Search OEDI Data

Utah FORGE: Phase 3A Year 1 Annual Report for 2020

This is the Utah FORGE annual report for Phase 3A year 1, which was completed on December 28th, 2020. This report includes site infrastructure, site operations, seismic monitoring, a conceptual geological model, outreach, and communications for the Utah FORGE project during Phase ...

Moore, J. et al Energy and Geoscience Institute at the University of Utah

Dec 28, 2020
1 Resources
0 Stars
Publicly accessible

Research Report of Low Temperature Geothermal Play Fairway Analysis for the Appalachian Basin

This is a final report summarizing a one-year (2014-15) DOE funded Geothermal Play Fairway Analysis of the Low-Temperature resources of the Appalachian Basin of New York, Pennsylvania and West Virginia. Collaborators included Cornell University, Southern Methodist University, and...

Jordan, T. et al Cornell University

Sep 30, 2015
22 Resources
0 Stars
Publicly accessible

UNH TDP Concurrent Measurements of Inflow, Power Performance, and Loads for a Grid-Synchronized Vertical Axis Cross-Flow Turbine Operating in a Tidal Estuary

This data was collected between October 12 and December 15 of 2021 at the University of New Hampshire (UNH) and Atlantic Marine Energy Center (AMEC) turbine deployment platform (TDP). This data set includes over 29 days of grid connected turbine operation during this 65 day time f...

Wosnik, M. et al National Renewable Energy Laboratory

Dec 21, 2021
30 Resources
0 Stars
Publicly accessible

Hydraulic Studies of Drilling Microbores with Supercritical Steam, Nitrogen and Carbon Dioxide

Hydraulic studies of drilling micropores at various depths and with various hole sizes, tubing, fluids and rates to show theoretical feasibility. WELLFLO Simulations Report separated into three parts: Step 4: Drilling 10,000 ft Wells with Supercritical Steam, Nitrogen, and Carbon...

Karaaslan, M. Impact Technologies LLC

Jan 01, 2010
3 Resources
0 Stars
Publicly accessible

Operational Performance Requirements For Motor Power Sections Used in Geothermal Drilling Based Upon Minimum Specific Energy

Operational performance requirements are needed to support development of specifications for downhole motor power sections to be used for drilling hard rock during geothermal wellbore construction. Theoretical torque specifications are derived based upon a widely-accepted rock-re...

Raymond, D. Sandia National Laboratories

Sep 10, 2014
1 Resources
0 Stars
Publicly accessible

Gravity Survey on the Glass Buttes Geothermal Exploration Project Lake County, Oregon

This report covers data acquisition, instrumentation and processing of a gravity survey performed on the Glass Buttes Geothermal Exploration Project, located in Lake County, Oregon for ORMAT Technologies Inc. The survey was conducted during 21 June 2010 to 26 June 2010. The surve...

Akerley, J. Ormat Nevada Inc

Oct 12, 2011
2 Resources
0 Stars
Publicly accessible

Hawthorne Nevada Deep Direct-Use Feasibility Study 3D Seismic

The objective of this project is to use a multi-disciplinary, three-tiered approach to assess the geothermal resource and determine the feasibility of implementing a large-scale, direct-use facility for the Hawthorne Army Depot (HAD) and the various town and county facilities in H...

Lowry, T. et al Nevada Bureau of Mines and Geology

Mar 29, 2018
6 Resources
0 Stars
Publicly accessible

REE Adsorption Performance with Immobilized Caulobacter Biofilms

This submission includes data collected from experiments on the performance of rare earth adsorption by immobilized bacteria that accompany the FY18 Q2 and Q3 quarter reports. Relevant information from these reports is included in a resource below. The spreadsheet below includes d...

Jiao, Y. and Park, D. Lawrence Livermore National Laboratory

Apr 01, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Seismic Activity from April, 2019

This dataset contains seismic event detections acquired using the 151 Nodal geophones deployed at the Utah FORGE site in April 2019. Details regarding the publishing are available in the paper linked below (Mesimeri, M. and K. L. Pankow et al. 2020). A frequency-domain-based algor...

Pankow, K. University of Utah Seismograph Stations

May 01, 2019
2 Resources
0 Stars
Publicly accessible

Development of a Neutron Diffraction Based Experimental Capability for Investigating Hydraulic Fractures for EGS-like Conditions

Understanding the relationship between stress state, strain state and fracture initiation and propagation is critical to the improvement of fracture simulation capability if it is to be used as a tool for guiding hydraulic fracturing operations. The development of fracture predict...

Polsky, Y. et al Oak Ridge National Laboratory

Feb 01, 2013
1 Resources
0 Stars
Publicly accessible

Snake River Plain Play Fairway Analysis: Mountain Home Geothermal Area Natural State Model

The Mountain Home area is characterized by high heat flow and temperature gradient. Temperature data are available from 18 boreholes with depths equal to or greater than 200 m, 5 of which have depths ranging from ~1340 m to ~3390 m (MH-1, MH-2, Bostic1, Lawrence D No.1, and Anschu...

Garg, S. et al Utah State University

Jul 28, 2015
4 Resources
0 Stars
Publicly accessible

LandRAY PTO Testing Utilizing the NREL NWTC 5MW Dynamometer

The overarching project objective is to demonstrate the feasibility of using an innovative PowerTake-Off (PTO) Module in Columbia Power's utility-scale wave energy converter (WEC). The PTO Module uniquely combines a large-diameter, direct-drive, rotary permanent magnet generator; ...

Lenee-Bluhm, P. and Rhinefrank, K. Columbia Power Technologies, Inc.

Jun 13, 2016
3 Resources
0 Stars
Publicly accessible

Underwater Mapping Results for Seabotix vLBV300 Vehicle with Tritech Gemini 720i Imaging Sonar near Newport, OR

This document presents results from tests to demonstrate underwater mapping capabilities of an underwater vehicle in conditions typically found in marine renewable energy arrays. These tests were performed with a tethered Seabotix vLBV300 underwater vehicle. The vehicle is equippe...

Hollinger, G. Oregon State University

May 15, 2017
5 Resources
0 Stars
Publicly accessible

MASK3 for Advanced WEC Dynamics and Controls

This report outlines the "MASK3" wave tank test within the Advanced WEC Dynamics and Controls (AWDC) project. This test represents the final test in the AWDC project. The focus of the MASK3 test was to consider coordinated 3-degree-of-freedom (3DOF) control of a WEC in a realistic...

Coe, R. et al Sandia National Laboratories

May 01, 2019
4 Resources
0 Stars
Publicly accessible

Accelerated Lifetime Testing of Main Shaft Seals for Tidal Turbine Rotors

The lifetime assessment experimental platform described in this report is specifically designed for testing the low-speed main shaft seal for Verdant Power's (Verdant Power Inc., New York, New York) fifth-generation (Gen5) underwater power generation turbine. This project is joint...

Murray, R. et al National Renewable Energy Laboratory

Jul 01, 2024
1 Resources
0 Stars
Publicly accessible

Improvements in 2016 to Natural Reservoir Analysis in Low-Temperature Geothermal Play Fairway Analysis for the Appalachian Basin

*These files add to and replace same-named files found within Submission 559 (hover over file display names to see actual file names in bottom-left corner of screen)* The files included in this submission contain all data pertinent to the methods and results of a cohesive multi-st...

Camp, E. Cornell University

Aug 18, 2016
16 Resources
0 Stars
Publicly accessible

Resource Analysis for Deep Direct-Use Feasibility Study in East Texas

The National Renewable Energy Laboratory, Southern Methodist University Geothermal Laboratory, Eastman Chemical, Turbine Air Systems, and the Electric Power Research Institute are evaluating the feasibility of using geothermal heat to improve the efficiency of natural gas power pl...

Richards, M. et al Southern Methodist University

Jun 28, 2018
13 Resources
0 Stars
Publicly accessible

Utah FORGE: Preliminary Monitoring, Analyses, and Impact Assessment

Preliminary monitoring and analyses for the Utah FORGE Milford Site. Includes a report detailing the seismic monitoring goals and results, a detailed techno-economic infrastructure assessment with an analysis, a budget, schedules, and cost summaries, and a summary of environmental...

Pankow, K. Energy and Geoscience Institute at the University of Utah

Feb 09, 2017
3 Resources
0 Stars
Publicly accessible

Hawthorne Nevada Deep Direct-Use Feasibility Study Geology

Lowry, T. and Oldow, J. Nevada Bureau of Mines and Geology

Mar 29, 2018
5 Resources
0 Stars
Publicly accessible

1D Heat Loss Models Validation Experiment

Contains data from the model validation in the 1D Heat Loss Models to Predict the Aquifer Temperature Profile during Hot/Cold Water Injection Project. The data include two COMSOL models (2D axisymmetric benchmark model and 2D Vinsome model), one python code (1D Vinsome based FEM n...

Chen, K. et al UC Berkeley

Jan 18, 2022
8 Resources
0 Stars
Publicly accessible

First Results Project Hotspot Drilling

Project Hotspot drilled 3 slim hole exploratory wells in southern Idaho, each just under 2 km deep. These holes were designed to investigate thermal structure in three different settings within the Snake River Volcanic Province: (1) along the axial volcanic high of the central SRP...

Shervais, J. et al Utah State University

Mar 15, 2013
1 Resources
0 Stars
Publicly accessible

Technical Report-Rare Earth Element Data Associated with Oil and Gas Reservoir Rock

This work was developed to complement the geochemical assessments of produced water and geothermal water samples. Specifically, this task was designed to test the influence of reservoir rock-type and corresponding mineralogy/geochemistry on the concentrations of REE found in oil a...

McLaughlin, J. et al University of Wyoming

Jul 01, 2017
2 Resources
0 Stars
Publicly accessible

Summary of Cement Formulations Tested by BNL for Self-Healing Ability Tests Conditions and Data

A table of cement formulations tested by Brookhaven National Laboratory in 2016-2017 in the frame of the "Self-healing and Re-Adhering Cements with Improved Toughness at Casing and Formation Interfaces for Geothermal Wells" project.

Sugama, T. Brookhaven National Laboratory

Sep 27, 2017
2 Resources
0 Stars
Publicly accessible

Assessing REE Concentrations in Geothermal and Oil and Gas Produced Waters: A Potential Domestic Source of Strategic Mineral Commodities

The project team collected and analyzed 224 water samples and 101 matching rock samples. INL's improved method of measuring aqueous REEs allows study of samples previously thought too volume limited to measure. The study found that aqueous REEs occur at trace levels in all analyz...

Quillinan, S. et al University of Wyoming

Mar 08, 2019
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 58-32 Stimulation Conference Paper and Data

The U.S. Department of Energy's (U.S. DOE) Frontier Observatory for Research in Geothermal Energy (FORGE) is a field laboratory that provides a unique opportunity to develop and test new technologies for characterizing, creating and sustaining Enhanced Geothermal Systems (EGS) in ...

Best, S. Energy and Geoscience Institute at the University of Utah

Apr 24, 2019
2 Resources
0 Stars
Publicly accessible

<< Previous 13 14 15 16 17 18 19 20 21 22 Next >>