TY - DATA AB - **Overview** Sequence W: Extended Blade (F) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed ranged from 5 m/s to 21 m/s, and the yaw angle was held at 0°. The blade pitch angle was 3°. The rotor rotated at 72 RPM. Blade pressure measurements were collected. The five-hole probes were removed and the plugs were installed. Plastic tape 0.03-mm thick was used to smooth the interface between the plugs and the blade. The teeter dampers were replaced with rigid links, and these two channels were flagged as not applicable by setting the measured values in the data file to –99999.99 Nm. The teeter link load cell was pretensioned to 40,000 N. During postprocessing, the probe channels were set to read –99999.99. The standard tip blocks were replaced with blade extensions that created a 5.532-m radius rotor as shown in Appendix A. The extension used the S809 airfoil throughout, and the linear taper of the blade continued along the extension. Note that the blade radius was not changed during post-processing so the pressure tap locations are at the same radial location, but the reference to 30% represents 30% of 5.029 m, not 5.532 m. Throughout this report, references to the blade span are made for the 5.029-m radius, not the 5.532-m radius. **Data Details** File naming information can be found in the attached Word document "Sequence W Filename Key", copied from the Phase VI Test Report. AU - Fingersh, Lee DB - Open Energy Data Initiative (OEDI) DP - Open EI | National Renewable Energy Laboratory DO - 10.21947/1481777 KW - a2e KW - atmosphere to electrons KW - wind KW - weto KW - eere KW - uae6 KW - Unsteady Aerodynamics Experiment Phase VI NREL-NASA Ames Wind Tunnel Experiment KW - UAE6 KW - Wind Tunnel Tests Data KW - Sequence W KW - Raw Data KW - z22 KW - 00 LA - English DA - 2018/11/12 PY - 2018 PB - Wind Energy Technologies Office (WETO) T1 - UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence W - Raw Data UR - https://doi.org/10.21947/1481777 ER -