Search OEDI Data

Land use requirements for ground-mounted solar power facilities.

This dataset is part of a larger internal dataset at the National Renewable Energy Laboratory (NREL) that explores various characteristics of large solar electric (both PV and CSP) facilities around the United States. This dataset focuses on the land use characteristics for solar ...

Ong, S. and Laboratory, N. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

Wind Integration National Dataset (WIND) Toolkit

Wind resource data for North America was produced using the Weather Research and Forecasting Model (WRF). The WRF model was initialized with the European Centre for Medium Range Weather Forecasts Interim Reanalysis (ERA-Interm) data set with an initial grid spacing of 54 km. Thre...

Maclaurin, G. et al National Renewable Energy Laboratory

Sep 26, 2014
6 Resources
1 Stars
Publicly accessible

Measured Performance of a Varied Airflow Small-Diameter Duct System

In this study, researchers with the U.S. Department of Energy's Building America team IBACOS built on research previously done in two new-construction unoccupied test houses-one in Pittsburgh, Pennsylvania (Poerschke and Stecher 2014) and one in Fresno, California (Stecher and Poe...

Poerschke, A. Ibacos Innovation

Apr 27, 2016
5 Resources
0 Stars
Publicly accessible

Underwater Mapping Results for Seabotix vLBV300 Vehicle with Tritech Gemini 720i Imaging Sonar near Newport, OR

This document presents results from tests to demonstrate underwater mapping capabilities of an underwater vehicle in conditions typically found in marine renewable energy arrays. These tests were performed with a tethered Seabotix vLBV300 underwater vehicle. The vehicle is equippe...

Hollinger, G. Oregon State University

May 15, 2017
5 Resources
0 Stars
Publicly accessible

ResStock: Annual Baseline Results with Component Loads

The ResStock Analysis Tool was developed by NREL with support from the U.S. Department of Energy to provide a new approach to large-scale residential analysis by combining large public and private data sources, statistical sampling, detailed sub hourly building simulations, and hi...

Speake, A. et al National Renewable Energy Lab

Mar 03, 2023
6 Resources
0 Stars
Publicly accessible

2020 Annual Technology Baseline (ATB) Cost and Performance Data for Transportation Technologies

The 2020 Transportation Annual Technology Baseline (ATB) provides detailed cost and performance data, estimates, and assumptions for vehicle and fuel technologies in the United States. The Transportation ATB includes current and projected estimates through 2050 for light-duty vehi...

Jadun. . et al National Renewable Energy Laboratory

Aug 22, 2020
5 Resources
0 Stars
Publicly accessible

Raw Pressure Data from Observation Wells at Brady's Hot Springs

This .csv files contain the raw water pressure data from three observation wells during pumping tests performed in the Spring of 2016. Included is a "read me" file explaining the details of where and how the data were collected.

Lim, D. University of Wisconsin

Mar 13, 2016
6 Resources
0 Stars
Publicly accessible

Brady's Geothermal Field Analysis of Pressure Data

*This submission provides corrections to GDR Submissions 844 and 845* Poroelastic Tomography (PoroTomo) by Adjoint Inverse Modeling of Data from Hydrology. The 3 *csv files containing pressure data are the corrected versions of the pressure dataset found in Submission 844. The ...

Lim, D. University of Wisconsin

Mar 17, 2017
6 Resources
0 Stars
Publicly accessible

Pressure Data from Cranfield CO2 Thermosiphon Test

Pressure data recorded using PANEX pressure gauges at the bottom of wells CFU31-F2 and CFU31-F3.

Freifeld, B. Lawrence Berkeley National Laboratory

Jan 21, 2015
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Fluid Injection Induced Shearing Experiments on Fractured Granitoid at Elevated Temperatures

This repository contains experimental data from a series of fluid injection-induced shearing tests conducted on Utah FORGE granitoid. The experiments were performed using an aluminum triaxial pressure vessel (TEMCO) apparatus at Pennsylvania State University. The primary aim was t...

Elsworth, D. et al Pennsylvania State University

Aug 12, 2024
16 Resources
0 Stars
Publicly accessible

Brady Geothermal Field Borehole Pressure Data

This submission supersedes pressure data from March 2017 which can be found as a link in the submission resources. This submission contains 3 .csv files with time series pressure data in 3 observation wells at Brady Geothermal Field as part of the PoroTomo project. These pressure ...

Cardiff, M. and Lim, D. University of Wisconsin

Apr 01, 2016
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Friction-Permeability-Seismicity Laboratory Experiments with Non-Linear Acoustics

Laboratory experimental data on saw-cut interface of Westerly Granite and Utah Forge granitoid rocks. Experiments include velocity-stepping and fluid pressure stepping experiments. Mechanical data from 3 ISCO pumps connected to a Temco pressure vessel measure axial, confining and ...

Eijsink, A. and Elsworth, D. Pennsylvania State University

Jul 08, 2022
2 Resources
0 Stars
Publicly accessible

Raw Neutron Scattering Data for Strain Measurement of Hydraulically Loaded Granite and Marble Samples in Triaxial Stress State

This entry contains raw data files from experiments performed on the Vulcan beamline at the Spallation Neutron Source at Oak Ridge National Laboratory using a pressure cell. Cylindrical granite and marble samples were subjected to confining pressures of either 0 psi or approximate...

Polsky, Y. Oak Ridge National Laboratory

May 23, 2014
58 Resources
0 Stars
Publicly accessible

Temperature and Pressure Data Brady Monitoring Well SP-2

Static Pressure and Temperature Log for Brady monitor well SP-2. This data was taken from Well SP-2 which is part of the Brady Hot Springs Geothermal Site. The data contains pressure and temperature vs depth data for RIH (run in hole) Static conditions and POOH (pull out of hole) ...

Akerley, J. University of Wisconsin

Jan 01, 2015
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Temperature-Dependent Fracture Seismicity from Fluid Injection Experiments

This dataset contains experimental data from fluid injection experiments conducted to investigate the influence of temperature on fracture seismicity. The experiments were performed on granite samples from Utah FORGE. The samples were prepared with a 30-degree inclined fracture an...

Wang, J. et al Pennsylvania State University

Feb 29, 2024
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Fault Reactivation Through Fluid Injection Induced Seismicity Laboratory Experiments

Included are results from shear reactivation experiments on laboratory faults pre-loaded close to failure and reactivated by the injection of fluid into the fault. The sample comprises a single-inclined-fracture (SIF) transecting a cylindrical sample of Westerly granite. All expe...

Yu, J. et al Pennsylvania State University

Jul 01, 2023
27 Resources
0 Stars
Publicly accessible

Pressure-Temperature Simulation at Brady Hot Springs

These files contain the output of a model calculation to simulate the pressure and temperature of fluid at Brady Hot Springs, Nevada, USA. The calculation couples the hydrologic flow (Darcy's Law) with simple thermodynamics. The epoch of validity is 24 March 2015. Coordinates are ...

Feigl, K. Temple University

Jul 11, 2017
3 Resources
0 Stars
Publicly accessible

Fracture Sustainability Pressure, Temperature, Differential Pressure, and Aperture Closure Data

In these data sets, the experiment time, actual date and time, room temperature, sample temperature, upstream and downstream pressures (measured independently), corrected differential pressure (measured independently and corrected for offset and room temperature) indication of ape...

Kneafsey, T. Lawrence Berkeley National Laboratory

Sep 30, 2016
5 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Core-Flooding Experiment Results

This dataset contains core-flood experimental results from the Utah FORGE project, generated through laboratory tests at Lawrence Livermore National Laboratory. The experiments were conducted at temperatures of 100C and 200C using core samples from the 16A(78)-32 well. The primary...

Smith, M. et al Lawrence Livermore National Laboratory

Apr 04, 2024
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Pressure Temperature Logs from Blundell Well 71-10, Beaver County

This archive contains an Excel spreadsheet with pressure and temperature logs from PacifiCorp well 71-10. This well is in the Blundell Power Plant geothermal well field near Roosevelt Hot Springs, Beaver County, Utah. The spreadsheet also contains UTM coordinates for the location ...

Foster, K. Energy and Geoscience Institute at the University of Utah

Oct 08, 2018
1 Resources
0 Stars
Publicly accessible

Laboratory Evaluation of EGS Shear Stimulation-Test 001

This is the results of an initial setup-shakedon test in order to develop the plumbing system for this test design. a cylinder of granite with offset holes was jacketed and subjected to confining pressure and low temperature (85C) and pore water pressure. Flow through the sample w...

Bauer, S. Sandia National Laboratories

Jul 29, 2014
1 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2615: Well 58-32 and 78-32 Poroelastic Properties

Lab data on permeability, grain bulk modulus, drained bulk modulus, Skempton's pore pressure coefficient, and Biot's effective stress coefficient for Utah Forge Well 58-32 and Well 78-32. Work done as part of project number 5-2615 by the University of Oklahoma.

Ghassemi, A. and Zhou, X. University of Oklahoma

Oct 31, 2022
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Hydrothermal Friction-Hydraulic Transmissivity Laboratory Experiments

Submission includes data from laboratory slide-hold-slide tests, combined with flow through tests, conducted on Westerly granite with 30 degree sawcut. Tests were conducted with a constant confining pressure of 30 MPa with an average pore pressure of 10 MPa at temperatures of 23 a...

Jeppson, T. and Lockner, D. United States Geological Survey

Feb 24, 2022
1 Resources
0 Stars
Publicly accessible

Data of High-Temperature Dynamic LCM Testing Setup

Data from high temperature dynamic sealing tests for various fracture widths, at various temperatures (degrees F), with 5 wt.% bentonite-based mud containing various material fiber contents, at 100 to 400 psi differential pressure. Data from pressure test and evaluation of the dy...

Magzoub, M. et al University of Oklahoma

May 31, 2021
11 Resources
0 Stars
Publicly accessible

Lab-Scale Stimulation Results on Surrogate Fused Silica Samples

Lab-scale stimulation work on non-porous fused silica (similar mechanical properties to igneous rock) was performed using pure water, pure CO2 and water/CO2 mixtures to compare back to back fracturing performance of these fluids with PNNL's StimuFrac.

Fernandez, C. Pacific Northwest National Laboratory

Jul 06, 2016
1 Resources
0 Stars
Publicly accessible

1 2 3 4 5 Next >>