spacing of 25 meters between nodes....
Feigl, K. and PoroTomo Team, . University of Wisconsin
Mar 06, 2019
10 Resources
0 Stars
Publicly accessible
10 Resources
0 Stars
Publicly accessible
Resource Analysis for Deep Direct-Use Feasibility Study in East Texas, Part 2
The National Renewable Energy Laboratory, Southern Methodist University Geothermal Laboratory, Eastman Chemical, Turbine Air Systems, and the Electric Power Research Institute are evaluating the feasibility of using geothermal heat to improve the efficiency of natural gas power pl...
Richards, M. et al Southern Methodist University
Mar 01, 2019
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
PoroTomo Distributed Temperature Sensing (DTS) Measurements made in Brady Observation Well 56-1
This submission is a follow-up to Distributed Temperature Sensing (DTS) measurements made in Brady observation well 56-1 during the PoroTomo field experiment conducted in March, 2016. The measurements in this data set were made on August 24, 2018 over an approximately 20 hour per...
Kratt, C. et al Oregon State University
Jan 09, 2019
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Feasibility of a Deep Direct-Use Geothermal System at the University of Illinois Urbana-Champaign
Paper authored by Stumpf et al. for the 2018 Geothermal Resources Council Annual Meeting held in Reno, NV USA. Included with the paper is the Microsoft PowerPoint presentation made at the GRC meeting and data tables associated with some of the figures.
Stumpf, A. et al University of Illinois
Dec 31, 2018
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Geocellular model of St. Peter Sandstone for University of Illinois at Urbana-Champaign DDU Feasibility Study
The geocellular model of the St. Peter Sandstone was constructed for the University of Illinois at Urbana-Champaign DDU feasibility study. Starting with the initial area of review (18.0 km by 18.1 km [11.2 miles by 11.3 miles]) the boundaries of the model were trimmed down to 9.7 ...
Damico, J. University of Illinois
Dec 31, 2018
5 Resources
0 Stars
Publicly accessible
5 Resources
0 Stars
Publicly accessible
Geocellular Model of Mt. Simon Sandstone for University of Illinois at Urbana-Champaign DDU feasibility study
The geocellular model of the Mt. Simon Sandstone was constructed for the University of Illinois at Urbana-Champaign DDU feasibility study. Starting with the initial area of review (18.0 km by 18.1 km [11.2 miles by 11.3 miles]) the boundaries of the model were trimmed down to 9.7 ...
Damico, J. University of Illinois
Dec 31, 2018
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Utah FORGE: Area Terrain Slope Data
This archive contains a terrain slope image, in units of degrees, of the Utah FORGE area near Roosevelt Hot springs. The data was derived from 0.5 m resolution LiDAR DEM data and is in a GeoTiff format. It was processed using ArcGIS.
Nash, G. Energy and Geoscience Institute at the University of Utah
Dec 10, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Earth Model Mesh Data for Selected Surfaces
This submission contains a number of data files with vertices of meshed/interpolated surfaces used in the Phase 2B earth model. Examples include land surface (based on 10-meter DEM), the granitoid-basin fill contact, several faults, and also interpolated temperature isosurfaces f...
Podgorney, R. Idaho National Laboratory
Dec 07, 2018
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Utah FORGE: Geologic, Topographic, and Other Related Maps and GIS Data from the Earth Model
This submission contains a number of maps and shapefiles related to the Utah FORGE site. Examples include geologic maps (several variations) and GIS data for the Utah FORGE site outline.
All data are georeferenced to UTM, zone 12N, NAD 83, NAVD 88.
Podgorney, R. et al Idaho National Laboratory
Dec 07, 2018
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 58-32 Injection Test Data
This submission contains pressure and flow time series data from the reservoir testing of Well 58-32. These activities were part of the Utah FORGE Phase 2B site suitability confirmatory testing.
Podgorney, R. and McLennan, J. Idaho National Laboratory
Dec 07, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Roosevelt Hot Springs Analytical Well-Based Temperature Model Data
This submission contains a cumulative record of one-dimensional temperature modeling based off of well data in the vicinity of the Utah FORGE site. Temperature log data from wells used, and in some cases were extrapolated below the bottom of a number of wells. The data were corre...
Podgorney, R. and Allis, R. Idaho National Laboratory
Dec 07, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Well Data for Student Competition
Well 58-32 (previously labeled MU-ESW1) was drilled near Milford Utah during Phase 2B of the FORGE Project to confirm geothermal reservoir characteristics met requirements for the final FORGE site.
Well Accord-1 was drilled decades ago for geothermal exploration purposes. While ...
Podgorney, R. et al Idaho National Laboratory
Dec 07, 2018
12 Resources
0 Stars
Publicly accessible
12 Resources
0 Stars
Publicly accessible
Utah FORGE: Drilling Data for Student Competition
Diagnostic drilling data (Pason log files) from Well 58-32 (previously labeled MU-ESW1), which was drilled near Milford Utah during Phase 2B of the FORGE Project to confirm geothermal reservoir characteristics met requirements for the final FORGE site. This dataset includes both ...
Podgorney, R. et al Idaho National Laboratory
Dec 07, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Analysis of downhole data from USU-1 well Leidos Technical Report
USU Camas-1 is a geothermal test well drilled in Camas Prairie, Idaho, in the Summer and Fall of 2018. The purpose of this test well was to validate Play Fairway methodologies of the Snake River Plain Play Fairway Analysis project.
In this report, test data are analyzed to infer...
Garg, S. and Goranson, C. Utah State University
Dec 04, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Elevation Grid for top Columbia River Basalt (CRBG) in the Portland Basin used in DDU Feasibility Study
The Portland Basin is a prime location to assess the feasibility of DDU-TES because natural geologic conditions provide thermal and hydraulic separation from overlying aquifers that would otherwise sweep away stored heat. Under the Portland Basin, the lower Columbia River Basalt G...
Bershaw, J. and Scanlon, D. Portland State University
Dec 01, 2018
5 Resources
0 Stars
Publicly accessible
5 Resources
0 Stars
Publicly accessible
Utah FORGE: Milford Deep Test Well 58-32 (MU-ESW1) Pressure and Temperature Logs
This archive consists of a pdf graphic log and a LAS text file representing the results of the pressure and temperature logs measured on Nov. 8th, 2018 from the Utah FORGE deep test well 58-32 (MU-ESW1). The logs were taken by DI Drill Survey Services.
Moore, J. Energy and Geoscience Institute at the University of Utah
Nov 08, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
USU Camas-1 Test Well: Documentation
This submission contains documents that describe the USU Camas-1 test well, drilled in Camas Prairie, Idaho, in Fall 2018 and Fall 2019. The purpose of this well is to validate exploration methodologies of the Snake River Plain (SRP) Play Fairway Analysis (PFA) project.
Shervais, J. Utah State University
Oct 31, 2018
13 Resources
0 Stars
Publicly accessible
13 Resources
0 Stars
Publicly accessible
Full Moment Tensor Inversion Software
The link points to a website at NCEDC to download the full moment tensors inversion software The moment tensor analysis conducted in the current project is based on the full moment tensor model described in Minson and Dreger (2008). The software including source, examples and tut...
Gritto, R. and Dreger, D. Array Information Technology
Oct 31, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Western USA Assessment of High Value Materials in Geothermal Fluids and Produced Fluids
This submission includes the following:
Field Characteristics: Describes the geological and production field characteristics of sampling sites
Geochemistry of Produced Fluids Idaho-Nevada-New Mexico-Oregon-Utah: Summarizes the all the analytical results for aqueous samples...
Simmons, S. et al Energy and Geoscience Institute at the University of Utah
Oct 31, 2018
5 Resources
0 Stars
Publicly accessible
5 Resources
0 Stars
Publicly accessible
Utah FORGE: Pressure Temperature Logs from Blundell Well 71-10, Beaver County
This archive contains an Excel spreadsheet with pressure and temperature logs from PacifiCorp well 71-10. This well is in the Blundell Power Plant geothermal well field near Roosevelt Hot Springs, Beaver County, Utah. The spreadsheet also contains UTM coordinates for the location ...
Foster, K. Energy and Geoscience Institute at the University of Utah
Oct 08, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Beaver Basin Wildcat Well Lu Lu State #1 Dip Meter and Neutron Density Logs
This dataset contains Schlumberger dip meter and neutron density logs for Lu Lu State #1 wild cat well which is located in the Beaver Basin, Beaver County, Utah. There is also a text file with well location coordinates.
Schlumberger, S. Energy and Geoscience Institute at the University of Utah
Oct 08, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Snake River Plain Geothermal Play Fairway Analysis Project Active Source Seismic Data
This archive contains seismic shot field records for 10 profiles located in Camas Prairie, Idaho. The eight numbered .sgy files were acquired using a seismic land streamer system with an accelerated weight drop source and 72 geophones. These 10-Hz geophones were mounted on base pl...
Liberty, L. and Shervais, J. Boise State University
Sep 30, 2018
21 Resources
0 Stars
Publicly accessible
21 Resources
0 Stars
Publicly accessible