TY - DATA AB - **Overview** Sequence 5: Sweep Wind Speed (F,P) This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speed was ramped from 5 m/s to 25 m/s by the wind tunnel operator. This was repeated with a decreasing ramp. The yaw angle was maintained at 0°. The blade tip pitch was 3° or 6°. The rotor rotated at 72 RPM. Blade pressure and probe measurements were collected for both pitch angles. The five-hole probes were removed and the plugs were installed for another 3° pitch case. Plastic tape 0.03 mm thick was used to smooth the interface between the plugs and the blade. The teeter dampers were replaced with rigid links, and these two channels were flagged as not applicable by setting the measured values in the data file to –99999.99 Nm. The teeter link load cell was pre-tensioned to 40,000 N. During post-processing, the probe channels were set to read -99999.99. The 6- minute campaigns were named using the sequence designation 5, followed by DN or UP, which indicates the wind speed ramp direction. The next four digits are 0000, and the sequence digit is at the end. **Data Details** File naming information can be found in the attached Word document "Sequence 5 Filename Key", copied from the Phase VI Test Report. AU - Fingersh, Lee DB - Open Energy Data Initiative (OEDI) DP - Open EI | National Renewable Energy Laboratory DO - 10.21947/1481780 KW - a2e KW - atmosphere to electrons KW - wind KW - weto KW - eere KW - uae6 KW - Unsteady Aerodynamics Experiment Phase VI NREL-NASA Ames Wind Tunnel Experiment KW - UAE6 KW - Wind Tunnel Tests Data KW - Sequence 5 KW - Raw Data KW - z26 KW - 00 LA - English DA - 2018/11/12 PY - 2018 PB - Wind Energy Technologies Office (WETO) T1 - UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence 5 - Raw Data UR - https://doi.org/10.21947/1481780 ER -