Search OEDI Data
Showing results 26 - 50 of 511.
Show
results per page.
Order by:
Available Now:
Research Areas
Accessibility
Data Type
Organization
Source
Geocellular Model of Mt. Simon Sandstone for University of Illinois at Urbana-Champaign DDU feasibility study
The geocellular model of the Mt. Simon Sandstone was constructed for the University of Illinois at Urbana-Champaign DDU feasibility study. Starting with the initial area of review (18.0 km by 18.1 km [11.2 miles by 11.3 miles]) the boundaries of the model were trimmed down to 9.7 ...
Damico, J. University of Illinois
Dec 31, 2018
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Hawaii Play Fairway Analysis: Oahu Groundwater Flow Model
Groundwater flow model for the island of Oahu. Data is from the following sources:
Rotzoll, K., A.I. El-Kadi. 2007. Numerical Ground-Water Flow Simulation for Red Hill Fuel Storage Facilities, NAVFAC Pacific, Oahu, Hawaii Prepared TEC, Inc. Water Resources Research Center, Univer...
Lautze, N. University of Hawaii
Jan 01, 2015
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Snake River Plain Play Fairway Analysis Favorability Models
This submission contains a link to two USGS data publications. Each data release contains all digital geographic data used and produced by the Snake River Plain Play Fairway Analysis for Phase 1 and Phase 2 (ArcGIS shapefiles and raster files) as well as the model processing scrip...
DeAngelo, J. et al Utah State University
Jun 01, 2020
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Utah FORGE: Seismic and Other Shapefiles from the Roosevelt Hot Springs Area
Three shapefiles in this submission show the position of proposed seismic line surveys. The mid-crustal velocity anomaly file shows the extent of an anomalously low P-wave velocity zone in the subsurface. Two other files show the extent of known hydrothermal systems in the Rooseve...
Moore, J. Energy and Geoscience Institute at the University of Utah
Mar 22, 2016
7 Resources
0 Stars
Publicly accessible
7 Resources
0 Stars
Publicly accessible
DCIF Westerly Granite AE Stress Effect Test (Task 3-1)
Directional Cooling-Induced Fracturing (DCIF) experiments were conducted on rectangular Westerly granite blocks (width=depth=4.0", height=2.0"). Liquid nitrogen was poured in a small, 1"-diameter copper cup attached to the top of the sample, and the resulting acoustic emissions (A...
Nakagawa, S. and Trzeciak, M. Lawrence Berkeley National Laboratory
Jul 08, 2021
15 Resources
0 Stars
Publicly accessible
15 Resources
0 Stars
Publicly accessible
First Results Project Hotspot Drilling
Project Hotspot drilled 3 slim hole exploratory wells in southern Idaho, each just under 2 km deep. These holes were designed to investigate thermal structure in three different settings within the Snake River Volcanic Province: (1) along the axial volcanic high of the central SRP...
Shervais, J. et al Utah State University
Mar 15, 2013
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
LiDAR as an Exploration Tool
Using LiDAR to identify structural and volcanic evolution of a Miocene-Pleistocene age bimodal volcanic complex and implications for geothermal potential. The file includes an updated geologic map, methods, and preliminary results.
Boschmann, D. et al Ormat Nevada Inc
Jan 01, 2011
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Machine Learning to Identify Geologic Factors Associated with Production in Geothermal Fields: A Case-Study Using 3D Geologic Data from Brady Geothermal Field and NMFk
In this paper, we present an analysis using unsupervised machine learning (ML) to identify the key geologic factors that contribute to the geothermal production in Brady geothermal field. Brady is a hydrothermal system in northwestern Nevada that supports both electricity producti...
Siler, D. et al United States Geological Survey
Oct 01, 2021
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Utah FORGE: 3D Gravity Data
These resources describe the 3D geophysical inversion modeling of gravity data at the FORGE site near Milford, Utah. FORGE is the Frontier Observatory for Research in Geothermal Energy and the site in Utah has been selected by the U.S. Dept. of Energy for a 5-year R&D program to t...
Hardwick, C. and Witter, J. Energy and Geoscience Institute at the University of Utah
Jun 24, 2019
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
SMP and Fracture Modeling
The problem of loss circulation in geothermal wells is inherently challenging due to high temperatures, brittle rocks, and presence of abundant fractures. Because of the inherent challenges in geothermal environments, there are limitations in selecting proper lost circulation mate...
Salehi, S. et al University of Oklahoma
Oct 01, 2021
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Snake River Plain Geothermal Play Fairway Analysis Project MT Data
MT is measured in the field by using induction coils to measure the time-varying magnetic source for frequencies between 1000-0.001~Hz, and electric dipoles to measure the Earth's electrical response. Because the magnetic source field is polarized, orthogonal directions of the f...
Peacock, J. et al United States Geological Survey
May 06, 2018
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Validation of Innovative Exploration Technologies for Newberry Volcano: Report of 4D Seismic Analysis
Validation of Innovative Exploration Technologies for Newberry Volcano: Report of 4-D seismic Analysis by Apex HiPoint (Sigma3) 2012
Jaffe, T. Davenport Newberry Holdings, LLC
Dec 12, 2012
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Geothermal Electricity Technology Evaluation Model (GETEM) Individual Case Files and Summary Spreadsheet (GETEM version Spring 2013)
This group of files includes 10 GETEM individual scenario files and 1 summary spreadsheet. Each spreadsheet contains final data (following the revisions made between summer of 2011 and spring of 2013).
Entingh, D. et al Idaho National Laboratory
Mar 07, 2013
11 Resources
0 Stars
Publicly accessible
11 Resources
0 Stars
Publicly accessible
Utah FORGE Phase 3 Native State Model: 2022 Update
This is the Phase 3 native state model update. The Phase 3 numerical model represents a significant subsurface volume below the FORGE site footprint. The model domain of 4.0 km x 4.0 km x 4.2 km is located approximately between depths of 4000 to 4200 meters below land surface. Thi...
Podgorney, R. and Liu, R. Idaho National Laboratory
Jul 29, 2022
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Active Management of Integrated Geothermal-CO2 Storage Reservoirs in Sedimentary Formations
Active Management of Integrated Geothermal-CO2 Storage Reservoirs in Sedimentary Formations: An Approach to Improve Energy Recovery and Mitigate Risk: FY1 Final Report
The purpose of phase 1 is to determine the feasibility of integrating geologic CO2 storage (GCS) with geothermal ...
A., T. Lawrence Livermore National Laboratory
Jan 01, 2012
8 Resources
0 Stars
Publicly accessible
8 Resources
0 Stars
Publicly accessible
Utah FORGE LBNL 3-2535 Preliminary Report on Development of a Reservoir Seismic Velocity Model
This report describes the development of a preliminary 3D seismic velocity model at the Utah FORGE site and first results from estimating seismic resolution in the generated fracture volume during Stage 3 of the April 2022 stimulation.
A preliminary 3D velocity model for the larg...
Gritto, R. Array Information Technology
Jan 30, 2023
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Magnetotelluric Data Collected in 2016 over the San Emidio Geothermal Field in Nevada
This data set includes the magnetotelluric (MT) data collected from October 21 to November 9, 2016 over the San Emidio geothermal field in Nevada by Quantec Geoscience USA Inc. on behalf of US Geothermal Inc. as part of a project entitled "A Novel Approach to Map Permeability Usi...
Folsom, M. et al Ormat Technologies, Inc.
Nov 09, 2016
11 Resources
0 Stars
Publicly accessible
11 Resources
0 Stars
Publicly accessible
GEOPHIRES files for DDU techno-economic simulations
During 2017-2019, the U.S. Department of Energy funded six geothermal deep direct-use (DDU) projects to investigate feasibility of DDU for heating, cooling and thermal storage in the United States. In a follow-on study conducted at the National Renewable Energy Laboratory (NREL), ...
Beckers, K. and Kolker, A. National Renewable Energy Laboratory
Mar 31, 2021
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Data of High-Temperature Dynamic LCM Testing Setup
Data from high temperature dynamic sealing tests for various fracture widths, at various temperatures (degrees F), with 5 wt.% bentonite-based mud containing various material fiber contents, at 100 to 400 psi differential pressure.
Data from pressure test and evaluation of the dy...
Magzoub, M. et al University of Oklahoma
May 31, 2021
11 Resources
0 Stars
Publicly accessible
11 Resources
0 Stars
Publicly accessible
Utah FORGE Project 3-2535: Building a 3D Resistivity Model for Simulation and Survey Design of EM Measurements
The included report outlines the creation of three 3D resistivity models that will be used to determine the sensitivity of EM measurements for the hypothetical stimulated reservoir at FORGE as well as for EM survey design. FORGE project 3-2535 is planning on using a casing source ...
Alumbaugh, D. et al Lawrence Berkeley National Laboratory
Dec 01, 2022
5 Resources
0 Stars
Publicly accessible
5 Resources
0 Stars
Publicly accessible
Electricity Market and NREL ATB Resources
The following resources host grid service pricing (e.g. ancillary services) beyond wholesale electric pricing. The NREL Annual Technology Baseline (ATB) provides a consistent set of technology cost and performance data for energy analysis.
Rhodes, G. National Renewable Energy Laboratory
Jan 31, 2020
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
SMP Preparation, Programming, and Characterization
The problem of loss circulation in geothermal wells is inherently challenging due to high temperatures, brittle rocks, and presence of abundant fractures. Because of the inherent challenges in geothermal environments, there are limitations in selecting proper lost circulation mate...
Salehi, S. et al University of Oklahoma
Oct 01, 2021
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Fallon FORGE: 3D Geologic Model
The 3D geologic model for the Fallon for site was constructed in EarthVision software using methods similar to (Moeck et al., 2009, 2010; Faulds et al., 2010b; Jolie et al., 2012, 2015; Hinz et al., 2013a; Siler and Faulds, 2013; Siler et al., 2016a, b) References are included in ...
Blankenship, D. and Siler, D. Sandia National Laboratories
Mar 01, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Dixie Valley Engineered Geothermal System Exploration Methodology Project, Baseline Conceptual Model Report
The Engineered Geothermal System (EGS) Exploration Methodology Project is developing an exploration approach for EGS through the integration of geoscientific data. The Project chose the Dixie Valley Geothermal System in Nevada as a field laboratory site for methodlogy calibration...
Iovenitti, J. AltaRock Energy Inc
May 15, 2013
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Hotspot Project: The Snake River Geothermal Drilling Project Initial Report
The Snake River volcanic province (SRP) overlies a thermal anomaly that extends deep into the mantle; it represents one of the highest heat flow provinces in North America. The primary goal of this project is to evaluate geothermal potential in three distinct settings: (1) Kimama ...
Shervais, J. et al Utah State University
Jan 01, 2012
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible