TY - DATA AB - **Overview** Sequence F: Downwind High Cone (F) This test sequence used a downwind, rigid turbine with an 18° cone angle. The wind speed ranged from 10 m/s to 20 m/s. Excessive inertial loading due to the high cone angle prevented operation at lower wind speeds. Yaw angles of ±20° were achieved. The blade tip pitch was 3°. The rotor rotated at 72 RPM. Blade and probe pressure measurements were collected. The teeter dampers were replaced with rigid links, and these two channels were flagged as not applicable by setting the measured values in the data file to –99999.99 Nm. The teeter link was replaced with a shorter bar so the load cell was not installed during this test. However, the teeter link load cell channel was flagged as not applicable by setting the measured values in the data file to -99999.99 N. **Data Details** File naming information can be found in the attached Word document "Sequence F Filename Key", copied from the Phase VI Test Report. AU - Fingersh, Lee DB - Open Energy Data Initiative (OEDI) DP - Open EI | National Renewable Energy Laboratory DO - 10.21947/1483641 KW - a2e KW - atmosphere to electrons KW - wind KW - weto KW - eere KW - uae6 KW - Unsteady Aerodynamics Experiment Phase VI NREL-NASA Ames Wind Tunnel Experiment KW - UAE6 KW - Wind Tunnel Tests Data KW - Sequence F KW - Raw Data KW - z05 KW - 00 LA - English DA - 2018/11/28 PY - 2018 PB - Wind Energy Technologies Office (WETO) T1 - UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence F - Raw Data UR - https://doi.org/10.21947/1483641 ER -