Search OEDI Data

Analysis of a suspended cylinder in a wave basin

**Overview** The Offshore Code Comparison, Collaboration, Continued, with Correlation (OC5) is an international research project run under the International Energy Agency (IEA) Wind Task 30. The project is focused on validating the tools used design offshore wind systems. OC5 con...

Robertson, A. Wind Energy Technologies Office (WETO)

Jul 22, 2019
1 Resources
0 Stars
Publicly accessible

TEAMER AquaHarmonics High Fidelity WEC Sim PTO and Control Model Validation

Collaborative effort between AquaHarmonics, Sandia National Laboratories (SNL), and the National Renewable Energy Laboratory (NREL) to revise and validate Aquaharmonics' full wave to wire model, allowing for reduced uncertainty and increased understanding of design requirements of...

Tom, N. and Leon, J. AquaHarmonics, Inc.

Dec 31, 2021
5 Resources
0 Stars
Publicly accessible

Passive Seismic Emission Tomography Results at San Emidio Nevada

The utility of passive seismic emission tomography for mapping geothermal permeability has been tested at San Emidio in Nevada. The San Emidio study area overlaps a geothermal field in production since 1987 and another resource to the south of the production field. Passive seismic...

Warren, I. et al Ormat Technologies, Inc.

Dec 01, 2016
2 Resources
0 Stars
Publicly accessible

BOBr Processed Breaking Wave Data, Agate Beach, OR

This data was recorded by the BOBr (Buoy to Observe Breaking) off the coast of Newport, OR at Agate Beach in the surf zone. The data was recorded by a 9dof inertial measurement unit and consists of a timestamp, quaternion orientation, acceleration vector, rotation vector, and mag...

C, A. Oregon State University

Oct 31, 2013
17 Resources
0 Stars
Publicly accessible

Conducting a 3D Converted Shear Wave Project to Reduce Exploration Risk at Wister, CA

2010 Peer Review of the 'Conducting a 3D Converted Shear Wave' Project to reduce exploration risk at Wister, CA. The presentation includes a timeline, budget, barriers, and partners. The objective of the project is also explained in the presentation.

Matlick, S. Ormat Nevada Inc

May 18, 2010
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Circulation Testing Processed data

This submission includes processed and reduced data for circulation testing that was conducted at the 164' fracture on the 4850 ft level of the Sanford Underground Research Facility. The circulation tests were done to test the flow through the 164' fracture in the EGS Collab Exper...

Fu, P. et al Lawrence Livermore National Laboratory

Apr 01, 2021
7 Resources
0 Stars
Publicly accessible

Directional Cooling-Induced Fracturing Westerly Granite Test Results

Directional Cooling-Induced Fracturing (DCIF) experiments were conducted on a short, cylindrical sample of Westerly granite (diameter = 4 inches, height ~ 2 inches). Liquid nitrogen was poured in a copper cup attached to the top of the sample, and the resulting acoustic emissions ...

Nakagawa, S. Lawrence Berkeley National Laboratory

Dec 18, 2020
5 Resources
0 Stars
Publicly accessible

BOBr Raw Breaking Wave Data, Agate Beach, OR

Raw data from the BOBr (Buoy to Observe Breaking) wave measurement buoy. Data was recorded off the coast of Newport, OR at Agate Beach, in the surf zone.

C, A. Oregon State University

Oct 31, 2013
12 Resources
0 Stars
Publicly accessible

Centipod WEC, Advanced Controls, WEC Geometry CAD

CAD files depicting the wetted geometry of the Centipod WEC used in numerical models during this project. This includes the wetted geometry of the point absorber body ('pod') and the WEC 'backbone'.

McCall, A. Dehlsen Associates, LLC

Feb 15, 2016
3 Resources
0 Stars
Publicly accessible

Conducting a 3D Converted Shear Wave Project to reduce exploration risk at Wister, CA: Geothermal Technologies Program 2011 Peer Review

2011 Peer Review of the 'Conducting a 3D Converted Shear Wave' Project to reduce exploration risk at Wister, CA.

Matlick, S. Ormat Nevada Inc

Jun 01, 2011
1 Resources
0 Stars
Publicly accessible

Utah FORGE Development of a Reservoir Seismic Velocity Model and Seismic Resolution Study

This is data from and a final report on the development of a 3D velocity model for the larger FORGE area and on the seismic resolution in the stimulated fracture volume at the bottom of well 16A-32. The velocity model was developed using RMS velocities of the seismic reflection su...

Vasco, D. and Chan, C. Array Information Technology

Apr 30, 2022
2 Resources
0 Stars
Publicly accessible

EGS Collab: 3D Geophysical Model Around the Sanford Underground Research Facility

This package contains data associated with a proceedings paper (linked below) submitted to the 44th Workshop on Geothermal Reservoir Engineering. The Geophysical Model text file contains density, P and S-wave seismic speeds on a 3D grid. The file has six columns and provides latit...

Chai, C. et al Lawrence Berkeley National Laboratory

Feb 06, 2019
3 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Circulation Testing

These data and test descriptions comprise a chilled circulation test conducted at the 164' fracture in the EGS Collab Experiment 1 testbed on the 4850 ft level of the Sanford Underground Research Facility. Descriptions of the meta data, design drawings for the flow testing system,...

Knox, H. et al Lawrence Berkeley National Laboratory

Apr 01, 2019
11 Resources
0 Stars
Publicly accessible

Reservoir Stimulation Optimization with Operational Monitoring for Creation of EGS

EGS field projects have not sustained production at rates greater than half of what is needed for economic viability. The primary limitation that makes commercial EGS infeasible is our current inability to cost-effectively create high-permeability reservoirs from impermeable, igne...

A., C. Pacific Northwest National Laboratory

Sep 25, 2013
19 Resources
0 Stars
Publicly accessible

PoroTomo: Horizontal Distributed Acoustic Sensing (DAS) Measurements During an M 2.3 Explosion

Included here are Distributed Acoustic Sensing (DAS) data collected by the horizontal DAS array at Brady's Hot Springs Geothermal Field. The system recorded this data during an M 2.3 explosion at the Nevada Test Site (NTS), which is located approximately 400km southeast of the fie...

Kratt, C. et al Center for Transformative Environmental Monitoring Programs (CTEMPs)

Dec 18, 2018
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 2C Topical Report

This is the topical report that wraps up the work and results achieved during Utah FORGE Phase 2C. The zip file includes several folders containing (1) an overview; (2) the results; (3) the lessons learned; and (4) the conclusions. It also contains a folder containing appendices i...

Moore, J. et al Energy and Geoscience Institute at the University of Utah

Dec 11, 2019
2 Resources
0 Stars
Publicly accessible

HERO WEC V1.0 WEC-Sim Model

This zip file contains the files that are needed to simulate NREL's HERO WEC (hydraulic and electric reverse osmosis wave energy converter). This requires the user to have already installed WEC-Sim. In addition to the standard toolboxes that are required to run WEC-Sim the user wi...

Jenne, S. National Renewable Energy Laboratory

Aug 12, 2022
2 Resources
0 Stars
Publicly accessible

CalWave xWave New Technology Qualification and Path to Certification Final Report

Final report including results and conclusions of the New Technology Qualification (NTQ) review of CalWave Power Technologies Inc's xWave technology, performed by American Bureau of Shipping.

Petcovic, D. and Zhang, S. CalWave Power Technologies Inc.

Oct 31, 2022
1 Resources
0 Stars
Publicly accessible

Magnetotelluric Data Collected in 2016 over the San Emidio Geothermal Field in Nevada

This data set includes the magnetotelluric (MT) data collected from October 21 to November 9, 2016 over the San Emidio geothermal field in Nevada by Quantec Geoscience USA Inc. on behalf of US Geothermal Inc. as part of a project entitled "A Novel Approach to Map Permeability Usi...

Folsom, M. et al Ormat Technologies, Inc.

Nov 09, 2016
11 Resources
0 Stars
Publicly accessible

kISMET Final Report and Highlights

The files in this submission describes the results of a series of stress measurement and hydraulic fracturing experiments conducted at the Sanford Underground Research Facility (SURF) in Lead, SD. This report describes the accomplishments of the kISMET (permeability (k) and Induce...

Oldenburg, C. et al Lawrence Berkeley National Laboratory

Oct 31, 2016
2 Resources
0 Stars
Publicly accessible

Newberry EGS Literature References

Research references to literature about the Newberry geothermal area, Oregon.

Rose, K. National Energy Technology Laboratory

Apr 22, 2016
1 Resources
0 Stars
Publicly accessible

University of Massachusetts Marine Renewable Energy Center Waverider Buoy Data

The compressed (.zip) file contains Datawell MK-III Directional Waverider binary and unpacked data files as well as a description of the data and manuals for the instrumentation. The data files are contained in the two directories within the zip file, "Apr_July_2012" and "Jun_Sept...

Lohrenz, S. University of Massachusetts

Oct 07, 2015
3 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: 4100 Foot Level Elastic Property Data

Static and dynamic elastic properties (Young's modulus, Shear Modulus, P-wave Modulus, and Poisson's Ratio) of amphibolites and rhyolites from the TV4100 and TH4100 boreholes at the Sanford Underground Research Laboratory (SURF). Elastic properties include Young's modulus, Poisson...

Jahnke, B. et al Lawrence Berkeley National Laboratory

Dec 18, 2020
4 Resources
0 Stars
Publicly accessible

HERO WEC V1.0 SolidWorks Model

The attached zip file includes a SolidWorks pack-and-go assembly of NREL's HERO WEC (hydraulic and electric reverse osmosis wave energy converter) V1.0. This model does not include all aspects of the design (i.e. RO (reverse osmosis) system, electrical enclosure, hose, cable) it o...