Search OEDI Data

Evaluation of the Performance of Houses With and Without Supplemental Dehumidification in a Hot-Humid Climate

Understanding indoor humidity conditions in low energy homes in hot-humid climates is critical to promoting long term occupant comfort, indoor air quality and building durability. The results of this study were expected to inform the residential building community on whether suppl...

Kerrigan, P. and Norton, P. National Renewable Energy Laboratory

Apr 27, 2016
7 Resources
0 Stars
Publicly accessible

Industrial Facility Combustion Energy Use

Facility-level industrial combustion energy use is calculated from greenhouse gas emissions data reported by large emitters (>25,000 metric tons CO2e per year) under the U.S. EPA's Greenhouse Gas Reporting Program (GHGRP, https://www.epa.gov/ghgreporting). The calculation applies ...

McMillanNational Renewable Energy Laboratory

Jul 19, 2016
2 Resources
0 Stars
Publicly accessible

Utah FORGE Project 3-2535: Modeling Studies of Energized Steel-Casing Source EM Method for Detecting Stimulated Zone

Numerical modeling Studies for electromagnetic (EM) Data Acquisition Survey Design this milestone report describes the 3D modeling studies of energized steel-casing source electromagnetic method for detecting stimulated zone at the Utah FORGE Site. FORGE project 3-2535 is planning...

Um, E. et al Lawrence Berkeley National Laboratory

Feb 06, 2023
4 Resources
0 Stars
Publicly accessible

Using Fully Coupled Hydro-Geomechanical Numerical Test Bed to Study Reservoir Stimulation with Low Hydraulic Pressure

This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimu...

Fu, P. et al Lawrence Livermore National Laboratory

Jan 31, 2012
2 Resources
0 Stars
Publicly accessible

Industrial Process Heat Demand Characterization

This data set is an expansion of the facility-level process heat survey conducted by McMillan et al. 2015 https//doi.org/10.2172/1334495. Using the same methodology annual facility combustion energy use was calculated from emissions data reported to U.S. Environmental Protection A...

McMillan and RuthNational Renewable Energy Laboratory

Jul 05, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE 1-2551: Development of a Multi-Stage Fracturing System and Wellbore Tractor 2024 Annual Workshop Presentation

This is a presentation on the Development of a Multi-Stage Fracturing System and Wellbore Tractor by Colorado School of Mines, presented by William Fleckenstein. This video describes (1) the development and use of a low-cost and rapid multistage fracture stimulation technology wit...

Fleckenstein, W. Energy and Geoscience Institute at the University of Utah

Jan 13, 1970
1 Resources
0 Stars
Publicly accessible

Control Strategies to Reduce the Energy Consumption of Central Domestic Hot Water Systems

Domestic hot water (DHW) is the second-largest energy end use in U.S. buildings; it is exceeded only by space conditioning. In this study, the U.S. Department of Energy's Building America research team Advanced Research Integrated Energy Solutions installed and tested two types o...

Dentz, J. et al The Levy Partnership, Inc Systems Building Research Alliance

Apr 27, 2016
3 Resources
0 Stars
Publicly accessible

Analysis of Joist Masonry Moisture Content Monitoring

BSC TO5 Task 7.2 Analysis of Joist Masonry Moisture Content Monitoring House Lawrence, MA 01840 This work involved the field monitoring of embedded wood joist ends in a solid brick building in zone 5A that was retrofitted with interior insulation. Eleven joists throughout the bui...

Ueno, K. Building Science Corporation

Apr 27, 2016
3 Resources
0 Stars
Publicly accessible

Utah FORGE 4-2541: Optimization and Validation of a Plug-and-Perf Stimulation Treatment Design Workshop Presentation

This is a presentation on the Optimization and Validation of a Plug-and-Perf Stimulation Treatment Design at Utah FORGE project by Fervo Energy, presented by Sireesh Dadi. The project's objective was to develop a multistage hydraulic stimulation approach designed specifically to t...

Dadi, S. and Norbeck, J. Fervo Energy

Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

Solar-to-Grid Public Data File for Utility-scale (UPV) and Distributed Photovoltaics (DPV) Generation, Capacity Credit, and Value for 2012-2020

Lawrence Berkeley National Laboratory (Berkeley Lab) estimates hourly project-level generation data for utility-scale solar projects and hourly county-level generation data for residential and non-residential distributed photovoltaic (PV) systems in the seven organized wholesale m...

Seel, J. et al Lawrence Berkeley National Lab

Oct 01, 2021
4 Resources
1 Stars
Publicly accessible

Modular Zero Energy Ready Homes: Bright Built Maine

Kaplan Thompson Architects (KTA) has specialized in sustainable, energy-efficient buildings, and they have designed several custom, zero-energy homes in New England. These zero-energy projects have generally been high-end, custom homes with budgets that could accommodate advanced ...

Aldrich, R. and Butterfield, K. Steven Winter Associates of the Consortium for Advanced Residential Buildings

Apr 27, 2016
2 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2417: Fiber-Optic Geophysical Monitoring of Reservoir Evolution Workshop Presentation

This is a presentation on the Fiber-Optic Geophysical Monitoring of Reservoir Evolution at the Utah FORGE Milford Site project by Rice University, presented by Prof. Jonathan Ajo-Franklin. The project's objective was to develop an end-to-end fiber-optic sensing approach for EGS to...

Ajo-Franklin, J. et al Rice University

Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

First Tracer Test After Circulation in Desert Peak 27-15

Following the successful stimulation of Desert Peak target EGS well 27-15, a circulation test was initiated by injecting a conservative tracer (1,5-nds) in combination with a reactive tracer (7-amino-1,3-naphthalene disulfonate). The closest production well 74-21 was monitored ove...

Rose, P. University of Utah

Nov 16, 2013
1 Resources
0 Stars
Publicly accessible

Utah FORGE: 2023 Induced Seismicity Mitigation Plan

This is the updated Utah FORGE Phase 3B induced seismicity mitigation plan (ISMP) covering the general Utah FORGE area. This new version incorporates newly collected seismic data, including data collected during the 2022 stimulation and a probabilistic seismic hazard assessment (...

Pankow, K. et al University of Utah Seismograph Stations

Aug 09, 2023
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Hydraulic Pressure Test Results

The EGS Collab experiment 2 was focused on testing shear stimulation techniques. Shear stimulation, in this case, means using hydraulic pressure to cause shear slip on preexisting fracture or fault planes such that the hydraulic conductivity of the fracture or fault increases. The...

Burghardt, J. et al Lawrence Berkeley National Laboratory

Feb 17, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE Development of a Reservoir Seismic Velocity Model and Seismic Resolution Study

This is data from and a final report on the development of a 3D velocity model for the larger FORGE area and on the seismic resolution in the stimulated fracture volume at the bottom of well 16A-32. The velocity model was developed using RMS velocities of the seismic reflection su...

Vasco, D. and Chan, C. Array Information Technology

Apr 30, 2022
2 Resources
0 Stars
Publicly accessible

Utah FORGE GeoThermOPTIMAL Video

This is a project description video by Dr. William W. Fleckenstein related to their "Development of Multi-Stage Fracturing System and Wellbore Tractor to Enable Zonal Isolation During Stimulation and EGS Operations in Horizontal Wellbores" R&D project at Utah FORGE which is linked...

Fleckenstein, W. Colorado School of Mines

Dec 12, 2022
2 Resources
0 Stars
Publicly accessible

Utah FORGE 4-2492: Design and Implementation of Innovative Stimulation Treatments to Maximize Energy Recovery 2024 Annual Workshop Presentation

This is a presentation on the Design and Implementation of Innovative Stimulation Treatments to Maximize Energy Recovery Efficiency by The University of Texas at Austin, presented by Mukul M. Sharma. This video slide presentation discusses the following objectives: (1) to place fr...

Sharma, M. Energy and Geoscience Institute at the University of Utah

Sep 16, 2024
1 Resources
0 Stars
Publicly accessible

Solar-to-Grid Public Data File for Utility-scale (UPV) and Distributed Photovoltaics (DPV) Generation, Capacity Credit, and Value

Seel, J. et al Lawrence Berkeley National Lab

Sep 30, 2020
5 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Distributed Fiber Optic Temperature Data (DTS)

Distributed fiber optic sensing was an important part of the monitoring system for EGS Collab Experiment #2. A single loop of custom fiber package was grouted into the four monitoring boreholes that bracketed the experiment volume. This fiber package contained two multi-mode fiber...

Rodriguez Tribaldos, V. et al Lawrence Berkeley National Laboratory

Nov 08, 2022
10 Resources
0 Stars
Publicly accessible

Utah FORGE: Wells 16A(78)-32 and 16B(78)-32 Stimulation Pressure and Circulation Data April, 2024

This dataset consists of all of the pressure pumping data for Utah FORGE Well16A78-32 fracturing stages, Well 16B78-32 fracturing stages, and a 9-hour circulation test which took place after all of the frac plugs were drilled out. Fracturing in the wells took place in stages from ...

England, K. Energy and Geoscience Institute at the University of Utah

Jun 03, 2024
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 58-32 Stimulation Data

Pressure, temperature, and flow data from open-hole, upper perforation, and lower perforation well stimulations gathered from various tools collected at well 58-32 during phase 2C.

Best, S. Geothermal Resource Group

Apr 20, 2019
16 Resources
0 Stars
Publicly accessible

Numerical Modeling for Hydraulic Fracture Prediction

Numerical modeling on fused silica cylindrical materials for predicting overpressures required to fracture an homogeneous pure (surrogate) material with known mechanical properties similar to igneous rock materials and later compare these values to experimental overpressures obtai...

Gupta, V. Pacific Northwest National Laboratory

Apr 26, 2016
1 Resources
0 Stars
Publicly accessible

National Transmission Planning Study Long-Term Modeling Results

The National Transmission Planning Study (NTP Study) analyzed the transformation needed to ensure the U.S. transmission system continues to reliably meet electricity demand as the power sector evolves. The study linked several long and short-term power systems models to test numer...

Brown, P. and Mai, T. National Renewable Energy Laboratory (NREL)

Sep 10, 2023
14 Resources
0 Stars
Publicly accessible

Utah FORGE: Development of Multi-Stage Fracturing System and Wellbore Tractor to Enable Zonal Isolation During Stimulation and EGS Operations in Horizontal Wellbores

This paper discusses the progress on a project funded by the DOE Utah FORGE (Frontier Observatory for Research in Geothermal Energy) for the development of a subsurface heat exchanger for Enhanced Geothermal Systems (EGS) using unique casing sleeves cemented in place and are used ...

Fleckenstein, W. et al Colorado School of Mines

Oct 05, 2022
1 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 6 7 8 9 Next >>