TY - DATA AB - This map shows areas of anomalous surface temperature in Alamosa and Saguache Counties identified from ASTER thermal data and spatial based insolation model. The temperature is calculated using the Emissivity Normalization Algorithm that separate temperature from emissivity. The incoming solar radiation was calculated using spatial based insolation model developed by Fu and Rich (1999). Then the temperature due to solar radiation was calculated using emissivity derived from ASTER data. The residual temperature, i.e. temperature due to solar radiation subtracted from ASTER temperature was used to identify thermally anomalous areas. Areas that had temperature greater than 2o were considered ASTER modeled "very warm modeled surface temperature" are shown in red on the map. Areas that had temperatures between 1o and 2o were considered ASTER modeled "warm modeled surface temperature" are shown in yellow on the map. This map also includes the locations of shallow temperature survey points, locations of springs or wells with favorable geochemistry, faults, transmission lines, and areas of modeled basement weakness "fairways." Note: 'o' is used in this description to represent lowercase sigma. AU - Hussein, Khalid DB - Open Energy Data Initiative (OEDI) DP - Open EI | National Renewable Energy Laboratory DO - 10.15121/1361181 KW - geothermal KW - Colorado KW - San Miguel County KW - Remote sensing KW - ASTER KW - Thermal infrared KW - map KW - thermal anomalies KW - surface temperature anomalies LA - English DA - 2012/02/01 PY - 2012 PB - Flint Geothermal, LLC T1 - Surface Temperature Anomalies Derived from Night Time ASTER Data Corrected for Solar and Topographic Effects, San Miguel County, Colorado UR - https://doi.org/10.15121/1361181 ER -