Search OEDI Data

Wave Energy Prize 1/50th Testing Team Flapper/Harvest Oscillating Wave Surge Converter

This submission of data includes all the 1/50th scale testing data completed on the Wave Energy Prize for the Team Flapper/Harvest, and includes: 1/50th test data (raw & processed) 1/50th test data video and pictures 1/50th Test plans and testing documents SSTF_Submission (sum...

Scharmen, W. Ricardo Detroit Technical Center

Dec 18, 2015
8 Resources
0 Stars
Publicly accessible

Wave Energy Prize Wave Calibration Data for the 1:20 Scale Testing at MASK

Time series data, sensor layout, and wave calibration summaries for the wave height measurements for the 10 calibration sea states for the 1:20 scale testing of the Wave Energy Prize (WEP) at the US Navy's Maneuvering and Seakeeping (MASK) Basin at the Naval Surface Warfare Center...

Driscoll, R. National Renewable Energy Laboratory

May 08, 2017
6 Resources
0 Stars
Publicly accessible

Underwater Mapping Results for Seabotix vLBV300 Vehicle with Tritech Gemini 720i Imaging Sonar near Newport, OR

This document presents results from tests to demonstrate underwater mapping capabilities of an underwater vehicle in conditions typically found in marine renewable energy arrays. These tests were performed with a tethered Seabotix vLBV300 underwater vehicle. The vehicle is equippe...

Hollinger, G. Oregon State University

May 15, 2017
5 Resources
0 Stars
Publicly accessible

MASK3 for Advanced WEC Dynamics and Controls

This report outlines the "MASK3" wave tank test within the Advanced WEC Dynamics and Controls (AWDC) project. This test represents the final test in the AWDC project. The focus of the MASK3 test was to consider coordinated 3-degree-of-freedom (3DOF) control of a WEC in a realistic...

Coe, R. et al Sandia National Laboratories

May 01, 2019
4 Resources
0 Stars
Publicly accessible

LandRAY PTO Testing Utilizing the NREL NWTC 5MW Dynamometer

The overarching project objective is to demonstrate the feasibility of using an innovative PowerTake-Off (PTO) Module in Columbia Power's utility-scale wave energy converter (WEC). The PTO Module uniquely combines a large-diameter, direct-drive, rotary permanent magnet generator; ...

Lenee-Bluhm, P. and Rhinefrank, K. Columbia Power Technologies, Inc.

Jun 13, 2016
3 Resources
0 Stars
Publicly accessible

Mass Customization of Prefabricated Panel Blocks for Deep Wall Insulation Retrofits

The project this data comes from looks to make building wall retrofits less expensive and easier to install by using exterior insulating panels. This is done to make buildings more energy efficient without expensive wall retrofits or reconstruction. The "Measurement and Verificati...

Sharon, A. et al Fraunhofer Center for Manufacturing Innovation CMI

Dec 14, 2021
2 Resources
0 Stars
Publicly accessible

Utah FORGE Development of a Reservoir Seismic Velocity Model and Seismic Resolution Study

This is data from and a final report on the development of a 3D velocity model for the larger FORGE area and on the seismic resolution in the stimulated fracture volume at the bottom of well 16A-32. The velocity model was developed using RMS velocities of the seismic reflection su...

Vasco, D. and Chan, C. Array Information Technology

Apr 30, 2022
2 Resources
0 Stars
Publicly accessible

EGS Collab: Modeling and Simulation Working Group Teleconference Series (99-128)

This submission contains the presentation slides and recordings from EGS Collab Modeling and Simulation Working Group (MSWG) teleconferences number 99 through 128. These teleconferences served three objectives for the project: 1) share simulation results, 2) communicate field acti...

White, M. et al Pacific Northwest National Laboratory

Jun 07, 2022
31 Resources
0 Stars
Publicly accessible

Reference Model 3 Scaled Geometry (RM3: Wave Point Absorber)

Contains the Reference Model 3 (RM3) scaled scale geometry files of the Wave Point Absorber, developed by the Reference Model Project (RMP). These scaled geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. The scaled RM3 device ...

Neary, V. et al Sandia National Laboratories

Sep 30, 2014
7 Resources
0 Stars
Publicly accessible

Testing LCM on a Large Scale for Geothermal Drilling Applications Using a Novel Experimental Setup

Rheology data obtained from flow loop tests, performed using different lost circulation materials (LCM) to study their effect on fluid rheology and wellbore hydraulics. The sealing performance of different LCM was tested using different fracture sizes. Five academic papers / repor...

Mohamed, A. et al University of Oklahoma

Apr 22, 2022
10 Resources
0 Stars
Publicly accessible

Chemical Impact of Elevated CO2 on Geothermal Energy Production

Numerical simulations have shown that the use of supercritical CO2 instead of water as a heat transfer fluid yields significantly greater heat extraction rates for geothermal energy. If this technology is implemented successfully, it could increase geothermal energy production and...

Carroll, S. et al Lawrence Livermore National Laboratory

Jan 01, 2013
3 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Preliminary Test Wells Locations and Orientations

The EGS Collab project is evaluating a site for Experiment 2 (hydraulic fracturing/shearing) at a depth of 1.25 km in the Sanford Underground Research Facility (SURF) on the 4100 Level. Two early test holes were drilled in an alcove (formerly known as Battery Charging Station) nea...

Neupane, G. et al Idaho National Laboratory

Dec 19, 2019
4 Resources
0 Stars
Publicly accessible

Environmental Life Cycle Assessment Spreadsheet tool for Deep Direct-Use Geothermal at the University of Illinois at Urbana-Champaign Campus

A Life Cycle Assessment (LCA) spreadsheet tool was developed to analyze potential environmental benefits of a deep direct-use (DDU) geothermal energy system (GES) at the University of Illinois at Urbana-Champaign (U of IL) campus. The LCA spreadsheet tool is a unique contribution ...

Tinjum, J. et al University of Illinois

Jan 31, 2020
2 Resources
0 Stars
Publicly accessible

GEOPHIRES Simulations for Deep Direct Use (DDU) Projects

This folder contains the GEOPHIRES codes and input files for running the base case scenarios for the six deep direct-use (DDU) projects. The six DDU projects took place during 2017-2020 and were funded by the U.S. Department of Energy Geothermal Technologies Office. They investiga...

Beckers, K. National Renewable Energy Laboratory

Jun 30, 2020
1 Resources
0 Stars
Publicly accessible

RANS Simulation RRF of Single Lab-Scaled DOE RM1 MHK Turbine

Attached are the .cas and .dat files for the Reynolds Averaged Navier-Stokes (RANS) simulation of a single lab-scaled DOE RM1 turbine implemented in ANSYS FLUENT CFD-package. The lab-scaled DOE RM1 is a re-design geometry, based of the full scale DOE RM1 design, producing same p...

Javaherchi, T. et al University of Washington

Apr 15, 2014
3 Resources
0 Stars
Publicly accessible

Wave Energy Prize 1/50th Testing AquaHarmonics Point Absorber

This submission of data includes all the 1/50th scale testing data completed on the Wave Energy Prize for the AquaHarmonics team, and includes: 1/50th test data (raw & processed) 1/50th test data video and pictures 1/50th Test plans and testing documents SSTF_Submission (summa...

Scharmen, W. Ricardo Detroit Technical Center

Jan 15, 2016
9 Resources
0 Stars
Publicly accessible

M3 Wave DMP/APEX WEC Final Technical Report

This project successfully developed methods for numerical modeling of sediment transport phenomena around rigid objects resting on or near the ocean floor. These techniques were validated with physical testing using actual sediment in a large wave tank. These methods can be applie...

Morrow, M. et al M3 Wave

May 31, 2018
1 Resources
0 Stars
Publicly accessible

H2@Scale Hydrogen Economic Potential Supply and Demand Locations

This data release provides estimates of hydrogens economic potential for possible hydrogen applications and production technologies by geographic location for various scenarios, as described in "The Technical and Economic Potential of the H2@Scale Concept within the United States"...

Ruth, M. et al National Renewable Energy Laboratory

Oct 01, 2020
5 Resources
0 Stars
Publicly accessible

Utah FORGE Phase 3A, Year 2, Annual Report

This is the annual report for Utah FORGE Phase 3A, year two, which was published on July 28th, 2022. The report includes site infrastructure, site operations, seismic monitoring reports, FORGE modeling reports, and external research and design. The ultimate objective of Utah FORGE...

Moore, J. et al Energy and Geoscience Institute at the University of Utah

Jul 29, 2022
1 Resources
0 Stars
Publicly accessible

Azura WEC 1/15th Wave Tank Test Data

Test data from the 1/15th Wave Tank Tests of the Azura performed in 2017/2018 to validate the power performance and survivability of the Azura Design developed by Northwest Energy Innovations (NWEI) planned for deployment at the US Navy's Wave Energy Test Site. Raw and processed d...

Ling, B. Northwest Energy Innovations

Feb 02, 2018
9 Resources
0 Stars
Publicly accessible

United States Offshore Wind Supply Curves 2024

This data packet contains supply curves, hourly generation profiles, and composite siting exclusion TIFFs for offshore wind (OSW) in the waters of the EEZ off the contiguous United States. The supply curves offer comprehensive metrics such as capacity (MW), generation (MWh), level...

Geospatial Data Science, N. National Renewable Energy Laboratory (NREL)

Jan 01, 2024
15 Resources
0 Stars
Publicly accessible

Advanced Sorbent Structure Recovery of REEs, Precious Metals and Other Valuable Metals from Geothermal Waters and Its Associated Technoeconomics

This work evaluates, develops and demonstrates flexible, scalable mineral extraction technology for geothermal brines based upon solid phase sorbent materials with a specific focus upon rare earth elements (REEs). The selected organic and inorganic sorbent materials demonstrated h...

Addleman, S. et al Pacific Northwest National Laboratory

May 25, 2017
3 Resources
0 Stars
Publicly accessible

Washington Geothermal Play Fairway Analysis Technical Report

An investment of $0.7M from the Geothermal Technology Office for Phase 2 of Play Fairway Analysis in Washington State improved existing favorability models and increased model confidence. New 1:24,000-scale geological mapping, 15 detailed geophysical surveys, 2 passive seismic sur...

Steely, A. et al Washington Geological Survey

Dec 20, 2017
1 Resources
0 Stars
Publicly accessible

Geothermal Project NEPA Database

During the 2013 fiscal year, the National Renewable Energy Laboratory (NREL) developed the Geothermal National Environmental Policy Act (NEPA) Database with funding provided by the U.S. Department of Energy (DOE) Geothermal Technologies Office (GTO). The information in the databas...

Young, K. and Levine, A. National Renewable Energy Laboratory

Sep 30, 2014
4 Resources
0 Stars
Publicly accessible

RANS Simulation VBM of Single Full Scale DOE RM1 MHK Turbine

Attached are the .cas and .dat files along with the required User Defined Functions (UDFs) and look-up table of lift and drag coefficients for Reynolds Averaged Navier-Stokes (RANS) simulation of a single full scale DOE RM1 turbine implemented in ANSYS FLUENT CFD-package. In this...

Javaherchi, T. and Aliseda, A. University of Washington

Apr 10, 2013
8 Resources
0 Stars
Publicly accessible

<< Previous 8 9 10 11 12 13 14 15 16 17 Next >>